• Proceedings of the IEEK Conference
• /
• 2002.06b
• /
• pp.165-168
• /
• 2002

As the demand for higher data-rate chip-to-chip communication such as memory-to-controller, processor-to-processor increases, low cost high-speed serial links\ulcorner become more attractive. This paper describes a 0.25-fm CMOS 1.6Gbps/pin 4-level transceiver using Stub Series Terminated Logic for high Bandwidth. For multi-gigabit/second application, the data rate is limited by Inter-Symbol Interference (ISI) caused by channel low pass effects, process-limited on-chip clock frequency, and serial link distance. The proposed transceiver uses multi-level signaling (4-level Pulse Amplitude Modulation) using push-pull type, double data rate and flash sampling. To reduce Process-Voltage-Temperature Variation and ISI including data dependency skew, the proposed high-speed calibration circuits with voltage swing controller, data linearity controller and slew rate controller maintains desirable output waveform and makes less sensitive output. In order to detect successfully the transmitted 1.6Gbps/pin 4-level data, the receiver is designed as simultaneous type with a kick - back noise-isolated reference voltage line structure and a 3-stage Gate-Isolated sense amplifier. The transceiver, which was fabricated using a 0.25 fm CMOS process, performs data rate of 1.6 ~ 2.0 Gbps/pin with a 400MHB internal clock, Stub Series Terminated Logic ever in 2.25 ~ 2.75V supply voltage. and occupied 500 * 6001m of area.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.9 no.2
• /
• pp.85-90
• /
• 2009

This paper presents a single supply PLC SoC ASIC with a built-in analog Front-end circuit. To achieve the low power consumption along with low cost, this PLC SoC employs fully CMOS Analog Front End (AFE) and several LDO regulators (LDOs) to provide the internal power for Logic Core, DAC and Input/output Pad driver. The receiver part of the AFE consists of Pre-amplifier, Gain Amplifier and 1 bit Comparator. The transmitter part of the AFE consists of 10 bit Digital Analog Converter and Line Driver. This SoC is implemented with 0.18 ${\mu}m$ 1 Poly 5 Metal CMOS Process. The single supply voltage is 3.3 V and the internal powers are provided using LDOs. The total power consumption is below 30 mA at stand-by mode to meet the Eco-Design requirement. The die size is 3.2 $\times$ 2.8 $mm^{2}$.

• Journal of Institute of Control, Robotics and Systems
• /
• v.12 no.9
• /
• pp.883-890
• /
• 2006

Nowadays, CPS is used widely, especially in cases which need more precise position information, such as car navigation systems and even in the mobile robot for position measuring in the outdoor environment. RTK (Real-Time Kinematics) and DGPS (Differential Global Positioning System) have more precise accuracy than the general-purposed GPS. However can't easily use them because of high prices and large size of equipments. In order fur the mobile robot to obtain precise position information it is important that CPS receiver has portability and low price. In this study, we introduce a new GPS data acquisition system that offers the precise position data using the DGPS mechanism and satisfying low cost and portability. In addition to this, we propose an improved data compensation algorithm that offers more accurate position information to the outdoor mobile robot by compensating the error rate of CPS data measured from the three points with geometrical rotation and distance formula. Proposed method is verified by comparing with the precise real position data obtained by RTK. Proposed method has more than 70% performance enhancement.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.311-315
• /
• 2006

Precision location and positioning of Asset within a network is an attractive feature with various applications, especially in indoor environments. Such a demand is met by the standard task group, IEEE 802.15.4a. Several methods, that is, pulse, chirp and chaotic communications have been proposed so far to satisfy the requirements of the standard. Among them, ultra wideband direct chaotic communications has advantageous features such as low hardware complexity, low cost, lower power consumption and flexible frequency band plan. In this paper, the feasibility of the ranging system using non-coherent chaotic transceiver is investigated by designing and implementing the system and the performance is proved by conducting location experiments in real indoor environments.

• Journal of Korean Society for Geospatial Information Science
• /
• v.23 no.4
• /
• pp.49-55
• /
• 2015

This paper explains major considerations for integrated GPS/GLONASS/BDS positioning, and then analyzes integrated GNSS positioning accuracies based on low-cost receivers in open-sky and poor reception environments. In an open-sky environment, horizontal RMSE of the integrated system positioning is about 1.2m. It shows improved result compared with single system positioning, the improvement ratio was 17-55%. In poor reception environments, we sometimes could not do positioning because the number of visible satellites gets below four. In an integrated positioning mode, the number of visible satellites was always higher than four, allowing us to find positions all the time. The horizontal RMSE of the integrated system positioning in poor reception environments is about 6.4m. Compared with single system positioning;the integrated system positioning shows better performance and the improvement ratio was 8-47% for the horizontal directions.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.9
• /
• pp.1087-1093
• /
• 2012

