• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2008.03a
• /
• pp.671-679
• /
• 2008

The effect of Pre-cooled Turbojet Engine installation and nozzle exhaust jet on Hypersonic Turbojet EXperimental aircraft(HYTEX aircraft) were investigated by three-dimensional numerical analyses to obtain aerodynamic characteristics of the aircraft during its in-flight condition. First, simulations of wind tunnel experiment using small scale model of the aircraft with and without the rectangular duct reproducing engine was performed at M=5.1 condition in order to validate the calculation code. Here, good agreements with experimental data were obtained regarding centerline wall pressures on the aircraft and aerodynamic coefficients of forces and moments acting on the aircraft. Next, full scale integrated analysis of the aircraft and the engine were conducted for flight Mach numbers of M=5.0, 4.0, 3.5, 3.0, and 2.0. Increasing the angle of attack $\alpha$ of the aircraft in M=5.0 flight increased the mass flow rate of the air captured at the intake due to pre-compression effect of the nose shockwave, also increasing the thrust obtained at the engine plug nozzle. Sufficient thrust for acceleration were obtained at $\alpha=3$ and 5 degrees. Increase of flight Mach number at $\alpha=0$ degrees resulted in decrease of mass flow rate captured at the engine intake, and thus decrease in thrust at the nozzle. The thrust was sufficient for acceleration at M=3.5 and lower cases. Lift force on the aircraft was increased by the integration of engine on the aircraft for all varying angles of attack or flight Mach numbers. However, the slope of lift increase when increasing flight Mach number showed decrease as flight Mach number reach to M=5.0, due to the separation shockwave at the upper surface of the aircraft. Pitch moment of the aircraft was not affected by the installation of the engines for all angles of attack at M=5.0 condition. In low Mach number cases at $\alpha=0$ degrees, installation of the engines increased the pitch moment compared to no engine configuration. Installation of the engines increased the frictional drag on the aircraft, and its percentage to the total drag ranged between 30-50% for varying angle of attack in M=5.0 flight.

• Journal of Animal Science and Technology
• /
• v.44 no.1
• /
• pp.135-144
• /
• 2002

An experiment was conducted to evaluate a ventilation system, which was devised to encourage farmers to use the enclosed growing and finishing pig housing system. A roof-air-entry ventilation system in winter and a side-wall-air-entry system in summer were evaluated. Air flow rate on the floor level which is the low part of pen and the living area of pigs in the enclosed growing and finishing pig house during winter was measured at 0 to 0.19 m/s at the minimum ventilation efficiency of 1,440 $m^{3}/h$. During summer the air flow rate was detected at 0.07 to 0.42 m/s at the maximum ventilation efficiency of 24,000 $m^{3}/h$. Therefore, it is concluded that the side-wall ventilation system is suitable for growing and finishing pigs in the enclosed house during the days of mid-summer and the roof-ventilation system was suitable during the coldest days of mid-winter. In addition, although the enclosed pig house has the system in which air exhausts through only one side wall, air should enter through both-side walls for the better ventilation performance.

• Journal of Animal Science and Technology
• /
• v.48 no.3
• /
• pp.467-478
• /
• 2006

Maintenance of an optimal air quality in the enclosed pig building is potentially important in terms of pig performance and farmer health. The objective of this on-site experiment is to evaluate and compare efficiencies of currently utilized biological additives to reduce odor emissions from the enclosed pig building. As a result, generally all the additives except for salt water, artificial spice and essential oil were proved ineffective in reducing odor generation. The beneficial effects of salt water, artificial spice and essential oil on odor reduction were highlighted on ammonia, odor intensity and offensiveness, and sulfuric odorous compounds, respectively. To efficiently utilize odor masking agent such as the artificial spice, ventilation rate should keep slightly lower than the optimal level. Essential oil functioned well as not only masking agent but also antimicrobial agent for reducing odor. To precisely quantify odor concentration, it should be measured by not the odor sensor but the olfactometry technique.

