• Korean Journal of Applied Biomechanics
• /
• v.14 no.1
• /
• pp.117-131
• /
• 2004

The foreign superior players and national team players' turning phase was measured, compared and analyzed to help the representative players improve the skill of turn. The underwater video camera used to analyze and evaluate the representative players' skill of turn in detail and the result is as follows. 1. The record for the phase of turn was similar to the rank of the last record. The improvement of the skill of turn was required because Korean players' record was lower than the foreign players' one. In case of 200m events the 1st turn was the fastest and it took more time as the turn is repeated. 2. It shows that the preparation phase and turing motion cause the difference between the players and within one player. 3. The horizontal movement of center of gravity moves to turning point slowly in the preparation phase, does not move nearly in the turning phase and increase again in the propulsion phase. Good record has short time for turn phase. The result means that the shorten the turning phase is the most important factor. Therefore the preparation for this is required. The vertical movement is maintained or increase a little and then move to from the turning phase. 4. The characteristic of horizontal velocity in center of gravity is that there is any big changes at the preparation phase, the faster velocity is found from the better record and the accelerating time is fast at the propulsion phasen. The wrong motion is made by not using the swimming velocity for fuming and waiting and more time is required by this. 5. The angle of knee when the player touch the turning point is 106.22-135.56 and the maximum angle of knee during the driving after the touch of tuning point is full extension. The size of maximum angle of knee did not match with the required time of propulsion phase. It seems that the individual difference is big when the players touch the turning point the angle of knee and the research for the individual angle which can reveal the maximum power should be carried out. The national team player's skill for the him is behind the foreign players' one and a lot of problems were found. It shows that the players could not practice the skill for turn during the training. The 1st reason for it is the various facilities like underwater window or analyzing equipment like underwater camera with which the coaches can teach and correct the players' detailed skill. It is need to evaluate the players' detailed skill exactly and correct it by objective data to complete the good skill in the future. In this regard, the investment for the facility is necessary.

• Fire Science and Engineering
• /
• v.30 no.5
• /
• pp.1-8
• /
• 2016

Safety management in hazardous areas with potentially explosive gas atmospheres (here in after referred to as hazardous areas) in large scale facilities dealing with combustible or flammable materials at home and abroad is very important (significant) for the coexistence of the company and local society based on business continuity management (BCM) and reliance. For the safety management in hazardous areas, two systems are mainly used: (1) the control system for the prevention of combustible or flammable substances and (2) the explosion proof system for the elimination of ignition sources when flammable gases are leaked to inhibit the transition to fire or explosion accidents. While technology and regulations on explosion proof facilities or devices for electrical ignition sources are well developed and defined, those for thermal ignition sources need to be more developed and established. In this study, the internal combustion engine in hazardous areas was investigated to determine the risk of ignition. For this purpose, document searches were conducted on the relevant international standards and accidents cases and risk analysis reports. In addition, this study assessed the application cases of the diesel engine's safety equipment, such as spark arresters regarding the site of process safety management (PSM) system in central Korea. To practically apply these results to the hydrocarbon industry, the safety management method for explosion prevention in hazardous areas was provided by risk identification for ignition sources of internal combustion engines, such as diesel engines.

• Fire Science and Engineering
• /
• v.33 no.5
• /
• pp.94-102
• /
• 2019

As the importance of first responses for fire accidents has grown in the safety management of nuclear power plants, a systematic approach to measure firefighters' psychological states and competence is needed. The current study investigated the construct of the risk perception of the firefighters working near nuclear power plant sites, and then developed and validated a new scale to measure firefighters' risk perception regarding nuclear power plant accidents. The scale items were developed on the basis of literature review and interviews with the firefighters working near nuclear power plant sites. In order to validate the new scale, we recruited 180 firefighters from five fire stations in the vicinity of the nuclear power plants in Jeonnam Province, Gyeongbuk Province, and Busan. The results of exploratory factor analyses revealed that the scale consisted of five factors: "manual" reflecting a lack of response guidelines and manuals for fire incidents and radioactive material release; "fear" reflecting a fear of fire incidents in the nuclear power plants and their catastrophic consequences; "resource" reflecting a lack of protective equipment and manpower for responding to fire incidents in the nuclear power plants; "trust" reflecting trust and cooperation with the counterpart institutions for firefighting in the nuclear power plants; and "knowledge" reflecting the knowledge of radioactivity and firefighting in the nuclear power plants. Further analyses provided statistical evidence supporting for the 15-item scale's internal consistency and construct validity. Finally, We discussed the implication and limitations of the current research.

