• Korean Journal of Crystallography
• /
• v.6 no.2
• /
• pp.141-157
• /
• 1995

Single crystals of TeO2 with large diameter were grown by Czochralski technique with auto-diameter control system. The ratio of crystal to crucible was 60-70%. The effect of critical pulling and rotation rate on the crystal quality was studied. Optimum growth parameters for high quality crystal pulling rate was less than 1.2 mm/hr. The solid-liquid interface was convex at the rotation rate of 10-23 rpm and concave at the rotation rate of more than 25 rpm, depending on the size of crystal and crucible. The platinum concentration in the melts is one of the main factors of the constitutional supercooling and thus the bubble entrapment in the growing crystal. Growth axis was confirmed to {110} direction during the whole growth procedure. Infrared spectrometric study and dislocation density measurment by chemical etching method on the grown crystal were performed. Finally, the reasons of cooperation of striations, inclusions, and optical inhomogeneities were discussed.

• Korean Journal of Optics and Photonics
• /
• v.11 no.5
• /
• pp.360-364
• /
• 2000

We demonstrate self-starting passIve mode locking of a Cr:LiSAF laser, using a SCIDlconduclor Saturable Absorber Mirror (SESAM), Two high-power red semiconductor lasers (Coherent S-67-500C-100-H) of wavelength 667 nm and maximum power of 500 mW were used as pump lasers, The cavity has 10 cm radius-ai-curvature folding minors, two SF 10 prisms, a 99% reflectivity output coupler and a SESAM at dIe focus of a 10 cm radIus-at-curvature mirror. We used the laser crystal in BrewsterBrewster shape with 1 5% $Cr^{+3}$ ion concentration and the length of 6 mm, An X-shaped resonator was used to compensate the astigmatism induced by tile crystal. The structure of the SESAM cOllSists of 30 pmr of $AlAs/Al_{0.15}Ga_{0.85}As$ layer, wi1l1 a 10 nm GaAs quantum well situated in the topmost layer Output spectra were centeled at 833 nm, with 4 nm spectral bandwidth and pulse width was measured to be 220 fs, Output power of 3 mW is obtained at a pump power of 800 mW. 00 mW.

• Korean Journal of Optics and Photonics
• /
• v.22 no.6
• /
• pp.283-290
• /
• 2011

A Raman LIDAR system has been designed and constructed for quantitative measurement of water vapor mixing ratio. The comparison with commercial microwave radiometer and global navigation satellite system(GNSS) was performed for the precipitable water vapor(PWV) profile and total PWV. The result shows that the total GNSS-PWV and LIDAR-PWV have good correlation with each other. But, there is small difference between the two methods because of maximum measurement height in LIDAR and the GNSS method. There are some significant differences between Raman and MWR when the water vapor concentration changes quickly near the boundary layer or at the edge of a cloud. Finally we have decided that MWR cannot detect spatial changes but LIDAR can measure spatial changes.

• YAKHAK HOEJI
• /
• v.54 no.2
• /
• pp.106-111
• /
• 2010

The chemical structures of eight compounds purified from two plants (Polygala tenuifolia Willdenow and Dioscorea batatas Decene) were determined and their anti-microbial activity against three microbial strains (Staphylococcus aureus, Pseudomonas aeruginosa, and Candida albicans) was tested. The three micro organisms were cultured in 96-well plates or Petri dishes without (control) or with the eight compounds added at concentrations of 100 to 0.01 ${\mu}M$ (wt/vol). The growth of the microorganisms in the medium was examined after a 24-h incubation. The inhibitory effect of each compound on the growth of the microorganisms was calculated from the optical density measured at 595 nm, turbidity, and size of the inhibition zone around the treated paper disc. The minimum inhiitory concentration (MIC) of compounds 4 to 7 against S. aureus was 0.08, 0.05, 1.3 and 0.02 ${\mu}M$, respectively, and 0.09, 0.1, 0.2 and 100 ${\mu}M$ against C. albicans. The $IC_{50}$ (50% inhibition) values of compounds 5 and 6 were 3.1 and 6.4 ${\mu}M$ against S. aureus, respectively, and 10 and 2.4 ${\mu}M$ against C. albicans. Therefore, compounds 4 to 6 were the most potent anti-microbial agents among the eight compounds tested.

