• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.10
• /
• pp.33-38
• /
• 2011

A novel low-power synchronization technique is presented for the local synchronization. Since the proposed technique transmits an enable signal instead of a clock signal which consumes large power, it can considerably reduce the power consumption. The source-synchronization scheme which is widely adopted for the local synchronization is compared with the proposed technique. It is shown that the proposed low-power synchronization technique provides approximately 50% power saving.

• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 1998.04a
• /
• pp.373-380
• /
• 1998

Generally the excessive caused by isolated sources in localized to members closely located to the vibration sources. In this case it may not be economical to model the whole structure to obtain the responses of a specific member. In this study, a substructuring technique has been used for local vibration of a framed structure. The boundary conditions of members selected are determined by condensing the degrees of freedom of the remaining members. Fixed and hinged boundary condition are also assumed for comparison. According to the results, the substructuring technique is quite efficient in predicting the responses of a structure on which the vibration source in located, but is not very reliable for the members located for away from the source.

• Journal of Environmental Science International
• /
• v.3 no.1
• /
• pp.39-47
• /
• 1994

Dispersion characteristics of air pollutants in the mountainous coastal area are investigated in considering with the mesoscale local circulations using a two dimensional numerical model with two kinds of topograpy of 500m and 300m. In the model, land-sea breezes and mountain-valley wind are mainly considered under the condition of the absence of large scale prevailing flow in the circulation analysis, and the pollutants dispersion is traced by the Lagrangian methods. According to the results, the wind velocity is affected by topography and is stronger in the case of 500m height mountain than that of 300m, the Pollutants that source is near the coast transported over the mountain and dispersed to behind inland area. It is classified that the topography change control affects the wind velocity and the circulations. The pollutants that source is different transported and concentrated to behind inland and/or diffused to the sea area by the combination of the wind system with topographic changes. The results can be applied to the air pollution control with the arrangement design of industrial area and the planning of coastal developments.

• Nuclear Engineering and Technology
• /
• v.52 no.8
• /
• pp.1650-1660
• /
• 2020

Comparing with the large containment, the gas can not flow freely within the local compartment due to the small volume of the compartment in case of serious accident, which affects the hydrogen flow distribution, and it will determines the location where high concentration occurs in compartment. In this paper, hydrogen distribution and possible hydrogen risk in the vessel under the different conditions are investigated. The results show that when the initial gas momentum is increased, the ability of gas enters into the upper region of the vessel will be strengthened, and the hydrogen volume fraction in the upper region of the vessel is higher. Comparing with horizontal source direction, when source direction is vertically towards upper space, hydrogen is more likely to accumulate in the upper region of the vessel. With the increasing of steam mass flow, the dilution effect of steam on the hydrogen volume fraction will be strengthened, while the pressure in the vessel is also increased. When steam flow is decreased, the hydrogen explosion risk is higher in the vessel. The experiment data can provide technical support for the validation of the CFD software and the mitigation of hydrogen risk in the containment compartment.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.18 no.2
• /
• pp.479-491
• /
• 1994

Discrete vortex method was applied for simulating an active control of turbulent leading- edge separation bubble. The leading-edge separation zone was perturbed by a time-dependent sinusoidal perturbation of different frequencies and levels. In order to describe the local sinusoidal perturbation at the separation point, a source pulsation vortex technique was proposed. The present two-dimensional vortex simulations were qualitatively compared with the experimental results for a blunt circular cylinder, where perturbation was introduced along the square-cut leading edge of the cylinder $(Kiya et al.^{(6,7)}).$ It was found that the reattachment length attained a minimum point at low levels of perturbation and two minima at a moderate higher perturbation frequency. The effects of local perturbation on the evolution of leading-edge separation bubble were scrutinized by comparing the perturbed flow with the natural flow. These comparisons were made for the distributions of mean velocity and its velocity fluctuations, intermittency and wall velocity. The motions of instantaneous reattachment in the space-time domain were demonstrated, which were also compared with the experimental findings. In order to investigate the reduction mehanism of reattachment length in the separation bubble, various cross-correlations for velocity and pressure and the relevant convection velocities were evaluated. It was observed that the convection velocity was closely associated with its corresponding pulsationg frequency.

