• Journal of the Korean Society for Precision Engineering
• /
• v.20 no.2
• /
• pp.199-208
• /
• 2003

Continuously variable transmission (CVT) mechanisms considered here combine the functions of a K-H-V type differential gear unit and a V-belt type continuously variable unit (CVU). As combining the functions of a K-H-V type differential gear unit and a V-belt type CVU, 24 different mechanisms are presented. Some useful theoretical formula related to speed ratio, power flow and efficiency are derived and analyzed. These mechanisms have many advantages which are the decrease of CVT size, the increase of overall efficiency, the extension of speed ratio range, and the generation of geared neutral.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.1
• /
• pp.174-179
• /
• 2013

This paper presents a capacitor loaded tunable bandpass chip filter using multiple split ring resonators (MSRRs) with two transmission zeros. To obtain high selectivity and minimize the chip size, asymmetric feed lines are adopted to make a pair of transmission zeros located on each side of passband. Compared with conventional filters using cross-coupling or source-load coupling techniques, the proposed filter uses only two resonators to achieve high selectivity through a pair of transmission zeros. In order to optimize selectivity and sensitivity (insertion loss) of the filter, the effect of the position of asymmetric feed line on transmission zeros and insertion loss is analyzed. The SOI-CMOS switched capacitor composed of metal-insulator-metal (MIM) capacitor and stacked-FETs is loaded at outer rings of MSRRs to tune passband frequency and handle high power signal up to +30 dBm. By turning on or off the gate of the transistors, the passband frequency can be shifted from 4GH to 5GHz. The proposed on-chip filter is implemented in 0.18-${\mu}m$ SOI CMOS technology that makes it possible to integrate high-Q passive devices and stacked-FETs. The designed filter shows miniaturized size of only $4mm{\times}2mm$ (i.e., $0.177{\lambda}g{\times}0.088{\lambda}g$), where ${\lambda}g$ denotes the guided wave length of the $50{\Omega}$ microstrip line at center frequency. The measured insertion loss (S21)is about 5.1dB and 6.9dB at 5.4GHz and 4.5GHz, respectively. The designed filter shows out-of-band rejection greater than 20dB at 500MHz offset from center frequency.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.14 no.1
• /
• pp.20-39
• /
• 2020

This paper considers a downlink multi-carrier cooperative non-orthogonal multiple access (NOMA) transmission, where no direct link exists between the far user and the base station (BS), and the communication between them only relies on the assist of the near user. Firstly, the BS sends a superimposed signal of the far and the near user to the near user, and then the near user adopts simultaneous wireless information and power transfer (SWIPT) to split the received superimposed signal into two portions for energy harvesting and information decoding respectively. Afterwards, the near user forwards the signal of the far user by utilizing the harvested energy. A minimum data is required to ensure the quality of service (QoS) of the far user. We jointly optimize power allocation, subcarrier allocation, time allocation, the power allocation (PA) coefficient and the power splitting (PS) ratio to maximize the number of data bits received at the near user under the energy causality constraint, the minimum data constraint and the transmission power constraint. The block-coordinate descent method and the Lagrange duality method are used to obtain a suboptimal solution of this optimization problem. In the final simulation results, the superiority of the proposed NOMA scheme is confirmed compared with the benchmark NOMA schemes and the orthogonal multiple access (OMA) scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.7A
• /
• pp.669-677
• /
• 2011

Superframe in IEEE 802.15.4 Standard is subdivided into an active period and an inactive period to reduce energy consumption. But communication nodes use same data transmission range in an active period, thus communication nodes spend a lot of energy to send data another nodes. In this paper, we proposed reduce energy consumption algorithm that nodes use different transmission power. Cordinator split transmission area into four group and transmit becon message to nodes. Nodes adjust transmission power according to becon message and wates lowe energy than normal nodes. We proposed energy-efficient cross layer protocol that have different PAN (Personal Area Network) by four range group.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.5
• /
• pp.1096-1106
• /
• 2013

This paper presents the control of a Permanent Magnet Electric Variable Transmission (PM-EVT) for Hybrid Electric Vehicles (HEVs). Consisting of two electric machines, the EVT realizes the power split function in an electromagnetic way rather than in a mechanical way. A specific PM-EVT has been designed for Toyota Prius II. The control scheme of the entire vehicle is deduced using the Energetic Macroscopic Representation methodology. The energy management strategy yields local control references. A specific attention is paid for the field weakening for wide speed range. Simulation results are provided to illustrate the EVT modeling and control.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.7 no.6
• /
• pp.182-197
• /
• 1999

