• 해양환경안전학회:학술대회논문집
• /
• 해양환경안전학회 2008년도 춘계학술발표회
• /
• pp.185-189
• /
• 2008

동계 한반도의 기후에 큰 영향을 미치는 한랭 건조한 대륙성고기압이 서해를 거쳐 한반도의 확장해 올 때 서해 연안지역의 적설량과 서해의 해황이 어떻게 상호 영향을 미치는가를 알아보았다. 서해 연안지역의 적설량은 인천은 1월, 2월과 12월, 군산과 목포는 1월, 12월과 2월 순으로 적설량이 많다. 한랭 건조한 대륙기단의 중심이 서해를 통과하는 경우가, 서해를 통과하지 않는 경우보다 인천지역에서는 약 3.4배, 군산에서는 약 2.3배 정도를 해양으로부터 많은 열을 흡수한다. 또한, 서해 연안지역에서 1일 10 cm 이상의 대설이 발생한 기간에는 잠열속과 현열속에 의한 방출열량이 약 $100W/m^2$ 이상이다. 대설이 발생한 시기의 기압배치는 중국 북부 지방이나 중부 지방에 고기압이 위치하고, 동해상이나 일본 열도상에 저기압이 존재하여 서해 또는 한반도에서 전선이 형성되는 서고동저형의 특징을 보인다. 한편, 대설이 발생한 기간동안 서해 연안지역의 풍향은 북풍 또는 북서풍이 우세하고, 풍속은 $4\sim8m/sec$ 정도이다.

• 한국항행학회논문지
• /
• 제16권6호
• /
• pp.982-987
• /
• 2012

본 논문에서는 AWGN 채널에서 특정 판정영역 내에 수신된 샘플들을 이용해 DD(Decision Directed) 방식으로 SNR을 추정하는 경우에 발생하는 SNR 추정 오차에 대해서 분석하였다. 수신기에서 특정 성좌점에 해당하는 기준 판정영역에 수신된 샘플들로 이상적인 수신점과의 에러벡터를 이용하여 SNR을 추정하는 경우, 다른 판정영역에 대응되는 송신심볼이 잡음의 영향으로 기준 판정영역으로 넘어온 샘플들까지 포함되므로, 추정된 신호 성좌점의 평균치가 이동함으로써 DD방식의 SNR 추정이 부정확하게 이루어진다. 이러한 현상을 변형된 확률밀도 함수를 기반으로 설명하고 실제 SNR과 추정 SNR과의 오차를 유도하여 정량적으로 분석하였다. 또한 컴퓨터 시뮬레이션을 통한 SNR 추정오차가 이론적으로 유도된 SNR 추정오차와 일치하고, 제안한 보정기법을 통해 SNR 추정 성능을 크게 개선할 수 있음을 확인하였다.

• 전력전자학회논문지
• /
• 제21권5호
• /
• pp.411-417
• /
• 2016

Theoretical IPMSM control technique is complicated, and reliability is low because of the changing parameters. Further, in case of general look-up table designing method which obtains torque characteristics (according to current and speed) or torque characteristics (according to magnetic flux through the entire control region), obtaining a precise result can be difficult and has the disadvantage taking too much time to establish a current look-up table. In this paper, the new auto maximum torque point tracking (MTPT) algorithm that automatically finds the optimum stator d - q axis electric current reference through the entire speed region is devised; consequently, it could establish a 3D look-up table with torque characteristics according to current and speed. In case of using the devised auto MTPT algorithm, the result value detailed was obtained in comparison with the generalized look-up design technique, and checked to reduce the current look-up table establishment time.

• Journal of Positioning, Navigation, and Timing
• /
• 제4권2호
• /
• pp.73-77
• /
• 2015

Global Positioning System (GPS) Precise Point Positioning (PPP) has been extensively used for geodetic applications. Since December 2012, BeiDou navigation satellite system has provided regional positioning, navigation and timing (PNT) services over the Asia-Pacific region. Recently, many studies on BeiDou system have been conducted, particularly in the area of precise orbit determination and precise positioning. In this paper PPP method based on BeiDou observations are presented. GPS and BeiDou data obtained from Mokpo (MKPO) station are processed using the Korea Astronomy and Space Science Institute Global Navigation Satellite System (GNSS) PPP software. The positions are derived from the GPS PPP, BeiDou B₁/B₂ PPP and BeiDou B₁/B₃ PPP, respectively. The position errors on BeiDou PPP show a mean bias < 2 cm in the east and north components and approximately 3 cm in the vertical component. It indicates that BeiDou PPP is ready for the precise positioning applications in the Asia-Pacific region. In addition, BeiDou tropospheric zenith total delay (ZTD) is compared to GPS ZTD at MKPO station. The mean value of their difference is approximately 0.52 cm.

• 한국환경과학회지
• /
• 제18권12호
• /
• pp.1399-1410
• /
• 2009

The study on community structure of benthic macroinvertebrates from wetland Woopo was conducted for the long-term ecological monitoring. The wetland Woopo is located in Changnyeong-Gun, Gyeongsangnam - Do of Korea. In 2006, we investigated the seasonal variation of benthic macroinvertebrates with quantitative and qualitative collecting methods. The collection was performed monthly at four surveying region, Woopo, Sajipo, Mokpo and Topyong stream. In this study, 6 classes, 16 orders, 48 families, 95 species were identified on group of benthic macroinvertebrates. The species diversity index and the species richness index were the highest in Topyung region and it was 3.222 and 10.216 respectively. The two species, Cercion calamorum and Cloeon dipterum were quantitatively collected for 9 months. The changes of body lengths of 50 individuals were recorded and the advanced growth on the two species was expected from present study.