• Korean Journal of Poultry Science
• /
• v.32 no.3
• /
• pp.219-224
• /
• 2005

This study was carried out to investigate the effect of feldspar on laying Performance and e99 qualify in hens. A total of 96 'Tetra Brown' layers were assigned to 4 treatments in a completely randomized design. Each treatment consisted 4 replicates accommodating 6 layers per replication. Experiment diets were a control diet without feldspar and supplemented 0.5, 1.0 and $1.5\%$ feldspar. The egg Production rate was significantly increased in layers 134 diets supplemented 0.5 and $1.0\%$ feldspar compared to that of control (P<0.05). Egg weight, egg mass, feed intake, feed conversion ratio, egg shell strength and egg yolk color were not significantly different among the treatments (P>0.05). The haugh unit and blood spot of the eggs were significantly increased in $1.5\%$ feldspa. diets compared to that of control (p<0.05). However, the albumen index and meat spot in the eggs were not statistically different among treatments (P>0.05). Sensory evaluation traits were not significantly differed in terms of appearance, color, texture flavor and overall acceptability of eggs (P>0.05). The juiciness of boiled eggs was significantly increased in eggs of birds fed $1.0\%$ feldspar diets(P>0.05).

• KIPS Transactions on Software and Data Engineering
• /
• v.4 no.10
• /
• pp.465-472
• /
• 2015

We propose a novel plane detection in disparity space and evaluate its performance. Our method simplifies and makes scenes in disparity space easily dealt with by approximating various surfaces as planes. Moreover, the approximated planes can be represented in the same size as in the real world, and can be employed for obstacle detection and camera pose estimation. Using a stereo matching technique, our method first creates a disparity image which consists of binocular disparity values at xy-coordinates in the image. Slants of disparity values are estimated by exploiting a line simplification algorithm which allows our method to reflect global changes against x or y axis. According to pairs of x and y slants, we label the disparity image. 4-connected disparities with the same label are grouped, on which least squared model estimates plane parameters. N plane models with the largest group of disparity values which satisfy their plane parameters are chosen. We quantitatively and qualitatively evaluate our plane detection. The result shows 97.9%와 86.6% of quality in our experiment respectively on cones and cylinders. Proposed method excellently extracts planes from Middlebury and KITTI dataset which are typically used for evaluation of stereo matching algorithms.

• Journal of the Korea Concrete Institute
• /
• v.15 no.1
• /
• pp.35-42
• /
• 2003

To use ferro copper slag as aggregate in the construction, an evaluation upon the two kinds of ferro copper slag being produced was conducted to determine the basic physical, and mechanical properties, chemical component and environmental noxiousness. As a result of experiment, it was found that two kinds of ferro copper slag satisfies the physical and mechanical properties of aggregate, prescribed in KS F 2526, and that in the result of noxious heavy metal eruption test by single bach extraction, no eruption of noxious heavy metal was detected or the eruption was far below the reference value. And mortar test was conducted by replacing sand of 25, 50, 75, 100% and the performance level was presented upon reviewing the fluidity property and variable aspects of unit weight. The increase of strength in accordance with replacement rate of sand was found to be the below than the equivalent level compared to the testing specimens that did not use ferro copper slag, but those of 25% replacement rate was above than 0%. Thus, two kinds of ferro copper slag, produced in the domestic, were found to be possessing the enough physical properties to use as concrete aggregate assuming that used with sand and in particular, it was reviewed to be advantageous in manufacturing concrete or mortar that requires weight.

• The Journal of the Korea Contents Association
• /
• v.12 no.4
• /
• pp.40-51
• /
• 2012

