• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.8
• /
• pp.25-32
• /
• 2011

Networks-on-chip (NoC) is emerging as a key technology to overcome severe bus traffics in ever-increasing complexity of the Multiprocessor systems-on-chip (MPSoC); however traditional electrical interconnection based NoC architecture would be faced with technical limits of bandwidth and power consumptions in the near future. In order to cope with these problems, a hybrid optical NoC architecture which use both electrical interconnects and optical interconnects together, has been widely investigated. In the hybrid optical NoCs, wormhole switching and simple deterministic X-Y routing are used for the electrical interconnections which is responsible for the setup of routing path and optical router to transmit optical data through optical interconnects. Optical NoC uses circuit switching method to send payload data by preset paths and routers. However, conventional hybrid optical NoC has a drawback that concurrent transmissions are not allowed. Therefore, performance improvement is limited. In this paper, we propose a new routing algorithm that uses circuit switching and adaptive algorithm for the electrical interconnections to transmit data using multiple paths simultaneously. We also propose an efficient method to prevent livelock problems. Experimental results show up to 60% throughput improvement compared to a hybrid optical NoC and 65% power reduction compared to an electrical NoC.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.11
• /
• pp.83-93
• /
• 2014

It is a widespread concern that electrical interconnection based network-on-chip (NoC) will ultimately face the limitation in communication bandwidth, transmission latency and power consumption in the near future. With the development of silicon photonics technology, a hybrid optical network-on-chip (HONoC) which embraces both electrical- and optical interconnect, is emerging as a promising solution to overcome these problems. Today's leading edge systems-on-chips (SoCs) comprise heterogeneous many-cores for higher energy efficiency, therefore, extended study beyond regular topology based NoC is required. This paper proposes an energy and latency optimization topology design technique for HONoC taking into account the traffic characteristics of target applications. The proposed technique is implemented with genetic algorithm and simulation results show the reduction by 13.84% in power loss and 28.14% in average latency, respectively.

• Korean Journal of Metals and Materials
• /
• v.50 no.1
• /
• pp.23-27
• /
• 2012

The color of a natural diamond that contains nitrogen impurities can be enhanced by a high pressure high temperature (HPHT) treatment. Type IaAB diamond samples containing nitrogen impurities were executed by HPHT process of 5.6 Gpa, 10 min by varying the annealing temperature at 1600, 1650, and $1700^{\circ}C$. Property characterization was carried out using an optical microscope, FT-IR spectrometer, low-temperature PL spectrometer, and micro Raman spectrometer. By observing optical micrographs, it can be seen that diamond sample began to alter its color to vivid yellow at $1700^{\circ}C$. In the FT-IR spectrum, there were no Type changes of the diamond samples. However, amber centers leading to brown colors lessened after $1700^{\circ}C$ annealing. In the PL spectrum, all the H4 centers became extinct, while there were no changes of yellow color center H3 before or after treatment. In the Raman spectrum, no graphite spots were detected. Consequently, diamond color enhancement can be done by higher than $1700^{\circ}C$ HPHT annealing at 5.6 GPa-10 min.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1996.06a
• /
• pp.526-526
• /
• 1996

The single crystal of LiTaO3 is well known eletro-optic material as well as the piezoelectric one applied to SAW filter. LiTaO3 has large electro-optic effects, so applied to optical switch, acosto-optic deflector, and optical memory device using photorefractive effects. The crystal growth of SAW-grade LiTaO3 has been studied many aspects, but there is no detail research about optic-grade crystal growth. The conditions of optic-grade LiTaO3 single crystal are as below. The optical transmittance must be over 75%, and axial and radial concentratiom uniformity below 1%. The variation of Curie temperature depending on Li/Ta ratio must be also below 2$^{\circ}C$ and no internal no internal cracks and defects. Because of the limitation of crystal quality, the growing of optic-grade LiTaO3 single crystal is very difficult compared with the growing of SAW-grade. In this research, upper conditions of optic-grade single crystal was investigated after growing of 1 inch diameter and 1.5 inch length LiTaO3 single crystal having no internal cracks and defects using Czochralski method. Curie temperature was determined with DSC and measuring capacitance and lattice parameter was calculated about the grown crystal and ceramic powder samples of various Li/Ta ratio. The result of Tc variation was below 1.2$^{\circ}C$ all over the grown crystal, so it is confirmed that LiTaO3 was grown under congruent melting composition having optical homogeniety. Also, the optical transmittance was about 78%, which was sufficient for optical device.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.7
• /
• pp.131-139
• /
• 2013

