• Transactions on Electrical and Electronic Materials
• /
• v.1 no.1
• /
• pp.40-44
• /
• 2000

Metal-ferroelectric-insulator-semoiconductor field effect transistor (MFISFETs) were fabricated using CMOS processes. The Pt/SBT/NO combined layers were etched for forming a conformal gate by using Ti/Cr metal masks and a two step etching method, By the method, we were able to fabricate a small-sized gate with the dimension of $16/4{\mu}textrm{m}$ in the width/length of gate. It has been chosen the non-self aligned source and drain implantation process, We have deposited inter-layer dielectrics(ILD) by low pressure chemical vapor deposition(LPCVD) at $380^{circ}C$ after etching the gate structure and the threshold voltage of p-channel MFISFETs were about 1.0 and -2.1V, respectively. It was also observed that the current difference between the $I_{ON}$(on current) and $I_{OFF}$(off current) that is very important in sensing margin, is more that 100 times in $I_{D}-V_{G}$ hysteresis curve.

• Korean Journal of Pharmacognosy
• /
• v.37 no.1 s.144
• /
• pp.33-36
• /
• 2006

The quantitative analytical method for the content of dioscin in Dioscorea rhizoma using a high performance liquid chromatography(HPLC) system was established for its quality control. After extracting Discorea rhizoma flour with ethanol, dioscin was separated though an ODS column with a flow rate of 1.0ml/min of acetonnitril-methanol-0.01 M phosphate buffer (pH 5.0)(6:3:1, v/v%), and the amount of dioscin was detected at 210nm. Relation time of dioscin in HPLC chromatogram were about $7.45{\pm}0.34\;min$ and calibration curve showed good linearity at concentrations from 0.1 to 2.0 mg/ml of dioscin. When 5 commercial Dioscorea rhizoma flours were analyzed by HPLC, the peak for dioscin was well separated from others in ethanol extract of Dioscorea rhizoma, and the amount of dioscin was in the range from 0.076 to 0.142(w/w)%.

• Electrical & Electronic Materials
• /
• v.8 no.2
• /
• pp.171-175
• /
• 1995

Optimum condition of remote plasma enhanced chemical vapor deposition using orthogonal array method was chosen. Characteristics of oxide films deposited by RPECVD with SiH$_{4}$ and N$_{2}$O gases were investigated. Etching rate of the optimized SiO$_{2}$ films in P-etchant was about 6[A/s] that was almost the same as that the high temperature thermal oxide. The films showed high dielectric breakdown field of more than 7[MV/cm] and a resistivity of 8*10$^{13}$ [.ohmcm] around at 7[MV/cm]. The interface trap density of SiO$_{2}$/Si interface around the midgap derived from the high frequency C-V curve was about 5*10$^{10}$ [/cm$^{2}$eV]. It was observed that the dielectric constant of the optimized SiO$_{2}$ film was 4.29.

• The Bulletin of The Korean Astronomical Society
• /
• v.38 no.1
• /
• pp.56.1-56.1
• /
• 2013

We have carried out follow-up observations of transiting extrasolar planets using small- to medium-sized reflectors located in Korea. Using the 0.60m telescope stationed at CbNUO (Chungbuk National University Observatory) we have achieved a photometric precision of 1.48 milli-magnitudes (root-mean-square scatter of data) of a HAT-P-09b (transit duration of 3.43 hrs) transit light curve (transit depth ~ 1.3%) with V=12.3 mag for the host star. We expect a photometric precision of 1.0 - 1.2 milli-magnitude for brighter targets (V ~ 10 - 11 mag). The transit technique and its application will be outlined. The results of test observations will be presented and the defocus technique will be discussed.