In this paper, we implemented a HF-band magnetic-field communication system consisting of an amplitude shift keying(ASK) transmitter, a pair of loop antennas, and an ASK receiver. Especially, we suggested a new ASK transmitter architecture, where a drain bias of class E amplifier is switched alternatively between two voltage levels with respect to input data. A maximum 5 W class E amplifier was designed using a low cost IRF510 power MOSFET at the frequency of 6.78 MHz. A measured sensitivity of the designed ASK receiver is -78 dBm, which consists of a log amplifier, a filter, and a comparator. Maximum communication range of magnetic-wave communication system with loop antennas was calculated using magnetic field equations in both near-field and far-field ranges. Also, in order to verify the calculated values, an indoor propagation loss was measured using a pair of loop antennas whose dimensions are $30{\times}30cm$. Maximum operating range is estimated about 35 m in case of transmitter's output power of 1 W and receiver sensitivity of -70 dBm, respectively. Finally, the communication field test using the designed ASK transmitter and receiver was successfully done at the distance of 5 m.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2015.10a
• /
• pp.279-282
• /
• 2015

Fisheries development of the basic law pursuant to article 15 (marine safety management, etc.) one of maritime safety and maritime traffic facilities nationwide network of DGPS in accordance with the building maximize infrastructure utilization and country. Source technology has been improving steadily raised for the benefit daegukmin. In particular, look at the type of product for the marine supply medium-wave receiver Performance products that satisfy most of the IMO Advisory. The antenna and receiver are separate structural supply for some integrated model with a very high Rather it is used as a portable receivers for marine positioning cheap integrated model development is needed. Correction of satellite navigation receivers for the current Marine GPS module, medium-wave modules can be developed one low cost Integrated in independent operating environments do not support the model development done look at what the problem is 285kHz ~ 315kHz in DGPS Beacon receiver structure using a medium wave or Beacon The medium-wave antenna and a GPS receiver signal to noise ratio was studied GPS signal attenuation on the DGPS performance looked at each GPS manufacturer medium-wave signal-to-noise ratio and normalized impact by GPS manufacturers noise power ratio per bandwidth for medium-wave GPS signals affect it was implemented to improve performance.

• Journal of Advanced Navigation Technology
• /
• v.20 no.5
• /
• pp.433-439
• /
• 2016

Several low-cost global navigation satellite system (GNSS) receivers do not support general range-domain correction, and DGNSS-CP (differential GNSS) method had been suggested to solve this problem. It improves its position accuracy by projecting range-domain corrections to the position-domain and then differentiating the stand-alone position by the projected correction. To project the range-domain correction, line-of-sight vectors from the receiver to each satellite should be calculated. The line-of-sight vectors can be obtained from GNSS broadcast ephemeris data or satellite direction information, and this paper shows positioning performance for the two methods. Stand-alone positioning result provided from Septentrio PolaRx4 Pro receiver was used to show the difference. The satellite direction information can reduce the computing load for the DGNSS-CP by 1/15, even though its root mean square(RMS) of position error is bigger than that of ephemeris data by 0.1m.

• Journal of Advanced Navigation Technology
• /
• v.15 no.1
• /
• pp.83-90
• /
• 2011

The technique of localization is the core technology for information exchange or environment monitering to measure the position of an object or person. Today, the techniques of localization have been studied extensively and it can be applied to logistics, medical, robotics, etc. But, a lot of money to apply technique of localization is needed. Hence in this paper, we proposed AoA localization system based on Zigbee at low cost. The System measured the RSSI value by rotating the directional antenna using a step motor and Zigbee module. When the measured RSSI is the largest, the receiver measures the angles from beacons which are located at the corners with the rotating angle of a stepping motor and the position of the receiver will be calculated by appling AoA localization method. The measured results show an error about 35~36 cm.

• Korean Journal of Optics and Photonics
• /
• v.20 no.3
• /
• pp.143-147
• /
• 2009

We propose an asymmetrical 2.5 Gbps / 622 Mbps bidirectional optical subscriber network with Manchester coded downstream and NRZ (Non-Return-to-Zero) upstream remodulation. The proposed system has important characteristics in the optical network unit (ONU): it does not require a light source or the usual control circuits such as wavelength control and output power control, and it is possible to use a synchronization scheme between upstream and downstream data. We theoretically analyze BER(Bit Error Rate) performance of upstream data remodulated with Manchester coded downstream according to the types of NRZ downstream data and perform simulations with MATLAB. The BER performance and the receiver sensitivity have been improved by 3 dB by adjusting threshold levels compared to the conventional receiver. The results have shown the remodulation scheme with Manchester coded downstream could be a useful technology for asynchronous and asymmetric optical subscriber networks with low cost and simple structures.