• Journal of Power Electronics
• /
• v.5 no.3
• /
• pp.206-211
• /
• 2005

Conventional switched capacitor converters have an inherent drawback that their efficiency decreases as the output current increases. This inherent drawback is due to a periodical forced charging and discharging operation in the internal switched capacitors accompanied by a large capacitor current. Their efficiency can not be increased by decreasing its internal resistance. As a result, conventional switched capacitor converters have been limited to uses with a very small output current. To solve this problem we presented a novel switched capacitor converter topology that uses a resonant operation instead of the forced charging and discharging operation. Its advantage over a conventional switched capacitor converter is higher efficiency even in a high output current region. In this paper, the operation analysis and steady-state characteristics are described in detail for a half buck type switched capacitor converter, and they are confirmed by experimentation.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.18 no.2
• /
• pp.161-165
• /
• 2012

It is one of the most important to protect the battery over charging for stable use and to extend the life of battery which occurs with repeated charging and discharging. Various research have been studied to know the state of health, and in this paper the terminal voltage of battery is measured to calculate the state of charge simply. The circuit used comparator is designed and built not to fall under the specific voltage of battery. The designed circuit board is attached to the automatic water sanitizer device with a solar power system. The system is located in the water tank where there is not water and electric service, and confirmed that the state of working is good.

• Explosives and Blasting
• /
• v.26 no.2
• /
• pp.64-76
• /
• 2008

Bulk Emulsion blasts using mechanized charging system, which is generally used in foreign countries, have recently introduced and gradually increased in Korea. The Bulk Emulsion are safe and able to increase the charging density for improvement of fragmentation and advancement especially in tunneling, and minimizing environmental problem. Because of less toxic gas generation, the explosives are called, namely ech-friendly products. There are two kinds of Bulk Emulsion; one is for open cut and the other is for tunneling. According to features of blast sites and its purpose, the compositions are different, but the principle is the same. In this study, trial blasts using Bulk Emulsion for tunneling had executed at 10 sites in Korea. The major result of the major job-sites is the following. First of all, compared with cartridge explosive, Bulk Emulsion was able to increase its charging density up to $35{\sim}60%$, to decrease the blast holes to approximately $10{\sim}30%$ down, and the advancement was improved up to $8{\sim}20%$ and also 30% up in its fragmentation. Toxic gas production after cartridge blasting showed 34.44ppm of its CO. Bulk Emulsion, however, showed 20.13ppm, which was 58.45% production of the cartridge explosive, and NOx was below 2ppm. The mechanized charging system of Bulk Emulsion should be applied to large sized tunnel blasting, long advanced tunnel which can secure the advancement of over $4{\sim}5m$, and the sites required finishing rapidly.

• Journal of Families and Better Life
• /
• v.19 no.1
• /
• pp.77-93
• /
• 2001

This paper examines consumer problems and issues of credit card use. The cases of credit card problems were from a civil consumer organization called Green Consumers Network in Korea. This paper focused on over five concerns, including credit card issuing, lost or stolen card settlements, vendor fee charging to customer, withholding payment in case of unsatisfactory purchases, and abusive debt collecting practices. Some solutions for the consumer problems were suggested.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2003.05a
• /
• pp.191-209
• /
• 2003

Voices of Customers; 1. Long time operating power 2. Quick Charging 3. High power and energy density 4. Safety 5. Small and light power Technical Requirements for Delivering DMFC to Consumer's Hands; 1. MEA having tripled power density. 2. Membrane of maintaining the same protonic conductivity and near 0% cross-over when 10M or higher concentration of methanol fueling (Omitted)

• Convergence Security Journal
• /
• v.7 no.3
• /
• pp.109-120
• /
• 2007

VoIP service provides various functions that PSTN phone service hasn't been able to provide. Since it also has superiority in service charge, the number of user is increasing these days. When we think of the other side in cost aspect, the spam caller can also send his/her commercial message over phone line using more economic way. This paper presents the characteristics that should be considered to detect the spam call using greylisting method. We have explored static and dynamic characteristics in VoIP calls, and analyzed the relation among them. Especially, we have surveyed the authentication and charging method of Korean VoIP service provider. We have analyzed each charging method using our spam call simulation result, and derived the charging method that can be favored by spam caller. The contribution of the work is in analysis result of static aspect for SPIT Level calculation in greylisting method.

