• Transactions of the Korean Society of Automotive Engineers
• /
• v.19 no.1
• /
• pp.1-8
• /
• 2011

In recent years, there has been an interest in early-injection diesel engines as it has the potential of achieving a more homogeneous and leaner mixture close to TDC compared to standard diesel engine. The more homogeneous mixture may result in reduced NOx and soot emissions and higher efficiency in homogeneous charge compression ignition engines. While earlier studies have shown that a reduction in NOx emissions from HCCI engine is possible, there are some significant problems including the control of ignition timing and combustion rate. In order to investigate the effect of EGR and hydrogen enriched gas on combustion characteristics and emissions, an experiments with single cylinder CRDi engine were carried out concerning the formation of various premixed charge, which can achieved by early injection, EGR and hydrogen enriched gas. EGR was not effective to further reduce NOx and PM emissions. It was found that NOx emissions were decreased with an introduction of hydrogen enriched gas and an adequate diesel fuel amount.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.18 no.1
• /
• pp.66-72
• /
• 2010

This study was done to analyze the condition of combustion exhaust gas that is produced according to incinerator operating condition in A area Kyonggido. The boiler exhaust gas temperature, the oxygen concentration of boiler, the outgassing temperature of Semi Drying Sorber(SDS), the temperature of catalytic reactor, the concentration of NOx, SOx, CO, Hcl and Dust were investigated by change the temperature of incinerator. The concentration of SOx, CO, HCL and DUST were below 5 ppm as increase the temperature of incinerator however the concentration of NOx was increased from 40 ppm to 70 ppm as increase the temperature of incinerator. The boiler exhaust gas temperature and the temperature of catalytic reactor were not changed however the oxygen concentration of boiler was decreased gradually as increase the temperature of incinerator.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.41 no.8
• /
• pp.639-648
• /
• 2013

This paper describes on the NOx/CO emission characteristics, temperature characteristics and flame structures when firing coal derived synthetic gas especially for gases of Buggenum and Taean IGCC. These combustion characteristics were observed by conducting ambient-pressure elevated-temperature combustion tests in GE7EA model combustor when varying heat input and nitrogen dilution ratio. Nitrogen addition caused decrement in adiabatic flame temperature, thus resulting in the NOx reduction. At low heat input condition, nitrogen dilution raised the CO emission dramatically due to incomplete combustion. These NOx reduction and CO arising phenomena were observed at certain flame temperature of $1500^{\circ}C$ and $1250^{\circ}C$, respectively. As increasing nitrogen dilution, adiabatic flame temperature and combustor liner temperature were decreased and singular points were detected due to change in flame structure such as flame lifting. From the results, the effect of nitrogen dilution on the NOx/CO and flame structure was examined, and the test data will be utilized as a reference to achieve optimal operating condition of the Taean IGCC demonstration plant.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.9
• /
• pp.870-875
• /
• 2015

Diesel engines are widely used due to superior power and fuel consumption, however there are many challenges in exhaust gas management. Exhaust gas recirculation (EGR) is the most effective technique for reducing mono-nitrogen oxide (NOx) emissions in a diesel engine, in comparison with other catalytic technologies. In addition, the technology has a number of advantages in terms of economic efficiency and implementation. In this study, the effects on the power and exhaust characteristics of diesel engines equipped with EGR systems were investigated. It was found that as the EGR rate increased, horsepower expressed as IHP and BHP decreased. The net effect of the application of EGR was measured at various engine speeds. EGR technology caused decreases in BHP of around 9% during low engine speed and 3.5% during high engine speed. Additionally, NOx emissions reduced as the EGR rate increased, and increased as engine speed increased. However, smoke emissions increased as the EGR rate increased, and decreased as engine speed increased. The optimum operating conditions and ERG rate to simultaneously achieve minimum NOx and smoke emissions were investigate. It was found that as the EGR rate increased, optimal operating speed for minimal NOx and smoke also increased. Keywords: Diesel engine, Exhaust gas recirculation, Power perfomance, Emission characteristics, NOx, Smoke

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.3
• /
• pp.251-257
• /
• 2012