Described in this paper is an optimal driving control algorithm which focused on the improvement of fuel economy and the minimization of pollutant emissions in the parallel type hybrid drivertrain system for transit bus. For the energy balance among components such as engine, induction machine and buttery, the algorithm for power split ration determine is proposed. When it is implemented in the hybrid electric control unit(HECU) , using the sub-optimal method and the approximate technique , it is possible to save the memory , to shorten the calculation time, and to achieve the efficient driving actually. A Shift strategy for automated manual transmission is the other side of the driving control algorithm. It enables to select the optimal gear by using several shift maps which were predefined from the proposed method in this paper, As a results of driving simulation, it is proved that these algorithms make the hybrid drivetrain system to reduce fuel consumption and emissions considerably and to have the ability to the efficient use of battery.

• ETRI Journal
• /
• v.34 no.6
• /
• pp.838-846
• /
• 2012

This paper proposes a cost-effective hybrid-type power budget extender (PBEx) that can provide a high power budget of over 45 dB in an asymmetric 10-Gb/s Ethernet passive optical network (10/1G-EPON). The hybrid-type 10/1G-EPON PBEx comprises a central office terminal (COT) and remote terminal (RT) module supporting four channels and uses a coarse wavelength division multiplexing (CWDM) technology between the COT and RT for a reduction of fiber cost and efficient access network design. The proposed 10/1G-EPON PBEx can provide over a 40-km reach and 128-way split per CWDM wavelength with no modification of a legacy 10/1G-EPON system and can satisfy the error-free service in $10^{10}$ packet transmission.

• Proceedings of the KIEE Conference
• /
• 2003.07a
• /
• pp.590-592
• /
• 2003

The presence of congestion in transmission system can reduce the market size and split bulk system into smaller system. Consequently, this creates the problem concerining Local Market Power and can be main reason for the inclose of practical market price. In this paper, a range of indices have been derived to quantify the degree of local market power through statistical analysis in the uniform pricing market. Application of the indices has been illustrated using the electricity market in Korea. The indices proposed in this paper seem to be effectively applied in electricity market under uniform pricing scheme.

• Journal of electromagnetic engineering and science
• /
• v.13 no.4
• /
• pp.259-262
• /
• 2013

This paper analyzes the effects of metamaterial slabs with negative permeability when applied to a two-loop wireless power transmission (WPT) system, both in theory and electromagnetic (EM) simulations. The analysis of magnetic flux focusing provided here assumes quasi-magnetostatics or magnetostatics. The slab structures with negative permeability have been realized using the periodically arrayed ring resonators (RRs) at 13.36MHz. Some examples with ideal lossless slabs of -1, -2, and -3 showed a great enhancement of WPT efficiencies when compared with the free space cases. However, practical lossy slabs made of planar copper RRs did not show significant enhancement of WPT efficiencies due to the relatively high losses in the ring resonator (or in the slab consisting of RRs) near the resonant frequency.

• Journal of the Korean Society of Safety
• /
• v.36 no.5
• /
• pp.10-17
• /
• 2021

The controversy over the risk of the human body being affected by electromagnetic fields emitted from 60 Hz power lines continues without end. There are currently no new studies or research progress being made in this direction that is notable, and the number of civil complaints is gradually increasing. The problem is that each study produces different results, among which the effect of exposure to magnetic fields on childhood leukemia is a major one. In Korea, an electrician who was maintaining a 22.9 kV power line died of leukemia, which has recently been recognized as an occupational disease. Methods to reduce magnetic fields from power lines include shielding with wire loops, incorporating split phases and compaction techniques, installing underground power lines, converting to high-voltage direct current (HVDC), and increasing the ground clearance of transmission towers. Depending on whether a separate power supply is needed or not, there are two types of wire loops: passive loop and active loop. Magnetic field reduction is currently done through underground power lines; however, the disadvantage of this process is high construction costs. Installing passive loops, with relatively low construction costs, leads to lower magnetic field reduction rates than installing underground cables and a weakness to not solving the landscape problem. This methodological study aims at designing methods and reducing the effects of 2-wire set loops-the simplest and most practical. Since the method proposed in this study has been designed after analyzing the distribution of complex electromagnetic fields near the expected loop installation location, a practical design can be implemented without the need for any difficult optimization programming.