• Journal of Drive and Control
• /
• v.17 no.4
• /
• pp.141-151
• /
• 2020

The aim of this study was to analyze the safety factor of range-shift gear pairs on multi-purpose agricultural implement machinery for an optimal design of a transmission system. Gear-strengths such as bending and contact stress and safety factors were analyzed under three load conditions: an equivalent engine torque at plow tillage, a rated engine torque, and the maximum engine torque. Root and contact safety factor were calculated to be 3.88, 5.14, 2.24, 2.11, 2.21, 0.99 and 0.78, 0.94, 0.65, 0.68, 0.84, 0.85, respectively, under equivalent engine torque condition at the plow tillage. The root and contact safety factor were calculated to be 1.91, 2.53, 1.10, 1.04, 1.07, 0.48 and 0.55, 0.66, 0.46, 0.48, 0.59, 0.59, respectively, under rated engine torque condition. The root and contact safety factor were calculated to be 1.60, 2.11, 0.92, 0.87, 0.90, 0.40 and 0.51, 0.61, 0.42, 0.44, 0.54, 0.54, respectively, under the maximum engine torque condition. The multi-purpose agricultural implement machinery could be conducted under plow tillage operation. However, gear specifications for tooth surface need modification because the gear surface would be broken at all driving conditions as safety factors are lower than 1.

• Journal of Advanced Navigation Technology
• /
• v.11 no.1
• /
• pp.17-23
• /
• 2007

This paper, describes the VDR physical layer design in VDL Mode-2 in order to meet the requirements of International standards. VDR's frequency band is 117.975~137MHz, and CSMA(Carrier Sense Multiple Access), D8PSK(Differential Eight Phase Shift Keyed), 25KHz's channel bandwidth use. The analysis of the isolated channel from near channels, sensitivity of the receiver, dynamic range of the receiver, linear of the transmitter and energy of spurious for linear and non-linear simulation as a requirement condition of performance of VDR and teaches the course of design. The transmitting power level should be lower than 5dB from Po1dB point and the selected IF frequency is 45MHz to suppress the spurious signals. The receiver designed has 4.5dB of Noise figure, 27.52dB of Es/No, Mixer isolation up to 30dB, IIP3 power of LNA up to +10dBm to minimize the intermodulation.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.10
• /
• pp.3439-3457
• /
• 2014

Clustering is an effective method for improving the performance of large scale mobile ad hoc networks. However, when the moving speed is very fast, the topology changes quickly, which leads to frequent cluster topology updates. The drastically increasing control overheads severely threaten the throughput of the network. SCBCS (Signal Characteristic Based Cluster Scheme) is proposed as a method to potentially reduce the control overheads caused by cluster formation and maintenance in aeronautical ad hoc networks. Each node periodically broadcasts Hello packets. The Hello packets can be replaced by data packets, which preserve bandwidth. The characteristics of the received packets, such as the Doppler shift and the power of two successive Hello packets, help to calculate the relative speed and direction of motion. Then, the link connection lifetime is estimated by the relative speed and direction of motion. In the clustering formation procedure, the node with the longest estimated link connection time to its one-hop neighbors is chosen as the cluster head. In the cluster maintenance procedure, re-affiliation and re-clustering schemes are designed to keep the clusters more stable. The re-clustering phenomenon is reduced by limiting the ripple effect. Simulations have shown that SCBCS prolongs the link connection lifetime and the cluster lifetime, which can reduce the topology update overheads in highly dynamic aeronautical ad hoc networks.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.38 no.1
• /
• pp.80-86
• /
• 2010

This paper describes the development result of S-band Transmitter of STSAT-3 by satellite research center(SaTReC), KAIST. STSAT-3 has two kinds of communication channels, S- band for Telemetry & Command and X-band for mission payload. S-band Transmiiter(STX) consist of modulator, frequency synthesizer, power amp and DC/DC converter. The modulation scheme of STX is FSK(Frequency Shift Keying). The interface between spacecraft OBC and STX is RS-422. The STX is based on modular design. The RF output power of STX is 1.5W(31.7dBm) and BER of STX is under 1E-5. The Test of STX is completed successfully such as functional Test and environmental(vibration, thermal vacuum) Test.

