• 전기학회논문지
• /
• 제60권1호
• /
• pp.201-204
• /
• 2011

For efficient noise reduction in a Fourier transform ion cyclotron resonance (FT-ICR) mass spectrum, a new algorithm was proposed. The suggested algorithm reduces white and electrical noise, and it improves signal-to-noise ratio. This algorithm has been optimized to reduce the noise more efficiently using the traces of signal level. The algorithm has been efficiently combined with derivative window to improve the resolution as well S/N. Time domain data was corrected for DC voltage interference. $t^n$ window was applied in time domain data to improved the resolution. However, $t^n$ window can improve the signal resolution, it will also increase the noise level in frequency domain. Therefore, newly developed noise reduction algorithm will be applied to make a balance between resolving power and S/N ratio for magnitude mode. The trace algorithm can determine the current data point with several data points (mean, past data, calculated past data). In the current calculations, we assumed data points with S/N ratio more than 3 were considered as signal data points. After the windowing and noise reduction, both resolution and signal-to-noise ratio were improved. This algorithm is applicable more efficiently to frequency dependent noise and large size data.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2010년도 추계학술대회 논문집
• /
• pp.54-55
• /
• 2010

• Corrosion Science and Technology
• /
• 제7권5호
• /
• pp.296-299
• /
• 2008

High order statistical parameters were evaluated using the electrochemical noise data collected during corrosion of type 430 stainless steel coupled to a inert, platinum electrode in 3.5% NaCl solution. High order statistical parameters are shown to predict uniform corrosion properly. However, Localization index, skewness of current, kurtosis and skewness of potential are capable of predicting pitting corrosion only when the transients are large with long life time. Of the high order statistical parameters evaluated, kurtosis of current is found to be the most sensitive parameter for detecting uniform and pitting corrosion.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2003년도 춘계학술대회논문집
• /
• pp.136-141
• /
• 2003

This paper is concerned with the eddy current damper which can be used to enhance the damping of the host structure. The operating principle of the eddy current damper is first explained in detail. The dynamic interaction between the magnets and the copper plate produces eddy current thus resulting in the damping force. By attaching the eddy current damper to the host structure, the damping of the total structure can be increased so that vibrations can be suppressed. The advantage of the eddy current damper is that it doesn't require any electronic devices and power supply. The effect of the eddy current damper on the global dynamic characteristics of the structure is investigated by considering the cantilever with the eddy current damper. Experimental results show that the eddy current damper is an effective device for vibration suppression.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2003년도 춘계학술대회논문집
• /
• pp.353-356
• /
• 2003

Acoustic holography is adopted in identifying the noise sources of a vehicle's underbody. Wind noise from a vehicle's underbody accounts for a large portion of the overall noise level due to the complex flow structure. Current study presents the development process of acoustic holography in the vehicle underbody, and discusses the results obtained using the method. Difficulties associated with using acoustic holography as well as the implication of the results regarding future noise reduction possibilities are discussed.

• Journal of electromagnetic engineering and science
• /
• 제4권3호
• /
• pp.137-142
• /
• 2004

In this paper, we present a new current-current negative feedback(CCNF) differential voltage-controlled oscillator (VCO) with 1/f induced low-frequency noise suppressed. By means of the CCNF, the 1/f induced low-frequency noise is removed from the proposed CCNF VCO. Also, high-frequency noise is stopped from being down-converted into phase noise by means of the increased output impedance through the CCNF and the feedback capacitor $C_f. The proposed CCNF VCO represents 11-dB reduction in phase noise at 10 kHz offset, compared with the conventional differential VCO. The phase noise of the proposed CCNF VCO is measured as - 87 dBc/Hz at 10 kHz offset frequency from 5.5-GHz carrier. The proposed CCNF VCO consumes 14.0 mA at 2.0 V supply voltage, and shows single-ended output power of - 12 dBm.

• ETRI Journal
• /
• 제38권2호
• /
• pp.235-243
• /
• 2016

A low-noise readout integrated circuit (ROIC) for a microelectromechanical systems (MEMS) microphone is presented in this paper. A positive feedback signal amplification technique is applied at the front-end of the ROIC to minimize the effect of the output buffer noise. A feedback scheme in the source follower prevents degradation of the noise performance caused by both the noise of the input reference current and the noise of the power supply. A voltage booster adopts noise filters to cut out the noise of the sensor bias voltage. The prototype ROIC achieves an input referred noise (A-weighted) of -114.2 dBV over an audio bandwidth of 20 Hz to 20 kHz with a $136{\mu}A$ current consumption. The chip is occupied with an active area of $0.35mm^2$ and a chip area of $0.54mm^2$.

• 환경영향평가
• /
• 제21권6호
• /
• pp.941-949
• /
• 2012

The various plants including power plants have been increased near downtown in accordance with the policy objective of rising the power feed rate and development projects. As a result of these various plants near residential area, noise damage complaints has been raised very often. The power plant is included with the range of environmental impact assessment project. Nevertheless, environmental noise issues regarding construction of these power plants have arisen. Accordingly it is time to consider the environmental and social issues of plants noise in accordance with the government's policy objectives of increased power production. In this study, we reviewed the current noise impact assessment and we also sought solutions to these issues. In order to minimize the problem of noise impact on neighborhood and residents, we intended to propose alternative method of 3D simulation in dealing with these issues.

• Journal of electromagnetic engineering and science
• /
• 제11권1호
• /
• pp.27-33
• /
• 2011

In this paper, we propose a high gain, current reused ultra wideband (UWB) low noise amplifier (LNA) that uses TSMC 0.18 ${\mu}m$ CMOS technology. To satisfy the wide input matching and high voltage gain requirements with low power consumption, a resistive current reused technique is utilized in the first stage. A ${\pi}$-type LC network is adopted in the second stage to achieve sufficient gain over the entire frequency band. The proposed UWB LNA has a voltage gain of 12.9~18.1 dB and a noise figure (NF) of 4.05~6.21 dB over the frequency band of interest (1~10 GHz). The total power consumption of the proposed UWB LNA is 10.1 mW from a 1.4 V supply voltage, and the chip area is $0.95{\times}0.9$ mm.

• 대한전자공학회논문지SD
• /
• 제45권9호
• /
• pp.8-13
• /
• 2008

균일하게 도핑된 반도체에서, 분포된 확산 잡음원에 의해서 발생하는 단자잡음전류의 전력주파수밀도를 계산하였다. 고정된 전압에서 반도체의 길이가 작아짐에 따라, 또는 주어진 반도체에서 전류레벨이 증가함에 따라, AC 단락잡음전류는 열잡음 뿐만 아니라 과잉잡음을 보인다. 이 과잉잡음은 채널길이가 외인성 Debye 길이에 비해 매우 작은 경우에는 산탄잡음의 스펙트럼과 같은 모습을 보인다. 유한한 주파수에서 속도요동 잡음원에 의한 외인성 반도체에서 발생하는 과잉잡음을 최초로 유도하였다. 유도된 과잉잡음 공식은 반도체 채널의 통과 시간, 유전 이완 시간, 속도 이완 사이의 상호 작용에 따라 단자잡음 전류와 캐리어 농도 요동이 결정됨을 명시적으로 보여준다. 또한 유도된 해석적 식을 사용하여 여러 가지 반도체 샘플 길이와 바이어스, 주파수에 따른 잡음 스펙트럼의 변화도를 계산하였다. 유도된 공식은 quasi-ballistic 수송현상이 중요한 역할을 하는 나노스케일 MOSFET의 잡음 발생 기제를 이해할 수 있는 기반이 된다.