• 한국멀티미디어학회논문지
• /
• 제6권1호
• /
• pp.161-166
• /
• 2003

본 논문에서는 블루투스에서 사용할 0.25$\mu\textrm{m}$ CMOS 공정을 이용한 고이득 저잡음 증폭기를 설계하였다. 설계한 저잡음 증폭기는 캐스코드 인버터를 이용하였으며, 레퍼런스 전압원을 가지고 쵸크 인덕터를 사용하지 않는 1단으로 설계하였다. 기존 1단으로 설계된 저잡음 증폭기의 10~15dB의 낮은 전력이득을 개선한 구조이다. 설계된 2.4GHz 저잡음 증폭기는 2.2dB의 NF값과 21dB의 높은 전력이득을 가지고 있으며, 2.5V 공급 전원에서 255mW 소모전력을 갖는다

• Journal of the Optical Society of Korea
• /
• 제18권6호
• /
• pp.657-662
• /
• 2014

We demonstrate a simulation of a parallel hybrid fiber amplifier in the C+L-band with a gain controlling technique. A variable optical coupler is used to control the input signal power for both EDFA and RFA branches. The gain spectra of the C+L-band are flattened by optimizing the coupling ratio of the input signal power. In order to enhance the pump conversion efficiency, the EDFA branch was pumped by the residual Raman pump power. A gain bandwidth of 60 nm from 1530 nm to 1590 nm is obtained with large input signal power less than -5 dBm. The gain variation is about 1.06 dB at a small input signal power of -30 dBm, and it is reduced to 0.77 dB at the large input signal power of -5 dBm. The experimental results show close agreement with the simulation results.

• 전자공학회논문지
• /
• 제51권11호
• /
• pp.101-106
• /
• 2014

본 논문에서는 자동 이득 제어 회로를 이용한 와이드 다이나믹 레인지 RF root-mean-square (RMS) 전력 검출기를 소개한다. 제안하는 자동 이득 제어는 voltage gain amplifier (VGA), RMS 변환 블록, 이득 조절 블록으로 구성되어 있다. VGA는 dB-linear한 이득 관계를 갖는 캐스코드 VGA를 사용하였다. 제안하는 RMS 변환은 입력 신호 전 파장의 제곱 변환을 이용하여 RMS에 비례하는 DC 전압을 출력한다. 제안하는 RMS 전력 검출기는 500MHz에서 5GHz에서 작동하며 검출 범위는 0 dBm에서 -70dBm 이상의 신호를 -4.53 mV/dBm의 비율로 검출한다. 제안하는 RMS 전력 검출기는 TSMC 65nm 공정을 사용하여 설계되었으며 1.2V에서 5mW의 전력소비를 갖는다. 칩 레이아웃 면적은 $0.0097mm^2$이다.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1998년도 추계종합학술대회 논문집
• /
• pp.675-678
• /
• 1998

In this paper, power amplifiers for PCS phone were designed with the GEC Marconi H40 HEMT libray. The 1st stage was carefully designed in order to obtain k〉1 using a parallel resistor, and its S21 gain of 18.3dB and input reflection coefficient of -4dB were obtained. And S21 gain of 18dB and input reflection coefficient of -7dB were obtained from the 2nd stage. Finally, total S21 gain of 38dB, input reflection coefficient of -16dB, power gain of 35.2dB, output power of 28.7dBm and PAE(power added efficiency) of 29% were obtained from the designed MMIC power amplifiers. The chip size is $1.729$\times$0.94\textrm{mm}^2.$

• 전자공학회논문지A
• /
• 제30A권8호
• /
• pp.57-62
• /
• 1993

In this paper, both feasible power gain and power added efficiency at the operating center frequency of 12 GHz are stressed to design a power FET with double-heterjunction structure. The variable parameters or the design are the unit gate width, the gate length, the doping density of AlGaAs, the AlGaAs thickness, the spacer thickness, the Al mole fraction, and the GaAs well thickness. The results of simulation for the FET with 1.mu.m gate length show that the power gain and the power added efficiency are 10.2 dB and 36.3% at 12GHz, respectively. An extrapolation of the relation between current gain and unilateral gain yields a 17 GHz cutoff frequency and 43GHz maximum frequency of oscillation. The calculation of the current versus voltage characteristics show that the output power of the device is about 0.62W.