• The Journal of the Korea Contents Association
• /
• v.20 no.5
• /
• pp.585-594
• /
• 2020

After the launch of Jeju Special Self-Governing Province in 2006, a number of real estate development projects were carried out; the real estate industry has relatively largely grown as compared with other regions since 2011. This growth has slowed down in 2017, along with the increase of unsold houses and the short of its incoming population, causing its real estate market recession. This study analyzed the source of real estate industry growth in Jeju: either affected by national growth power or its regional competitiveness. This study applied Shift-Share Analysis and Growth Differential Analysis, by dividing the recovery period ('06~'10) and expansion period ('11~'16). According to the result, sales amount and the number of employees in the real estate industry in Jeju had grown in the recovery period based on the national growth power. Its regional competitiveness and stable industrial structure grew in the growth period. Development and subdividing of real estate contributed to the growth of the real estate industry in Jeju. On the other hand, management of real estate weakened its market.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.9
• /
• pp.668-676
• /
• 2018

In satellite communications, a modulation technique with a low peak-to-average power ratio, high transmission efficiency, and low bit error rate(BER) is required, and differential amplitude and phase shift keying(DAPSK) modulation technique has been appraised as a technology that meets these requirements. However, because conventional DAPSK modulation uses a regular constellation diagram, the Euclidean distance between the symbols in the inner concentric circles of the constellation are quite short. Such a characteristic degrades the BER. In this paper, we propose a DAPSK system that uses an efficient constellation assignment to improve the performance of existing DAPSK systems and evaluate the performance of the proposed scheme. From the simulation results, we confirm that the proposed 16-DAPSK system achieves an signal-to-noise ratio gain of 0.8 dB over the conventional approach at a BER condition of $10^{-4}$ when the number of symbols used in the symbol detector of the receiver is 2.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.11 no.1
• /
• pp.64-72
• /
• 1986

The error rate equation fo DS-BPSK(Direct Sequence Binary Phase Shift Keying) signal transmitted through the nonlinear satellite transponder has been derived in the cochannel interference and downlink Gaussian noise environment. The input to the satellite transponder is the superposition of DS-BPSK signal with one interfere which is a cochannel wide-band PN signal. The error rate performance of DS-BPSK system has been evaluated and shown in figures in terms of carrier to interference power ratio(CIR), downlink signal to noise power ratio(downlink SNR) and process gain. In the analysis, it has been shown that the use of a hard limiter in DS-BPSK satellite system leads to the generation of narrow-band intermodulation products which is independent of the process gain. Also it is known that the error rate performance can be improved in the low levels (below 10dB) of CIR as the CIR increase. As the process gain varies from 10 to 100 the curve gives the about 10 dB gain in downlink SNR to maintain a fixed error rate.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.10
• /
• pp.885-892
• /
• 2013

The main advantage of ESPAR antenna is that ESPAR antenna requires only a single RF chain for reduction of transceiver's hardware complexity, as compared to conventional MIMO system. In conventional MIMO system, each data symbol is mapped to each antenna. But, each data symbol is mapped to each orthogonal basis pattern in ESPAR antenna system. In this paper, we design beamspace MIMO system using ESPAR antenna with single RF chain for MIMO system of low-complexity and low power consumption. And then, we analyze performance of beamspace MIMO according to each PSK modulation. Performance of beamspace MIMO system is similar to performance of conventional MIMO system. As a result of analyzing the performance of beamspace MIMO system using higher-order PSK modulation. we can confirm that performance characteristic of beamspace MIMO system with low complexity and low power consumption is similar to digital communication of signal domain.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.10C
• /
• pp.1433-1443
• /
• 2004

The power line modem proposed in this paper transmits the remote control signal using CSK(Code Shift Keying) and DS/SS method. The CSK technique provides the increased capacity of transmission and robustness towards noise. Besides, the DS/SS technique provides protection against narrow-band Gaussian interference and multi-path interference. The modem supports full-duplex communication using FDD(Frequency Division Duplex) and the modem structure for forward link is same with that for reverse link. To switch each sub-controlled unit smoothly, 4/$\pi$-DQPSK is adopted for noncoherent demodulation. The PN code for spreading spectrum seues to divide each group which consists of sub-controlled units and Walsh code is used for the M-ary CSK technique. Each block is designed and verified with TMS320C5402 DSP. We show the superiority of the proposed method by analyzing numerically the system performance for the factors of the DS/SS and CSK method ullder additive white Gaussian noise and PBI.

• Journal of the Korean Society of Costume
• /
• v.55 no.2 s.92
• /
• pp.129-142
• /
• 2005

As more our society express their interests in strong and independent women on the onset of the 21st century when source of power shifts to knowledge and information, women with economic power are increasing in number, which is because demands for delicacy and objective Judgment known as unique qualities of woman who was deemed to be inferior to man in the past century are now in the rise in many professional sectors. The shift in public awareness of female image and capability is also being manifested recently by a new fashion style named New Women Power Dressing. Comparing the so-called new power dressing style with the female yuppie fashion of the 80s known to have marked the beginning of female power dressing, this study aims to define the uniqueness of women power dressing style of today, reanalyze the fashion style of today in reference to its predecessors and predict new fashion trend for the futurr. As a conclusion, both of the female yuppie style of the 80s and the new power dressing trend of the 2000s were found to stress manliness and showoff. Such characteristics were expressed in terms of focuses on both fitness and fashion style. However, the female yuppie look of the 80s and its successor of the 2000s showed significant difference in what they were intended to signify internally and how they were displayed externally.