• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.20 no.5
• /
• pp.227-231
• /
• 2010

Super hydrophilic $TiO_2$ thin films with photocatalytic property were successfully fabricated on a glass substrate by liquid phase deposition (LPD). The $TiO_2$ thin film formed nano particles on a surface at $70^{\circ}C$. As an immersion time in $TiF_4$ solution increased, the thickness of thin films gradually increased. $TiO_2$ thin film showed a water contact angel of below ca. $5^{\circ}$ and the transmittance of ca. 75~90 % in visible range. In addition, $TiO_2$ thin film showed the photocatalytic property to decompose methyl orange solution by the illumination of UV light. The surface morphologies, optical properties and contact angel of prepared thin films with a different immersion time were measured by field emission scanning electron microscope (FE-SEM), atomic force microscope (AFM), UV-Vis spectrophotometer and contact angle meter.

• Journal of the Korean Vacuum Society
• /
• v.19 no.3
• /
• pp.224-229
• /
• 2010

Indium oxide $(In_2O_3)$ thin films have been prepared on glass substrate by using radio-frequency reactive magnetron sputtering with changing the oxygen flow ratio. The substrate temperature was kept at a fixed value of $400^{\circ}C$, and the sputtering gas and reactive gas were supplied with argon and oxygen, respectively. The oxygen partial flow ratio was varied by controlling the amount of oxygen with respect to the total mixed gases, 10%, 20%, 30%, 40%, and 50%. The optical, electrical, and structural properties of the deposited thin films were investigated by using ultraviolet-visible-near infrared spectrophotometer, Hall measurement, and X-ray diffractometer and scanning electron microscopy. The $In_2O_3$ thin film deposited at 20% of oxygen flow ratio showed an average transmittance of 86% in the wavelength range of 430~1,100 nm, an electrical resistivity of $1.1{\times}10^{-1}{\Omega}cm$. The results show that the transparent conducting films with optimum conditions can be achieved by controlling the oxygen flow ratio.

• Korean Journal of Materials Research
• /
• v.11 no.3
• /
• pp.178-184
• /
• 2001

Transparent and highly oriented KLN thin films have been grown by an rf- magnetron sputtering deposition method. A homogeneous and stable KLN target was prepared by calcine and sintering process. For KLN target, stoichiometry and composition excess with K of 30% and 60%, and Li of 15% and 30% respectively, was prepared. The targets were sintered at low temperature to prevent vaporization of K and Li. KLN thin films were fabricated by rf-magnetron sputtering method using those targets. In this experiment, using the target of composition excessed with K of 60% and Li of 30%, single phase KLN thin film was produced. KLN thin film has excellent crystallinity and highly c-axis oriented on Corning 1737 substrate. Transmittance of thin film in visible range was 90%, absorption edge is 333 nm and refractive index at 632.8 nm was 1.93.

• Applied Biological Chemistry
• /
• v.26 no.2
• /
• pp.137-142
• /
• 1983

Starch granules of sweet potatoes, the Suwon 147 and the Chunmi were observed by photomicroscope and scanning electron microscope were round and polygonal. Granule sizes of the Suwon 147 and the Chunmi were $14{\sim}30{\mu}m,\;16{\sim}34{\mu}m$, respectively. X-ray diffraction pattern of starch granules resulted weak crystallinity at $2{\theta}$ 14.8, 17.2, 22.5. Starch granules were of the Ca crystalline type. The blue values of the Suwon 147 and the Chunmi were determined to be 0.342 and 0.279, amylose contents 27.6% and 23.6%, and water binding capacity 178.7% and 185.5%. Swelling of the starches negligible until $50^{\circ}C$ thereafter it increased rapidly. Swelling power of the Suwon 147 was more slightly than that of the Chunmi. Optical transmittance of 0.2% starch suspensions was increased rapidly from $65^{\circ}C$ and the gelatinization at $65{\sim}80^{\circ}C$ was of sing1e stage. Amylogram patterns of 4% starch solutions were similar to no peak viscosity. Viscosity of the Suwon 147 was increased, but that of the Chunmi was decreased at $92.5^{\circ}C$.

