• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.27 no.10
• /
• pp.93-100
• /
• 2013

Generally, the conventional battery charging system using an analog method has the large, heavy hardware and low efficiency. Also, it has the disadvantage that it is necessary to replace the control circuit on the basis of the characteristic curve of the specific battery cell. The proposed programmable digital LLC resonant charging system use high efficiency control system(CC-CV), and has characteristic a small hardware and advantage that a digital programming of the voltage, current, and battery capacity characteristics can be flexible. The system proposed the use of Half-bridge LLC resonant converter is possible to improve efficiency and reduce switching losses by using ZVS topology. Further, a constant voltage - constant current(CC-CV) control algorithm apply to the charger which using a buck converter. The performance of the proposed system is demonstrated through experiments.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.7
• /
• pp.72-78
• /
• 1998

This paper is focused on the fabrication of reliable novel antifuse, which could operate at low voltage along with the improvement in OFF and ON-state properties. The fabricated antifuse consists of Al/BaTi$_{2}$O$_{3}$/SiO$_{2}$/TiW-silicide structure. Through the systematic analyses for bottom metal and the intermetallic insulator, material and electri cproperties were investiaged. TiW-silicide as the bottom electrode had smooth surface with average roughness of 11.angs. at 10X10.mu.m$^{2}$ and was bing kept as-deposited SiO$_{2}$ film stable. Amorphous BaTi$_{2}$O$_{3}$ film as the another insulator was chosen because of its low breakdown strength (2.5MV/cm). breakdown voltage of antifuse is remarkably reduced by using BaTi$_{2}$O$_{3}$ film, and leakage current of that maintained low level due to the SiO$_{2}$ film. Low ON-resistance (46.ohm./.mu.m$^{2}$) and low programming voltage(9.1V) can be obtained in theses antifuses with 220.angs. double insulator layer and 19.6X10$^{-6}$ cm$^{2}$ area, while keeping sufficient OFF-state reliability (less than 1nA).

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.388-388
• /
• 2012

In this letter, We have investigated cell characteristics of the alloy FePt-NDs charge trapping memory capacitors with high-k $Al_2O_3$ dielectrics as a blocking oxide. The capacitance versus voltage (C-V) curves obtained from a representative MOS capacitor embedded with FePt-NDs synthesized by the post deposition annealing (PDA) treatment process exhibit the window of flat-band voltage shift, which indicates the presence of charge storages in the FePt-NDs. It is shown that NDs memory with high-k $Al_2O_3$ as a blocking oxide has performance in large memory window and low leakage current when the diameter of ND is below 2 nm. Moreover, high-k $Al_2O_3$ as a blocking oxide increases the electric field across the tunnel oxide, while reducing the electric field across the blocking layer. From this result, this device can achieve lower P/E voltage and lower leakage current. As a result, a FePt-NDs device with high-k $Al_2O_3$ as a blocking oxide obtained a~7V reduction in the programming voltages with 7.8 V memory.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.21 no.5
• /
• pp.67-78
• /
• 1984

EAROM device is an n-channel MOS transistor with a control gate stack ed on the floating gate. On account of channel injection type, channel lengths are designed 4-8 $\mu$m and chinnel widths 5-14 $\mu$m. These devices which have fourstructures of different type control gate are designed by NMOS 5 $\mu$m design rule and fabricated by double polysilicon gate NMOS Process. Double ion implantation is applied to increase punchthrough voltage and gate-controlled channel breakdown voltage. The drain and gate voltage for programming was 13-17V and 20-25V, respectively. EPROM cell fabricated could be erased not by optical method but by electrical method. The result of charge retention test showed decrease in stored charges by 4% after 200 hours at 1$25^{\circ}C$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.149-150
• /
• 2007

ONO(Oxide-Nitride-Oxide)구조는 기억소자의 전하보유 능력을 향상시키기 위해 도입된 게이트 절연막이다. 본 연구에서는 ELA(Excimer Laser Annealing)방법으로 비정질 실리콘을 결정화 시켜서 그 위에 NVM(Nonvolatile Memory)소자를 만들어 전기적 특성을 측정하여 결과를 나타내었다. 실험 결과 같은 크기의 $V_D$에서 $V_G$를 조절함으로써 $I_D$의 크기를 조절할 수 있었다. $V_G-I_D$ Graph에서는 $I_{on}$과 $I_{off}$, 그리고 Threshold Voltage를 알 수 있었다. $I_{on}/I_{off}$ Ratio는 $10^3-10^4$이다. $V_G-I_D$ Graph에서는 게이트에 인가하는 Bias의 양을 통해서 Threshold Voltage의 크기를 조절할 수 있었다. 이는 Trap되는 Charge의 양을 임의로 조절할 수 있다는 것을 의미하며, 이러한 Programming과 Erasing의 특성을 이용하여 기억소자로서의 역할을 수행하게 된다.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.23 no.1
• /
• pp.65-73
• /
• 1986

