• The Korean Journal of Physiology
• /
• v.5 no.2
• /
• pp.63-70
• /
• 1971

In an attempt to understand the possible effects of temperature and X-irradiation on the activities of surfactant in rabbits, the pulmonary surfactant from the rabbit was subjected to the incubation at $37^{\circ}C$ and X-irradiation with 900r in vitro, and activities of surfactant were measured at 10, 30, 60, and 90 minutes. Tension-area diagram of the lung extract was recorded automatically by the modified Langmuir-wilhelmy balance with a synchronized recording system designed in this Department. A comparison was made with the normal and the following results were obtained. 1) The maximal surface tension, minimal surface tension, width of the tension area diagram at the surface area of 40% and stability index of the normal rabbit lung extract were $31.6{\pm}3.11\;dynes/cm,\;8.2{\pm}0.56\;dynes/cm,\;21.4{\pm}4.40\;dynes/cm\;and\;1.12{\pm}0.22$,respectively. 2) In the $37^{\circ}C$ incubation group, maximal surface tension was similar to the normal value, while minimal surface tension was significantly lower and stability infer was markedly higher than the normal. 3) In the group where X-irradiation of 900r in vitro was applied, maximal surface tension did not differ greatly with the normal or the $37^{\circ}C$ incubation group. The minimal surface tension was significantly lower than the normal but comparing with the $37^{\circ}C$ incubation group, some decrease in minimal surface tension was noted. The width of the tension·area diagram at 40% and stability index in the irradiated group were significantly higher than the normal but a tendency of increase was noted comparing with the $37^{\circ}C$ incubation group.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.24 no.6
• /
• pp.709-715
• /
• 2016

This paper presents a comparison of an experimental study on spot and plug welding of an automotive body panel. Spot welding is a common joining technology used in automotive body panel assembly. In automotive body repair, however, plug welding is widely used due to its technical simplicity and cost benefit. Some researchers have focused on the use of spot welding in the manufacturing process, but there has been very little research done with respect to the engineering analysis of the plug welding process. In this study, two kinds of specimens are considered to compare the difference of failure strength between spot weld and plug weld: normal tension and shear tension. The experimental results show, in both normal tension and shear tension, that spot welding has higher failure strength than plug welding. In addition, plug welding is more vulnerable to shear tension than normal tension. This study can be applied to further studies on practical optimization for maintenance and repair of automotive body panels.

• The Journal of Korean Medicine
• /
• v.44 no.3
• /
• pp.102-116
• /
• 2023

Objectives: To provide a case report of effective use of Korean herbal medicine treatment to reduce the development and progression of normal-tension glaucoma(NTG). Methods: This case involved a 52-year-old patient who had a history of excimer laser surgery at the age of 25 and was using prescriptions such as Cosopts2 and Xalatan for eye drops. We treated this patient with Korean herbal medicine treatment for 2 years and assessed the progression of NTG based on the optical coherence tomography test results that he recevied at the ophthalmology clinic every 6 months. Results: During the two years of treatment with Korean herbal medicine, it was observed that the progression of NTG was halted. However, after discontinuing the Korean herbal treatment, the progression resumed. Conclusion: Korean herbal medicine treatment was found to be effective in treating normal tension glaucoma, and a minimum treatment period of two years is necessary for an accurate evaluation of NTG.

• Sleep Medicine and Psychophysiology
• /
• v.9 no.1
• /
• pp.56-60
• /
• 2002

Objective: Various psychological factors influence the occurrence of tension-type headaches. The aim of this study is to compare the level of alexithymia between tension-type headache patients and normal controls. Methods: Sixty-six subjects with tension-type headaches and 59 controls were studied. The Beck Depression Inventory and Toronto Alexithymia Scale (TAS-20K) were administered to the tension-type headache group and TAS-20K to the normal control group. Results: Compared with normal controls, the tension-type headache group had significantly higher alexithymia scores. There was also significant association between the level of alexithymia and the severity of the depression in tension-type headache patients. Conclusions: These findings suggest that patients with tension-type headaches have difficulty in expressing their emotions. And in patients with tension-type headaches, the more alexithymic they are, the more depressive.

