• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.3 no.3
• /
• pp.569-577
• /
• 1999

A wideband RF receiver for satellite mobile communications system was fabricated and evaluated of performance in low noise amplifier and high gain amplifier. The low noise amplifier used to the resistive decoupling and self-bias circuits. The low noise amplifier is fabricated with both the RF circuits and the self-bias circuits. Using a INA-03184, the high gain amplifier consists of matched amplifier type. The active bias circuitry can be used to provide temperature stability without requiring the large voltage drop or relatively high-dissipated power needed with a bias stabilized resistor. The bandpass filter was used to reduce a spurious level. As a result, the characteristics of the receiver implemented here show more than 55 dB in gain, 50.83 dBc in a spurious level and less than 1.8 : 1 in input and output voltage standing wave ratio(VSWR), especially the carrier to noise ratio is a 43.15 dB/Hz at a 1 KHz from 1537.5 MHz.

• Journal of electromagnetic engineering and science
• /
• v.9 no.2
• /
• pp.98-104
• /
• 2009

An InGaP/GaAs MMIC LC VCO designed with Harmonic Noise Frequency Filtering(HNFF) technique is presented. In this VCO, internal inductance is found to lower the phase noise, based on an analytic understanding of phase noise. This VCO directly drives the on-chip double balanced mixer to convert RF carrier to IF frequency through local oscillator. Furthermore, final power performance is improved by output amplifier. This paper presents the design for a 1.721 GHz enhanced LC VCO, high power double balance mixer, and output amplifier that have been designed to optimize low phase noise and high output power. The presented asymmetric inductance tank(AIT) VCO exhibited a phase noise of -133.96 dBc/Hz at 1 MHz offset and a tuning range from 1.46 GHz to 1.721 GHz. In measurement, on-chip down-converter shows a third-order input intercept point(IIP3) of 12.55 dBm, a third-order output intercept point(OIP3) of 21.45 dBm, an RF return loss of -31 dB, and an IF return loss of -26 dB. The RF-IF isolation is -57 dB. Also, a conversion gain is 8.9 dB through output amplifier. The total on-chip down-converter is implanted in 2.56${\times}$1.07 mm$^2$ of chip area.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.8 no.4
• /
• pp.289-294
• /
• 2008

A 77 GHz 3-stage low noise amplifier (LNA) employing one common source and two cascode stages is developed using $0.13{\mu}m$ CMOS process. To compensate for the low gain which is caused by lossy silicon substrate and parasitic element of CMOS transistor, positive feedback technique using parasitic inductance of bypass capacitor is adopted to cascode stages. The developed LNA shows gain of 7.2 dB, Sl1 of -16.5 dB and S22 of -19.8 dB at 77 GHz. The return loss bandwidth of LNA is 71.6 to 80.9 GHz (12%). The die size is as small as $0.7mm\times0.8mm$ by using bias line as inter-stage matching networks. This LNA shows possibility of 77 GHz automotive RADAR system using $0.13{\mu}m$ CMOS process, which has advantage in cost compared to sub-100 nm CMOS process.

• Proceedings of the IEEK Conference
• /
• 2002.06b
• /
• pp.61-64
• /
• 2002

We have optimally designed and implemented by a monolithic microwave integrated circuit(MMIC) the low noise amplifier(LNA) of 5.8GHz band composed of receiver front-end(RFE) in a on-board equipment system for dedicated short range communication using a depletion-mode GaAs MESFET. The LNA is provided with two active devices, matching circuits, and two drain bias circuits. Operating at a single supply of 3V and a consumption current of 18㎃, The gain at center frequency 5.8GHz is 13.4dB, Noise figure(NF) is 1.94dB, Input 3rd order intercept point(lIPS) is 3dBm, and Input return loss(5$_{11}$) and Output return loss(S$_{22}$) is -l8dB and -13.3dB, respectively. The circuit size is 1.2$\times$O.7$\textrm{mm}^2$.EX>.>.

• Electronics and Telecommunications Trends
• /
• v.36 no.3
• /
• pp.53-64
• /
• 2021

As the 5G service market is expected to grow rapidly, the development of high-power, high-efficiency power amplifiers for the 5G communication infrastructure is indispensable. Gallium nitride (GaN) is attracting great interest as a key device in power devices and integrated circuits due to its wide bandgap, high carrier concentration, high electron mobility, and high-power saturation characteristics. In this study, we investigate the technology trends of Ka-band GaN radio frequency (RF) power devices and integrated circuits for operation in the millimeter-wave band of recent 5G mobile communication services. We review the characteristics of GaN RF high electron mobility transistor (HEMT) devices to implement power amplifiers operating at frequencies around 28 GHz and compare the technology of foreign companies with the device characteristics currently developed by the Electronics and Telecommunication Research Institute (ETRI). In addition, the characteristics of Ka-band GaN monolithic microwave integrated circuit (MMIC) power amplifiers manufactured using various GaN HEMT device technologies are reviewed by comparing characteristics such as frequency band, output power, and output power density of integrated circuits. In addition, by comparing the performance of the power amplifier developed by ETRI, the current status and future direction of domestic GaN power devices and integrated circuit technology will be discussed.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.39 no.2
• /
• pp.81-91
• /
• 2002

In this paper, a high-quality integrated transformer using bondwires is proposed and fabricated. The bondwire transformer inherently has low conductor loss due to wide cross-section and small parasitic capacitance because the vertical placement of the bondwire loop separates from substrate and effectively reduces the substrate effects. It can be fabricated easily by used of the modern automatic wirebonding technology. The electrical characteristics of the fabricated transformers are compared with those of the spiral transformer It is expected that the bondwire transformer can improve the performance for RFIC and MMIC applied to a variety of application, for example, Mixer, Balanced Amplifier, VCO, and LNA.