Experiment have been conducted about thin oxide characteristics according to O2/N2 ratio needed for EEPROM cell fabrication. As a result, we think that there is no problem even if we grow oxide layer with large O2/N2 ratio and short exidation time and when the water is implated by As before oxidation, the oxide breakdown field is about IMV/cm lower than that is not implanted. Especially, the thin oxide characteristic seems to be affected largely by wafer cleaning and oxidation in air. On the basis of these, tunnel type EEPROM cell is fabricated by 3um CMOS process and its characteristic is studied. Tunnel oxide thickness(100\ulcorner is chosen to allow Fowler-Nordheim tunneling to charge the floating gate at the desired programming voltage and tunnel area(2x2um\ulcorneris chosen to increase capacitive coupling ratio. For program operation, high voltage (20-22V) is applied to the control gate, while both drain and source are gdrounded. The drain voltage for erase is 16V. It is shown that charge retention characteristics is not limited by leakage in the oxide and program/erase endurance is over 10E4 cycles of program erase operation.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.10
• /
• pp.918-922
• /
• 2006

Chalcogenide Phase change memory has the high performance necessary for next-generation memory, because it is a nonvolatile memory with high programming speed, low programming voltage, high sensing margin, low power consumption and long cycle duration. To minimize the power consumption and the program voltage, the new composition material which shows the better phase-change properties than conventional $Ge_2Sb_2Te_5$ device has to be needed by accurate material engineering. In the present work, we investigate the basic thermal and the electrical properties due to phase-change compared with chalcogenide-based new composition $Ge_1Se_1Te_2$ material thin film and convetional $Ge_2Sb_2Te_5$ PRAM thin film. The fabricated new composition $Ge_1Se_1Te_2$ thin film exhibited a successful switching between an amorphous and a crystalline phase by applying a 950 ns -6.2 V set pulse and a 90 ns -8.2 V reset pulse. It is expected that the new composition $Ge_1Se_1Te_2$ material thin film device will be possible to applicable to overcome the Set/Reset problem for the nonvolatile memory device element of PRAM instead of conventional $Ge_2Sb_2Te_5$ device.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.11
• /
• pp.914-920
• /
• 2000

When the charge-trap type SONOS(polysilicon-oxide-nitride-oxide-semiconductor) cells are used to flash memory, the tunneling program/erase condition to minimize the generation of interface traps was investigated. SONOSFET NVSM(Nonvolatile Semiconductor Memory) cells were fabricated using 0.35 ㎛ standard memory cell embedded logic process including the ONO cell process, based on retrograde twin-well, single-poly, single metal CMOS(Complementary Metal Oxide Semiconductor) process. The thickness of ONO triple-dielectric for the memory cell is tunnel oxide of 24 $\AA$, nitride of 74 $\AA$, blocking oxide of 25 $\AA$, respectively. The program mode(V$\_$g/=7, 8, 9 V, V$\_$s/=V$\_$d/=-3 V, V$\_$b/=floating) and the erase mode(V$\_$g/=-4, -5, -6 V, V$\_$s/=V$\_$d/=floating, V$\_$b/=3 V) by MFN(Modified Fowler-Nordheim) tunneling were used. The proposed programming condition for the flash memory of SONOSFET NVSM cells showed less degradation(ΔV$\_$th/, S, G$\_$m/) characteristics than channel MFN tunneling operation. Also, the program inhibit conditins of unselected cell for separated source lines NOR-type flash memory application were investigated. we demonstrated that the phenomenon of the program disturb did not occur at source/drain voltage of 1 V∼12 V and gate voltage of -8 V∼4 V.

• Journal of IKEEE
• /
• v.26 no.2
• /
• pp.329-332
• /
• 2022

In this paper, retention characteristics of lateral charge migration according to parameters of 3D NAND flash memory to which ferroelectric (HfO₂) structure is applied and ∆V_th were analyzed. The larger the P_s, the greater maximum polarization possible in ferroelectric during Programming. Therefore, the initial V_th increases by about 1.04V difference at P_s 70µC/cm² than at P_s 25µC/cm². Also, electrons trapped after the Program operation causes lateral charge migration over time. Since ferroelectric maintains polarization without applying voltage to the gate after Programming, regardless of P_s value, polarization increases as P_r increases and the ∆V_th due to lateral charge migration becomes smaller by about 1.54V difference at P_r 50µC/cm² than P_r 5µC/cm².

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.5
• /
• pp.1061-1066
• /
• 2012

A digital memory has been widely used as a device for storing information due to its reliable, fast and relatively simple control circuit. However, the storage of the digital memory will be limited by the inablility to make smaller linewidths. One way to dramatically increase the storeage capability of the memory is to change the type of stored data from digital to analog. The analog memory fabricated in a standard single poly 0.6um CMOS process has been developed. Single cell and adjacent circuit block for programming have been designed and characterized. Applications include low-density non-volatile memory, control of redundancy in SRAM and DRAM memories, ID or security code registers, and image and sound memory.