• KEPCO Journal on Electric Power and Energy
• /
• v.1 no.1
• /
• pp.85-91
• /
• 2015

We investigated the structure of inductive coupler and its magnetic coupling to increase the transmission coefficient for power line communication. A Rogowski coil, which is an air-cored inductive coupler, and a magnetic cored coupler were fabricated to analyze the transmission coefficient for different coupler parameters. This paper proposes the impedance matching method using lumped elements and an impedance transformer to increase the transmission coefficient. In the experiment, the transmission coefficient of the proposed system was increased in both narrowband and broadband cases, and a trade-off between the transmission coefficient and the bandwidth was shown. This method will be useful for the further study of impedance matching with the load variation.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.251-252
• /
• 2009

전류에 의한 자속변화를 검출하는 로고스키코일은 자성체를 코어로 이용하는 종전의 변류기 (Current Transformer) 와는 달리 공심이거나 비자성재료를 사용하기 때문에 자기적으로 포화되지 않으므로 일반적으로 디지털 적산 전력량계의 전류센서로 활용되고 있다. 본 연구는 저온소성 다층 세라믹 기판상에 로고스키코일을 적용한 전자식 전력량계의 정밀 전류측정용 센서 개발에 관한 것이며. 3차원 전자기장 해석 프로그램인 MWS를 하여 기판의 소재와 코일의 패턴의 크기 등을 달리하여 그 특성을 알아보고 실제 구현된 센서의 측정된 값과 비교해 보았다.

• Proceedings of the KIEE Conference
• /
• 2002.07c
• /
• pp.1884-1886
• /
• 2002

At present, the variable sensors are applied to detect PD pulse signals, UHF sensor, AE sensor and etc. In this paper we used the Rogowski sensor to detect PD pulse signals in air. We did performed test simulation and niddle to plane electrode structure for PD source. We compared Rogowski sensor with conventional type PD detector to detect discharge signals in air.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.55 no.10
• /
• pp.521-527
• /
• 2006

After various measuring methods and system were investigated, Rogowski colis for the measurement of parameters in current zero region were designed and manufactured. Using the Rogowski coils and a 38kV 40kA VCB (vacuum circuit breaker), at last the post-arc current has been successfully measured firstly. It was found that the Rogowski coils used in this study have good characteristics and propriety to measure the parameters of current zero. We realized that the data processing for evaluating the post-arc current from the experimental results needs much more careful attention than that for building the measuring technique and system. The magnitude of post-arc current and the falling time of it to zero are proportioned to the rate of current di/dt. The magnitude of post-arc currents were around $1{\sim}3A$ to the interruption current of $20{\sim}30kA$ in the model VCB.

• Proceedings of the KIEE Conference
• /
• 1984.07a
• /
• pp.237-239
• /
• 1984

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.51 no.12
• /
• pp.584-590
• /
• 2002

Crowbar system is usually applied to a pulsed power system in which a capacitor bank is discharged into a load. This provides a free wheeling path for the load current and prevents the capacitor from recharging due to a reverse voltage. Usually diodes have been used as a crowbar switch, but it is not a practical system because the cost of the diodes goes up enormously with increasing the system voltage and current. This paper presents a novel protection scheme of a charging and discharging system of a 300 kJ capacitor bank using a low-cost crowbar system which consists of a crowbar switch and resistors. Triggered vacuum switch(TVS) was used for a crowbar switch, and Rogowski coil was used to determine a trigger time of TVS. When this crowbar system is applied to our pulsed power system which consists of capacitor bank($123muF$), inductor() for forming a pulse, load resistor$(100 m\Omega)$, and a closing switch, instantaneous reversal voltage of capacitor bank could be limited less than 1.8 ㎸ until capacitor bank was charred to 17 ㎸.

• Journal of Korean Ophthalmic Optics Society
• /
• v.12 no.1
• /
• pp.69-74
• /
• 2007

The axial speed of plasma current sheath was measured with Rogowski coils and compared with the theory of snowplow model. Current sheath speed is measured with $10^6cm/s$. The speed of light gas, $H_2$ and He were similar to the theory of model, but the heavy gas, Ar was not similar to the theory. The disagreement of the heavy gas was guessed as a results of the instability of the current sheath.

• Proceedings of the Korean Vacuum Society Conference
• /
• 1999.07a
• /
• pp.34-34
• /
• 1999

토카막(Tokamak)에서는 플라즈마(plasma)로 불순불(impurity)의 유입을 방지하기 위해 고진공을 유지해야 하며 이를 위해 가열탈리(backing), 방전세정(discharge codanning) 등 wall conditioning이 기본적으로 요구된다. KT-1 토카막은 실험실 이전에 따른 해체로 인해 진공용기(vacuum vessel) 가 대기압 하에 수개월 동안 노출되어 있었기 때문에 재조립 후 가열 탈 리가 필수적이나 진공용기의 외부에 saddle loop coil을 비롯해 Rogowski, diamagnetic coil, poloidal field coil 등 많은 magnetic pick up coil 들이 설치되어 있어 열선 등 일반적인 방법으로 가열 탈 리가 어려운 상황이다. 따라서 KT-1 토카막에서는 전자석 코일에 상전원을 부가하였을 때 진공용기에 발생하는 유도가열 (inductive heatin)을 이용해 가열 탈리를 시도하였다. 유도 가열 탈리(inductive backing)는 토로이달 자장 코일(toroidal field coil)과 가열 저장 모일(ohmic heating coil)을 각각 이용하여 코일의 온도가 6$0^{\circ}C$ 이하가 유지되는 코일 전류 범위내에서 수행하였으며 먼저 이 둥 경우에 있어서 진공용기의 온도분포를 비교하엿다. 그리고 가열 탈리 기간 및 그 전, 후의 진공압력과 잔류기체 분압을 측정, 분석하였다. 유도가열에 의한 방법으로 KT-1 토카막에서 얻은 탈리온도는 12$0^{\circ}C$정도로 비교적 낮았으나 탈리 시간을 연장하여 탈리효과를 어느 정도 보상할 수 있으며 일반적인 가열 탈리가 여려운 경우 유도 가열 탈 리가 채택될 수 있는 또 하나의 방법이라 볼 수 있다.

• Proceedings of the KIEE Conference
• /
• 2006.11a
• /
• pp.366-368
• /
• 2006

This paper analyzes partial discharge pattern using Rogowski coil and acoustic emission sensor to power transformer. Therefore, the location of partial discharge and pattern is deduced as obtaining reliable data to establish core structure in transformer.

• Proceedings of the KIEE Conference
• /
• 1987.11a
• /
• pp.307-308
• /
• 1987

A low-Pressure gap decoupling crow-bar switch was designed and operated to obtain prolonged current pulses by discharging 50kJ condeser banks. And air core Rogowski coil was used for measuring high current.