• Proceedings of the IEEK Conference
• /
• 2002.06b
• /
• pp.181-184
• /
• 2002

본 논문에서는 600Hz 무선 LAN 시스템에 탑재를 위한 600㎓ 대역 전력증폭기 모듈을 개발 하였다. 600㎓ 대역 전력증폭기 모듈에 실장된 600㎓ 대역 전력증폭기 MMIC는 ETRI에서 설계 및 제작한 것으로 칩의 크기는 2.80 × 1.75㎟이며, on-wafer측정을 하여 얻은 결과는 동작 주파수 58~620Hz에서 소신호 이득은 12.4dB이고, 최대 소신호 이득은 59~60G보z에서 ISdB이며, 출력전력(Pldn)은 16.3~16.7dBm을 얻었다. 이와 같은 특성을 갖는 전력증폭기 MMIC를 사용하여 모듈을 제작하였으며, RF feed line을 위해 Rogers 사의 R03003 기판을 사용하였다. 모듈의 입출력은 동작 주파수 대역에 적합한 WRl5라는 waveguide 형태를 사용하였고, DC 바이어스 공급을 위해 3.5㎜ K-connector를 사용하였다 제작한 모듈의 크기는 40 × 30 × 15㎣이며, 최적의 성능을 얻고자 tuning bar를 상하로 이동하여 최적점을 찾았으며 나사로 고정하여 상태를 유지하도록 하였다. DC 바이어스 및 RF feed line과 칩의 연결은 본딩에 의한 인덕턴스를 최소화하기 위하여 3mil 두께의 리본 본딩을 하였다 전력증폭기 모듈을 측정한 결과, 동작주파수 600㎓ 대에서 소신호 이득은 6dB 이상, 입력 정합은 -lOdB 이하, 출력 정합은 -4dB 이하로 측정되었긴, 출력전력은 SdBm 이상으로 측정되었다. 동국대에서 제작한 600Hz 무선 LAN 시스템에 전력증폭기 모듈을 시스템 송신부에 탑재 시험한 결과, 동영상을 실시간으로 전송하는데 성공하였다.

• ETRI Journal
• /
• v.34 no.4
• /
• pp.485-491
• /
• 2012

In this paper, the implementations of a $0.1{\mu}m$ gallium arsenide (GaAs) pseudomorphic high electron mobility transistor process for a low noise amplifier (LNA), a subharmonically pumped (SHP) mixer, and a single-chip receiver for 70/80 GHz point-to-point communications are presented. To obtain high-gain performance and good flatness for a 15 GHz (71 GHz to 86 GHz) wideband LNA, a five-stage input/output port transmission line matching method is used. To decrease the package loss and cost, 2nd and 4th SHP mixers were designed. From the measured results, the five-stage LNA shows a gain of 23 dB and a noise figure of 4.5 dB. The 2nd and 4th SHP mixers show conversion losses of 12 dB and 17 dB and input P1dB of -1.5 dBm to 1.5 dBm. Finally, a single-chip receiver based on the 4th SHP mixer shows a gain of 6 dB, a noise figure of 6 dB, and an input P1dB of -21 dBm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.13 no.4
• /
• pp.277-284
• /
• 1988

A 12GHz low-noise amplifier, a single gate GaAs MESFET mixer, and a low-pass filter have been fabricated for DBS receiver applications by using MIC technology. Each subsystem contains DC block with symmetric line and ship capacitor, respectively. The frequency converter with chip capacitor exhibits a 20-23 dB conversin gain with a RF bandwidth of 11.581-11.981 GHz and an IF bandwidth of 581-981MHz. Rf bandwidth of 12.1GHz and an IF banewidth of 1GHz.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.2A
• /
• pp.194-200
• /
• 2006

A 26.4 GHz phase locked oscillator(PLO) for communication satellite transponder is developed. The PLO consists of fundamental frequency generation module(FFGM) and frequency multiplication part(FMP). The signal of 26.4 GHz is generated through frequency tripling process of 8.8 GHz fundamental frequency. Phase locking technique using sampling phase detector(SPD) is adopted to design the FFGM. The MMIC tripler and amplifier are also designed for the reduction of the size and mass of FMP. The phase noise characteristics are exhibited as -96 dBc/Hz at 10 tHz offset frequency and -105 dBc/Hz at 100 kHz offset frequency, respectively, with the output power over 11 dBm. All performance parameters are complied with the design requirements.