• Applied Biological Chemistry
• /
• v.28 no.4
• /
• pp.219-225
• /
• 1985

The viscometric properties of six kinds of waxy starches of Olchal and Hankang(waxy rice), Chalborie (waxy barley), Yullmoo (waxy Job's tears), Chajoe (waxy foxtail millet), Chalsusu (waxy great millet) and Chalocsusu (waxy corn) were investigated. The increase in optical transmittance of 0.1% starch suspensions occurred at $55^{\circ}C$ for Hankang, $60^{\circ}C$ for Olchal, Chalborie, Chajoe and Yullmoo and $65^{\circ}C$ for Chalsusu and Chalocsusu, and further inrreased $70^{\circ}C$ for Hankang and Olchal, $75^{\circ}C$ for Chajoe, Chalsusu, Chalocsusu and Yullmoo and above $85^{\circ}C$ for chalborie. Amylogram on 5%, starch suspensions showed that gelatinization temperature and maximum peak height were 850 B.U. at $62^{\circ}C$ for Hankang, $65^{\circ}C$ and 980 B.U. for Olchae, $64^{\circ}C$ and 1,080 B.U. for Chalborie, and 1,410 B.U. at $69^{\circ}C$ for Yullmoo, and 1,280 B.U. at $71^{\circ}C$ for Chajoe, and 1,260 B.U. at $71^{\circ}C$for Chalsusu and 1,420 B.U. at $70^{\circ}C$ for Chalocsusu. Swelling power of starches was $38{\sim}55$, and Hankang, Olchal, Chajoe, Chalocsusu and Yullmoo starches had higher swelling power than Chalsusu and Chalborie starches. Intrinsic viscosity of them was $1.43{\sim}1.75$ and hardness of them highly relevant to the gelatinization properties.

• Journal of the Korean institute of surface engineering
• /
• v.49 no.3
• /
• pp.316-321
• /
• 2016

To study emission characteristics for dual-emission tandem organic light emitting display (OLED), we fabricated blue fluorescent OLED according to thickness variation of $MoO_x$ as charge generation layer and Al as cathode. The bottom emission characteristics of OLED with $MoO_x$ 2, 3, 5 nm thickness showed threshold voltage of 9, 7, 9 V, maximum current emission efficiency of 19.32, 23.18, 15.44 cd/A and luminance of $1,000cd/m^2$ at applied voltage of 17.6, 13.2, 16.5 V, respectively. The top emission characteristics of OLED with $MoO_x$ 2, 3, 5 nm thickness indicated threshold voltage of 13, 10, 13 V, maximum current emission efficiency of 0.17, 0.23, 0.16 cd/A and luminance of $50cd/m^2$ at applied voltage of 22.6, 16.5, 20.1 V, respectively. In case of thicker or thinner than $MoO_x$ of 3 nm, the emission characteristics were decreased because of mismatching of electron and hole in emission layer. The bottom emission characteristics of OLED with Al 15, 20, 25 nm thickness showed threshold voltage of 8, 8, 7 V, maximum current emission efficiency of 18.42, 22.98, 23.18 cd/A and luminance of $1000cd/m^2$ at applied voltage of 16.2, 13.9, 13.2 V, respectively. The reduction of threshold voltage and increase of maximum current emission efficiency are caused by the increase of current injection according to increase of Al cathode thickness. The top emission characteristics of OLED with Al 15, 20, 25 nm thickness indicated threshold voltage of 7, 7, 8 V, maximum emission luminance of 371, 211, $170cd/m^2$, respectively. The top emission OLED of Al cathode with 15 nm thickness showed maximum luminance and it decreased at thickness of 20 nm. These phenomena are caused by the decrease of intensity of emitted light by reduction of optical transmittance according to increase of Al cathode thickness.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.31 no.4
• /
• pp.154-158
• /
• 2021

The optical transmittance of Mn-doped SnO₂ monolayer film increased gradually from 80.9 to 85.4 % at 550 nm wavelengths upon increasing the O₂/Ar+O₂ concentration rate from 0 to 7.9 % and the band gap energy changed from 3.0 to 3.6 eV. The resistivity tended to decrease from 3.21 Ω·cm to 0.03 Ω·cm, reaching a minimum at 2.7 %, and then gradually increased from 0.03 to 52.0 Ω·cm at higher O₂/Ar+O₂ gas concentration ratio. Based on XPS spectra analysis, the Sn 3d_5/2 peak of Mn-doped SnO₂ single layer shifted slightly from 486.40 to 486.58 and O_1s peak also shifted from 530.20 to 530.33 eV with increase the O₂/Ar+O₂ concentration ratio. Therefore, the XPS spectra results indicate that a multiphase with SnO and SnO₂ coexisted in the sputtered Mn-doped SnO₂ monolayer film.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.6
• /
• pp.80-85
• /
• 2019