Online discussion bulletin in Korea is not only a specific place where user exchange opinions but also a public sphere through which users discuss and form public opinion. Sometimes, there is a heated debate on a topic and any article becomes a political or sociological issue. In this paper, we propose how to analyze the popularity of articles by collecting the information of articles obtained from two well-known discussion forums such as AGORA and SEOPRISE. And we propose a prediction model for the article popularity by applying the characteristics of subject articles. Our experiment shown that the popularity of 87.52% articles have been saturated within a day after the submission in AGORA, but the popularity of 39% articles is growing after 4 days passed in SEOPRISE. And we observed that there is a low correlation between the period of popularity and the hit count. The steady increase of the hit count of an article does not necessarily imply the final hit count of the article at the saturation point is so high. In this paper, we newly propose a new prediction model called 'baseline'. We evaluated the predictability for popular articles using three models (SVM, similar matching and baseline). Through the results of performance evaluation, we observed that SVM model is the best in F-measure and precision, but baseline is the best in running time.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.26 no.3
• /
• pp.173-182
• /
• 2013

The building design projects which are being proceeded nowadays pursue a complex and various shape of structures, escaping from the traditional and regular shape of buildings. In this new trend of the architecture, there rises a demand of the research in the structural engineering for the effective realization of such complex-shaped buildings which disassembles the orthogonality of frames. As a distinguished characteristics of the buildings in a complex-shape, there frequently are inclined columns included in the structural frame. The inclined column causes extra axial force and bending moment at the beam-column connection so it is necessary to assess those effects on the structural behavior of the frame and the connection by experiment or analysis. However, with comparing to the studies on the normal beam-column connections, the inclined column connections have not been studied sufficiently. Therefore, this study evaluated the beam-column connections having an inclined column using nonlinear and finite element analysis method. In this paper, steel moment frames having inclined columns were analyzed by the nonlinear pushover analysis to check the global behavior and beam-column connection models were analyzed by the finite element analysis to check the buckling behavior and the fracture potentials.

• School Mathematics
• /
• v.13 no.1
• /
• pp.127-153
• /
• 2011

The purpose of this study was to investigate the effect of peer tutoring on mathematical inclination and mathematical communication ability of peer tutor. For the purpose of this study, research questions were established as follows: 1. How does peer tutoring affect to the mathematical inclination of peer tutors? 2. How does peer tutoring affect to the mathematical communication ability of peer tutors? To answer the research questions, four 5th grade peer tutors were selected for qualitative case study in an elementary school located in Goyang-si, Gyeonggi-do. Before and after 11 weeks of peer tutoring in their mathematics classes, mathematical inclination, mathematical communication ability of peer tutors were examined. For qualitative analysis, peer tutors were asked to complete worksheets, self-evaluation, journal for their peer tutoring in daily basis during the experiment. By comparing the scores in mathematical inclination test and mathematical communication test before and after the treatment and analyzing the data gathered for qualitative analysis, the conclusions were drawn as follows: First, Peer tutoring has positive effects on the mathematical inclination of peer tutors. Scores for mathematical inclination of peer tutors after the treatment increased and qualitative analysis showed positive change in their attitude toward mathematics. Second, Peer tutoring has positive effects on the mathematical communication ability of peer tutors. Scores in the performance assessment for mathematical communication ability of peer tutors after the treatment increased. Also qualitative analysis showed that peer tutors tried to develop various ways to solve a problem and explained them to their peer tutee sophisticatedly.

• Journal of KIISE:Information Networking
• /
• v.32 no.3
• /
• pp.318-326
• /
• 2005

This paper presents the image feature extraction method and the image classification technique to select the harmful image flowed from the Internet by grade of image contents such as harmlessness, sex-appealing, harmfulness (nude), serious harmfulness (adult) by the characteristic of the image. In this paper, we suggest skin area detection technique to recognize whether an input image is harmful or not. We also propose the ROI detection algorithm that establishes region of interest to reduce some noise and extracts harmful degree effectively and defines the characteristics in the ROI area inside. And this paper suggests the multiple-SVM training method that creates the image classification model to select as 4 types of class defined above. This paper presents the multiple-SVM classification algorithm that categorizes harmful grade of input data with suggested classification model. We suggest the skin likelihood image made of the shape information of the skin area image and the color information of the skin ratio image specially. And we propose the image feature vector to use in the characteristic category at a course of traininB resizing the skin likelihood image. Finally, this paper presents the performance evaluation of experiment result, and proves the suitability of grading image using image feature classification algorithm.