• Journal of the Korean Society of Hazard Mitigation
• /
• v.10 no.2
• /
• pp.135-141
• /
• 2010

Recently, to ensure the stability of flood control, instead of removal of concrete revetment, the vegetation mat method has been widely used on the recovery soil. However, the recovery soil method often failed to be stable against the flood, which caused the economic loss. In this study, the rate of soil loss and the velocity distribution on high water revetment are evaluated by the hydraulic experiments. The maximum difference of the soil loss rate was 52% depending on the vegetation. The reduction of the soli loss rate according to the vegetation is large when the revetment slope is steep. The maximum soil loss rate is 19.5% when there is no vegetation.

• Membrane and Water Treatment
• /
• v.11 no.2
• /
• pp.111-121
• /
• 2020

The fouling of Nanofiltration membrane (NF) was examined using wastewater containing reactive black dye RB5 of 1500 Pt/Co color concentrations with 16890 mg/l TDS collected from El-alamia Company for Dying and Weaving in Egypt. The NF-unit was operated at constant pressure of 10 bars, temperature of 25℃, and flowrate of 420 L/min. SEM, EDX, and FTIR were used for fouling characterization. Using the ROIFA-4 program, the total inorganic fouling load was 1.07 mM/kg present as 49.3% Carbonates, 10.1% Sulfates, 37.2% Silicates, 37.2% Phosphates, and 0.93% Iron oxides. The permeate flux, recovery, salt rejection and mass transfer coefficients of the dye molecules were reduced significantly after fouling. The results clearly demonstrate that the fouling had detrimental effect on membrane performance in dye removal, as indicated by a sharp decrease in permeate flux and dye recovery 68%. The dye mass transfer coefficient was dropped dramatically by 34%, and the salt permeability increased by 14%. In this study, all the properties of the membrane used and the fouling that caused its poor condition are identified. Another study was conducted to regeneration fouled membrane again by chemical methods in another article (Abdel-Fatah et al. 2017).

• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.3
• /
• pp.315-322
• /
• 2007

The purpose of this study was to investigate the biodegradability and performance of organic removal and methane production rate when treating piggery wastewater using a granule of two-phase anaerobic process applied UASB. BMP test was conducted as simple means to monitor relative biodegradability of substrate and to determine methane production of an organic material. The two-phase anaerobic process is consisted of a continuous flow stirred-tank reactor (CFSTR) for the acidification phase and an Upflow Anaerobic Sludge Blanket reactor (UASB) for the methanogenesis. The acidogenic reactor played key roles in reducing the periodically applied shock-loading and in the acidification of the influent organics. A stable maximum biogas production rate was 400mL. The methane contents ranged from 73 to 80% during the experimental period. It is known that most of the removed organic matter was converted to methane gas, and the produced biogas might be high quality for its subsequent use.

• Journal of Korean Society for Atmospheric Environment
• /
• v.19 no.1
• /
• pp.25-31
• /
• 2003

Ceramic filter has been demonstrated as an attractive system to improve the thermal efficiency and to reduce the effluent pollutants. Removal of particulates from the hot gas stream is very important in air pollution control. In particular, the elimination of the particulate matters discharged from a gas turbine at high temperature can prevent the corrosion inside the IGCC. In this study, a Lab. scale test and numerical simulation were carried out to comprehend the relationship between pulse jet pressure and recovery of pressure drop and to characterize the reverse cleaning flow through a ceramic fil-ter element under high temperature and high pressure. When the pulse-jet pressures were 2, 3 and 4 kg/$ extrm{cm}^2$, the cleaning effect increase of about 10~30% by recovery of pressure drop caused by pulse pressure. Cleaning effect at 45$0^{\circ}C$ was greater than that at 55$0^{\circ}C$ or 650$^{\circ}$ for the same pulse pressure. According to the result of the present simulation, high pressure has been formed in terminal and central regions in our models and temperature distribution caused by pulse air is to be uniform comparatively on inner surface of filter.

• Journal of Microbiology and Biotechnology
• /
• v.24 no.9
• /
• pp.1245-1253
• /
• 2014

One-step sulfuric acid saccharification of the red alga Pterocladiella capillacea was optimized, and various detoxification methods (neutralization, overliming, and electrodialysis) of the acid hydrolysate were evaluated for fermentation with the thermotolerant yeast Kluyveromyces marxianus. A proximate composition analysis indicated that P. capillacea was rich in carbohydrates. A significant galactose recovery of $81.1{\pm}5%$ was also achieved under the conditions of a 12% (w/v) biomass load, 5% (v/v) sulfuric acid, $121^{\circ}C$, and hydrolysis for 30 min. Among the various detoxification methods, electrodialysis was identified as the most suitable for fermentable sugar recovery and organic acid removal (100% reduction of formic and levulinic acids), even though it failed to reduce the amount of the inhibitor 5-HMF. As a result, K. marxianus fermentation with the electrodialyzed acid hydrolysate of P. capillacea resulted in the best ethanol levels and fermentation efficiency.