• Journal of the Korean Ceramic Society
• /
• v.37 no.4
• /
• pp.354-358
• /
• 2000

Tetragonal (t)-ZrO2/Al2O3 composites doped with Y2O3, Nb2O5, and Fe2O3 ((Y, Nb, Fe)-TZP/Al2O3) were prepared over the range containing Fe2O3 from 0.1 to 0.5 mol% with 0.1 mol% intervals to evaluate the effect of Fe2O3 addition on chromaticity, hydrothermal stability, and mechanical property of the composites. After autoclaving for 20 h at 18$0^{\circ}C$ under 3.5 MPa water vapor pressure, no tlongrightarrowm phase transformation was observed probably due to the preferential solid solubility of Fe2O3 in Al2O3, the presence of the rigid Al2O3 particles, and the inherent phase stability of (Y, Nb)-TZP. The optimized strength and the fracture toughness of the composite were 700 MPa and 8.5 MPa.m1/2, respectively, when 0.1 mol% Fe2O3 was added. The composites have shown a gradual color change from a slightly white ivory to a pale yellowish brown with increasing the Fe2O3 concentration.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.33 no.3
• /
• pp.181-185
• /
• 2020

Hazardous and noxious substance (HNS) detection sensors were fabricated using multi-walled carbon nanotubes (MWCNTs) and various binder materials for ion batteries. To obtain uniformly printed films, the printing precision according to the substrate cleaning method was monitored, and the printing paste mixing ratio was investigated. Binders were prepared using styrene butadiene rubber + carboxymethyl cellulose (SBR+CMC), polyvinylidene fluoride + n-methyl-2-pyrrolidene (PVDF+NMP), and mixed with MWCNTs. The surface morphology of the printed films was examined using an optical microscope and a scanning electron microscope, and their electrical properties are investigated using an I-V sourcemeter. Finally, sensing properties of MWCNT printed films were measured according to changes in the concentration of the chemical under the various applied voltages. In conclusion, the MWCNT printed films made of (SBR+CMC) were found to be feasible for application to the detection of hazardous and noxious chemicals spilled in seawater.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.12
• /
• pp.5412-5419
• /
• 2011

The need is growing for high-speed spindle because various equipment are becoming more precise, miniaturization and high speed with the development of industries. Air-lubricated dynamic bearings are widely used in the optical lithographic manufacturing of wafers to realize nearly zero friction for the motion of the stage. Air-lubricated dynamic bearing can be used in high-speed, high-precision spindle system and hard disk drive(HDD) because of its advantages such as low frictional loss, low heat generation, averaging effect leading better running accuracy. In the paper, numerical analysis is undertaken to calculate the performance of air-lubricated dynamic bearing with herringbone groove. The static performances of herringbone groove bearings which can be used to support the thrust load are calculated. Electrochemical micro machining($EC{\mu}M$) which is non-contact ultra precision machining method has been developed to fabricate the air-lubricated dynamic bearing and optimum parameters which are inter electrode gap size, concentration of electrolyte, machining time are simulated using numerical analysis program.