• Journal of Gifted/Talented Education
• /
• v.23 no.4
• /
• pp.537-565
• /
• 2013

The purpose of this study was to investigate teachers' responses to curriculum evaluation of gifted curriculum in visual arts. Especially, this study examined whether there are differences of the responses among three types of institutions for gifted education (institution for gifted education, community based gifted classroom, and school based gifted classroom). Teachers from these three types of institutions for gifted education were interviewed. The results are as follows. First, teachers viewed that consideration is needed for 3 criteria. Teachers from different institutions showed different responses to 'professionalism of working personnel' and 'utilization of advisory committee'. Second, teachers viewed that 13 criteria need consideration. Teachers from different institutions showed different responses to 'support personnel for gifted education' and 'educational equipment and resource supply'. Third, teachers viewed that consideration is needed for 2 criteria. Teachers from different institutions showed different responses to 'efforts for professional development of instructors'. Fourth, teachers viewed 4 criteria need consideration. Teachers from different institutions showed different responses to 'budget planning for next year'. Based on the findings, implications for developing and implementing the evaluation criteria for the gifted curriculum in visual arts were discussed.

• Journal of Korea Water Resources Association
• /
• v.48 no.5
• /
• pp.321-330
• /
• 2015

In recent, the impacts of urbanization on hydrology and water quality can be minimized with the use of Low Impact Development (LID) practices in urban areas. But, there are no ways to verify or to show the quantitative effectiveness with LID practices. This study designed and developed to perform experiments in natural or artificial representation of hydrological cycle, which is called rainfall-runoff simulator to be able to quantify factors in hydrological system. This simulator was applied to a pervious pavement block. The study conducted analysis of effectiveness for a pervious pavement block by comparing the results with a general pavement block. The result from the pervious pavement block showed remarkably reduction effect on surface runoff with increase of rainfall intensity and more duration time. Also, the simulator was possible to control no surface runoff by a rainfall intensity at 50 mm/hr for an hour. The research indicated possibility and effectiveness for LID practices. This might be widely available to apply to LID practices verification. Therefore, the study is possible to make use of practical standards on fundamental studies.

• Journal of Conservation Science
• /
• v.30 no.3
• /
• pp.307-315
• /
• 2014

The gold textile is Korean traditional weaving technique using the gold thread since 5th century. The making technique of gold thread was written in various references, but it is severed because the gold thread weaving equipment and sumptuous moods were forbidden in the early 18th century. There are some studies of traditional gold thread which are mainly about conservation treatment of cleaning and strength. To restore traditional gold thread, investigation of material and manufacturing technique is vitally required. The gold threads are composed of gold leaf, adhesive and base sheet. Gold leaf and base sheet are available for investigation because they are exposed to the surface, whereas adhesive is not easy to investigate because it is not exposed to the surface. In this study, samples are made of pure and impure gold, animal glue and lacquer, and various types of Hanji based on domestic and foreign references to compare materials for gold threads. As a result of morphological character and stability evaluation, the optimum materials for the restoration of gold threads are pure gold, animal glue and Dochimji(smoothing paper by beating). This study is expected to be basic data for manufacturing gold threads techniques and modernization of traditional gold threads hereafter research.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.24 no.5
• /
• pp.548-553
• /
• 2014