• Food Science and Biotechnology
• /
• 제15권6호
• /
• pp.920-924
• /
• 2006

The microbiological safety of foodservice facilities and side dishes in 6 elementary schools and 6 universities in the Jeolla-do region was evaluated. The micro-aerosol evaluation of foodservice facilities including the kitchen, refrigerators, and freezers showed a comparatively high level of microbial contamination. In the microbial safety evaluation of cooking utensils and appliances, the total plate counts of serving tables, cutting boards, and food plates were comparatively high, but did not reveal significant counts of coliforms, Staphylococcus aureus, and Escherichia coli were both below the general limit of microbial contamination. The microbiological safety of the cooking utensils and appliances were satisfactory. In the microbiological safety evaluation of side dishes served at these foodservice facilities, microbial counts were generally below the limit of microbial contamination.

• Journal of Mechanical Science and Technology
• /
• 제18권3호
• /
• pp.513-525
• /
• 2004

This paper reports an experimental study on flow boiling of pure refrigerants R l34a and R l23 and their mixtures in a uniformly heated horizontal tube. The flow pattern was observed through tubular sight glasses with an internal diameter of 10㎜ located at the inlet and outlet of the test section. Tests were run at a pressure of 0.6 MPa in the heat flux ranges of 5-50㎾/㎡, vapor quality 0-100 percent and mass velocity of 150-600㎏/㎡s. Both in the nucleate boiling-dominant region at low quality and in the two-phase convective evaporation region at higher quality where nucleation is supposed to be fully suppressed, the heat transfer coefficient for the mixture was lower than that for an equivalent pure component with the same physical properties as the mixture. The reduction of the heat transfer coefficient in mixture is explained by such mechanisms as mass transfer resistance and non-linear variation in physical properties etc. In this study, the contribution of convective evaporation, which is obtained for pure refrigerants under the suppression of nucleate boiling, is multiplied by the composition factor by Singal et al. (1984). On the basis of Chen's superposition model, a new correlation is presented for heat transfer coefficients of mixture.

• 한국해양환경ㆍ에너지학회지
• /
• 제9권1호
• /
• pp.36-44
• /
• 2006

연안해역에서 점착성 퇴적물의 수송과정을 수치모의하였다. 복잡한 지형을 가진 연안해역에 효과적인 유한요소모형 이 해수유동과 퇴적물 수송을 모의하기 위해 수립되었다. 침식률을 기존 연구결과 및 바닥퇴적물 시료의 물리특성 분석자료를 가지고 편리하게 결정하였으며, 모의결과는 관측된 부유사 농도의 시간변화와 잘 일치하는 양호한 계산 결과를 보였다, 따라서 본 연구에서 사용한 침식률 결정방법이 퇴적물 수송모의에 효과적으로 활용될 수 있음을 확인할 수 있었다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제23권4호
• /
• pp.533-542
• /
• 1999

In this study the flow characteristics of developing turbulent pulsating flows in a square-sec-tional 180。 curved duct are investigated experimentally. The experimental study of air flow in a square-sectional curved duct is carried out to measure axial velocity distribution secondary flow velocity profiles and wall shear stress distributions by using a Laser Doppler Velocimetry system with the data acquisition and processing system of Rotating Machinery Resolver (RMR) and PHASE software at the entrance region of the duct which is divided into 7 sections from the inlet(${{\o}}=0_{\circ}$) to the outlet (${{\o}}=180_{\circ}$) in $30_{\circ}$ intervals. The results obtained from the study are summarized as follows: (1) The time-averaged critical Dean number of turbulent pulsating flow(De ta, cr) is greater than $75{\omega}+$ It is understood that the critical Dean number and the critical Reynolds number are related to the dimensionless angular frequency in a curved duct. (2) Axial velocity profiles of turbulent pulsating flows are of an annular type similar to those of turbulent stead flows. (3) Secondary flows of trubulent pulsating flows are strong and complex at the entrance region. As velocity amplitudes(A1) become larger secondary flows become stronger. (4) Wall shear stress distributions of turbulent pulsating flows in a square-sectional $180_{\circ}$ curved duct are exposed variously in the outer wall and are stabilized in the inner wall without regard to the phase angle.

• 한국태양에너지학회 논문집
• /
• 제39권6호
• /
• pp.41-54
• /
• 2019

The purpose of this study is to analyze the performance of solar thermal system according to regional weather conditions and feedwater temperature. The performance analysis of the system was carried out for the annual and winter periods in terms of solar fraction, collector efficiency and it's optimal degree. The system is simulated using TRNSYS program for 6 cities, Seoul, Incheon, Gangneung, Mokpo, Gwangju, and Ulsan. Simulation results prove that the solar fraction of the system varies greatly from region to region, depending on weather conditions and feedwater temperatures. Monthly average solar fraction for winter season from November to February, a time when heat energy is most required, indicated that the highest is 73.6% in Gangnueng and the lowest is 56.9% in Seoul. This is about 30% relative difference between the two cities. On the other hand, the collector efficiency of the system for all six cities was analyzed in the range between 40% and 42%, indicating small difference compare to the solar fraction. The annual average solar fraction is rated the highest at 40 collector degree, while monthly average solar fraction during winter season is rated at 60 degree.