• Nutrition Research and Practice
• /
• v.11 no.1
• /
• pp.64-69
• /
• 2017

BACKGROUND/OBJECTIVES: This study was performed to measure fat-soluble vitamins and minerals in breast milk of Korean lactating mothers who exclusively breastfed their babies. SUBJECTS/METHODS: Breast milk samples were collected from 334 mothers. Concentrations of retinol and ${\alpha}$-tocopherol were analyzed by high performance liquid chromatography ultraviolet spectrometry while concentrations of minerals were measured by inductively coupled plasma optical emission spectrometry. RESULTS: Retinol and ${\alpha}$-tocopherol contents of breast milk were $39.58{\pm}19.64{\mu}g/dL$ and $0.23{\pm}0.13mg/dL$, respectively. Average sodium, potassium, calcium, phosphorus, and magnesium levels in breast milk were $11.11{\pm}5.16$, $38.56{\pm}9.01$, $27.87{\pm}6.10$, $13.56{\pm}3.30$, and $3.05{\pm}0.65mg/dL$, respectively. Contents of trace elements such as iron, zinc, copper, and manganese were $40.26{\pm}46.21$, $98.40{\pm}62.47$, $24.09{\pm}9.03$, and $0.90{\pm}1.63{\mu}g/dL$, respectively. Fat-soluble vitamin concentration was positively correlated with total fat in milk samples, but no significant differences were observed in levels of retinol, ${\alpha}$-tocopherol, or minerals based on whether or not lactating women were taking dietary supplements. CONCLUSIONS: Micronutrient contents of breast milk samples from Korean lactating women were comparable to those of other nations. Retinol and ${\alpha}$-tocopherol levels were correlated and also with total fat in breast milk.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.07a
• /
• pp.207-210
• /
• 2005

In order to investigate the influence of the homo buffer layer on the microstructure of the ZnO thin film, undoped ZnO buffer layer were deposited on sapphire (0001) substrates by ultra high vaccum pulsed laser deposition (UHV-PLD) and molecular beam eiptaxy (MBE). After high temperature annealing at $600^{\circ}C$ for 30min, undoped ZnO buffer layer was deposited with various oxygen pressure (35~350mtorr). On the grown layer of undoped ZnO, Arsenic-doped(l, 3wt%) ZnO layers were deposited by UHV-PLD. The optical property of the ZnO was analyzed by the photoluminescence (PL) measurement. From $\Theta-2\Theta$ XRD analysis, all the films showed strong (0002) diffraction peak, and this indicates that the grains grew uniformly with the c-axis perpendicular to the substrate surface. Field emission scanning electron microscope (FE-SEM) revealed that microstructures of the ZnO were varied with oxygen pressure, arsenic doping level, and the deposition method of undoped ZnO buffer layers. The films became denser and smoother in the cases of introducing MBE-buffer layer and lower oxygen pressure during As-doped ZnO deposition. Higher As-doping concentration enhanced the columnar-character of the films.

• Mycobiology
• /
• v.48 no.5
• /
• pp.383-391
• /
• 2020

Use of nanoparticles (NPs) in several commercial products has led to emergence of novel contaminants of air, soil and water bodies. The NPs may exhibit greater ecotoxicity due to nano-scale dependent properties over their bulk counterparts. The present investigation explores the effect of in vitro supplementation of TiO₂, silica and silver NPs on radial growth and ultrastructural changes in the hyphae and spores of two mushroom genera, Ganoderma lucidum and Volvariella volvaceae. A concentration dependent decrease in radial growth on NP amended potato dextrose agar medium was recorded. However, in comparison to control, there was decrease in radial diameter on supplementation with TiO₂ NPs while an increase was recorded for silica and silver NPs amendments as compared to their bulk salts at same concentrations after 48 h of incubation. Optical microscopy studies showed decrease in the number of spores while increase in spore diameter and thinning of hyphal diameter on NPs supplementation. Scanning electron microscopy analysis of fungal growth showed presence of deflated and oblong spores in two fruiting strains of Ganoderma while Volvariella exhibited decreased sporulation. Further, hyphal thinning and branching was recorded in response to NP amendments in both the test mushrooms. Enhancement of protein content was observed on NP compared to bulk supplementation for all cultures, concentrations and hours of incubation except for TiO₂ NPs. Likewise, bulk and NP supplementations (at 100 mg L^-1) resulted in enhanced laccase activity with occurrence of laccase specific protein bands on SDS-PAGE analysis.