In order to evaluate the performance of arrow that manufactures through production process, it is used that personal experiences such as hunters who have been using bow and arrow for a long time, technicians who produces leisure and sports equipment, and experts related with this industries. Also, the intensity of arrow's impact point which obtains from repeated shooting experiments is an important indicator for evaluating the performance of arrow. There are some ongoing researches for evaluating performance of arrow using intensity of the arrow's impact point and the arrow's flying image that obtained from high-speed camera. However, the research that deals with mutual relation between distribution of the arrow's impact point and characteristics of the arrow (length, weight, spine, overlap, straightness) is not enough. Therefore, this paper suggests both the system that could describes the distribution of the arrow's impact point into numerical representation and the correlation model between characteristics of arrow and impact points. The inputs of the model are characteristics of arrow (spine, straightness). And the output is MAD (mean absolute distance) of triangular shaped coordinates that could be obtained from 3 times repeated shooting by changing knock degree 120. The input-output data is collected for learning the correlation model, and ANN (artificial neural network) is used for implementing the model.

• Journal of Convergence for Information Technology
• /
• v.10 no.11
• /
• pp.47-54
• /
• 2020

This study proposes an NFC-based payment system that considers user convenience while expanding the existing payment method for RFID-based individual food and logistics waste equipment. In line with this trend, I proposed to apply NFC to the existing RFID-based food meter to release the food in the meantime and to address the problem of re-carrying due to card loss, card not possessed, and non-filling, and the question that could not be identified by various cumbersome procedures. NFC's function alone has been certified for its convenience, which led to its introduction and research in the period of time. Of course, we need to negotiate fees with the transportation card company, but if we see a market share related to transportation card soon, we think smooth negotiations will take place. NFC method will be expanded to all phones with iPhone NFC opening. Therefore, in the next study, we intend to apply the payment system in NFC by linking with local currency, mobile vouchers, and card companies, which are being paid as respective payment means according to the recent emergency support system for COVID-19.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.18 no.4
• /
• pp.191-203
• /
• 2018

Identify the effects of ISO quality management system on the durability of the enterprise by applying it to early startups and small - and medium-sized enterprises. In particular, the quality management system of a technology start-up small and medium sized companies is important in applying the management system to the financial, management and quality control services rather than to research and development. The quality management system is applied to the medical equipment manufacturers, mobile phone brokers, foreign Chinese companies, and components manufacturers for diesel engines.Try it. Check the case where the quality management system has been applied to the company concerned and the nonconformities have been improved. In addition, the success of the project was determined by applying the quality control system to maintain the stability and perpetuation of the company through the case of the failed selection. The company explains that recently, it must appoint internal auditors to carry out continuous improvement activities and that those who want the development and continuity of the company must reflect the quality management system.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.7 no.4
• /
• pp.143-154
• /
• 2004

The researchers, who seek geological and environmental information, depend on the remote sensing and aerial photographic datum from various commercial satellites and aircraft. However, the adverse weather conditions and the expensive equipment can restrict that the researcher can collect their data anywhere and any time. To allow for better flexibility, we have developed a compact, a multi-spectral automatic Aerial photographic system(PKNU 2). This system's Multi-spectral camera can catch the visible(RGB) and infrared(NIR) bands($3032{\times}2008$ pixels) image. Visible and infrared bands images were obtained from each camera respectively and produced Color-infrared composite images to be analyzed in the purpose of the environment monitor but that was not very good data. Moreover, it has a demerit that the stereoscopic overlap area is not satisfied with 60% due to the 12s storage time of each data, while it was possible that PKNU 2 system photographed photos of great capacity. Therefore, we have been developing the advanced PKNU 2(PKNU 3) that consists of color-infrared spectral camera can photograph the visible and near infrared bands data using one sensor at once, thermal infrared camera, two of 40 G computers to store images, and MPEG board to compress and transfer data to the computer at the real time and can attach and detach itself to a helicopter. Verification and calibration of each sensor(REDLAKE MS 4000, Raytheon IRPro) were conducted before we took the aerial photographs for obtaining more valuable data. Corrections for the spectral characteristics and radial lens distortions of sensor were carried out.