• 제목/요약/키워드: RF switches

검색결과 65건 처리시간 0.019초

가속도계를 이용한 마비환자의 보행이벤트 검출 (Gait-Event Detection using an Accelerometer for the Paralyzed Patients)

  • 공세진;김철승;문기욱;엄광문;탁계래;김경섭;이정환;이영희
    • 전기학회논문지
    • /
    • 제56권5호
    • /
    • pp.990-992
    • /
    • 2007
  • The purpose of this study is to develop a practical gait-event detection system which is necessary for the FES (functional electrical stimulation) control of locomotion in paralyzed patients. The system is comprised of a sensor board and an event recognition algorithm. We focused on the practicality improvement of the system through 1) using accelerometer to get the angle of shank and dispensing with the foot-switches having limitation in indoor or barefoot usage and 2) using a rule-base instead of threshold to determine the heel-off/heel-strike events corresponding the stimulation on/off timing. The sensor signals are transmitted through RF communication and gait-events was detected using the peaks in shank angle. The system could detect two critical gait-events in all five paralyzed patients. The standard deviation of the gait events time from the peaks were smaller when 1.5Hz cutoff frequency was used in the derivation of the shank angle from the acceleration signals.

SPDT 단일고주파집적회로 스위치용 pHEMT 채널구조 설계 (Design of pHEMT channel structure for single-pole-double-throw MMIC switches)

  • 문재경;임종원;장우진;지흥구;안호균;김해천;박종욱
    • 한국진공학회지
    • /
    • 제14권4호
    • /
    • pp.207-214
    • /
    • 2005
  • 본 연구에서는 스위치, 위상변위기, 감쇄기등 전파제어회로를 설계 및 제작할 수 있는 pHEMT스위치 소자에 적합한 에피구조를 설계하였다. 고성능의 스위치 소자를 위한 pHEMT 채널층 구조는 이중 면도핑층을 가지며 사용 중 게이트 전극의 전계강도가 약한 깊은 쪽 채널층의 Si 면농도가 상층부보다 약 1/4정도 낮을 경우 격리도등 우수한 특성을 보였다. 설계된 에피구조와 ETRI의 $0.5\mu$m pHEMT MMIC 공정을 이용하여 2.4GHz 및 5GHz 대역 표준 무선랜 단말기에 활용 가능한 SPDT Tx/Rx MMIC 스위치를 설계 및 제작하였다. 제작된 SPDT형 스위치는 주파수 6.0 GHz, 동작전압 0/-3V에서 삽입손실 0.849 dB, 격리도 32.638 dB, 그리고 반사손실 11.006 dB의 특성을 보였으며, 전력전송능력인 $P\_{1dB}$는 약 25dBm, 그리고 선형성의 척도인 IIP3는 42 dBm 이상으로 평가되었다. 이와 같은 칩의 성능은 본 연구에서 개발된 SPDT 단일고주파집적회로 스위치가 2.4GHz뿐만 아니라 SGHB 대역 무선랜 단말기에 활용이 충분히 가능함을 말해준다.

인체 부착용 방사패턴 재구성 안테나의 SNR 및 BER 성능 분석 (Performance analysis of SNR and BER for radiation pattern reconfigurable antenna)

