• Progress in Superconductivity
• /
• v.11 no.2
• /
• pp.158-161
• /
• 2010

We measured the critical current of a Cooper pair transistor consisting of two Josephson junctions and a gate electrode. The Cooper pair transistors were fabricated by using electron-beam lithography and double-angle evaporation technique. The Gate voltage dependence of critical current was measured by observing voltage jumps at various gate voltages while sweeping bias current. The observed oscillation was 2e-periodic, which shows the Cooper pair transistor had low level of quasiparticle poisoning.

• Aerospace Engineering and Technology
• /
• v.4 no.2
• /
• pp.117-125
• /
• 2005

Generally, the inertial navigation and guidance unit uses AF(Analog-to-Frequency) converters which convert analog signals into frequency signals to enhance a measurement accuracy of gyroscope and accelerometer outputs. The confidence level of AF converter is guaranteed by a prudential decision of calibration procedure and a performance of periodic calibration test. In this paper, we focus on the synchronous charge balance type AF converter which has a separate positive or negative current input and its calibration method is described. The calibration tests are classified into the scale factor error calibration and the bias calibration. These tests are automatically performed by the calibration program.

• Journal of radiological science and technology
• /
• v.16 no.1
• /
• pp.101-106
• /
• 1993

In order to assure safety of both patient and operator, and to provide uniform quality radiographs, it is necessary to perform periodic calibration of diagnostic X-ray equipment. A basic parameter of diagnostic equipment's and its image sharpness is the size(and shape the energy distribution) of the focal spot as viewed along the central X-ray beam. This size determines the resolution possible with the equipment and also determines the heat characteristics of an anode. A fine focus tube gives high resolution but causes high local heating of target. In past, the pin-hole and star pattern image measurement for evaluation of resolution have been widely used, but it produced blurring and inaccuracy of image. So newly inverted Ug-meter has advantage in more convenient measurement method and less out-put bias than other image measurement. The authors intended to compare measured focal size between Ug-meter and focal spot test tool, changed state from setting to now of units.

• The Journal of Asian Finance, Economics and Business
• /
• v.9 no.6
• /
• pp.151-158
• /
• 2022

Even after three decades of economic reforms, India's labor market is characterized by stark inter-gender differences in terms of both participation rate and working time. Identification of the causes is necessary to remove the disparity and unequal sharing of economic opportunities to make way for women's empowerment. This research attempts in that direction, examining the prevalence of these inequities in rural areas of North-East Indian states using unit-level data from the 2017-18 Periodic Labour Force Survey (PLFS). The methodology for the estimation here is based on Blinder- Oaxaca decomposition method after correcting for sample bias forwarded by Heckman. The analysis shows that in both labor force participation and the wage gap, the females in the region lag behind their male counterparts by a huge margin. Further, the analysis shows that one of the main factors leading to the difference is the disparities in human capital assets. On top of female educational enrollment being low, there is also a huge lack of higher educational attainment, while males have accomplished much better in both the parameters. Moreover, the presence of social stigma against women working and discrimination put the female labor outcomes in a gloomy state.

• Korean Journal of Remote Sensing
• /
• v.38 no.5_3
• /
• pp.953-966
• /
• 2022

Since aerosols adversely affect human health, such as deteriorating air quality, quantitative observation of the distribution and characteristics of aerosols is essential. Recently, satellite-based Aerosol Optical Depth (AOD) data is used in various studies as periodic and quantitative information acquisition means on the global scale, but optical sensor-based satellite AOD images are missing in some areas with cloud conditions. In this study, we produced gap-free GeoKompsat 2A (GK-2A) Advanced Meteorological Imager (AMI) AOD hourly images after generating a Random Forest based gap-filling model using grid meteorological and geographic elements as input variables. The accuracy of the model is Mean Bias Error (MBE) of -0.002 and Root Mean Square Error (RMSE) of 0.145, which is higher than the target accuracy of the original data and considering that the target object is an atmospheric variable with Correlation Coefficient (CC) of 0.714, it is a model with sufficient explanatory power. The high temporal resolution of geostationary satellites is suitable for diurnal variation observation and is an important model for other research such as input for atmospheric correction, estimation of ground PM, analysis of small fires or pollutants.

• Journal of Advanced Navigation Technology
• /
• v.13 no.3
• /
• pp.399-405
• /
• 2009

This paper proposes a design of attenuator based on meta-material structure and its application. The unit-cell attenuator based on the lossy transmission line consists of the CRLH(Composite Right/Left Handed) transmission line and PIN diodes to be controlled internal loss according to diode bias voltage to change resistance of diode. Also, to reduce the initial losses, there is used parallel connection of PIN diodes. To increase attenuations, it is connected a cascade unit-cell of attenuator with periodic structure. The attenuation quantities of unit-cell are about 10dB and phase variations are 15o maximum at 1.5 GHz ~ 2.5 GHz. Also, its application is represented a vector modulator.