• Archives of Plastic Surgery
• /
• v.47 no.3
• /
• pp.256-262
• /
• 2020

Background Most women consider an oval-shaped face to be youthful and beautiful. In recent years, demand has grown for surgical procedures with a shorter downtime and fewer complications. These minimally invasive procedures include botulinum toxin type A (BoNTA) injection, filler injection, suction-assisted liposuction (SAL), laser-assisted lipolysis (LAL), thread lifting, and fat grafting. This study aims to introduce an effective method for creating an aesthetically pleasing lower face using a combination of minimally invasive procedures. Methods From March 2017 to March 2019, 94 patients simultaneously underwent LAL, SAL, and thread lifting. Ancillary procedures such as BoNTA injections, hyaluronic acid filler injections, and removal of the buccal fat pad (BFP) were selectively performed according to the patient's condition. Results Patients rated their postoperative satisfaction as very satisfied, satisfied, dissatisfied, or very dissatisfied. Approximately 83% of all respondents were satisfied with the results, whereas the remaining respondents had complaints regarding the outcomes. The most common reasons for dissatisfaction were a longer-than-expected recovery time and undercorrection, and the most severe complaint was skin depression as a result of overcorrection. Conclusions Our method of simultaneously performing LAL, SAL, and thread lifting, while adding BoNTA, filler injections, and BFP removal as needed, was capable of producing consistent and reliable aesthetic outcomes for the lower face.

• Journal of Industrial Technology
• /
• v.7
• /
• pp.27-47
• /
• 1987

Fine anthracite is very difficult to upgrade by conventional processes such as gravity concentration or froth flotation, because large quantities of fine coals are generated at the mining and preparation stages and a significant portion of these fine coals are mixed with gangue minerals. This study, therefore, was carried out for the purpose of improving recovery of low ash clean coal, effective beneficiation of low-grade coking coal and removal of sulphur from high-sulphur coals by employing the method of selective agglomeration using oil or polystrene flocculants, for coals which are generally hydrophobic in nature will be extracted by using flocculants. Studies were performed by varying solid concentration, concetration of bridging liquid, mixing speed and mixing time, balling speed and balling time, dispersant dosage, flocculant dosage, pulp pH, and particle size. The results were : when the methods of the oil agglomeration and selective flocculation were employ(in the two process the sample was ground to the size of -74 micron), 1) ash content of the agglomerated coal was 9.85, 7.83%, 2) combustibel recovery of it was 98.5%, 93.5%, respectively. It was observed in selective flocculation that polystyrene is an effective flocculant for coal, De-entrapment of shale from the concentrate flocculated by mechanical agitation was necessary for substantional reductions in final ash content.

• Korean Journal of Animal Reproduction
• /
• v.4 no.1
• /
• pp.75-82
• /
• 1980

This experiment was carried out to improve a simple and effective procedure of egg transfer which is considered to be the most useful technique for the improvementand proliferation of domestic animals. Several experiment procedures such as superovulation, surgical recovery of ovulated egg, in vitro capacitation of ejaculated spermatozoa, in vitro fertilization and culture of embryo were conducted. The results obtained in this experiment were summarized as follows: 1. In rabbits treated with PMS in combination with estradiol and HCG, 10 to 43 eggs were obtained in one rabbit and the average ovulation number of 20 rabbits was 21 eggs. 2. Six to 24 eggs (average 13 eggs) were recovered from the removed oviducts by the methods of flushing technique and the average recovery rate of 20 rabbits was 61.9 percent. 3. Most rabbit spermatozoa ejaculated by artificial vagina were capacitated in vitro by the culture of the spermatozoa with PBI medium at 37$^{\circ}C$ for 4 hours after removal of seminal plasma. 4. Normal fetilization following in vitro fetilization was observed in 88 (42.7%) of 206 eggs. 5. The number of eggs developed to 2-, 4-, and 8-cell stage following in vitro culture with PBI medium at 37$^{\circ}C$ was 26 (70.3%), 20 (54.1%) and 17 (45.9%) of 37 eggs used for in vitro culture.

• Journal of Chest Surgery
• /
• v.28 no.5
• /
• pp.491-494
• /
• 1995

A fibroma arising in the right ventricle outflow tract of a 14 month-old infant was successfully removed. The patient was first seen because of shortness of breath and tachycardia. Pertinent clinical and laboratory findings included a grade II/VI systolic murmur, blood pressure of 120/60 mmHg, slight cardiomegaly on chest X-ray, a mass obstructing the outflow tract of the right ventricle on echocardiography and magnetic resonance imaging. On october 30,1992, under cardiopulmonary bypass, a 4cm x 3cm x 3cm tumor was resected from the right ventricular outflow tract, together with a portion of the ventricular wall. Histologically, it was diagnosis as a fibroma. The patient was sent home on the 6th postoperative day following an uneventful recovery form the operation. Although cardiac fibroma is the second most common cardiac tumor in infancy and childhood, it is usually found in the left ventricle and one arising in the right ventricle is considered rare. Although it is a benign tumor, it could produce a severe cardiac dysfunction and even sudden death, depending on its size and location. With the advance in diagnostic techniques and operative management, there is a renewed interest in the early detection and operative removal of these tumors. The case herein presented is the first such case successfully managed and reported in the Korean literature.

• Archives of Plastic Surgery
• /
• v.35 no.1
• /
• pp.92-95
• /
• 2008

Purpose: Heterotopic ossification in pressure sore patients is reported to rarely develop, but once it occurs, it frequently causes joint stiffness and mobilization restriction. The aim of this article is to report our experience of atypical bone growing at femur neck fracture site with chronic, extensive pressure sore in patient with paraplegia secondary to spinal injury. Methods: A 28-year-old male patient presented with atypical bone growth at femur neck fracture site with pressure sore. He had undergone atypical growth bone removal and separation of united iliac bone and femur, and then pressure sore was covered by advanced rotation flap. Results: The patient mobilized hip joint and rode in a wheelchair. Complications such as dehiscence, infection, hematoma and flap necrosis did not occur. Conclusion: We experienced successful correction of atypical bone growth removal and recovery of pressure sore. We report our experience of atypical bone growth of fracture site and the related literature was reviewed.