• Analytical Science and Technology
• /
• v.22 no.5
• /
• pp.432-438
• /
• 2009

In order to develop the analytical method for the pharmaceutical tablets containing ranitidine HCl by square wave voltammetry (SWV), $5.00{\times}10^{-5}M$ ranitidine HCl solutions prepared with phosphate buffers of various pH values were investigated by SWV. The well defined main peak due to the electrochemical reduction of $-NO_2$ in the structure of ranitidine moved towards the cathodic direction by -70 mV/pH as the pH values were increased indicating the involvement of hydrogen in its reduction. The calibration curve, the plot of peak currents (Ip) vs. concentrations of ranitidine HCl in the range between $1.00{\times}10^{-7}M$ and $1.00{\times}10^{-5}M$ showed linearity with slopes of $232,530{\mu}A/M$ (pH 6.14), $289,015{\mu}A/M$ (pH 7.07) and $232,843{\mu}A/M$ (pH 8.01). When one pharmaceutical tablet was simply dissolved in the phosphate buffer with a pH value of 6.14 and determined by standard addition method using SWV, the within-day precision study (n=4) resulted in the contents of ranitidine HCl as $171{\pm}2.1mg$ ($102{\pm}1.3%$ of the specified contents, RSD of 1.2%) in a tablet of Curan$^{(R)}$. The inter-day precision for 5 days was 1.1% of RSD. For Zantac$^{(R)}$ the within-day precision study (n=4) showed the contents of ranitidine HCl as $167{\pm}0.8mg$ ($99{\pm}0.5%$ of the specified contents, RSD of 0.5%) in a tablet and the inter-day precision for 5 days was 0.3% of RSD.

• YAKHAK HOEJI
• /
• v.32 no.6
• /
• pp.402-414
• /
• 1988

In order to clarify the receptor types and mechanisms underlying the positive inotropic effect of dopamine on the mammalian ventricular myocardium, the action potential, its first derivatives and isometric contraction of the rabbit papillary muscle were recorded using a force transducer and glass capillary microelectrodes filled with 3M KCl. The results were as follows; (1) In normal Tyrode solution, the contractile force was increased and duration of action potential was shortened with increments of dopamine concentration ($10^{-6}-10^{-4}M$). (2) The dose-response curve was markedly shifted to the right by pretreatment with reserpine (5mg/kg i.p., 24hrs prior to the experiment). (3) In 19mM $K^+-Tyrode$ solution, the duration of action potential, maximum rate of rise (V_{max}) of action potential and overshoot were significantly increased with increments of dopamine concentration ($10^{-6}-10^{-4}M$). (4) The inotropic effect of dopamine on the rabbit papillary muscle pretreated with reserpine was antagonized by atenolol ($10^{-6}M$), but not by phentolamine ($3{\times}10^{-6}M$). (5) In rabbit papillary muscle partially depolarized by 19mM $K^+-Tyrode$ solution, slow electrical response (calcium mediated action potential) as well as contraction were restored by dopamine ($10^{-4}M$); this restoration was blocked by calcium antagonists ($3{\times}10^{-5}M$ $LaCl_3{\cdot}6H_2O$, $3{\times}10^{-6}M$ diltiazem) or ${\beta}-adrenoceptor$ antagonist ($3{\times}10^{-6}M$ atenolol), but not affected by ${\alpha}-adrenoceptor$ antagonist ($10^{-5}M$ phentolamine, $3{\times}10^{-6}M$ yohimbine) or vascular dopaminergic receptor antagonist ($10^{-5}M$ haloperidol). The above results may be interpreted as that the positive inotropic effect of dopamine through both direct and indirect action are caused by increase in slow inward current ($Ca^{2+}$ influx into themyocardial cell), and the direct action is mainly due to the stimulation of ${\beta}-adrenoceptors$ in the rabbit papillary muscle.