• Fire Science and Engineering
• /
• v.32 no.4
• /
• pp.1-6
• /
• 2018

As a preliminary study to quantify the measurement uncertainty of the Schmidt-Boelter type heat flux gauge, the present study has been conducted to evaluate the measurement error due to the calibration constant supported by manufacturer. Calibrations of heat flux gauges are performed at NIST Fire Research Division using a calibration facility with heat source of a 2000 W halogen-tungsten filament lamp and the calibration constant is obtained by comparing the response of the reference and a standard heat flux gauge at the same irradiance conditions. Calibration for heat flux gauges made by three different manufacturers is compared with their factory calibration constant. Relative error due to fluctuation of output signal from heat flux gauges does not exceed 1% of the mean value and the relative error between calibration of this study and factory calibration constant ranged from 1.5% to 14.3%. The present study shows that a continuous and periodic calibration is necessary for accurate heat flux measurement.

• Journal of the Korean Vacuum Society
• /
• v.9 no.3
• /
• pp.290-295
• /
• 2000

In order to utilize as a pre-ionization means for reproducible ohmic plasma on KAIST-TOKAMAK, a simple, safe, economical and continuous microwave source has been developed using a home kitchen micro-wave oven. The magnetron used in the study can provide 500 W of power at 2.45 GHz. A conventional magnetron in a home kitchen microwave oven generates microwave for 8 ms at every 16 ms periodically due to the periodic (60 Hz) high voltage applied to the magnetron cathode. In order to generate continuous microwave which is suitable for tokamak pre-ionization, the magnetron operation circuit has been modified using a DC high voltage (5 kV, 1 A) power supply. It provides high-voltage with small ripple for magnetron cathode bias. Using the developed magnetron system, electron cyclotron resonace heated (ECH) plasmas were produced and the characteristics of the system were studied by diagnosing the ECH plasma using Langmuir probe and $H_{\alpha}$ emission diagnostics.

• Management & Information Systems Review
• /
• v.35 no.1
• /
• pp.51-68
• /
• 2016

In this paper, we aim to analyze the effect of accounting policy change subsequent to the adoption of K-IFRS in Korea, whereby the firms are required to recognize impairment losses on goodwill on a periodic basis rather than to amortize over a specific period. As a principle-based accounting standard, the K-IFRS expands the scope of fair value measurement with a view to enhance the relevance and timeliness of accounting information. In the same vein, intangibles with indefinite useful life, of which goodwill is an example, are subject to regulatory impairment tests at least once a year. Related literature on the impact of mandatory change in goodwill policy document that impairment recognition is more likely to be practiced opportunistically, mainly because managers have a greater discretion to conduct the tests under K-IFRS. However, existing literature examined the frequency and/or magnitude of the goodwill impairment before versus after the K-IFRS adoption, failing to notice the impairment symptoms at individual firm level. Borrowing the definition of impairment symptoms suggested by Ramanna and Watts(2012), this study performs a series of tests to determine whether the goodwill impairment recognition achieves the goal of communicating timelier information under the K-IFRS regime. Using 947 firm-year observations from domestic companies listed in KRX and KOSDAQ markets from 2008 to 2011, we document overall delays in recognizing impairment losses on goodwill after the adoption of K-IFRS relative to prior period, based on logistic and OLS regression analyses. The results are qualitatively similar in robustness tests, which use alternative proxy for goodwill impairment symptom. Afore-mentioned results indicate that managers are likely to take advantage of the increased discretion to recognize the impairment losses on goodwill rather than to provide timelier information on impairment, inconsistent with the goal of regulatory authority, which is in line with the improvement of timeliness and relevance of accounting information in conjunction with the full implementation of K-IFRS. This study contributes to the extant literature on goodwill impairment from a methodological viewpoint. We believe that the method employed in this paper potentially diminishes the bias inherent in researches relying on ex post impairment recognition, by conducting tests based on ex ante impairment symptoms, which allows direct examination of the timeliness changes between before and after K-IFRS adoption.

• Journal of the Korean Vacuum Society
• /
• v.18 no.2
• /
• pp.108-115
• /
• 2009

The superlattice infrared photodetector (SLIP) with an active layer of 8/8-ML InAs/GaSb type-II strained-layer superlattice (SLS) of 150 periods was grown by MBE technique, and the proto-type discrete device was defined with an aperture of $200-{\mu}m$ diameter. The contrast profile of the transmission electron microscope (TEM) image and the satellite peak in the x-ray diffraction (XRD) rocking curve show that the SLS active layer keeps abrupt interfaces with a uniform thickness and a periodic strain. The wavelength and the bias-voltage dependences of responsivity (R) and detectivity ($D^*$) measured by a blackbody radiation source give that the cutoff wavelength is ${\sim}5{\mu}m$, and the maximum Rand $D^*$ ($\lambda=3.25{\mu}m$) are ${\sim}10^3mA/W$ (-0.6 V/13 K) and ${\sim}10^9cm.Hz^{1/2}/W$ (0 V/13 K), respectively. The activation energy of 275 meV analyzed from the temperature dependent responsivity is in good agreement with the energy difference between two SLS subblevels of conduction and valence bands (HH1-C) involving in the photoresponse process.