• Journal of Korean Society of Transportation
• /
• v.28 no.3
• /
• pp.29-37
• /
• 2010

Ramp metering control is the most representative strategy of uninterrupted flow control and management system. Ramp metering is to adjust vehicles entering an expressway in such a way that expressway mainline maintains flow stability by regulating ramp vehicles. The effect of two metering strategies, single-entry metering and platoon metering, on mainstream under the same metering rate with pre-timed metering are analyzed by micro-simulation. Platoon metering shows lower performance than single-entry metering under the same metering rate in terms of speed, density, and delay, causes earlier breakdown than single-entry metering. It indicates that the selection of metering type has critical importance as the flow of mainline is high.

• Journal of Communications and Networks
• /
• v.8 no.1
• /
• pp.70-84
• /
• 2006

We propose a new distributed QoS routing scheme called pre-computation based selective probing (PCSP). The PCSP scheme is designed to provide an exact solution to the constrained optimization problem with moderate overhead, considering the practical environment where the state information available for the routing decision is not exact. It does not limit the number of probe messages, instead, employs a qualitative (or conditional) selective probing approach. It considers both the cost and QoS metrics of the least-cost and the best-QoS paths to calculate the end-to-end cost of the found feasible paths and find QoS-satisfying least-cost paths. It defines strict probing condition that excludes not only the non-feasible paths but also the non-optimal paths. It additionally pre-computes the QoS variation taking into account the impreciseness of the state information and applies two modified QoS-satisfying conditions to the selection rules. This strict probing condition and carefully designed probing approaches enable to strictly limit the set of neighbor nodes involved in the probing process, thereby reducing the message overhead without sacrificing the optimal properties. However, the PCSP scheme may suffer from high message overhead due to its conservative search process in the worst case. In order to bound such message overhead, we extend the PCSP algorithm by applying additional quantitative heuristics. Computer simulations reveal that the PCSP scheme reduces message overhead and possesses ideal success ratio with guaranteed optimal search. In addition, the quantitative extensions of the PCSP scheme turn out to bound the worst-case message overhead with slight performance degradation.

• Journal of the Korean Dietetic Association
• /
• v.12 no.2
• /
• pp.157-171
• /
• 2006

This study was intended to suggest HACCP-based standard recipe for bellflower roots, classified as no thermal cooking process, served in a university foodservice operation. The time-temperature and microbial contamination level in each cooking step were analyzed. The temperatures of bellflower root, peeled garlic and green onion at receiving were at 13.8$\pm$2.8, 12.6$\pm$2.9 and 13.7$\pm$$0.8^\circC$ respectively, which were above the temperature limit. The time consumed for pre-preparation was up to 90 min at room temperature having high microbial growth potential. The levels of total plate counts (TPC) of bellflower root and garlic were over the limit of $10^6$ CFU/g as were the numbers of coliforms in bellflower roots. There were no microbial reductions in pre-preparation and cooking, which resulted in over $10^5$- $10^6$ CFU/g of TPC at service step. Two CCPs identified were washing/sanitation at pre-preparation and service steps. The control measures were washing/sanitation and temperature control. It was verified that CCPs for no cooking process developed in preceding studies were applicable for the microbiological food safety of this menu item. The HACCP-based standard recipe was developed to produce a quantity for 100 servings by observing the critical limits established for CCPs. These results suggest that the selection of proper provider is imperative to control the microbial contamination of raw materials at purchasing step. Also, the sanitary education program should be developed for the employees to understand and comply the HACCP plan and standard recipe.

• Journal of Life Science
• /
• v.16 no.2 s.75
• /
• pp.289-296
• /
• 2006

In order to establish highly efficient gene transfer condition at early stage of soybean transformation, various experiments were performed and compared their efficiencies by transient GUS analysis; those conditions are genotype determination of Korean soybean cultivars for amenability to Agro-infection, appropriate agar and selective agent concentration, orientation of explant placement, hormone pre-culture, and liquid selection condition. In the genotype screen of Korean soybean varieties, 14 amenable genotypes were selected. For efficient Agrobacterium washing, cefotaxime was chosen and hygromycin at the concentration of 10 and 15 ppm was used as selection agent in the media. Agar concentration was slightly better in 0.6% and 0.8% for both shoot and callus formation, and explant placement with adaxial side down showed high frequency of GUS expression. For wounding treatment, oriental needle was efficient than scalpel for shoot formation and gene transfer. To increase the frequency of gene transfer, hormone pre-treatment was applied. BA at the concentration of 5 and 10 ppm resulted in better survival at the late stage of selection in shoot elongation media. Selection in liquid media after hormone pre-treatment seemed to be effective to remove the escaped non-transformants at early stage of procedure. Considering the results obtained, Eunhakong could be the first choice as a material for soybean transformation among Korean soybean genotypes.

• Journal of Plant Biotechnology
• /
• v.44 no.1
• /
• pp.82-88
• /
• 2017

Transgenic lily plants have been obtained after particle bombardment, using PDS-1000/He system and scale explants of lilies, followed by PPT (D-L-phosphinothricin) selection. In this study, scales of the lily plants cv. 'red flame' were bombarded with a plasmid containing the bar gene as a selectable marker, and the AtSIZ gene as a gene of interest, showing salt tolerance and drought tolerance respectively, and both being driven by the CaMV 35S promoter. For optimization of a protocol, factors which optimized and showed a high transformation efficiency under following conditions, were considered: a bombardment pressure of 1100 psi, a target distance of 6 cm and $1.0{\mu}m$ of gold particle, and 24-h pre-culture and post-culture on MS medium containing 0.2 M sorbitol and 0.2 M mannitol as osmoticum agents. After bombardment, all the bombarded scales of lily were transferred to MS medium without selective agents, for a week. Subsequently, these bombarded scales were transferred to a selection MS medium containing 10 mg/l PPT, and incubated for a month for further selection, after which they were cultured for another 4-8 weeks with a 4-week subculture regime on the same selection medium. After transferring into hormone-free MS medium, the PPT-resistant scales with shoots were successfully rooted and regenerated into plantlets. PCR analysis revealed that the surviving putatively transformed plantlets indicated the presence of both the bar gene and the AtSIZ gene. In conclusion, when 100 scales of lily cv. Red flame are bombarded, this study produced approximately 17-18 transgenic plantlets with an optimized bombardment protocol. The protocol described here can contribute to the breeding program of lilies.

