• 전기학회논문지
• /
• 제66권6호
• /
• pp.892-897
• /
• 2017

Until now, it has been for choosing most economic result to be generally used for designing remote MicroGrid (MG) system. It is able to make economic benefit by reducing operation cost, but proportion of renewable energy will be minimum. In other words, it is difficult to get an effect by renewable energy because economic feasibility is an only consideration. Therefore, various factors should be considered and design objectives should be are diversified to design proper remote MG system. In this paper, remote MG system is classified into two types according to design objectives, and they are analysed through case study based on economic evaluation. In addition, economic feasibility for each type is analysed through sensitivity analysis according to various factors that affect the design results of the system.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2007년도 하계학술발표대회 논문집
• /
• pp.43-43
• /
• 2007

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2010년도 춘계학술대회 초록집
• /
• pp.244.1-244.1
• /
• 2010

Bio energy development by using Low Calorific Gas Turbine(LCGT) has been developed for New & Renewable energy source for next generation power system, low fuel and operating cost method by using the renewable energy source in landfill gas (LFG), Food Waste, water waste and Livestock biogas. Low calorific fuel purification by pretreatment system and carbon dioxide fixation by green house system are very important design target for evaluate optimum applications for bio energy. Main problems and accidents of Low Calorific Gas Turbine system was derived from bio fuel condition such as hydro sulfide concentration, siloxane level, moisture concentration and so on. Even if the quality of the bio fuel is not better than natural gas, LCGT system has the various fuel range and environmental friendly power system. The mechanical characterisitics of LCGT system is a high total efficiency (>70%), wide range of output power (30kW - 30MW class) and very clean emmission from power system (low NOx). Also, we can use co-generation system. A green house designed for four different carbon dioxide concentration from ambient air to 2000 ppm by utilizing the exhaust gas and hot water from LCGT system. We look forward to contribute the policy for Renewable Portfolio Standards(RPS) by using LCGT power system.

• Journal of Electrical Engineering and Technology
• /
• 제9권6호
• /
• pp.2004-2012
• /
• 2014

Energy storage devices are necessary to obtain stable utilization of renewable energy sources. When black-out occurs, distributed renewable power sources with energy storage devices can operate under standalone mode as uninterruptable power supply. This paper proposes a dynamic response analysis with small-signal modeling for the standalone operation of a photovoltaic power generation system that includes a bidirectional charger/discharger with a battery. Furthermore, it proposes a DC-link voltage controller design of the entire power conditioning system, using the storage current under standalone operation. The purpose of this controller is to guarantee the stable operation of the renewable source and the storage subsystem, with the power conversion of a very efficient bypass-type PCS. This paper presents the operating principle and design guidelines of the proposed scheme, along with performance analysis and simulation. Finally, a hardware prototype of 1-kW power conditioning system with an energy storage device is implemented, for experimental verification of the proposed converter system.

• 설비공학논문집
• /
• 제25권8호
• /
• pp.464-470
• /
• 2013

Economic feasibility was conducted regarding the regulation that dictates obligatory installation of renewable energy facilities in small proportion. A concern is how to allocate the capacities of candidate facilities (solar collectors, PV cells and geothermal heat pumps) with minimum cost, and meet the obligatory energy supply proportion. A design rule has been developed, with which a designer can tune his or her design strategy between installation cost and LCC. This was derived mainly from documents regarding the KEMCO installation guide. It was concluded that PV was the cheapest, with respect to installation cost, but a geothermal heat pump was the most recommended, when LCC was also taken into account. The proposed design result was also confirmed, by simulation results obtained from Energy Plus.

• Ocean Systems Engineering
• /
• 제13권3호
• /
• pp.247-268
• /
• 2023

Tidal stream energy extraction remains a site-specific resource due to the "first generation" criteria requiring high-velocity tidal streams. Most studies on tidal energy and turbine blade design heavily focus on installation sites with higher velocity conditions that are non-existent in tropical countries such as the Philippines. To shorten this gap, this review paper tackles tidal turbine design considerations for low-energetic regions such as the tropics. In-depth discussions of operating principles, methods of analysis, and designs of tidal turbine blades are presented. Notable tidal stream projects around the world are also mentioned in the paper. Also, it provides a perspective on the potential of this renewable energy to produce electricity for various sites in the Philippines. Finally, the paper emphasizes the need for new tidal turbine blade designs to be viable in tropical regions, such as the Philippines.