• Journal of Power Electronics
• /
• 제16권1호
• /
• pp.277-286
• /
• 2016

This paper offers two Maximum Power Point Tracking (MPPT) systems for Photovoltaic (PV) applications. The first MPPT method is based on a fixed frequency Model Predictive Control (MPC). The second MPPT technique is based on the Predictive Hysteresis Control (PHC). An experimental demonstration shows that the proposed techniques are fast, accurate and robust in tracking the maximum power under different environmental conditions. A DC/DC converter with a high voltage gain is obligatory to track PV applications at the maximum power and to boost a low voltage to a higher voltage level. For this purpose, a high gain Switched Inductor Quadratic Boost Converter (SIQBC) for PV applications is presented in this paper. The proposed converter has a higher gain than the other transformerless topologies in the literature. It is shown that at a high gain the proposed SIQBC has moderate efficiency.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2006년도 하계종합학술대회
• /
• pp.501-502
• /
• 2006

In this paper low power high gain amplifier is suitable for application in low power systems was designed and fabricated. The amplifier used both subthreshold bias for low power and positive feedback Q-enhancement technique for high gain. The amplifier used TSCM $0.18{\mu}m$ RF CMOS technology measures a power gain of 32.3dB, a quality factor of 366 and a power consumption of 3mW in a supply voltage of 1.8V.

• Journal of Power Electronics
• /
• 제11권4호
• /
• pp.599-605
• /
• 2011

This paper proposes a gain scheduling method that improves the stability of grid-connected systems employing an LCL-filter. The method adjusts the current controller gain through an estimation of the grid impedance in order to reduce the resonance that occurs when using an LCL-filter to reduce switching harmonics. An LCL-filter typically has a frequency spectrum with a resonance peak. A change of the grid-impedance results in a change to the resonant frequency. Therefore an LCL-filter needs a damping method that is applicable when changing the grid impedance for stable system control. The proposed method instantaneously estimates the grid impedance and observes the resonant frequency at the same time. Consequently, the proposed method adjusts the current controller gain using a gain scheduling method in order to guarantee current controller stability when a change in the resonant frequency occurs. The effectiveness of the proposed method has been verified by simulations and experimental results.

• 한국통신학회논문지
• /
• 제25권10B호
• /
• pp.1714-1721
• /
• 2000

In the mobile communication using DS-CDMA systems the problem of multiple user interference which reduce the performance is generated by multiple user access. In this paper to solve this problem we proposed the direct decision blind adaptive receiver with knowledge of only the desired user's spreading sequence. Simulation result present that the total user's power has equal gain The gain of signal to interference ratio for the proposed blind DD-LMS receiver has about 6[dB] than conventional receiver at additive white Gaussian noise and large gain at multipath channels. And when interference user's power has more large gain than desired user's power the gain of SIR for the proposed receiver has large value. And simulation result of bit error rate present that DD-LMS receiver has higher performance than LCCMA receiver. Thus the proposed blind DD-LMS receiver has robustness against interference of high power user and multipath channels.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2003년도 하계종합학술대회 논문집 Ⅲ
• /
• pp.1295-1298
• /
• 2003

The steam generator level in a PWR is very difficult to control particularly at low power. And the constant control gain and time value are not adaptive in steam generator level controller. In normal operation constant control gain and time value have no problem. But there is problem at low power. So variable control gains based on the temperature are required. The best control gain is decided by the experienced knowledge. A fuzzy gain tuner is used for the gain tuning. In the design of fuzzy gain-tuner processing, the experienced knowledge is employed for making fuzzy rules.