• Journal of the Korean Society for Heat Treatment
• /
• v.28 no.2
• /
• pp.63-67
• /
• 2015

$TiO_2/Ag/TiO_2$ trilayer films were deposited with radio frequency (RF) and direct current (DC) magnetron sputtering onto the glass substrate to consider the influence of Ag interlayer on the optical properties of the films. The thickness of $TiO_2$ films was kept at 24 nm, while the thickness of Ag interlayer was varied as 5, 10, 15, and 20 nm. As-deposited $TiO_2$ single layer films show the optical transmittance of 66.7% in the visible wave-length region and the optical reflectance of 16.5%, while the $TiO_2$ films with a 15 nm thick Ag interlayer show the enhanced optical transmittance of 80.2% and optical reflectance of 77.8%. The carrier concentration was also influenced by Ag interlayer. The highest carrier concentration of $1.01{\times}10^{23}cm^{-3}$ was observed for a 15 nm thick Ag interlayer in $TiO_2/Ag/TiO_2$ films. The observed result means that an optimized Ag interlayer in $TiO_2/Ag/TiO_2$ films enhanced the structural and optical properties of the films.

• Korean Journal of Materials Research
• /
• v.18 no.8
• /
• pp.422-426
• /
• 2008

The effects of an addition of $ZrO_2$ on the microstructure and electrical properties of MgO films as a protective layer for AC plasma display panels were investigated. MgO + a 200 ppm $ZrO_2$ protective layer prepared by e-beam evaporation exhibited a secondary electron emission coefficient ($\gamma$) that was improved by 21% compared to that of a pure MgO protective layer. The relative density and Vickers hardness increased with a further addition of $ZrO_2$. These results suggest that the discharge properties and optical properties of MgO protective layers are closely related to the relative density and Vickers hardness. The good optical and electrical properties of $\gamma$, at 0.080, a grain size of $19\;{\mu}m$ and an optical transmittance of 91.93 % were obtained for the MgO + 200 ppm $ZrO_2$ protective layer sintered at $1700^{\circ}C$ for 5 hrs.

• Korean Journal of Materials Research
• /
• v.31 no.7
• /
• pp.382-385
• /
• 2021

Well-crystallized vanadium pentoxide V₂O₅ thin films are fabricated on MgO single crystal substrates by using pulsed-laser deposition technique. The linear optical transmission spectra are measured and found to be in a wavelength range from 300 to 800 nm; the data are used to determine the linear refractive index of the V₂O₅ films. The value of linear refractive index decreases with increasing wavelength, and the relationship can be well explained by Wemple's theory. The third-order nonlinear optical properties of the films are determined by a single beam z-scan method at a wavelength of 532 nm. The results show that the prepared V₂O₅ films exhibit a fast third-order nonlinear optical response with nonlinear absorption coefficient and nonlinear refractive index of 2.13 × 10^-10 m/W and 2.07 × 10^-15 cm²/kW, respectively. The real and imaginary parts of the nonlinear susceptibility are determined to be 3.03 × 10^-11 esu and 1.12 × 10^-11 esu, respectively. The enhancement of the nonlinear optical properties is discussed.

• Bulletin of the Korean Chemical Society
• /
• v.29 no.12
• /
• pp.2521-2524
• /
• 2008

• Textile Coloration and Finishing
• /
• v.24 no.4
• /
• pp.233-238
• /
• 2012

The opto-functional materials have been developed as a promising research topic toward the end uses for optical materials and applications. The attractive area in this part was the design of sensor molecules for detecting harmful environmental factors. These harmful factors impart undesired effects on wide range of chemical and biological phenomenon. In this context, many researchers have studied luminescence chemosensor materials. These sensor molecules showed optical signals such as color or fluorescence change by detecting harmful environmental factors. In this study, the novel fluorescence chemosensor 1 has been designed and synthesized through reaction of rhodamine 6g hydrazide and 2-hydroxy-1-naphthaldehyde. The chemosensor 1 had been analyzed by UV-Vis and fluorescence spectrophotometer. We found that this chemosensor 1 has 'off-on' and dual type sensing properties toward $Cu^{2+}$ and $Mg^{2+}$.

