• 한국통신학회논문지
• /
• 제37C권12호
• /
• pp.1245-1255
• /
• 2012

전파 교란에 취약한 GNSS 시스템을 위하여 다양한 항재밍 알고리즘들이 존재하며, 배열 안테나를 이용한 방식이 가장 좋은 성능을 보인다. 그 중 재머의 위치를 파악하기 위한 DOA 추정 알고리즘의 역할이 매우 중요하다. 그러나 헬기의 경우 로터의 회전에 의해 정지 동체와 달리 진폭과 위상이 시간에 따라 변하는 무선 채널이 형성되어 기존 항재밍 알고리즘의 성능에 영향을 미칠 수 있다. 본 논문에서는 로터 영향을 안테나 간 상관성에 따른 네 개의 시나리오로 모델링하였으며 로터 영향에 의해 DOA 추정 알고리즘의 성능이 저하되고 JNR에 관계없이 성능이 포화됨을 확인하였다. 이의 해결을 위해 평균화 방식을 이용하였을 때 추정 샘플의 누적 수가 많아질수록 성능이 향상되며 이동 평균 방식을 함께 이용할 경우 유사한 성능을 내면서도 필요한 메모리 수를 줄이고 DOA 추정 변동량이 완화됨을 확인하였다.

• 전기전자학회논문지
• /
• 제26권2호
• /
• pp.287-291
• /
• 2022

일반적으로 V2X 통신은 차량의 고속이동에 따라 물리계층 채널 임펄스 응답의 진폭과 위상정보가 시간 및 주파수에서 빠르게 변화하기 때문에, 수신단에서 이러한 채널을 정확하게 추정하는 것이 매우 어려운 일이다. 이러한 문제를 효과적으로 극복하기 위해 최근 패킷 내부에 주기적으로 미드앰블을 삽입하는 미드앰블 기반 채널추정 방식이 고려되고 있다. 하지만 단순히 미드앰블을 삽입하는 방법은 미드앰블의 수가 증가할수록 성능 이득 대비 주파수 효율이 빠르게 감소하는 문제점을 가지고 있다. 본 논문에서는 이러한 문제점을 해결하기 위해 기존의 데이터 파일럿 기반 채널추정방법과 미드앰블 방법을 결합한 새로운 양방향 평균화 채널추정기법을 제안한다. 제안하는 기법은 이러한 평균화 과정과 미드앰블의 위치 최적화를 통해 보다 적은 수의 미드앰블로 채널 추정의 정확도를 비약적으로 향상시킬 수 있다. 마지막으로 미드앰블의 수에 따른 패킷오류율 시뮬레이션을 통해 주파수 효율 관점에서 제안하는 기법의 우수성을 입증한다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1991년도 하계학술대회 논문집
• /
• pp.720-725
• /
• 1991

In this thesis, the lead-lag compensator is designed to improve output characteristics of flyback zero voltage switching quasi-resonant converters. The switch and the diode are assumed ideally. And the SMPS is modelled by state equations with four operation modes. And the model for controller design is also achived by using a state space averaging method, which is continuous time average of state variables every period. The lag, the lead and the lead-lag compensator is designed the SMPS respectively. The time domain analysis and the frequency domain analysis are done for each compensated circuit. It is possible increasing the phase margin and improving the transient response by the compensators. The phase lag compensator has small overshoot comparatively. But the bandwidth is narrower than the others, so it has longest settling time. For the phase lead compensator, the response come to steady-state within short period. But the overshoot is the largest due to its large peak gain. Finally, the phase lead-lag compensator has medium characteristics in the overshoot and the settling time.

• 한국조명전기설비학회지:조명전기설비
• /
• 제7권6호
• /
• pp.34-41
• /
• 1993

전력 수요가 증가함에 따라 전력용 변압기의 용량이 커지고, 따라서 변압기사고의 파급효과가 커지게 된다. 본 논문은 전력용 변압기의 절연 열화에 의한 사고를 예방진단하기 위한 부분방전의 초음파 측정 기술을 응용하여, 초음파-초음파 측정법에 대한 부분방전점의 위치검출법을 연구하였다. 정확도를 높이기 위해 상호상관함수를 이용할 것을 제안하였으며 모의변압기에서 실험한 결과 만족할 만한 결과를 얻었다.

• Journal of Power Electronics
• /
• 제17권5호
• /
• pp.1268-1277
• /
• 2017

Three-phase pulse width modulation (PWM) rectifiers are usually designed under the assumption of ideal ac power supply and input inductance. However, non-ideal circuit parameters may lead to a voltage collapse of PWM rectifiers. This paper investigates the mechanism of voltage collapse in three-phase PWM rectifiers. An analytical stability boundary expression is derived by analyzing the equilibrium point of the averaging state space model, which can not only accurately locate the voltage collapse boundary in the circuit parameter domain, but also reveal the essential characteristic of the voltage collapse. Results are obtained and compared with those of the trial-error method and the Jacobian method. Based on the analysis results, the system parameters can be divided into two categories. One of these categories affects the critical point, and other affects only the instability process. Furthermore, an effective control strategy is proposed to prevent a vulnerable system from being driven into the instability region. The analysis results are verified by the experiments.

