• The Journal of Korean Physical Therapy
• /
• v.25 no.5
• /
• pp.297-302
• /
• 2013

Purpose: This study was conducted in order to investigate the kinematic gait parameter of lower extremities with different gait conditions (level walking, stair, ramp) in hemiplegic patients. Methods: Ten hemiplegic patients participated in this study and kinematic data were measured using a 3D motion analysis system (LUKOtronic AS202, Lutz-kovacs-Electronics, Innsbruk, Austria). Statistical analysis was performed using one-way repeated measure of ANOVA in order to determine the difference of lower extremity angle at each gait phase with different gait conditions. Results: Affected degree of ankle joint in the heel strike phase showed significant difference between level walking and climbing stairs, and toe off phase showed significant difference between level walking and climbing stairs, ramps, and climbing stairs. Affected degree of knee joint showed no significant difference in all attempts. Affected degree of hip joint in the toe off phase showed significant difference between level walking, ramps and stairs, and climbing ramps. Swing phase showed significant difference between sides for level walking and stairs, climbing ramps. Affected ankle joint of heel strike and toe off, and affected hip joint of toe off and the maximum angle of swing phase in the angle was increased. Unaffected side of the ankle joint, knee joint, and hip joint showed a significant increase in walking phase. Conclusion: These findings indicate that compared with level walking, different results were obtained for joint angle of lower extremity when climbing stairs and ramps. In hemiplegia patient's climbing ramps, stairs, more movement was observed not only for the non-affected side but also the ankle joint of the affected side and hip joint. According to these findings of hemiplegic patients when climbing stairs or ramps, more joint motion was observed not only on the unaffected side but also on the affected side compared with flat walking.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.41 no.6
• /
• pp.13-22
• /
• 2004

This study proposes a risk analysis methodology for information system security management in which the complexity on the procedure that the existing risk analysis methodology is reduced to the least. The proposed risk analysis methodology is composed of 3 phases as follows: beforehand processing phase, counter measure setting phase, post processing phase. The basic risk analysis phase is a basic security management phase in which fixed items are checked when the information security system is not yet established or a means for the minimum security control is necessary for a short period of time. In the detailed risk analysis phase, elements of asset a vulnerability, and threat are analysed, and using a risk degree production table produced from these elements, the risk degree is classified into 13 cases. In regard to the risk, the 13 types of risk degree will execute physical, administrative, and technical measures through ways such as accepting, rejecting, reducing, and transferring. Also, an evaluation on a remaining risk of information system is performed through a penetration test, and security policy set up and post management phase is to be carried out.

• Korean Institute of Interior Design Journal
• /
• v.18 no.6
• /
• pp.194-201
• /
• 2009

The purpose of this study is to develop basic data for the efficient space plan of the Department Store focusing on users by survey of preference to methods of plan considering the functional phase, the economical phase and the adaptable phase. The results are as follows : First, we could know that users had the low degree of satisfaction to the adaptable phase of space plan for Supporting Facilities in department stores at the present time. Second, we must have the appropriate space size by using structure, doors and windows for user's satisfaction. This is the method of plan considering the functional phase for Supporting Facilities. And we could think that the methods of using the center flow plan and the arrangement of two or three facing are good for user's satisfaction. Third, it will be efficient plan if we find methods to be cleaned the structure easily and to be changed and repaired the system furniture easily for management. that methods are to be considered the economical phase for Supporting Facilities. Forth, methods of plan considering the adaptable phase are to change the size of space by using the movable type furniture and the form of space by changing structure.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2002.11a
• /
• pp.161-164
• /
• 2002

In this paper, a design technique is introduced for designing a 360-degree linear analog phase shifter at 1.8㎓. Using tunable short-circuit terminated comb-line filters as reactive loads, the circuit gives a very small insertion loss(less than 0.1㏈) and an almost linear phase shifter over the filter bandwidth for the full 360-degree range. We were showed large phase variation with small capacitance variation in the quadrature hybrid coupler using tunable shorted terminated combline filters.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.33 no.11
• /
• pp.1347-1352
• /
• 2009

Magnetic force driven six degree-of-freedom active vibration isolation system is developed. The velocity sensor using an electromagnetic principle that is commonly used in the vibration control is investigated since its phase lead characteristic causes an instability problem for a low frequency vibration. A lag-type compensator is adopted to reduce the phase lead and the stability test is performed by using a Bode analysis. The performance of the AVIS is validated by comparing with the passive isolation system by using the frequency responses.

• International Journal of Contents
• /
• v.1 no.2
• /
• pp.35-38
• /
• 2005

This paper describes a design of simple and precision direction finder that can be adapted to shipboard or mobile vehicles used for Electronic support measure, ELINT and radio signal monitoring systems. The direction finding technology has improved with monolithic integrated circuit, linear array antennas, and interferometer. Interferometer uses the phase-comparison principle and has a good direction finding accuracy but it has an ambiguity problem. We suggest a simple ambiguity solver using phase-comparison technology with amplitude-comparison principle. The direction finding device that has been designed by the suggested method has 0.7 degree RMS error in azimuth angle and 0.6 degree RMS error in elevation angle in 0.5 - 2.0 GHz.

• Journal of applied mathematics & informatics
• /
• v.15 no.1_2
• /
• pp.251-264
• /
• 2004

We introduce a semidiscrete mixed finite element approximation for the single-phase linear Stefan problem and show the unique existence of the approximation. And the optimal rate of convergence in $L^2$ and $H^1$ norms are derived.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.420-423
• /
• 2003

A low temperature difference model Stirling engine is a small Stirling engine running with several degree of temperature difference without power output. In this study, the design parameters to give maximum power are discussed. As results, the phase angle is about 100 degree, and compression ratio is 1.5% of the ratio of heat source temperatures at maximum power condition.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.8
• /
• pp.1188-1195
• /
• 2022

The 6-port phase correlator consists of one in-phase power divider and three 3-dB 90-degree phase difference power dividers, and is mainly used in a demodulation circuit that determines the phase of an input signal. This paper proposes the wideband 6-port phase correlator that consists of an in-phase power divider using a wideband 2:1 impedance transformer with three 37.5-Ω coaxial cables, and a 3-dB 90-degree phase difference power divide using Wireline. The proposed wideband phase correlator fabricated at a center frequency of 1000MHz has the value of the input reflection coefficient(S₁₁ and S₂₂) -14dB or less in the frequency range of 640~1270MHz. Also, the signal transmission characteristic(S_i1), from the in-phase power divider input port to four output ports, has the amplitude of -6.5±0.6dB and the phase error of within ±3.4°, and the signal transmission characteristic(S_i2), from the 90 degree phase difference power divider input port to four output ports, has the amplitude of -6.1±0.6dB and the phase error of within ±6.2°.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2006.05a
• /
• pp.643-646
• /
• 2006

The popularity of OFDM systems is being increased because of high speed data transmission capability and the spectral efficiency characteristics. However, since OFDM systems are very sensitive to the phase noise, The interference among subcarriers and the total system noise can be increased seriously due to the degree of phase noise effects which can cause the orthogonality problems. Therefore, these phase noise effects were analyzed using the phase noise model by varying its parameters. Especially in this paper, The degree of system performance degradation was investigated for the OFDM systems applying the relatively simple transmit and receiver diversity.