• Proceedings of the Korea Concrete Institute Conference
• /
• 2004.05a
• /
• pp.76-79
• /
• 2004

The use of recycled aggregate concrete is increasing faster than the development of appropriate design recommendations. This paper is making advances in the recycling of waste concrete material for use as recycled aggregate to make secondary concrete product. Using recycled aggregates from demolished concrete, we manufactured concrete blocks to experiment overall performance in feasible performances. This paper reports limited experimental data on the structural performance of shear wall used concrete blocks made in recycled aggregates. Reinforced concrete frame and shear walls were tested to determine their diagonal cracking and ultimate shear behavior. The variable in the test program was the existence of infilled wall used concrete blocks Made in recycled aggregates. Based on the experimental results, Infilled wall has a high influence on the maximum strength and initial stiffness of reinforced concrete frame. Structural performance of specimen WSB1 and WSB2 is quite different from RCF specimen, particularly strength, stiffness and energy dissipation capacity.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.50 no.3
• /
• pp.105-112
• /
• 2008

Solar energy, which is one of renewable energy, would be the most useful resources that can be applied to making energy recycling villages without using fossil energy. This study analyzed energy potential on solar energy considering weather condition in three traditional villages and compared with energy consumption surveyed. A photovoltaic system having 3.0kWp capacity of unit module can generate 182.5%, 96.1% and 170.9% of the yearly mean consumption of electric power in Makhyun, Boojang, and Soso, respectively. A flat-plate solar collector having $2.64m^2$ area of unit module can generate warm water of $142{\ell}$/day, $89{\ell}$/day, and $173{\ell}$/day, respectively in three study villages. In Makhyun and Soso, photovoltaic power and warm water produced by solar energy were sufficient to supply required amount of electric power and warm water. However, both electric power and warm water produced by unit solar module were not sufficient in Boojang area, and so it is required to increase the module area by more than 50%. According to the results of this study, the appropriate combination of energy resources can be applied to rural green-village planning if the characteristic of energy potential for each local area is considered.

• Journal of Powder Materials
• /
• v.21 no.2
• /
• pp.131-136
• /
• 2014

Cathode materials and their precursors are prepared with transition metal solutions recycled from the the waste lithium-ion batteries containing NCM (nickel-cobalt-manganese) cathodes by a $H_2$ and C-reduction process. The recycled transition metal sulfate solutions are used in a co-precipitation process in a CSTR reactor to obtain the transition metal hydroxide. The NCM cathode materials (Ni:Mn:Co=5:3:2) are prepared from the transition metal hydroxide by calcining with lithium carbonate. X-ray diffraction and scanning electron microscopy analyses show that the cathode material has a layered structure and particle size of about 10 ${\mu}m$. The cathode materials also exhibited a capacity of about 160 mAh/g with a retention rate of 93~96% after 100 cycles.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.3
• /
• pp.851-855
• /
• 2013

This paper describes an environmentally friendly process for the recovery of $LiFePO_4$ cathode materials from scrap electrodes by a simple thermal treatment method. The active materials were easily separated from the aluminum substrate foil and polymeric binders were also decomposed at different temperatures ($400^{\circ}C$, $500^{\circ}C$, $600^{\circ}C$) for 30 min under nitrogen gas flow. The samples were characterized by X-ray diffraction (XRD), scanning electronic microscopy (SEM), Raman spectroscopy, Thermogravimetric analysis (TGA), and differential scanning calorimetry (DSC). The electrochemical properties of the recycled $LiFePO_4$ cathode were evaluated by galvanostatic charge and discharge modes. The specific charge/discharge capacities of the recycled $LiFePO_4$ cathode were similar to those of the original $LiFePO_4$ cathode. The $LiFePO_4$ cathode material recovered at $500^{\circ}C$ exhibits a somewhat higher capacity than those of other recovered materials at high current rates. The recycled $LiFePO_4$ cathode also showed a good cycling performance.

• Journal of The Korean Digital Architecture Interior Association
• /
• v.13 no.4
• /
• pp.25-32
• /
• 2013

The green building is one of biggest factors to go the goal of energy saving and environmental conservation, reduction of energy consumption, friendly energy technology, recycling of resource, and environmental pollution reduction technology. The purpose of these green buildings realized by the energy-saving technology such as the exterior materials or curtain wall system. The curtain wall system is a element that come to insulated portions of building envelope that results in heat loss. The purpose of this paper is to carried out mock-up tests for exterior wall used in autoclaved lightweight concrete panels in green building practices. Mock-up test execute a mixed process between standard test procedure and complex test procedure based on AAMA 501(American Society for Testing and Materials) and ASTM 283, ASTM 330(American Society for Testing and Materials). In results, tests meet the requirements that grant values in steps of procedures provided on ASTM and AAMA. ALC panel is suitable for a exterior wall product to be gratified thermal cycling performance and structural capacity, deflection(H/200) and lateral displacement(H/50), for curtain walls.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.4
• /
• pp.141-148
• /
• 2006

Skull melting method can be a good candidate for growing oxide single crystals with high quality and for mass production because of its low production costs and high yield through recycling of crust. In this study, rutile single crystals were frown by the skull melting method and ingot characteristics with the variation of different growth conditions has been investigated. Conditions for high quality rutile ingot growth were used for producing cold-crucible size of ${\Phi}12cm{\times}H14cm$, capacity of 3000 pF tank condenser, work frequency of 2.84 MHz, melt-dwelling time of 9hrs and growing speed of 2 mm/h.

