• Journal of IKEEE
• /
• v.3 no.2 s.5
• /
• pp.221-225
• /
• 1999

In this paper, a new type of predistortion linearizer has been studied. It employs a series feedback amplifier with a large source inductance as a predistortion linearizer, which provides positive amplitude and negative phase deviations for input Power and can compensate for AM-AM and AM-PM distortions of power amplifier. This predistortion lineariaer consists of only one CaAs FET, large source inductor, input output matching networks and bias circuits. Because of its simple circuit, the linear can be operated over a broad bandwidth and has good thermal stability The characteristics of this linearizer can be easily tuned using source inductor, its gate bias condition. In fabricated linearizer, the third-order intermodulation distortion(IMD) for main amplifier alone is 10.61dBc, and the $IM_3$ for main amplifier with predistorter is 21.91dBc. Therefore, the $IM_3$ characteristic results an improvement of approximately 11dB.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.44 no.2 s.314
• /
• pp.32-38
• /
• 2007

This paper represents a Doherty amplifier (DPA) with analog predistorter (PD) to improve the linearity of the DPA while preserving the high efficiency. A third-order PD cancels fifth-order intermodulation (IM5) as well as third-order intermodulation (IM3) components by their same phase difference in the PD and DPA. This is accomplished by independently controlling their phase by using the phase-controlled error generator in the PD. Also, we confirm the phase-control ability of the error generator experimentally with a simple and accurate phase measurement setup. For experimental verification, a third-order PD has been implemented and tested in a 180-W DPA at the wide-band code division multiple access (WCDMA) band of 2.11-2.17 GHz. Two-tone test results show that significant cancellation of IM3 and IM5 components can be obtained. For four-carrier WCDMA applications, significant adjacent channel leakage ratio (ACLR) improvement is achieved over a wide range of output power levels. This technique is cost-effective and convenient due to its simple structure, compact size, and three control parameters.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.10
• /
• pp.41-49
• /
• 2004

Nonlinear distortion introduced by the optical transmitter using a direct modulation of laser diode(LD) and an indirect modulation of optical modulator can limit considerably the performance of analog optical link system such as subcarrier multiplexing system. In this paper, we have compensated the nonlinear distortion of LD and optical modulator using electrical predistorter. In the case of LD, two-tone experiments using 877.5 MHz and 882.5 MHz have shown reduction of 19 dB in third-order intermodulation product(IMP$_3$). And in the case of optical modulator, we have achieved nearly 21 dB reduction in IMP3 through two-tone experiments using 1.8975 GHz and 1.9025 GHz. The spurious free dynamic ranges of LD and optical modulator are also improved by 5 dB/Hz$^{2}$ 3/ and 7 dB/Hz$^{2}$ 3/, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.10
• /
• pp.8-16
• /
• 2010

An orthogonal frequency division multiplexing (OFDM) system is a special case of multicarrier transmission, where a single data stream is transmitted over a number of lower-rate subcarriers. One of the main reasons to use OFDM is to increase robustness against frequency-selective fading or narrowband interference. However, in the radio systems the distortion introduced by high power amplifiers (HPA's) such as traveling wave tube amplifier (TWTA) considered in this paper, is also critical. Since the signal amplitude of the OFDM system is Rayleigh-distributed, the performance of the OFDM system is significantly degraded by the nonlinearity of the HPA in the OFDM transmitter. In this paper, we propose a simplicial canonical piecewise-linear (SCPWL) model based digital predistorter to compensate for nonlinear distortion introduced by an HPA in an OFDM system. Computer simulation is carried on an OFDM system under additive white Gaussian noise (AWGN) channels with 16-QAM and 64-QAM modulation schemes and modulator/demodulator implemented with 1024-point FFT/IFFT. The simulation results demonstrate that the proposed predistorter achieves significant performance improvement by effectively compensating for the nonlinearity introduced by the HPA.

