• 전력전자학회논문지
• /
• 제20권2호
• /
• pp.152-159
• /
• 2015

In a weak grid condition, the precise grid impedance estimation is essential to guaranteeing the high performance current control and power transfer for a grid-connected inverter. This study proposes a precise estimation method for grid impedance by PQ variations by employing the variation method of reference currents. The operation principle of grid impedance estimation is fully presented, and the negative impact of the phase locked loop is analyzed. Estimation error by a synchronization angle in the park's transformation using the phase locked loop is derived. As a result, the variation method of reference currents for accurate estimation is introduced. The validation of the proposed method is verified through several simulation results and experiments based on a 2-kW voltage source inverter prototype.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제3권4호
• /
• pp.188-193
• /
• 2003

This paper describes a novel burst-mode clock and data recovery (CDR) circuit which can be used for 622Mbps burst mode applications. The CDR circuit is basically a phase locked loop (PLL) having two phase detectors (PDs), one for the reference clock and the other for the NRZ data, whose operations are controlled by an external control signal. This CDR was fabricated in a 1-poly 5-metal $0.25{\;}\mu\textrm{m}$ CMOS technology. Jitter generation, burst/continuous mode data receptions were tested. Operational frequency range is 320Mhz~720Mhz and BER is less than 1e-12 for PRBS31 at 622Mhz. For the same data sequence, the extracted clock jitter is less than 8ps rms. Power consumption of 100mW was measured without I/O circuits.

• 한국전자파학회논문지
• /
• 제27권7호
• /
• pp.635-645
• /
• 2016

본 논문에서는 주파수 잠금회로(FLL: Frequency Locked Loop)를 이용하여 발진기의 위상잡음을 개선할 수 있음을 보였다. 1차적으로 헤어-핀 공진기를 이용하여 전압제어발진기(VCO)를 제작하였다. 제작된 VCO는 발진주파수 5 GHz에서 위상잡음을 측정한 결과, 1 kHz offset 주파수에서 -53.1 dBc/Hz를 보였다. 위상잡음을 개선하기 위하여, VCO에 5 GHz 공진기로 구성된 주파수 검출기(frequency detector), 루프 필터, 전위변환기(level shifter)를 이용 궤환회로를 구성, 주파수 잠금회로를 구성하였다. 제작된 주파수 잠금회로는 5 GHz의 주파수에서 발진하고, 1 kHz offset 주파수에서 -120.6 dBc/Hz의 위상잡음을 보였다. 따라서 주파수 잠금회로를 이용, VCO의 위상잡음을 획기적으로 약 67.5 dB 개선할 수 있음을 보였다. 또한, 얻어진 주파수 잠금회로를 이용한 발진기의 위상잡음 성능은 수정발진기의 위상잡음과 비견할만한 것이다.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제7권1호
• /
• pp.11-19
• /
• 2007

This paper presents two novel compensation circuits for leakage current and power supply noise (PSN) in phase locked loop (PLL) using a nanometer CMOS technology. The leakage compensation circuit reduces the leakage current of the charge pump circuit which becomes more serious problem due to the thin gate oxide and small threshold voltage in nanometer CMOS technology and the PSN compensation circuit decreases the effect of power supply variation on the output frequency of VCO. The PLL design is based on a 32nm predictive CMOS technology and uses a 0.9V power supply voltage. The simulation results show that the proposed PLL achieves a 88% jitter reduction at 440MHz output frequency compared to the PLL without leakage compensator and its output frequency drift is little to 20% power supply voltage variations. The PLL has an output frequency range of $40M{\sim}725MHz$ with a multiplication range of 11023, and the RMS and peak-to-peak jitter are 5ps and 42.7ps, respectively.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2007년도 추계학술대회 논문집
• /
• pp.250-254
• /
• 2007

As photovoltaic(PV) power generation systems become more common, it will be necessary to investigate islanding detection method for PV systems. Islanding of PV systems can cause a variety of problems and must be prevented. However, if the real and reactive powers of the load and PV system are closely matched, islanding detection by passive methods becomes difficult. Also, most active methods lose effectiveness when there are several PV systems feeding the same island. The active frequency drift positive feedback method(AFDPF) enables islanding detection by forcing the frequency of the voltage in the island to drift up or down. In this paper the research for the minimum value of chopping fraction gain applied digital phase-locked-loop (DPLL) to AFDPF considering output power quality and islanding prevention performance are performed by simulation and experiment according to IEEE Std 929-2000 islanding test.

• 한국태양에너지학회 논문집
• /
• 제27권2호
• /
• pp.37-44
• /
• 2007

As photovoltaic(PV) power generation system becomes more common, it will be necessary to investigate islanding detection method for PV systems. Islanding of PV systems can cause a variety of problems and must be prevented. However, if the real and reactive power of the load and PV system are closely matched, islanding detection by Passive methods becomes difficult. Also, most active methods lose effectiveness when there are several PV systems feeding the same island. The active frequency drift positive feedback method(AFDPF) enables islanding detection by forcing the frequency of the voltage in the island to drift up or down. In this paper the research for the minimum value of chopping fraction gain applied digital phase-locked-loop (DPLL) to AFDPF considering output power quality and islanding prevention performance are performed by simulation and experiment according to IEEE Std 929-2000 islanding test.