• YAKHAK HOEJI
• /
• v.54 no.4
• /
• pp.295-299
• /
• 2010

The aim of this study was to develop and validate for determination of alibendol in human plasma by HPLC method. After precipitation of 500 ${\mu}l$ plasma samples by 50% methanol 50 ${\mu}l$ and 60% perchloric acid 30 ${\mu}l$ and the supernatant 50 ${\mu}l$ was injected into HPLC. The assay was performed isocratically using 10 mM potassium phosphate (pH 3.0) and acetonitrile (80 : 20, v/v) as mobile phase. The $C_{18}$ column (particle size $3.5{\mu}m$, $4.6{\times}50$ mm, Zorbax Eclipse) was used as a solid phase. The mobile phase was delivered at a flow-rate of 1.7 ml/min, detection was by ultraviolet absorption at 232 nm and concentrations were calculated on the basis of peak areas. In these conditions, alibendol can be separated from ethylparaben, the internal standard, and endogenous substances. The retention times of alibendol and ethylparaben were just about 2.6 and 3.5 minutes, respectively. This rapid HPLC method was validated by examining the precision and accuracy for inter- and intra-day analysis. The standard curve was linear ($R^2$=1.0000) over the concentration range of 0.05~20 ${\mu}g$/ml. The inter-day relative standard deviation (R.S.D.) and accuracy were 0.2~12.2% and 94.4~101.2% (82.7% at the lower limit of quatitation). The intra-day R.S.D. and accuracy were 0.1~11.8% and 98.8~102.5%, respectively. The method was successfully applied to the determination of alibendol in plasma for a pharmacokinetic study.

• Analytical Science and Technology
• /
• v.10 no.3
• /
• pp.187-195
• /
• 1997

Chemically modified electrodes(CMEs) for Ag(I) were constructed by incoporating 1,5,9,13-tetrathiacyclohexadecane([16]-ane-$S_4$) with a conventional carbon-paste mixture composed of graphite powder and nujol oil. Ag(I) ion was chemically deposited onto the surface of the modified electrode with [16]-ane-$S_4$ by immersion of the electrode in the acetate buffer solution(pH=4.5) containing $5.0{\times}10^{-4}M$ Ag(I) ion. And then the electrode deposited with Ag(I) was reduced at -0.3V vs. S.C.E. Well-defined stripping voltammetric peaks could be obtained by scanning the potential to the positive direction. The CME surface was regenerated with exposure to 0.1M $HNO_3$ solution and was reused for the determination of Ag(I) ion. When deposition/measurement/regeneration cycles were 10 times, the response could be reproduced with relative standard deviation of 6.08%. In case of differential pulse stripping voltammetry, the calibration curve for Ag(I) was linear over the range of $5.0{\times}10^{-7}{\sim}1.5{\times}10^{-6}M$. And the detection limit was $2.0{\times}10^{-7}M$. Various ions such as Cd(II), Ni(II), Pb(II), Zn(II), Mn(II), Mg(II), EDTA, and oxalate(II) did not influence the determination of Ag(I) ion, except Cu(II) ion.

• ALGAE
• /
• v.32 no.2
• /
• pp.131-137
• /
• 2017

Although green algae of the genus Closterium are considered ideal models for testing toxicity in aquatic ecosystems, little data about the effects of toxicity on these algal species is currently available. Here, Closterium ehrenbergii was used to assess the acute toxicity of copper (Cu). The median effective concentration ($EC_{50}$) of copper sulfate based on a dose response curve was $0.202mg\;L^{-1}$, and reductions in photosynthetic efficiency ($F_v/F_m$ ratio) of cells were observed in cultures exposed to Cu for 6 h, with efficiency significantly reduced after 48 h (p < 0.01). In addition, production of reactive oxygen species significantly increased over time (p < 0.01), leading to damage to intracellular organelles. Our results indicate that Cu induces oxidative stress in cellular metabolic processes and causes severe physiological damage within C. ehrenbergii cells, and even cell death; moreover, they clearly suggest that C. ehrenbergii represents a potentially powerful test model for use in aquatic toxicity assessments.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2000.01a
• /
• pp.145-146
• /
• 2000

Primary emphasis was placed on the electrophoretic deposition of low voltage phosphor to indium-tin oxide-coated glass for the application of field emission display. The phosphor deposited by various parameters, such as deposition time and applied voltages was examined in detail. In addition, a comparison was made by analyzing luminance properties of the phosphor mixed with and without conducting $In_2O_3$ powder of less than 1um size. The measurement was performed as a function of $In_2O_3$ concentration from 3% to 15% by weight. The enhanced impact of indium powder mixing on the phosphor was clearly demonstrated by aging performance curve at 1000V excitation voltages with a current density of $1\;mA/cm^2$