• The Journal of Korean Physical Therapy
• /
• v.30 no.4
• /
• pp.108-111
• /
• 2018

Purpose: This study examined the effects of the forward head posture and tension type headache on neck movement among office workers. Methods: The subjects were 6 male and 21 female patients composed of a forward head posture group, forward head posture group with a tension type headache and a normal group. Each group consisted of 2 males and 7 females. The cranio-vertebral angle of the head and the angle of motion of the neck were measured. SPSS 23.0 was used for data analysis and one-way ANOVA was performed for the mean comparison of the neck movements in the three groups. Results: The participants had a limitation in the movement of all necks between the forward head posture group and forward head posture with tension type headache group compared to the normal subjects. The forward head posture with tension headache group had limited neck extension and lateral bending compared to the forward head posture group. Conclusion: Office workers have limitations in the movement of the neck when they are accompanied by forward head posture and tension headache. In particular, when accompanied with a tension headache, there is a restriction on the neck extension and side bending. This study is expected to provide basic data for the relief of tension headache and the treatment of forward head posture in office workers.

• Journal of the Korea Concrete Institute
• /
• v.11 no.6
• /
• pp.35-46
• /
• 1999

The steel fiber reinforced concrete may affect substantially to the tension stiffening at post cracking behavior. Even if several tension stiffening models exist, they are for plain and normal strength concrete. Thus, the development of tension stiffening models for steel fibrous high strength RC members are necessary at this time when steel fiber reinforced and high strength concretes are common in use. This paper presents tension stiffening effects from experimental results on direct tension members with the main variables such as concrete strength, concrete cover depth, steel fiber quantity and aspect ratio. The comparison of existing models against experimental results indicated that linear reduced model closely estimated the test results at normal strength level but overestimated at high strength level. Discontinuity stress reduced model underestimated at both strength levels. These existing models were not valid enough in applying at steel fibrous high strength concrete because they couldn't consider the concrete strength nor section area. Thus, new tension stiffening models for high strength and steel fiber reinforced concrete were proposed from the analysis of experimental results, considering concrete strength, rebar diameter, concrete cover depth, and steel fiber reinforcement.

• The Korean Journal of Physiology
• /
• v.4 no.2
• /
• pp.53-60
• /
• 1970

In an attempt to clarity the effect of X-irradiation on the activity of surfactant in rabbits, and also to observe the possible difference when the irradiation was made in single or fractionated dose, X-ray in dose of 900 r was irradiated to rabbits either in single or fractionated dose of 300 r each day for three day, Tension-area diagram of lung extract was recorded automatically by a modified Langmuir-Wilhelmy balance with a synchronized recording system designed in this department. The surface tension of lung extract was measured at 1,3,5,24, and 48 hours post-irradiation, and the results were compared with the non-irradiated normal group. The result obtained are summerized as follows: 1) The maximal surface tension, minimal surface tension, width of the tension-area diagram at the surface area of 40% in lung extract, and stability index of the normal rabbit lung extracts were 40.73 dynes/cm, 8.96 dynes/cm. 20.71 dynes/cm, and 1.28 respectively. 2) Activity of surfactant was significantly depressed by X-irradiation, and the pattern of depression was more prominent in the single irradiation group than in the fractionated group. 3) It was found that the changes of the width of the tension-area diagram at the surface area of 40% in lung extract and stability indices corresponded well with that of the maximal or minimal surface tension.