• Journal of the Optical Society of Korea
• /
• v.17 no.1
• /
• pp.33-37
• /
• 2013

In this study a new design concept of the Fabry-Perot filter, constructed with an anisotropic space layer and a couple of isotropic mirrors, was proposed based on the Maxwell equations and the characteristic matrix method. The single- and double-cavity Fabry-Perot filters were designed, and their optical properties were investigated with a developed software package. In addition, the dependence of the transmittance and phase shift for two orthogonal polarization states on the column angle of the anisotropic space layer and the incidence angle were discussed. We demonstrated that the polarization state of electromagnetic waves and phase shifts can be modulated by exploiting an anisotropic space layer in a polarization F-P filter. Birefringence of the anisotropic space layer provided a sophisticated phase modulation with varied incidence angles over a broad range, resulting in a wide-angle phase shift. This new concept would be useful for designing optical components with isotropic and anisotropic materials.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.4
• /
• pp.1205-1211
• /
• 2013

The structural and optical properties of the ZnO, Al-doped ZnO, Ga-doped ZnO, and In-doped ZnO nanorods were investigated using field-emission scanning electron microscopy, X-ray diffraction, photoluminescence (PL) and ultraviolet-visible spectroscopy. All the nanorods grew with good alignment on the ZnO seed layers and the ZnO nanorod dimensions could be controlled by the addition of the various dopants. For instance, the diameter of the nanorods decreased with increasing atomic number of the dopants. The ratio between the near-band-edge emission (NBE) and the deep-level emission (DLE) intensities ($I_{NBE}/I_{DLE}$) obtained by PL gradually decreased because the DLE intensity from the nanorods gradually increased with increase in the atomic number of the dopants. We found that the dopants affected the structural and optical properties of the ZnO nanorods including their dimensions, lattice constants, residual stresses, bond lengths, PL properties, transmittance values, optical band gaps, and Urbach energies.

• Korean Journal of Materials Research
• /
• v.19 no.3
• /
• pp.125-131
• /
• 2009

In this report, the structural and optical properties of sol-gel derived $Mg_xZn_{1-x}O$ thin films upon changes in the composition and annealing temperature were investigated. The $Mg^{2+}$ content and the annealing temperature were varied in the range of $0{\leq}x{\leq}0.35$ and $400^{\circ}C{\leq}T{\leq}600^{\circ}C$, respectively. The films exhibited a hexagonal wurtzite structure of a polycrystalline nature. The optical transmittance exceeded 85% and the optical band gap of the film was tuned as high as 3.84 eV at a value of x = 0.35 (annealed at $400^{\circ}C$), which was evidently the maximum $Mg^{2+}$ content for the single-phase polycrystalline $Mg_xZn_{1-x}O$ thin films prepared in this experiment. The optical band gap and photoluminescence emission were tailored to the higher energy side while maintaining crystallinity without a significant change of the lattice constant.

• Proceedings of the Polymer Society of Korea Conference
• /
• 2006.10a
• /
• pp.25-26
• /
• 2006

Azobenzene functionalized polymers have been extensively investigated due to the potential applications in the areas of optical switching, optical elements, optical information storage, and nonlinear optics. These applications are mainly achievable due to photoinduced properties of azobenzene groups with photoisomerization and photoinduced anisotropy. We report applications to the optoelectronic devices using inscribed one-(1D) and two-dimensional (2D) SRGs on azo polymer films. The inscribed holographic SRGs patterns were useful to control or enhance optoelectronic properties such as transparent electrode patterning, hybrid solar cell and ultraviolet GaN-based LED.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2011.05a
• /
• pp.7.2-7.2
• /
• 2011

Photoelectrochemical solar cells such as dye-sensitized cells (DSSCs), which exhibit high performance and are cost-effective, provide an alternative to conventional p-n junction photovoltaic devices. However, the efficiency of such cells plateaus at 11~12%, in contrast to their theoretical value of 33%. The majority of research has focused on improving energy conversion efficiency of DSSC by controlling nanostructure and exploiting new materials in photoelectrode consisting of semiconducting oxide nanoparticles and a transparent conducting oxide electrode (TCO). In this presentation, we introduce monodisperesed TiO2 nanoparticles prepared by forced hydrolysis method and their superiority as photoelectrode materials was characterized with aids of optical and electrochemical analysis. Inverse opal-based scattering layers containing highly crystalline anatase nanoparticles are also introduced and their feasibility for use as bi-functional light scattering layer is discussed in terms of optical reflectance and charge generation properties as a function of optical wavelength.