• Journal of Power Electronics
• /
• 제15권1호
• /
• pp.216-226
• /
• 2015

Grid synchronization is one of the key techniques for the grid-connected power converters used in distributed power generation systems. In order to achieve fast and accurate grid synchronization, a new phase locked loop (PLL) is proposed on the basis of the complex filter matrixes (CFM) orthogonal signal generator (OSG) crossing-decoupling method. By combining first-order complex filters with relation matrixes of positive and negative sequence voltage components, the OSG is designed to extract specific frequency orthogonal signals. Then, the OSG mathematical model is built in the frequency-domain and time-domain to analyze the spectral characteristics. Moreover, a crossing-decoupling method is suggested to decouple the fundamental voltage. From the eigenvalue analysis point of view, the stability and dynamic performance of the new PLL method is evaluated. Meanwhile, the digital implementation method is also provided. Finally, the effectiveness of the proposed method is verified by experiments under unbalanced and distorted grid voltage conditions.

• Transactions on Electrical and Electronic Materials
• /
• 제11권1호
• /
• pp.20-23
• /
• 2010

The analog front end (AFE) of a radio frequency identification transponder using the ISO 14443 type A standard with a 100% amplitude shift keying (ASK) modulation is proposed in this paper and verified by circuit simulations and measurements. This AFE circuit, using a 13.56 MHz carrier frequency, consists of a rectifier, a modulator, a demodulator, a regulator, a power on reset, and a dynamically enabled digital phase locked loop (DPLL). The DPLL, with a charge pump enable circuit, was used to recover the clock of a 100% modulated ASK signal during the pause period. A high voltage lateral double diffused metal-oxide semiconductor transistor was used to protect the rectifier and the clock recovery circuit from high voltages. The proposed AFE was fabricated using the $0.18\;{\mu}m$ standard CMOS process, with an AFE core size of $350\;{\mu}m\;{\times}\;230\;{\mu}m$. The measurement results show that the DPLL, using a demodulator output signal, generates a constant 1.695 MHz clock during the pause period of the 100% ASK signal.

• 한국통신학회논문지
• /
• 제26권10B호
• /
• pp.1464-1469
• /
• 2001

본 논문에서는 디지털 하이브리드 위상고정루프(Digital Hybrid Phase-Locked Loop, DHPLL) 주파수 합성기 구조에서 고 순도 스펙트럼과 초고속 스위칭 속도를 위한 설계기술을 제안한다. D/A 변환기 출력으로 전압제어발진기(Voltage Controlled Oscillator, VCO)를 구동하는 개 루프(open-loop) 구성 방식과 기존 위상고정루프(Phase Locked Loop, PLL)의 폐 루프(closed-loop) 구성 방식을 혼합한 하이브리드 구조의 주파수 합성기를 고려하여, 시스템 변수(개 루프 대역과 위상 여유)와 성능 파라미터(정착시간, 위상 잡음, 그리고 최대 오버슈트(Max. overshoot)의 관계를 연구하였다. 그리고 이 관계를 통해 스펙트럼 순도와 스위칭 속도를 향상시키기 위한 최적의 3가지 설계방안을 제시한다. 컴퓨터 시뮬레이션 결과, 주파수 스위칭 과정에서 발생하는 최대 오버슈트가 0.0991%이고 완전 정상상태 도달시간은 0.288msec이다. offset 주파수 10KHz에서 위상 잡음은 -128.15dBc이다.

• 한국통신학회논문지
• /
• 제19권10호
• /
• pp.1973-1981
• /
• 1994

본 논문에서는 위상 고정 루프 PLL(Phase Locked Loop)의 궤환 성질을 이용한 Ku-band(10.95-11.70GHz)용 위상고정 유전체 공진 발진기를 설계 및 제작하였다. 직렬 궤환형의 유전체 공진 발진기를 제작한 후, 발진기의 주파수를 전압 제어하기 위해 전압 가변 캐패시터로 작용하는 바랙터 다이오드를 사용하여 전압제어 유전체 공진 발진기를 구현하였다. 이와 같이 제작된 전압제어 유전체 공진 발진기에 샘플링 위상비교기를이용하여 위상고정 유전체 공진 발진기를 제작하였다. 위상고정 유전체 공진 발진기는 X-band 주파수 대역의 전압제어 유전체 공진 발진기 신호를 샘플링 위상 비교기를 이용하여 VHF 대역의 기준 신호에 위상고정시켜 높은 주파수 안정도를 얻는 것으로 유럽형 FSS(Fixed Satellite Service)를 위한 10.00 GHz를 구현하였다. 측정 결과 본 논문의 위상고정 유전체 공진 발진기는 전압제어 유전체 공진 발진기보다 높은 주파수 안정도를 보였으며, 10.00 GHz에서 출력전력 10 dBm 이상이었고 carrier로 부터 10 KHz 벗어난 점에서 -80dBc/Hz의 위상 잡음을 얻었다.