• The Korean Journal of Physiology
• /
• v.2 no.2
• /
• pp.63-73
• /
• 1968

It is well known that mammalian alveolar membrane is covered with a very thin layer of surfactant film which characteristically reduces surface tension of alveolar membrane, and maintains alveolar stability. Since Clements in 1957 demonstrated that the surfactant is extractable by mincing the lung tissue in saline, various studies on the subject have been succeeded by many workers. However, the effect of radiation on the surfactant is not well clarified. Present study was attempted to observe the effect of x-irradiation on the activity of surfactant in rabbits. X-ray in dose of 300 r, 600 r or 900 r was irradiated to the chest of rabbits. The lung was removed from normal or irradiated rabbits sacrificed by arterial blood shedding, and lung-saline extract, adding 3 grams of lung tissue to 50 mili-liters of saline, was prepared by means of Vertis homogenizer. Tension-area diagram of lung extract was recorded automatically by a modified Langmuir-Wilhelmy balance with a synchronized recording system designed in this department. The surface tension of lung extract was measured at 1st, 2 nd, 3 rd, 7 th and 15 th post-radiation day in 300 r irradiated group, at 3 rd, 7 th and 15 th post-radiation day in 600 r irradiated group, 3 rd and 7 th post-radiation day in 900 r irradiated group respectively. For the histo-pathological study, lung tissue preparations were made in all irradiatiated groups on the day of experiment and in normal group. The results obtained are summarized as follows: 1. The minimal surface tension, maximal surface tension and stability index of normal rabbits lung extracts were 7.68 dynes/cm, 38.84 dynes/cm, and 1.39 respectively. 2. The activity of surfactant was depressed prominently by x-irradiation. However, increase in the dose of x-irradiation did not show any significant change in the degree of surfactant activity suppression. The most marked depression in surfactant was observed at the third post-radiation day in all irradiated groups. 3. Activity of surfactant depressed by x-irradiation showed a tendency of recovering to normal on 15 th post-radiation day. 4. The tendency of change in activity of surfactant following x-irradiation was somewhat correlative with histo-pathological changes. But the degree of depression of surfactant by x-irradiation did not correspond to the degree of histo-pathological changes, and recovery of lung tissue from radiation damage, tissue edema and congestion, seemed to be followed by restoration of surfactant activity. 5. The width of the tension-area diagram was measured at the surface area of 40% in lung extract of normal and x-irradiated rabbits. And it was found that the changes of the width corresponded well with that of minimum surface tension and of stability index in all normal and x-irradiated groups.

• The Korean Journal of Physiology
• /
• v.5 no.1
• /
• pp.51-58
• /
• 1971

In an attempt to further clarify the effect of X·irradiation on the activity of surfactant in rabbits, X-ray in dose of 900r was irradiated to the lung tissues of rabbits in vitro. Tension-area diagram of the lung extract was recorded automatically by a modified Langmuir-Wilhelmy balance with a synchronized recording system designed in this department. The surface tension of the lung extract was measured at 1,3,5,24 and 48 hours post-irradiation, and the results were compared with the non·irradiated normal group. The result$ thus obtained are summarized as follows: I The maximal surface tension, minimal surface tension, width of the tension·area diagram at the surface area of 40% in the lung extract and stability index of the normal rabbit long extract were 40.73 dynes/cm, 8.96 dynes/cm, 20.71 dynes/cm and 1.28, respectively. II. When 900r of X-ray was irradiated to the lung in vitro, 1) The maximal and minimal surface tensions did not differ noticeably from the normal at 1,3, and 5 post-irradiation hours, but the minimal surface tension increased significantly at 24 and 48 hours Post-irradiation. 2) The width of the tension area at the surface area of 40% showed a tendency of decrease throughout the experiment. 3) The stability index showed no significant change at 1,3 and 5 post-irradiation hours,but at 24 and 48 hours post-irradiation a significant decrease was observed comparing with the control. III. Activity of surfactant was significantly depressed by X·irradiation in vitro especially at 24 and 48 hours post-irradiation.

• Journal of the Korean Society of Industry Convergence
• /
• v.25 no.5
• /
• pp.773-782
• /
• 2022

Estimation of cable tension through proper measurements is one of the essential tasks in evaluating the safety of cable structures. In this paper, a study on cable tension estimation using the built-in accelerometer and camera in a smartphone was conducted. For the experimental study, visual displacement measurement using a smartphone camera and acceleration measurement using a built-in accelerometer were performed in the cable-stayed bridge model. The estimated natural frequencies and transformed tensions from these measurements were compared with the theoretical values and results from the normal visual displacement method. Through comparison, it can be seen that the error between the method using the smartphone and the normal visual displacement is sufficiently small to be acceptable. It has also been shown that those errors are much smaller than the difference between the values calculated by the theoretical model. These results show that the deviation according to the type of measurement method is not large and it is rather important to use an appropriate mathematical model. In conclusion, in the case of cable tension estimation, it can be said that the visual displacement measurement and acceleration using a smartphone can be a sufficiently applicable method, just like the normal visual displacement method. It is also noteworthy that the smartphone accelerometer has a larger magnitude error and has more limitations such as high-frequency sampling instability compared to the visual displacement method, but shows almost the same performance as the visual displacement method in this cable tension estimation.