• Korean Journal of Comparative Education
• /
• v.27 no.4
• /
• pp.231-254
• /
• 2017

The purpose of this study was to identify the actual condition and problems of Mongolian teacher quality management of selection and qualification and to recommend improvement. We examined the Mongolian teacher qualification management system with four criteria based on previous research. The results of this study are as follows. Mongolian government established quality management mechanisms such as selection of pre-service teachers, verification of teacher certificate, and appointment of in-service teachers, and teacher qualification standards. These Mongolian teacher selections and qualification systems were operated to attract the manpower required for teaching, to verify their qualifications and to induce professional development. However, the systems have not been able to verify the teachers' ability to practice in the field. We also found that the systems themselves were criticized for failing to guarantee conformity, fairness and transparency. Based on the results of this study, we discussed and draw policy implications for improvement of teacher quality management of selection and qualification in Mongolia.

• Journal of The Korean Association For Science Education
• /
• v.34 no.2
• /
• pp.135-146
• /
• 2014

The purpose of this study is to explore evaluation criteria that pre-service elementary teachers employ as they evaluate and select models to explain electric circuits. Thirty junior students in a university of education have participated in the study as a part of the science education course in which they were enrolled. The lessons for the participants have been organized as a cyclic sequence of different modeling pedagogies including the expressive, experimental, and evaluative modeling. The pre-service teachers have been given five electric circuits in order and asked to create models and further develop them through peer discussion. Their modeling activities have been video- or audio-recorded, and the recordings and their transcripts have been analyzed using a framework of model evaluation criteria. It reveals that the types and frequencies of evaluation criteria used are different between situations of model development and model selection. While empirical and theoretical criteria have been used dominantly in both situations, more various criteria have been employed in the situation where the pre-service teachers selected one model among alternatives. Implications for science education and science education research have been suggested.

• Journal of Digital Convergence
• /
• v.12 no.5
• /
• pp.403-413
• /
• 2014

This study is to select educational films suitable for enhancing creativity and personality in order to develop educational contents aimed at pre-service early childhood teacher. First, three film critics based on sub-elements of ego-identity selected final 59 films. Next, three education experts classified the 59 films into small groups based on components each for creativity and personality. As a result, first, films classified according to pre-service early childhood teacher' sub-elements of ego-identity, educational components for creativity, and educational components for personality were 8 in job, 7 in religion, 6 in politics, 7 in philosophical life style, 8 in friendship, 8 in relationship, 7 in gender role, and 8 in leisure activity. Second, verifying suitability of film critics and education experts using Delphi method in order to select educational films to enhance pre-service early childhood teacher' creativity and personality based on films was effective in increasing validity of the results of this research.

• Journal of Mechanical Science and Technology
• /
• v.20 no.1
• /
• pp.19-28
• /
• 2006

This paper describes rapid prototyping (RP) and reverse engineering (RE) application for orthopedic surgery planning to improve the efficiency and accuracy of the orthopedic surgery. Using the symmetrical characteristics of the human body, CAD data of undamaged bone of the injured area are generated from a mirror transformation of undamaged bone data for the uninjured area. The physical model before the injury is manufactured from Poly jet RP process. The surgical plan, including the selection of the proper implant, pre-forming of the implant and decision of fixation positions, etc., is determined by a physical simulation using the physical model. In order to examine the applicability and efficiency of the surgical planning technology, two case studies, such as a distal tibia comminuted fracture and an iliac wing fracture of pelvis, are carried out. From the results of the examination, it has been shown that the RP and RE can be applied to orthopedic surgical planning and can be an efficient surgical tool.

• Proceedings of the IEEK Conference
• /
• 2001.09a
• /
• pp.631-634
• /
• 2001

OFDM(orthogonal frequency division multiplexing) 시스템은 유효심볼의 뒷부분 일부를 복사하여 유효심볼 이전에 미리 전송하는 보호구간을 이용하여 다중경로에 의한 왜곡을 줄일 수 있다. 그러나, 유효심볼의 시작점을 정확히 판단하더라도 열악한 다중경로 또는 프리-고스트(pre-ghost) 채널의 영향으로 인해 심볼간 간섭(inter-symbol interference)이 발생한다. 본 논문에서는 다중경로 환경하의 기존 시스템에서 발생하던 심볼간 간섭을 제거할 수 있는 프레임 선택 알고리듬을 제안한다. 프레임 선택 알고리듬은 FFT 입력으로 유효심볼의 뒤 알부 대신 보호구간의 일부를 사용한다. FFT 입력으로 사용된 보호구간내 교체구간은 다중경로 환경에 따라 달라져야 하는데, 교체구간 판단을 위한 네 가지 알고리듬도 소개한다. 제안한 알고리듬을 DVB-T(digital video broadcasting-terrestrial) 시스템에 적용한 모의실험을 통하여 3 dB 이상의 성능향상을 얻을 수 있다.