To overcome the limitations in performance and power consumption of traditional electrical interconnection based network-on-chips (NoCs), a hybrid optical network-on-chip (HONoC) architecture using optical interconnects is emerging. However, the HONoC architecture should use circuit-switching scheme owing to the overhead by optical devices, which worsens the latency unfairness problem caused by frequent path collisions. This resultingly exert a bad influence in overall performance of the system. In this paper, we propose a new task mapping algorithm for optimizing latency by reducing path collisions. The proposed algorithm allocates a task to a certain processing element (PE) for the purpose of minimizing path collisions and worst case latencies. Compared to the random mapping technique and the bandwidth-constrained mapping technique, simulation results show the reduction in latency by 43% and 61% in average for each $4{\times}4$ and $8{\times}8$ mesh topology, respectively.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.44 no.3
• /
• pp.303-316
• /
• 2018

In this study, I investigated the applicability of fluorescein-derived xanthene dyes to fluorescent pigment and the controllability of the optical properties of manufactured pigments. Eosin Y (D&C Red No.22) and phloxine B (D&C Red No.28) were mainly used as a dye to prepare the pigment. Dyes dissolved in a solvent were poured into a powder dispersed in the solvent, then dried and pulverized to fabricate the pigments. Optical characteristics related with fluorescence of the prepared pigment were measured. The optical properties of pigments were varied depending on the solvent used, content of the dye in the pigment, and the ratio of dyes when more then two dyes were mixed. According to the experiment result, it seems that some of the dyes attached to the powder showed fluorescence while the rest did not contribute to it. From the result of pigment washing experiment to explore the binding (or interaction) strength and characteristics of the powder-dye system constituting the pigment, it seems that there are two or more different interactions existing in the pigment system, one of which is relatively stronger than the solvent-dye interaction.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2001.11a
• /
• pp.39-43
• /
• 2001

A system, IS-95C coupler that combines the signals of IS-95A/B and IS-95C BTS and compensates the differences between the signals of two systems and connected to optical repeater If no IS-95C coupler exist, Optical repeater can't service of signal balanced. A system carries on combination, amplification, level modulation function of the TX signals(IS-95A/B & IS-95C) and division and level modulation function of the RX signals. Isolation satisfied above 100dB.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.2
• /
• pp.429-434
• /
• 2010

A novel T-type polyester 7 containing 1-(2,5-dioxyphenyl)-2-{5-(1,2,2-tricyanovinyl)-2-thienyl}ethenes as nonlinear optical (NLO) chromophores, which are part of the polymer backbone, was prepared and characterized. Polyester 7 is soluble in common organic solvents such as dimethylsulfoxide and N,N-dimethylformamide. It showed a thermal stability up to $300^{\circ}C$ in thermogravimetric analysis thermogram and the glass-transition temperature ($T_g$) obtained from differential scanning calorimetry thermogram was around $113^{\circ}C$. The second harmonic generation (SHG) coefficient ($d_{33}$) of poled polymer films at 1,560 nm fundamental wavelength was around 1.85 pm/V. The dipole alignment exhibits a greater thermal stability even at $10^{\circ}C$ higher than $T_g$, and there is no SHG decay below $125^{\circ}C$ due to the partial mainchain character of the polymer structure, which is acceptable for nonlinear optical device applications.

• Macromolecular Research
• /
• v.17 no.11
• /
• pp.874-878
• /
• 2009

Photorefractive polymer composites were synthesized based on poly (N-vinylcazbazole) (PVK) doped with liquid nonlinear optical chromophores and a sensitizer $C_{60}$. PVK/liquid NLO chromophores/$C_{60}$ devices showed no signs of phase separation and did not require a plasticizer, such as ethylcarbazole. The composites showed 69% diffraction efficiency (C3) and a rapid response time of 46 ms (C1) in four-wave mixing experiments at a light intensity of $60\;mW/cm^2$ and a wavelength of 633 nm.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.10
• /
• pp.82-90
• /
• 2013

An Optical Network-on-Chip(ONoC) based on silicon photonics is one of promising technology for next generation exascale computing architectures. Recent active researches on ONoC focus on improving bandwidth further and avoiding path collisions by using wavelength division multiplexing (WDM). However, the number of wavelengths used for the WDM increases linearly as the number of Processing Element (PE) increases in existing ONoCs which adopt centralized routing architecture. The problem will also arises growing cost of optical devices such as light switches and light sources and limits the scalability of ONoC due to the sinal loss caused by interference of distinct light sources. In this paper, we proposes a distributed routing architecture for ONoC which is based on 2D-mesh structure using WDM technique and present a method that minimize the required number of wavelengths exploiting the connectivity of communication. In comparison with existing centralized routing architectures, results show reduction by 56% of the number of wavelengths and 21% of the number of optical switches in $8{\times}8$ networks.