• 한국안전학회지
• /
• 제17권2호
• /
• pp.85-91
• /
• 2002

A research on the performance of retrofit anchors was conducted using adhesives for rehabilitation. From the pull-out tests of the chemical anchors, the effect of the hole diameter, spacer, temperature, moisture, embedment depth, and aging time were investigated. The spacer did not directly increased the pull-out load hilt increased post-yielding resistance therefore the ductility of the retrofit anchors. When the hole was cleaned and dried after the immersion, the pull-out load was greatly increased compared to the wet hole. A design equation was unposed depending on the embedment depth of the anchor bolt.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 춘계 학술발표회 초청강연 및 논문집
• /
• pp.405-411
• /
• 2008

The pressurized grouting soil nailing method using rubber membrane packer system was developed for recycling materials to minimize environmental pollution and reducing construction costs. For this purpose, field pull-out tests were performed to evaluate the characteristics of soil nailing by measuring tensile stresses and axial displacements.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2000년도 가을 학술발표회 논문집
• /
• pp.127-134
• /
• 2000

Soil nailing is in-situ ground improvement technique of reinforcing soils using passive inclusions for the purpose of slope stability. Also soil nailing, in general, was used and studied as a reinforcement technique at cut slope, but this paper presents the results of study for soil nailing application as a reinforcement technique at the banking over slided slope. In-situ pull-out tests of nails, instrumented with strain gauges, were performed to investigate the maximum pull-out load and to calculate the unit side resistance in each different layer. And the apparent average unit side resistance of this study was compared with that of other sites installed at cut slope.

• 한국지반신소재학회논문집
• /
• 제20권4호
• /
• pp.53-62
• /
• 2021

최근 국내에서 활발히 적용되고 있는 LRFD 설계법의 합리적인 적용을 위하여 상대적으로 사례가 부족한 인발하중 및 수평하중의 연구를 위하여 사회적으로 중요한 구조물인 송전철탑의 기초 형태를 바탕으로 한 원형기초를 풍화토 단일지층과 풍화토, 풍화암, 연암으로 구성된 혼합지층에서의 현장실증시험을 수행하여 인발하중 및 수평하중에 대한 각 지층의 저항성 분석을 통해 설계에 영향을 미칠 수 있는 인자에 대하여 연구하였다.

• 한국지반공학회논문집
• /
• 제34권11호
• /
• pp.5-19
• /
• 2018

지반앵커의 정착장에 작용하는 정착응력 분포 특성은 매우 비선형적이며 공학적인 메카니즘이 비교적 복잡하기 때문에 다양한 지반조건 및 비선형적 주면전단거동을 구체적으로 모사하여 지반앵커를 설계하는데 어려움이 크다. 이런 한계로 인하여 현재 대부분의 관련 설계 기준서에는 편의상 정착장 전장에 걸쳐 일정한 주면전단응력분포를 가정하여 설계에 적용하고 있다. 따라서 본 연구에서는 인장형 앵커의 인발거동 특성을 분석하기 위하여 풍화토 지반조건을 대상으로 현장인발시험을 수행하였으며 이를 토대로 앵커 정착장의 주면전단거동을 정립하고, 정착장 거동특성을 비교적 간편하게 예측하기 위한 다중선형모델 및 이를 적용한 해석적 기법을 제안하였다. 현장시험결과와 해석적 결과가 상호 유사하게 나타남에 따라 본 연구에서 제시된 다중선형모델 및 이를 이용한 해석적 기법의 적용성 및 유효성을 확인할 수 있었다. 정착장 주면전단거동의 경우 최대인발하중 보다 작은 하중조건에서는 정착장 시작점에서 최대전단응력이 분포하게 되나 최대인발하중이 발생한 이후부터는 정착장 시작점에서 전단응력이 가장 작게 분포하고, 정착장 시작점으로부터 일정거리 이격된 지점에서 최대전단응력이 발생함을 확인하였다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2003년도 사면안정학술발표회
• /
• pp.119-127
• /
• 2003

