• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1999년도 전력전자학술대회 논문집
• /
• pp.311-314
• /
• 1999

This paper presents the design method of a repetitive controller to educe the harmonics in the output voltage waveform of the AC power supply systems. Output voltage error under the nonlinear load like a rectifier is cyclic with the same period to fundamental wave, therefore one can design the repetitive controller calculating cycle by cycle. The controller is verified mathematically and by simulations.

• Journal of Power Electronics
• /
• 제18권2호
• /
• pp.407-417
• /
• 2018

A novel family of Buck mode three-level direct ac converters with a high frequency link is proposed. These converters can transfer an unsteady high ac voltage with distortion into a regulated sinusoidal voltage with a low THD at the same frequency. The circuit configuration is constituted of a three-level converter, high frequency transformer, cycloconverter, as well as input and output filters. The topological family includes forward, push-pull, half-bridge, and full-bridge modes. In order to achieve a reliable three-level ac-ac conversion, and to overcome the surge voltage and surge current of the cycloconverter, a phase-shifted control strategy is introduced in this paper. A prototype is presented with experimental results to demonstrate that the proposed converters have five advantages including high frequency electrical isolation, lower voltage stress of the power switches, bi-directional power flow, low THD of the output voltage, and a higher input power factor.

• Journal of Power Electronics
• /
• 제9권6호
• /
• pp.823-834
• /
• 2009

This paper proposes a high-efficiency single-stage ac/dc converter. The proposed converter features low voltage stresses and reduced switching losses. It operates at the boundary of discontinuous- and continuous-conduction modes by employing variable switching frequency control. The turn-on switching loss of the switch can be reduced by turning it on when the voltage across it is at a minimum. The voltage across the bulk capacitor is independent of the output loads and maintained within the practical range for the universal line input, so the problem of high voltage stress across the bulk capacitor is alleviated. Moreover, the voltage stress of the output diodes is clamped to the output voltage, and the output diodes are turned off at zero-current. Thus, the reverse-recovery related losses of the output diodes are eliminated. The operational principles and circuit analysis are presented. A prototype circuit was built and tested for a 150 W (50V/3A) output power. The experimental results verify the performance of the proposed converter.

• 한국항행학회논문지
• /
• 제3권1호
• /
• pp.44-51
• /
• 1999

본 논문에서는 항공기용으로 사용되는 400 Hz 정현파 교류전원을 얻기 위한 단상 PWM 인버터의 출력전압 제어기법을 제안한다. 제안된 퍼지추론 제어 알고리즘은 부하변동이나 파라미터 변화에도 불구하고 인버터의 출력전압이 기준 정현파 전압을 추종하도록 한다. 퍼지추론은 출력전압과 기준전압의 오차와 오차 미분을 이용하고 퍼지추론에 의해 정해진 입력은 PWM 게이트 신호를 결정한다. 실험을 통하여 제안된 제어시스템의 성능을 확인하였다.

• 한국군사과학기술학회지
• /
• 제16권4호
• /
• pp.566-574
• /
• 2013

In this paper, direct power control system for three-phase PFC AC/DC converter without the source voltage sensors is proposed. The sinusoidal input current and unity effective power factor are realised based on the estimated flux in the observer. Both active and reactive power calculated using estimated flux. The estimation of flux is performed based on the reduced-order virtual flux observer using the actual currents and the command control voltage. Moreover, source voltage sensors are replaced by a estimated flux. DC output voltage has been compensated by DC output ripple voltage estimation algorithm. The active and reactive powers estimation are performed based on the estimated flux and Phase angle. The proposed algorithm is verified through simulation and experiment.

• 대한전기학회논문지
• /
• 제38권6호
• /
• pp.431-440
• /
• 1989

This paper proposes a new PWM cycloconverter which can step up input voltage. With input reactors ac power supply acts as current source, and with output capacitors the balanced output voltage is build-up. The converter is modeled with fourth order state equation using dq transformation and the steady state characteristics are evaluated. It is shown that the proposed converter can generate the output voltage 2-5 times greater than input voltage. The output voltage and input current have sinusoidal and smooth waveforms and the converter is capable of voltage build-up. The characteristics of the proposed converter is verified simulation and experiment.

• 전력전자학회논문지
• /
• 제9권2호
• /
• pp.171-177
• /
• 2004

일반적으로 압전변압기는 고압을 출력하는 전원장치로 사용되고 있으나, 최근 어댑터와 같은 AC/DC 전원장치에 이를 채용하려는 움직임이 활발히 전개되고 있다. AC/DC 컨버터의 소형 경량화론 위해 기존의 권선형 변압기 대신 압전변압기는 AC/DC 컨버터용이 아닌 LCD 백-라이트구동용으로 제작된 압전변압기(piezoelectric transformer)를 사용하여 AC/DC 컨버터의 기본 특성을 고찰하고자 한다. 압전변압기의 재질, 특성 값으로부터 등가회로의 모델링을 수행하고, 이를 시뮬레이션과 실험을 통하여 검증한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1997년도 전력전자학술대회 논문집
• /
• pp.314-317
• /
• 1997

The purpose of this study is developing a converter which is able to convert a 300[KW] power, and is a DC power supply output a 1500[V] DC voltage for inverter driving. The power converter is driven by two converter serisely and keep a high power factor of power source. This system is haven all the characteristic of voltage source converter by having a processing ability of regenerating power. The two converters controls a PWM modulation and output voltage using a only one 16 bit DSP processor.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2017년도 추계학술대회
• /
• pp.51-52
• /
• 2017

This paper presents an advanced DC droop using both an output current and a grid current. To control parallel-connected converters without communication, the DC droop control is conventionally used. The conventional DC droop control method droops output voltage using an output current. It cannot control the source current causing output voltage errors. This paper proposed the DC droop method using both an output current and a grid current to improve dynamic response of voltage droops. The simulation results with PSIM is provided.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2018년도 전력전자학술대회
• /
• pp.434-435
• /
• 2018

In this paper, a single-phase single-stage three-level AC/DC converter with a wide controllable output voltage is presented. It integrates a PFC converter and a three level DC/DC converter into one. The proposed converter operates at a fixed frequency and provides a wide controllable output voltage ($200V_{dc}-430V_{dc}$) with high efficiencies over a wide load range. In addition, the input boost inductors operate in a discontinuous mode to improve the input power factor. Moreover, all the switching devices operate with ZVS, and the converter's THD is small especially at full load. The feasibility of the proposed converter is verified with experimental results of a 1.5kW prototype.