• 한국ITS학회:학술대회논문집
• /
• v.2007 no.10
• /
• pp.131-135
• /
• 2007

• Journal of electromagnetic engineering and science
• /
• v.9 no.2
• /
• pp.78-84
• /
• 2009

This paper represents the effects of drain bias on the linearity and efficiency of an analog pre-distortion power amplifier(PA) for wideband code division multiple access(WCDMA) repeater applications. For verification, an analog predistorter(APD) with three-branch nonlinear paths for memory-effect compensation is implemented and a class-AB PA is fabricated using a 30-W Si LOMaS. From the measured results, at an average output power of 33 dBm(lO-dB back-off power), the PA with APD shows the adjacent channel leakage ratio(ACLR, ${\pm}$5 MHz offset) of below -45.1 dBc, with a drain efficiency of 24 % at the drain bias voltage($V_{DD}$) of 18 V. This compared an ACLR of -36.7 dEc and drain efficiency of 14.1 % at the $V_{DD}$ of 28 V for a PA without APD.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.2
• /
• pp.65-70
• /
• 2004

This paper presents a novel linearization scheme for a nonlinear RF amplifier It is based on the amplitude modulation with envelope signal. The 3rd order distortion generator is composed of two FETs and it adopts a balanced structure for the purpose of main carrier cancellation. The amplitude and phase of the IM3 component can be controlled at RF band. This predistorter is implemented and tested at the KOREA PCS Tx. band (1840∼1870MHz). Experimental results of two-tone test show that the IM3 cancellation is achieved about 30-40 ㏈ for the wide dynamic range. The adjacent channel power ratio is improved by over 10 ㏈ at the broad-band CDMA signal with a peak to average power ratio of l0㏈, and this improvement is maintained through a wide range of output power levels.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.2
• /
• pp.9-17
• /
• 2010

Recently, there has been much interest in orthogonal frequency division multiplexing (OFDM) for next generation wireless wideband communication systems. OFDM is a special case of multicarrier transmission, where a single data stream is transmitted over a number of lower-rate subcarriers. One of the main reasons to use OFDM is to increase robustness against frequency-selective fading or narrowband interference. However, in the radio systems it is also important to distortion introduced by high power amplifiers (HPA's) such as solid state power amplifier (SSPA) considered in this paper. Since the signal amplitude of the OFDM system is Rayleigh-distributed, the performance of the OFDM system is significantly degraded by the nonlinearity of the HPA in the OFDM transmitter. In this paper, we propose a canonical piecewise-linear (PWL) model based digital predistorter to prevent signal distortion and spectral re-growth due to the high peak-to-average power ratio (PAPR) of OFDM signal and the nonlinearity of HPA's. Computer simulation on an OFDM system under additive white Gaussian noise (AWGN) channels with QPSK, 16-QAM and 64-QAM modulation schemes and modulator/demodulator implemented with 1024-point FFT/IFFT, demonstrate that the proposed predistorter achieves significant performance improvement by effectively compensating for the nonlinearity introduced by the SSPA.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.4
• /
• pp.299-307
• /
• 2018

Considering a nonlinear high power amplifier(HPA) and a predistorter, we have designed a four-dimensional 8-ary phase shift keying trellis-coded modulation(4D-8PSK-TCM) system, which is recommended for X-band satellite communications. Subsequently, we have evaluated and analyzed the spectrum, constellation characteristics, and BER performance of the system. In satellite communications, owing to the limited power, nonlinear characteristics that determine the operating point of the HPA must be analyzed because the HPA consumes high power. We herein report the design of the 4D-8PSK-TCM system, with efficiencies of 2 and 2.25 bits/channel-symbol. The simulation results confirmed that a 0.35 roll-off value is effective, considering the low peak-to-average power ratio(PAPR) characteristic and the narrow occupation bandwidth of the spectrum. It also confirmed that approximately 15~20 dB of output backoff(OBO) value is required at the HPA when the predistorter is not used, and approximately 1 dB of the OBO value is required when the predistorter is used.

• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.211-214
• /
• 1998

The high power amplifier (HPA) for broadcasting transmitter systems has nonlinear property in terms of input signal power. Hence, it produces AM/AM and AM/PM modulation to the modulated signal. Therefore, the non-linearity results in bandwidth expansion and nonlinear distortion to in-band signal. In this paper, we propose a simple sain-based predistorter that requires less computational burden and less time for the full initialization of the pre-distorter ROM table.