For the calculation of internal stability, the hypothesis in conventional design is on the basis of two distinct zones, which are‘active zone’and‘passive zone’. This means that there is an abrupt discontinuous transition from active to passive states across a potential failure line. The existence of a discontinuity of this nature appears physically unreasonable, especially from kinematic considerations. A series of pull-out model tests was undertaken from a wall being rotated about the toe to find the strain distribution mobilized from near the wall face into the deep, stable zone through the centre plane. With this finding of transition zone, the objective of study is aiming at identifying the likely effect of this zone in designing method by comparing with the prevailing design method.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2001년도 봄 학술발표회 논문집
• /
• pp.339-346
• /
• 2001

For temporary excavation support in private land area, the strand of ground anchor should be removed In order to get permission to install anchors. The extractable or removable-strand compression anchor system was developed and evaluated by a series of pull-out load tests. Anchor pull-out tests were performed on seven instrumented full-scale low-pressure grouted anchors installed in weathered soil at the Geotechnical Experimentation Site at Sungkyunkwan University, Four anchors are the compression type anchors and three are the tension anchors. Performance test, creep test, and long term relaxation test were performed and presented. Load distributor was developed in order to distribute large compressive stresses in grout.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2000년도 사면안정 학술발표회
• /
• pp.235-239
• /
• 2000

For the calculation of internal stability, the hypothesis in conventional design is on the basis of two distinct zones, which are 'active zone' and 'passive zone'. This means that there is an abrupt discontinuous transition from active to passive states across a potential failure line. The existence of a discontinuity of this nature appears physically unreasonable, especially from kinematic considerations. A series of pull-out model tests was undertaken from a wall being rotated about the toe to find the strain distribution mobilized from near the wall face into the deep, stable zone through the centre plane. With this finding of transition zone, the objective of study is aiming at identifying the likely effect of this zone in designing method by comparing with the prevailing design method.

• 지구물리
• /
• 제8권1호
• /
• pp.39-43
• /
• 2005

For the calculation of internal stability, the hypothesis in conventional design is on the basis of two distinct zones, which are 'active zone' and 'passive zone'. This means that there is an abrupt discontinuous transition from active to passive states across a potential failure line. The existence of a discontinuity of this nature appears physically unreasonable, especially from kinematic considerations. A series of pull-out model tests was undertaken from a wall being rotated about the toe to find the strain istribution mobilized from near the wall face into the deep, stable zone through the centre plane. With this finding of transition zone, the objective of study is aiming at identifying the likely effect of this zone in designing method by comparing with the prevailing design method.

• 한국지반환경공학회 논문집
• /
• 제15권9호
• /
• pp.87-92
• /
• 2014

지압형 앵커는 지반 자체를 지지기구로 활용하여 인발에 저항하는 구조이며 앵커의 인발저항력은 지반의 지압저항력과 확장날개의 확공부 공벽 압착에 의한 마찰저항력으로 구성된다. 특히 확공 지압형 앵커는 정착장 확공부에서 발생하는 지압저항력으로 인발에 저항하여 지반변형을 억제하기 위한 주동보강 방식의 구조이다. 본 연구는 확공 지압형 앵커의 지압저항력 산정을 위해 수행되었으며, 실모형실험으로 지압저항력을 산정하고 그 결과를 지반의 일축압축강도와 비교하였다. 실모형실험에서는 모형지반들의 일축압축강도를 8개의 풍화암 조건으로 모사하여 앵커 인장시험을 수행해 지압저항력을 측정하였다. 실험에서 도출된 지압저항력은 모사된 지반강도와 일련의 선형적 관계를 보였으며, 선형회귀분석을 통해 경험식을 제시하였다. 지압저항력은 실모형 실험 결과 일축압축강도 대비 약 13배로 산정되었고, 이론식에서 제시하고 있는 수치와 상당히 일치하였다.