Vanadium dioxide is a well-known metal-insulator phase transition material. Lots of researches of vanadium redox flow batteries have been researched as large scale energy storage system. In this study, vanadium oxide($VO_x$) thin films were applied to cathode for lithium ion battery. The $VO_x$ thin films were deposited on Si substrate($SiO_2$ layer of 300 nm thickness was formed on Si wafer via thermal oxidation process), quartz substrate by RF magnetron sputter system for 60 minutes at $500^{\circ}C$ with different RF powers. The surface morphology of as-deposited $VO_x$ thin films was characterized by field-emission scanning electron microscopy. The crystallographic property was confirmed by Raman spectroscopy. The optical properties were characterized by UV-visible spectrophotometer. The coin cell lithium-ion battery of CR2032 was fabricated with cathode material of $VO_x$ thin films on Cu foil. Electrochemical property of the coin cell was investigated by electrochemical analyzer. As the results, as increased of RF power, grain size of as-deposited $VO_x$ thin films was increased. As-deposited thin films exhibit $VO_2$ phase with RF power of 200 W above. The transmittance of as-deposited $VO_x$ films exhibits different values for different crystalline phase. The cyclic performance of $VO_x$ films exhibits higher values for large surface area and mixed crystalline phase.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.12
• /
• pp.10-15
• /
• 2020

Ultraviolet rays, which have wavelengths smaller than 400 nm, are very harmful to the eyes. Recently, high-energy visible light was also revealed to be harmful to retinal cells. Therefore, polymer eyeglass lenses that can block UV and high-energy visible light are needed for eye health. In this study, high-refractive-index polymer eyeglass lens, n=1.67, were manufactured using the injection-mold method with the m-xylene diisocyanate monomer, 2,3-bis((2-mercaptoethyl)thio)-1-propanethiol monomer, benzotriazole UV absorber, release of alkyl phosphoric ester, dye mixture of CI solvent violet 13, and catalyst of dibutyltin dichloride mixture. A multi-layer anti-reflection coating was applied to manufactured polymer eyeglass lenses for both sides using an E-beam evaporation system. The optical properties of the manufactured lenses with the UV and high-energy visible light-blocking function were analyzed by UV-visible spectrophotometry. As a result, the polymer eyeglass lens with a UV absorber of 0.5 wt. % blocked 99% of UV and high-energy visible light shorter than 411 nm. The average transmittance of the polymer eyeglass lens with a UV absorber of 0.5wt.% was 97.9% in the range of 460 ~ 660 nm for photopic eye sensitivity higher than 10%. Therefore, clear image acquisition in photopic vision is possible.

• Journal of the Microelectronics and Packaging Society
• /
• v.30 no.3
• /
• pp.56-63
• /
• 2023

In this paper, we studied the effect of electron beam irradiation on sol-gel indium-gallium-zinc oxide (IGZO) thin films under air and nitrogen atmosphere and carried out the electrical characterization of the s ol-gel IGZO thin film transistors (TFTs). To investigate the optical properties, crystalline structure and chemical state of the sol-gel IGZO thin films after electron beam irradiation, UV-Visible spectroscopy, X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS) were carried out. The sol-gel IGZO thin films exhibited over 80% transmittance in the visible range. The XRD analysis confirmed the amorphous nature of the sol-gel IGZO films regardless of electron beam irradiation. When electron beam irradiation was conducted in a nitrogen (N₂) atmosphere, we observed an increased proportion of peaks related to M-O bonding contributed to the improved quality of the thin films. Sol-gel IGZO TFTs subjected to electron beam exposure in a nitrogen atmosphere exhibited enhanced electrical characteristics in terms of on/off ratio and electron mobility. In addition, the electrical parameters of the transistor (on/off ratio, threshold voltage, electron mobility, subthreshold swing) remained relatively stable over time, indicating that the electron beam exposure process in a nitrogen atmosphere could enhance the reliability of IGZO-based thin-film transistors in the fabrication of sol-gel processed TFTs.