• Journal of the Korean Institute of Telematics and Electronics
• /
• v.19 no.5
• /
• pp.1-4
• /
• 1982

Single crystals of InSe were obtained by the Bridgman method. The crystal structure was hombohedral(R3m) with lattice paramete. a=4.02A, c=24.96A. At 300$^{\circ}$K the electrical conductivity was about ~10-2($\Omega$.cm)-1, reslpectively. The electrical conductivity type was n- type. The donor level located at 0.072eV below the conduction band. The Photosensitivity was observed in range from 840nm to 1120nm. The energy gap of InSe single crystal measured from the photoconductivity and the optical transmittance spectrum was 1.20eV, 1.21eV, respectively.

• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.609-612
• /
• 1998

Pyroelectric properties of rhombohedral $Pb(ZrxTi_1-x)O_3ceramics$ with various Zr/Ti ratios of 84/16, 87/13, 90/10, and 93/7 are investigated using dynamic method. The response characteristics of PZT samples are examined by considering frequency dispersion. Since the reorientation of the grain does not the influence on the increase of frequency at low frequency (2~200Hz), the maximum pyroelectric response can be obtained with the change of spontaneous polarization. However, the pyroelectric response of PZT samples could be reduced as the spontaneous polarization decreases due to the restrain of the reorientation of the grain with the increasing of requency at high frequency (200~2000Hz). We have obtained the good pyroelectric response in the PZT sample having 84/16 Zr/Ti ratio, then the pyroelectric coefficient (${\gamma}$) and the figure of merit (FV) were $17.3nC/\textrm{cm}^2K$ and 2.28$\times$10-11Ccm/J, respectively. The noise equivalent power (NEP), the detectivity (D*) were 1.21$\times$10-7W/Hz$\frac{1}{2}$ and 8.26$\times$106cmHz$\frac{1}{2}$/W, respectively.

• The Korean Journal of Ceramics
• /
• v.1 no.1
• /
• pp.13-20
• /
• 1995

Effects of thermal annealing on the dielectric/piezoelectric properties of $Pb(Zn, Mg)_{1/3}Nb_{2/3}O_3-PbTiO_3$ ceramics (PZMNPT) with Zn/Mg=6/4) were examined across the rhombohedral/tetragonal morphotropic phase boundary (MPB). Both the relative dielectric permittivity ($\varepsilon$r)and the piezoelectric constant($d_33$)/electromechanical coupling constant ($k_p$)were increased by thermal annealing ($800^{\circ}$~$900^{\circ}C$) after sintering at $1150^{\circ}C$ for 1 hr. Based on the dielectric analysis using the series mixing model and the concept of a random distribution of the local Curie points, the observed improvements in the dielectric and piezoelectric properties of PZMN-PT were interpreted in terms of the elimination of PbO-rich amorphous intergranular layers(~1nm) induced by thermal annealing. A concrete evidence of the presence of amorphous grain-boundary layers in the unannealed (as-sintered) specimen was obtained by examining the structure of intergranular region using a TEM.

• Journal of the Korean Ceramic Society
• /
• v.32 no.3
• /
• pp.295-304
• /
• 1995

Stabilization of the perovskite phase and sequence of reactions occuring during calcination were studied with solid solutions formed between Pb(Zn1/3Nb2/3)O3 and Pb(Fe1/2Nb1/2)O3. In the PZN-PFN composition of equal molar ratio, rhombohedral type pyrochlore phase (Pb2Nb2O7) and PbO-rich distorted cubic type pyrochlore phase (Pb3Nb2O8) were coexisted as intermediate phases at temperatures below 85$0^{\circ}C$, and these phases transformed to a stable cubic type pyrochlore phase, Pb3Nb4O13 solid solution and a perovskite solid solution at temperatures above 85$0^{\circ}C$. The major stable phase as increasing sintering temperatures was a perovskite phase in this binary system and prominent suppression of the pyrochlore phase was achieved by substituting Zn2+ with Fe3+ or by increasing sintering temperature. The composition containing 20mol% PZN possessed the best dielectric properties, and the dissipation factor was lower than 5% in all compositions.

• Korean Journal of Materials Research
• /
• v.6 no.5
• /
• pp.504-514
• /
• 1996

고상반응법과 sol-gel법으로 제조된 NASICON의 상온과 25$0^{\circ}C$에서의 X선 회절 데이터를 리트벨트 분석을 행하였다. monoclinic에서 rhombohedral로 상전이가 일어나도 원자들의 변위는 매우 작았다. 이들 상간의 ZrO6 팔면체와 Si(P)O4 사면체고 구성된 골격은 다소 다르게 나타남으로 인하여 Na 이온의 자리도 변하였다. 이들 방법으로 제조된 NASICON은 Zr이 부족한 비화학양론 화학식, Na 1+x+4yZr2-xSixP3-xO12으로 표현될 수 있었다. 제조법에 따라 Na 이온들의 자리 점유율이 변화하였다. 상온에서는 Na(1)과 Na(3)자리의 자리 점유율의 합이 거의 1에 가까웠으나, 25$0^{\circ}C$에서는 Na(1)과 mid Na 자리를 단위 화학식 당 한 개를 약간 상회하는 Na 이온이 점유하였다. 상온과 25$0^{\circ}C$에서의 Na 이온의 이동 경로가 다름을 알 수 있었다. 또한 25$0^{\circ}C$에서는 Na(1)자리와 Na(2)자리 사이에 mid Na가 존재하며, 이 자리가 Na 이온의 이동에 중요한 역할을 함을 알 수 있었다.