• Journal of Advanced Marine Engineering and Technology
• /
• 제37권7호
• /
• pp.729-736
• /
• 2013

The turbulent properties in a mixed statistically stationary flow were investigated experimentally by a pseudo stereoscopic PIV. In order to validate the experimental results, the profiles of the turbulent kinetic energy were evaluated with the flow features. A mechanical agitator having 6 blades was installed at the bottom of the mixing tank (D=60cm, H=60cm). The agitator was rotated with 80rpm clockwise and counter-clockwise. For the measurements, three cameras were used and all were synchronized. The images captured by one of the three cameras was used for the measurement of rotational speed, and the images captured by the other two cameras were used to measure three dimensional components of velocity vectors. All vectors captured at the same rotational angle were phase averaged to construct three-dimensional vector fields to reconstruct the spatial distribution of the flow properties. It was seen that the jet scrolling along the tank was the main source of mixing.

• 대한기계학회논문집
• /
• 제18권9호
• /
• pp.2454-2462
• /
• 1994

The effects of thermal stratification on the flow of a stratified fluid past a heated circular cylinder were examined in a wind tunnel. Turbulent intensities, rms values of temperature and turbulent convective heat flux distributions in the heated cylinder wake with and without thermal stratification were measured by using a hot-wire and cold-wire combination probe. A phase averaging method was also used to estimated coherent motion in the near wake. It is found that the vertical turbulent motion in the stably stratified flow case dissipates faster than that of the neutral case, i.e., vertical growth of vortical structure is suppressed under the strongly stratified condition. The coherent motion of temperature makes a large contribution like velocity coherent motion. However, the coherent motions of temperature fluctuation become very different with the change of experimental conditions, though the velocity coherent motions are quite similar in all experimental conditions.

• 대한기계학회논문집B
• /
• 제22권2호
• /
• pp.153-161
• /
• 1998

This study describes the results of the analysis of measured rotating stall signal in a centrifugal compressor with vaneless diffuser. Unsteady flow and rotating stall in vaneless diffuser were investigated by measuring of unsteady velocity fluctuation using hot-wire anemometer. Experiments were carried out in several impeller rotating speeds, at different radius ratios. Single hot -wire was used to study the characteristics of rotating stall. As a result, the abrupt rotating stall was detected at all measured impeller rotating speeds and the several flow coefficients which are less than 0.16. The number of the stall cell was one at all measured rotational speeds, and the rotating direction was the same as that of the impeller. As the flow rate decreased, the profile of the phase averaged radial velocity component with time changed from a sawtooth to a sine wave.

• Current Optics and Photonics
• /
• 제7권6호
• /
• pp.708-713
• /
• 2023

A robust all-fiber nonlinear amplifying loop-mirror-based mode-locked femtosecond laser is demonstrated. Power-dependent nonlinear phase shift in a Sagnac loop enables stable and power-efficient mode-locking working as an artificial saturable absorber. The pump power is adjusted to achieve the lowest intensity noise for stable long-term operation. The minimum pump power for mode-locking is 180 mW, and the optimal pump power is 300 mW. The lowest integrated root-mean-square relative intensity noise of a free-running mode-locked laser is 0.009% [integration bandwidth: 1 Hz-10 MHz]. The long-term repetition-rate instability of a free-running mode-locked laser is 10^-7 over 1,000 s averaging time. The repetition-rate phase noise scaled at 10-GHz carrier is -122 dBc/Hz at 10 kHz Fourier frequency. The demonstrated method can be applied as a seed source in high-precision real-time mid-infrared molecular spectroscopy.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2013년도 추계학술대회
• /
• pp.343-345
• /
• 2013

본 논문에서는 125 MHz 동작 주파수에서 51개 위상의 클록을 출력하는 위상 고정 루프(phase-locked loop: PLL)을 제안한다. 제안된 위상 고정 루프는 125 MHz 주파수의 51-위상 클록을 출력하기 위해서 저항으로 연결된 3개의 전압제어발진기 (voltage controlled oscillator: VCO)를 이용한다. 각 전압제어발진기는 17단의 delay-cell로 구성되며, 3 개의 전압제어발진기를 연결하는 저항을 통해 동일한 위상차를 가지는 51개 위상 클록을 구현한다. 제안된 위상 고정 루프는 1.0 V의 공급전압을 이용하는 65 nm CMOS 공정에서 설계되었으며, 125 MHz 동작 주파수에서 시뮬레이션된 DNL과 peak-to-peak jitter는 각각 +0.0016/-0.0020 LSB와 1.07 ps이다. 제작된 위상 고정 루프의 면적과 전력 소모는 각각 $290{\times}260{\mu}m^2$과 2.5 mW이다.