• 전기학회논문지
• /
• 제67권2호
• /
• pp.224-232
• /
• 2018

According to government policy, renewable energy facility such as solar power generation is being implemented for newly constructed buildings. In recent years, the introduction of Energy Storage System (ESS) served as an emergency power for replacing an existing diesel generator has been increasing. Furthermore, in order to expand the efficacy of the ESS operation, operation in combination with renewable energy sources such as solar and wind power generation is increasing. Hence, development of the ESS operation algorithms for emergency mode as well as the peak power cut mode, which is the essential feature of ESS, are necessary. The operational scenarios of ESS need to consider load power requirement and the amount of the power generation by renewable energy sources. For the verification of the developed scenarios, tests under the actual situation are demanded, but there is a difficulty in simulating the emergency operation situation such as system failure in the actual site. Therefore, this paper proposes simulation models for the HILS(Hardware In the Loop Simulation) and operation modes developed through HILS for the ESS operated with renewable energy source under peak power reduction and emergency modes. The paper shows that the ESS operation scenarios developed through HILS work properly at the actual site, and it verifies the effectiveness of the control logic developed by the HILS.

• 한국태양에너지학회 논문집
• /
• 제39권6호
• /
• pp.1-13
• /
• 2019

With the adoption of the Paris Agreement, a new climate regime is intensifying the global interest in reducing greenhouse gas emissions. In the meantime, Korea is preparing to introduce a new renewable energy carbon certification system in order to activate the use of renewable energy and to reduce carbon emissions in the entire life cycle of manufacturing and disposal of renewable energy facilities. Therefore, this study aims to identify the implications for the introduction of the carbon certification system and to establish a theoretical basis for the system design by examining the status of overseas carbon certification, international trade norms and trade disputes. As a result, carbon emissions certification is being implemented in developed countries such as EU, UK, France, USA and Japan, but only France, Germany and EU have adopted carbon certification for renewable energy sector. The analysis of the WTO TBT Agreement and GATT also confirmed the possibility of a violation of the international trade rules of the carbon certification system and derived nine international technical standards related to carbon certification. Finally, by examining the case of trade disputes related to environmental labeling, the minimum requirements to be considered at the institutional design stage were drawn to eliminate the possibility of trade disputes.

• 한국인터넷방송통신학회논문지
• /
• 제21권2호
• /
• pp.137-142
• /
• 2021

태양광발전 가로등은 태양광에너지를 사용하여 2차전지에 충전 후 램프를 통해 야간조명에 활용하는 시스템으로서 부하 단 LED 가로등을 설치하여 독립형 또는 계통연계형으로 구성할 수 있다. 태양전지모듈을 통해 발전된 에너지는 충방전 제어장치를 통해 2차전지에 충전 후 일사량 감시에 따른 발전전압과 충전전압의 비교, 또는 일몰, 일출 후 특정시간 설정으로 LED 가로등을 점등 소등을 할 수 있다. 따라서 이러한 내용을 기반으로 본 논문에서는 신재생에너지 활용 및 저장기능을 이용한 교육용 모의 태양광발전 가로등 설계 및 제작을 통해 대학의 학생들에게 1) 태양광을 포함한 신재생에너지를 이용하여 전기에너지로 활용하는 에너지 변화의 흐름 이해, 2) 신재생에너지 이해 및 관련 제품의 기초설계와 제작 응용력 함양, 3) 전력변환을 통한 신재생에너지 활용과 하드웨어 제작을 통한 실습과 분석력 강화를 심어줄 수 있다.

• 디지털산업정보학회논문지
• /
• 제12권2호
• /
• pp.1-6
• /
• 2016

Several efforts to replace the use of existing fossil energy resources have already been made around the world. As a result, a new industry of renewable energy has been created, and efficient energy distribution and storage has been promoted intensively. Among the newly explored renewable energy sources, the most widely used one is solar energy generation, which has a high market potential. An energy storage system (ESS) is a system as required. In this paper, the design and implementation of an ESS for the efficient use of power in stand-alone street lights is presented. In current ESS applied to stand-alone street lights, either 12V~24V DC (from solar power) or 110V~220V AC (from commercial power) is used to recharge power in systems with lithium batteries. In this study, an ESS that can support both solar power and commercial power was designed and implemented; it can also perform emergency recharge of portable devices from solar powered street lights. This system can maximize the scalability of ESSes using lithium batteries with efficient energy conversion, with the advantage of being an eco-friendly technology. In a ripple effect, it can also be applied to smart grids, electric vehicles, and new, renewable storage markets where energy storage technology is required.