• Membrane and Water Treatment
• /
• v.5 no.4
• /
• pp.235-250
• /
• 2014

The impacts of membrane degradation due to chlorine attack on the rejection of inorganic salts and trace organic contaminants by nanofiltration (NF) and reverse osmosis (RO) membranes were investigated in this study. The rejection of trace contaminants was examined at environmentally relevant concentrations. Changes in the membrane surface morphology were observed as a result of chlorine exposure. A small increase in rejection was consistently observed with all four membranes selected in this study after being exposed to a low concentration of hypochlorite (100 ppm). In contrast, a higher concentration of hypochlorite (i.e., 2000 ppm) could be detrimental to the membrane separation capacity. Membranes with severe chlorine impact showed a considerable decrease in rejection over filtration time, possibly due to rearrangement of the polyamide chains under the influence of chlorine degradation and filtration pressure. The reported results indicate that loose NF membranes are more sensitive to chlorine exposure than RO membranes. The impact of hypochlorite exposure (both positive and negative) on rejection is dependent on the strength of the hypochlorite solution and is more significant for the neutral carbamazepine compound than the negatively charged sulfamethoxazole.

• Journal of Environmental Health Sciences
• /
• v.24 no.2
• /
• pp.20-31
• /
• 1998

There is a need for waste recycling. This study was carried out to investigate removal efficiency of TCE in water treatment with adsorbent made from coffee grounds which obtained after extraction of coffee through hot water. The removal of TCE in synthetic Waste water using adsorbents was examined varying dose, concentration and temperature on a laboratory scale. The results were as followed 1. As much as 95% TCE remogal was possible with adsorbent made from coffee grounds at an adsorbent dose over 2.5 g/l under the test conditions. 2. The removal rate of TCE was propotional to weight of adsorbent made from coffee grounds (0.025, 0.1, 0.3, 0.5 g). 3. In the effect of temperature, as temperature of wastewater was high, the rate of removal was increased. 4. Iodine number (865 mg/g) of adsorbent made from coffee grounds was not higher than that (1123 mg/g) of adsorbent made from coconut. But, in considering adsorption capacity, Iodine number was inapplicable to adsorbent made from coffee grounds. 5. Generally, Freundlich's equation applies to adsorption in wastewater. In case of TCE, slope (1/n) was 0.83, 1.06 and intercept (k) was 456.18, 405.19 at 150, 300 ppb respectively (average r=0.904, 0.933).

• Asian-Australasian Journal of Animal Sciences
• /
• v.23 no.2
• /
• pp.279-286
• /
• 2010

Livestock production in Vietnam is, as in most Asian countries, increasing rapidly and changing into specialized highly intensified operations. The volume of animal excreta generated exceeds the capacity of the operation land base and cannot be utilized efficiently. As a consequence, there is a loss of plant nutrients from livestock farms that causes environmental pollution. This study carried out a feed and excretion experiment measuring fecal characteristic, daily fecal production, daily nitrogen and phosphorous excretion from grower-finisher pigs fed prevalent rations in Vietnam. Furthermore, equations for assessing the excretion were tested, which can be used in farm models for optimal recycling of manure while focusing on reducing pollution. The results indicated that fecal production and nutrient excretion were affected by the different rations tested. This study showed that five selected equations for predicting excretion from grower-finisher pigs in Danish conditions can also be used with precision in Vietnamese pig farming systems. The equations have been proven valid and can, therefore, be used as a much needed tool for assessing fecal production and nitrogen in excreta on pig farms. The study also showed that about 12% of nitrogen excreted was emitted during housing. Waste water contains more than half of the nitrogen excreted, mainly in ammonium form which has a high potential for gaseous emission.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.41 no.2
• /
• pp.109-115
• /
• 2015

Odontoma is the most common odontogenic benign tumor, and the treatment of choice is generally surgical removal. After excision, bone grafts may be necessary depending on the need for further treatment, or the size and location of the odontoma. Although the osteogenic capacity of a demineralized tooth was verified as early as 1967 by Urist and many other investigators, the cumbersome procedure, including a long demineralization time, may be less than comfortable for clinicians. A modified ultrasonic technology, with periodic negative pressure and temperature control, facilitated rapid and aseptic preparation of demineralized teeth for bone grafts. This approach reduces the demineralization time dramatically (${\leq}80$ minutes), so that the graft material can be prepared chairside on the same day as the extraction. The purpose of this article is to describe two cases of large compound odonotomas used as graft material prepared chairside for enucleation-induced bony defects. These two clinical cases showed favorable wound healing without complications, and good bony support for future dental implants or orthodontic treatment. Finally, this report will suggest the possibility of recycling the benign pathologic hard tissue as an alternative treatment option for conventional bone grafts in clinics.