• Transactions on Electrical and Electronic Materials
• /
• v.12 no.2
• /
• pp.64-67
• /
• 2011

The effect of Ta substitution on the crystal structure, ferroelectric, and piezoelectric properties of $Bi_{0.5}(Na_{0.82}K_{0.18})_{0.5}Ti_{1-x}Ta_xO_3$ ceramics has been investigated. The Ta doping resulted in a transition from coexistence of ferroelectric tetragonal and rhombohedral phases to an electrostrictive pseudocubic phase, leading to degradations of the remnant polarization, coercive field, and piezoelectric coefficient $d_{33}$. However, the electricfield-induced strain was significantly enhanced by the Ta substitution-induced phase transition and reached a highest value of $S_{max}/E_{max}$ = 566 pm/V under an applied electric field 6 kV/mm when 2% Ta was substituted on Ti sites. The abnormal enhancement in strain was attributed to the pseudocubic phase with high electrostrictive constants.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.11a
• /
• pp.216-216
• /
• 2003

The layered nickel oxides (LiNiO$_2$) have been studied for possible use as cathode materials i3l 4V lithium batteries. Although LiCoO$_2$ has been known as the best candidate material for Li-ion batteries, which produces the best performance LiNiO$_2$ is generally accepted as an attractive cathode material, because of its various advantages such as lower cost higher discharge capacity and better reversibility. In this investigation, we calculated the electric state of LiNiO$_2$ using DV-X$\alpha$ molecular orbital method in order to obtain the information of chemical bonding among the Li, Ni and O. In LiNiO$_2$, alternate layers of Li and Ni occupy the octahedral sites of a cubic close packing of oxide ions, making up a rhombohedral structure with an R-3m space group, Li in 3a, Ni in 3b, and O in 6c sites. On the basis of this, we made the cluster model and studied ionization of each atoms and interaction between atoms according to Mullilcen population analysis.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1324_1325
• /
• 2009

The heterolayered $BaTiO_3/(Bi_{0.5}Na_{0.5})TiO_3$ thick films were fabricated by screen printing techniques on alumina substrates electrodes with Pt. We report the improved ferroelectric properties in the heterolayered teteragonal/rhombohedral structure composed of the $BaTiO_3$ and the $(Bi_{0.5}Na_{0.5})TiO_3$ thick films. We investigated the effects of deposition conditions on the structural and electrical properties of the heterolayered BNT/BT thick films. The structural and electrical properties of the heterolayered BNT/BT thick films were studied. All PZT heterolayered thin films show dense and homogeneous structure without the presence of the rosette structure. The dielectric constant, loss and remanent polarization oft heheterolayered BNT/BT thick films were superior to those of single composition $BaTiO_3$ and $(Bi_{1/2}Na_{1/2})TiO_3$, and those values for the heterolayered BNT/BT thick films sintered at $1100^{\circ}C$ were 916, 0.79 and $12.63{\mu}C/cm^2$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.689-692
• /
• 2001

In this paper, the pizoelectric and dielectric properties of 0.95Pb(ZrxTil-x)O$_3$- 0.05Pb(Mn$\_$0.2/Fe$\_$0.4/W$\_$0.4/)O$_3$piezoelectric ceramics is investigated as a function of Zr/Ti mole ratio. Also, MPB(Morphotropic Phase Boundary) and optimal sintering temperature is studied using XRD and SEM. As a results, when Zr/Ti mole ratio is 52/48, electromechanical coupling factor, k$\_$p/, is 58[%], permittivity, $\varepsilon$$\^$T/$\_$33//$\varepsilon$0, is 1360 and piezoelectric strain constant, d$\_$33/ is 265[pC/N] and the piezoelectric and dielectric properties become maximum. Phase transition temperature of its ternary piezoelectric system is about 350[$^{\circ}C$]. From the XRD analysis, when Zr/Ti mole ratio is 52/48, tetragonal phase transits to rhombohedral phase. Also, From measuring results of the sintering density, when sintering temperature is 1050[$^{\circ}C$], sintering density become maximum and is about 7930[kg/㎥], and average grain size is about 2-3[$\mu\textrm{m}$].

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07b
• /
• pp.657-661
• /
• 2002

PZT powder was prepared by partial oxalate method using $(Zr_{0.53}Ti_{0.47})O_2$, $Pb(NO_3)_2$ and $(COOH)_2{\cdot}2H_2O$ as a precipitant. $Nb_2O_5$ additive effect on microstructure and piezoelectric properties of PZT ceramics were investigated. The coexistence of rhombohedral and tetragonal phases of PZT ceramics at the sintering temperature of $1100^{\circ}C$ was revealed from the X-ray diffraction patterns. The grain size PZT ceramics was decreased with the increase $Nb^{5+}$. and the sinterbility of PZT ceramics was decreased with the increase $Nb^{5+}$ addition. The electromechanical coupling factors $K_p$ show above 0.60 at $1100^{\circ}C$ sintering temperature by $Nb_2O_5$ addition above 0.6mol%.