• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.41 no.3
• /
• pp.246-252
• /
• 2013

This paper presents method to suppress signal interference by using the filter in the RF output stage of the radiation equipment as a way to avoid interference between the RF(Radio Frequency) equipment mounted on aircraft. Especially filter design to suppress harmonics of the radiation equipment and testing method to verify the filter's performance is presented. Filter was installed at RF output stage of U/VHF radio in order to prevent interference between U/VHF(Ultra/Very High Frequency) radio and data link system. Filter design and testing method in this paper will be able to give help in the design of aircraft equipments as a tool that can be used to establish measures for problem of interference in the aircraft.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.1
• /
• pp.99-104
• /
• 2013

In this paper, we developed a fully integrated downconverter MMIC (monolithic microwave integrated circuit) including Lange coupler and output active balun for millimeter wave applications. Concretely, ${\lambda}$/4 transmission line was added to Lange coupler for size reduction of RF/LO input, and mixed RF/LO signals were applied to gate of the FET of mixer. Active balun was used at output port for a coupling of out-of-phase IF output signals. According to measured results, the proposed downconverter MMIC showed good RF performances. For example, the downconverter MMIC showed an LO leakage power of -25 dBc at IF output port, and a RF-LO isolation of 18 dB. Therefore, off-chip components such as LO rejection filters were not required for a normal operation of the proposed downconverter MMIC. The proposed downconverter MMIC showed a conversion gain of 10.3 dB at RF frequency of 63 GHz. The size of the downconverter MMIC including all active and passive components was $2.2{\times}1.4mm^2$.

• Journal of the Korean Vacuum Society
• /
• v.20 no.5
• /
• pp.345-355
• /
• 2011

GaAs-based metamorphic high electron mobility transistors (MHEMTs) and InP-based high electron mobility transistors (HEMTs) have good microwave and millimeter-wave frequency performance with lower minimum noise figure. MHEMTs have some advantages, especially for cost, compared with InP-based ones. In this paper, InAlAs/InxGa1-xAs/GaAs MHEMTs are simulated for DC/RF small-signal analysis. The hydrodynamic simulation parameters are calibrated to a fabricated 0.1-${\mu}m$ ${\Gamma}$-gate MHEMT device having the modulation-doped $In_{0.52}Al_{0.48}As/In_{0.53}Ga_{0.47}As$ heterostructure on the GaAs substrate, and the simulations for RF small-signal characteristics are performed, compared with the measured data, and analyzed for the devices. In addition, the simulations for the DC/RF characteristics of the MHEMTs with different gate-recess structures are performed, compared and analyzed.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.37 no.8
• /
• pp.9-16
• /
• 2000

MOS transistors are fabricated and evaluated for RF IC applications such as mobile communication systems using 0.35m CMOS process. Characteristics of MOSFETs are analyzed at various channel length, width and bias conditions. From the analysis, cut-off frequency ($f_T$) is independent on channel width but maximum oscillation frequency ($f_{max}$) tends to derease as the channel width increases. As channel length increases, $f_T$ and fmax decrease. $f_T$ is 22GHz and fmax is 28GHz at its maximum value. High frequency noise performance is improved with larger channel width and smaller channel length at same bias conditions. NFmin at 2GHz is 0.45dB as a minimum value. From the evaluation, MOSFETs designed using 0.35m CMOS process demonstrated a full potential for the commercial RF ICs for mobile communication systems near 2GHz. And optimization methods of the CMOS transistors for RF applications are presented in this paper.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2022.10a
• /
• pp.583-584
• /
• 2022

Due to the development of drones, drone missions are performed in various fields, and BVLOS (Beyond Visual Line Of Sight) flight is performed in a wide area. Most drones operate through radio frequency (RF) communication and can only fly in a limited radius of about 1-2 km. To overcome this, in this paper, we propose a multi-communication protocol-based drone control system to control drones performing missions in BVLOS using RF and LTE (Long Term Evolution). The proposed system consists of a control unit and a drone unit. The control unit transmits one control signal generated from the remote controller through RF and LTE. The drone unit classifies the control signal transmitted through RF and LTE according to the priority of the communication protocol and delivers it to the FC (Flight Controller). Through the proposed control system, it is possible to overcome the RF communication distance limit and prevent the communication disconnection situation.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.1
• /
• pp.122-127
• /
• 2016

In this paper, new spectrum sensing schemes based on analog/RF front-end processing are introduced for IoT wireless sensor networks. While the conventional approaches for wireless channel cognition have been issued in signal processing area, the RF spectrum cognition concept makes it feasible to achieve cognitive wireless sensor networks (C-WSNs). The spectrum cognition at RF processing is categorized as four kinds of sensing mechanisms. Two recent reseaches are described as promising candidates for the C-WSN. One senses spectrum by the frequency discriminating receiver, the other senses and detects from the frequency selective super-regenerative receiver. The introduced systems with simple and low-power RF architectures play dual roles of channel sensing and demodulation. simultaneously. Therefore, introduced spectrum sensing receivers can be one of the best candidates for IoT wireless sensor devices in C-WSN environments.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.64 no.2
• /
• pp.280-283
• /
• 2015

This paper demonstrates a new radio frequency (RF) resonator at 3 T magnetic resonance imaging (MRI) system. An approach based on a split ring resonator (SRR) having effective metamaterial properties is investigated. Electromagnetic simulation results are compared for RF resonators and discussed in detail at 3 T. A new RF resonator has approximately 10% higher magnetic fields at the center of the human phantom than the previous RF resonator.

• Proceedings of the IEEK Conference
• /
• 2000.06e
• /
• pp.187-190
• /
• 2000

We presents the construction of radio frequency pad area array package modules which operate at radio frequency of 224MHz, and proposes the structure of RF module packages to improve its electrical characteristics. The module of RF PAA package was constructed in the configuration of three dimensional stacked package and reduced size. RF PAA packages showed the optimized and improved gain of 2dB by partitioning the RF transceiver with 3 dimensional stacked PAA packages.

• Journal of Satellite, Information and Communications
• /
• v.11 no.2
• /
• pp.18-22
• /
• 2016

In this paper, we proposed a scheme for signal detection based on average of detected energy of frequencies for backscatter communications. We applied this scheme on the bistatic backscatter radio architecture for RF energy harvesting. Tags reflected entire RF signals on a same bandwidth when transmitted energy signals. Receivers can optimal switching antenna by this scheme. Simulation results show that the proposed scheme can precisely detect signals from tag with properly calculated parameters.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.6
• /
• pp.927-934
• /
• 1999

A measuring system was integrated for the testing of live EED with continuous wave RF stimulus at low frequency range(1~250 MHz) and pulsed RF stimulus at high frequency range(8~10 GHz). The test system, set-up method and test procedure for the RF sensitivity of EED are described in this paper. The Bruceton method is applied to obtain distribution statistics such as mean firing level, standard deviation of the distribution and confidence levels for various applied firing signals.