• Progress in Superconductivity and Cryogenics
• /
• v.16 no.3
• /
• pp.21-25
• /
• 2014

As wireless power transfer (WPT) technology using strongly coupled electromagnetic resonators is a recently explored technique to realize the large power delivery and storage without any cable or wire, this technique is required for diffusion of electric vehicles (EVs) since it makes possible a convenient charging system. Typically, since the normal conducting coils are used as a transmitting coil in the CPT system, there is limited to deliver the large power promptly in the contactless EV charging system. From this reason, we proposed the combination CPT technology with HTS transmitting antenna, it is called as, superconducting contactless power transfer for EV (SUWPT4EV) system. As the HTS coil has an enough current density, it can deliver a mass amount of electric energy in spite of a small scale antenna. The SUCPT4EV system has been expected as a noble option to improve the transfer efficiency of large electric power. Such a system consists of two resonator coils; HTS transmitting antenna (Tx) coil and normal conducting receiver (Rx) coil. Especially, the impedance matching for each resonator is a sensitive and plays an important role to improve transfer efficiency as well as delivery distance. In this study, we examined the improvement of transmission efficiency and properties for HTS and copper antennas, respectively, within 45 cm distance. Thus, we obtained improved transfer efficiency with HTS antenna over 15% compared with copper antenna. In addition, we achieved effective impedance matching conditions between HTS antenna and copper receiver at radio frequency (RF) power of 370 kHz.

• The Journal of Korean Physical Therapy
• /
• v.4 no.1
• /
• pp.69-78
• /
• 1992

The purpose of this survey is to grasp the special school therapeutic education teachers, stress degrees in the real educational fields, and to campare the different stress degrees by the teaching responsibilities, by set by age, by the careers of special teaching profession, by his or her assiduity by the academic careers and teacher qualification, and by the reasons of stress. To perform this survey, the writer analyzed the answer sheets of the questionnairs returned by 85 special school therapeutic education teachers all over the country. The results of the analysis are as follows: First, the mean value of stress by the whole teachers was shown as endurable, and there was no difference among stress towels by the teaching responsibilities. As for the ratio of teachers confronted with the dangerous level of stress. the teachers taking charge of feebleminded school teachers the highest ratio, and those charging of deaf & dumb school teachers, the lowest. Second, the comparison by age didn't result in any difference, but in the relation of age to the handicap division there appeared meaningful differences. That is in the case of the therapeutic education theachers charging of crippled school, it revealed that the older they were, the more stress they suffered. In the case of the teachers charging of visually deaf & dumb school the tendency was opposite. The comparison by the special teaching profession careers, there showed no difference in the stress degree. The high or low academic careers didn't make any influence on the therapeutic education teachers stress degree. Third, The revealed on the highest stress degress, because reasons of relation the student's parents with students behavior.

• Journal of the Korean Society of Safety
• /
• v.35 no.6
• /
• pp.25-31
• /
• 2020

Boiling Liquid Expanding Vapor Explosion(BLEVE) can cause not only economic damage to the plant but also serious casualties. LPG accidents account for 89.6 percent of all accidents caused by gas leaks in Korea over the past nine years, while casualties from accidents also account for 73 percent of all accidents, according to statistics from the Korea Gas Safety Corporation. In addition, a potential explosion and a fire accident from one LPG storage tank may affect the nearby storage tanks, causing secondary and tertiary damage (domino effect). The safety distance standards for LPG used by LPG workplaces, charging stations, and homes in Korea have become stricter following the explosion of LPG charging stations in Bucheon. The safety distance regulation is divided into regulations based on the distance damage and the risk including frequency. This study suggests two approaches to optimizing the safety distance based on the just consequence and risk including frequencies. Using the Phast 7.2 Risk Assessment software by DNV GL, the explosion overpressure and heat radiation were derived according to the distance caused by BLEVE in the worst-case scenario, and accident and damage probability were derived by considering the probit function and domino effect. In addition, the safety distance between LPG tanks or LPG charging stations was derived to minimize damage effects by utilizing these measures.

• Journal of the Korean Society of Industry Convergence
• /
• v.26 no.4_2
• /
• pp.705-713
• /
• 2023

The phenomenon of abnormal climate conditions resulting from greenhouse gas-induced global warming is increasingly prevalent. To address this challenge, global initiatives are underway to adopt environmentally friendly, zero-emission fuels. In this study, we investigate the hydrogen embrittlement characteristics of materials used for eco-friendly hydrogen storage systems. The effects of hydrogen embrittlement on austenitic stainless steels of the FCC series and structural steel of the BCC series were examined. Initially, test samples of three different steel types were prepared in 2t and 3t sizes, and hydrogen was injected into the specimens using an electrochemical method over a 24-hour period. Subsequently, a universal material testing machine (UTM) was employed to monitor changes in mechanical strength and elongation. The FCC series stainless steels exhibited a tendency for elongation to decrease, indicating low sensitivity to hydrogen. In contrast, the mechanical strength and elongation of the BCC series steel changed significantly upon hydrogen charging, posing challenges for prediction. The results of the present study are expected to serve as a fundamental database for analyzing the impact of hydrogen embrittlement on both FCC and BCC series steel materials.