  • 이창민;정창원
    • 한국산학기술학회논문지
    • /
    • 제16권6호
    • /
    • pp.4125-4130
    • /
    • 2015
  • 본 논문은 생체신호 (체온, 혈압, 맥박 등)를 측정하는 웨어러블 (Wearable) 디바이스에 장착된 인체 부착용 방사패턴 재구성 안테나의 통신성능 비교에 관한 논문이다. 제안된 안테나의 동작주파수는 블루투스 (Bluetooth) 통신 대역의 2.4 - 2.5 GHz 이며, 안테나의 최대이득은 1.96 dBi 이다. 제안된 안테나는 두 개의 RF 스위치 (PIN diode)를 이용하여 서로 반대방향의 빔을 생성하여 전자기파 신호를 효율적으로 송수신 한다. 또한 제안된 안테나는 탑 로딩(Top Loading)을 이용 세 가지의 각도 변경 ($30^{\circ}$, $90^{\circ}$, $150^{\circ}$)을 통해 각 방사패턴의 지향성 변화를 조사 하였다. 본 논문에서는 방사패턴 재구성 안테나를 통해 전파 간섭이 없는 전자파 차페실의 이상적인 전파환경과 실제 전파간섭이 존재 (Universal Software Radio Peripheral, USRP)하는 스마트 하우스 내에서 웨어러블 디바이스 안테나의 신호대 집음비 (Signal-to-Noise Ratio, SNR) 및 비트 에러율 (Bit Error Rate, BER) 성능 측정을 진행하였다. 두 경우의 측정 비교 시 SNR은 평균적으로 5 dB의 성능저하를 보이며, BER은 최대 10배 증가하여 수신 에러율 (Error rate of receiving signal)이 높아지는 것을 확인하였으며, 본 논문에서 측정한 SNR과 BER의 측정 결과로 전자파기기의 방해전파로 인한 성능저하를 수치상으로 예측 하였다.

마이크로웨이브 스위치 메트릭스 용 SPST 스위치 MMIC (SPST Switch MMIC for Microwave Switch Matrix)

  • 장동필;염인복;오승엽
    • 한국통신학회논문지
    • /
    • 제31권2A호
    • /
    • pp.201-206
    • /
    • 2006
  • 다중 빔 위성중계기 부품중의 하나인 MSM(Microwave Switch Matrix)에 필요한 SPST 스위치 MMIC를 설계 및 제작하였다. 설계된 스위치 MMIC는 3GHz 대역에서 동작하며, 새로운 구조를 채택하여 기존의 FET 스위치보다 전력 특성과 격리도를 개선하였으며, 스위치의 On/Off 상태에서의 입출력 반사손실 특성이 우수하다. MMIC는 0.15um GaAs pHEMT 공정으로 제작되었으며, 3$\∼$4GHz 대역에서 2.0dB 이하의 삽입손실과, 63dB 이상의 격리도 성능을 가지는 것으로 측정되었다. 또한 사용된 단위 pHEMT 소자가 0.2mm Gate Width 임에도 불구하고 320dBm 이상의 OIP3 특성을 가지고 있는 것으로 측정되었으며, 이 결과는 기존의 발표된 FET 스위치에 비해 높은 전력 특성이다.

A Study of 0.5-bit Resolution for True-Time Delay of Phased-Array Antenna System

  • Cha, Junwoo;Park, Youngcheol
    • International journal of advanced smart convergence
    • /
    • 제11권4호
    • /
    • pp.96-103
    • /
    • 2022
  • This paper presents the analysis of increasing the resolution of True-Time-Delay (TTD) by 0.5-bit for phased-array antenna system which is one of the Multiple-Input and Multiple Output (MIMO) technologies. For the analysis, a 5.5-bit True-Time Delay (TTD) integrated circuit is designed and analyzed in terms of beam steering performance. In order to increase the number of effective bits, the designed 5.5-bit TTD uses Single Pole Triple Throw (SP3T) and Double Pole Triple Throw (DP3T) switches, and this method can minimize the circuit area by inserting the minimum time delay of 0.5-bit. Furthermore, the circuit mostly maintains the performance of the circuit with the fully added bits. The idea of adding 0.5-bit is verified by analyzing the relation between the number of bits and array elements. The 5.5-bit TTD is designed using 0.18 ㎛ RF CMOS process and the estimated size of the designed circuit excluding the pad is 0.57×1.53 mm2. In contrast to the conventional phase shifter which has distortion of scanning angle known as beam squint phenomenon, the proposed TTD circuit has constant time delays for all states across a wide frequency range of 4 - 20 GHz with minimized power consumption. The minimum time delay is designed to have 1.1 ps and 2.2 ps for the 0.5-bit option and the normal 1-bit option, respectively. A simulation for beam patterns where the 10 phased-array antenna is assumed at 10 GHz confirms that the 0.5-bit concept suppresses the pointing error and the relative power error by up to 1.5 degrees and 80 mW, respectively, compared to the conventional 5-bit TTD circuit.