This work presents an experimental investigation of NOx emissions according to inlet air temperature (550-660 K), stoichiometric air ratio (${\lambda}$, 1.4-2.1), and elevated pressure (2-5 bar) in a High Press Combustor (HPC) equipped with a double cone burner, which was designed by Pusan Clean Coal Center (PC3). The exhaust-gas temperature and NOx emissions were measured at the end of the combustion chamber. The NOx emissions generally decreased as a function of increasing ${\lambda}$. On the other hand, NOx emissions were influenced by ${\lambda}$, inlet air temperature and pressure of the combustion chamber. In particular, when the inlet air temperature increased, the flammability limit was extended to leaner conditions. As a result, a higher adiabatic temperature and lower NOx emissions could be achieved under these operation conditions. The NOx emissions that were governed by thermal NOx were greatly increased under elevated pressures, and slightly increased at sufficiently low fuel concentrations (${\lambda}$ >1.8).

• Journal of Sensor Science and Technology
• /
• v.6 no.4
• /
• pp.274-279
• /
• 1997

NOx sensors using tungsten oxide films as a base material were prepared and their electrical and sensing characteristics have been investigated. The $WO_{3}$ thick films doped with $SnO_{2}$ or $TiO_{2}$ showed higher sensitivity and better sorption characteristics to NOx gas than the pure $WO_{3}$ films material in air at operating temperature of $400^{\circ}C$. By addition of noble catalysts, such as Ru or Au, to the $TiO_{2}-WO_{3}$ thick films, their sensitivity, recovery and selectivity to NOx gas were found to be more enhanced.

• 한국연소학회:학술대회논문집
• /
• 2001.06a
• /
• pp.82-89
• /
• 2001

This paper concerns lean gas cyclone combustion system adopting distributed inlets with different velocity to promote ignition and burnout properties. Detailed temperature measurements have been achieved under different operating conditions and flue gas compositions and NOx have been measured. Experimental results show that cyclone combustor provided increasing combustion stability and reduction NOx emission level to negligible level.

• Journal of the korean Society of Automotive Engineers
• /
• v.8 no.4
• /
• pp.1-12
• /
• 1986

대기오염의 역사는 산업의 발전과 그 맥락을 같이 한다. 자동차가 대기오염의 한 Source로 주목 을 받기 시작한 것은 1940년대초 LA의 극심한 Smog발생의 원인을 찾으면서 부터이며, 1950년대 에 와서 Haagen Smit박사에 의해 Photo Smog의 Mechamism이 해석되면서 Smog를 유발하는 HC, NOx는 자동차 배출 Gas가 50% 이상을, 유해한 CO는 90%이상을 기여한다는 것이 파명되 어, 1965년 미국 California주에서 자동차에 대한 배출 Gas규제가 최초로 시작되었다. 자동차 배출 Gas로서 규제대상은 HC(타화수소), CO, NOx(질소산화물)이며, 엔진 Crankcase Emission(Blow-by Gas), Tail pipe로부터 배출되는 Exhaust Emission, 그리고 연료 Tank, 기 화기등의 연료계로부터 배출되는 Evaporative Emission에서의 HC, CO, NOx 각 상한치를 규제 하고 있다.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2003.05a
• /
• pp.355-360
• /
• 2003

Recently, a cement plays an important roll in the materials field. So, in this research we would like to study on the properties of waste gas reduction in the photocatalytic cement. The fundamental phenomena of waste gas reduction in the photocatalytic cement were observed by the NOx analyzer with reaction chamber, UV Lamp, MFC, and humidity control bath. As a result of this study, the photocatalytic cement used photocatalytic powder, admixture and other materials can obtain NOx gas reduction and its photocatalytic efficiency. Developing for the photocatalytic cement, we need a various study.

• Journal of Ocean Engineering and Technology
• /
• v.13 no.3B
• /
• pp.22-28
• /
• 1999

The purpose of this study is to investigate the NOx emission of turbulent diffusion flame formed in the after burner, which is located on the waste gas coming out from the test furnace. Three types of flame was tested and each of which was changed by adequate equivalence ratio. It is necessary to study more about NOx reduction effect in the after burner system.