• Journal of Power Electronics
• /
• v.14 no.4
• /
• pp.733-741
• /
• 2014

The integration of photovoltaic (PV) energy sources into DC grid has gained considerable attention because of its enhanced conversion efficiency with reduced number of power conversion stages. During the integration process, a local control unit is normally included with every power conversion stage of the PV source to accomplish the process of maximum power point tracking. A centralized monitoring and supervisory control unit is required for monitoring, power management, and protection of the entire system. Therefore, we propose a field-programmable gate array (FPGA) based centralized control unit that integrates all local controllers with the centralized monitoring unit. The main focus of this study is on the process of integrating many local control units into a single central unit. In this paper, we present design and optimization procedures for the hardware implementation of FPGA architecture. Furthermore, we propose a transient analysis and control design methodology with consideration of the nonlinear characteristics of the PV source. Hardware experiment results verify the efficiency of the central control unit and controller design.

• The Journal of the Korea Contents Association
• /
• v.10 no.9
• /
• pp.107-116
• /
• 2010

The facility location problem is one of the traditional optimization problems. In this paper, we deal with the single source capacitated facility location problem (SSCFLP) and it is known as an NP-hard problem. Thus, it seems to be natural to use a heuristic approach such as evolutionary algorithms for solving the SSCFLP. This paper introduces a new efficient evolutionary algorithm for the SSCFLP. The proposed algorithm is devised by incorporating a general adaptive link adjustment evolutionary algorithm and three heuristic local search methods. Finally we compare the proposed algorithm with the previous algorithms and show the proposed algorithm finds optimum solutions at almost all middle size test instances and very stable solutions at larger size test instances.

• Journal of Korean Library and Information Science Society
• /
• v.47 no.4
• /
• pp.359-384
• /
• 2016

This study aims to develop digital archives for honam catholic history institute. To achive the goal, this study considers historical archives of honam catholic history institute. Also, this study proposed an effective archiving method based on OSS(open source software) for contents collection, management, preservation and service. Archiving of local cultural contents can contribute to the local development along with cultural industry policy. This study performed interview with people in charge of management of archives to extract general requirements for implementation of local archives. With the results, this study limitations of current archives management and considerations of implementation of local archives. This study proposed a method to effectively solve the limitations through the processes.

• Journal of Korean Society for Atmospheric Environment
• /
• v.34 no.4
• /
• pp.517-533
• /
• 2018

We utilize the CAMx (Comprehensive Air Quality Model with eXtensions) system and the PSAT (Particulate Source Apportionment Technology) diagnostic tool to determine the $PM_{2.5}$ concentration and to perform its source apportionment in the southeastern region of South Korea. For a year-long simulation, eight local authorities in the region such as Pohang, Daegu, Gyeongju, Ulsan, Busan-Gimhae, Gosung-Changwon, Hadong, and all remaining areas in Gyeongsangnam-do, are selected as source areas based on the emission rates of $NO_x$, $SO_x$, VOC, and primary PM in CAPSS (Clean Air Policy Support System) 2013 emissions inventory. The CAMx-PSAT simulation shows that Pohang has the highest $PM_{2.5}$ self-contribution rate (25%), followed by Hadong (15%) and Busan-Gimhae (14%). With the exception of Pohang, which has intense fugitive dust emissions, other authorities are strongly affected by emissions from their neighboring areas. This may be measured as much as 1 to 2 times higher than that of the self-contribution rate. Based on these estimations, we conclude that the efficiency of emission reduction measures to mitigate $PM_{2.5}$ concentrations in the southeastern region of South Korea can be maximized when the efforts of local or regional emission controls are combined with those from neighboring regions. A comprehensive control policy planning based on the collaboration between neighboring jurisdictional boundaries is required.

• Journal of Korean Society for Atmospheric Environment
• /
• v.26 no.1
• /
• pp.21-33
• /
• 2010

The objective of this study was to estimate the $PM_{2.5}$ source apportionment at the Pinnacles National Monument IMPROVE site in western coastal USA. The PMF was applied to identify the existing sources and apportion the $PM_{2.5}$ mass to each source. To analyze local source impacts from various wind directions, the NPR analysis was performed using source contribution results with the wind direction values measured at the site. Also, PSCF was applied to identify the locations by point sources relative to the back trajectories. A total of 1,634 samples were collected from March 1988 to May 2004 by IMPROVE sampler and 32 chemical species were analyzed by PIXE, PESA, XRF, IC, and TOR methods. The PMF modeling identified seven sources and the average mass was apportioned to gasoline vehicle, secondary sulfate, aged sea salt, secondary nitrate, wood/field burning, diesel emission, and soil, respectively. In this study, the average mass was apportioned to gasoline vehicle (33.0%), secondary sulfate (25.7%), aged sea salt (17.8%), and secondary nitrate (10.1%). Also, this study suggests the possible role for source apportionment study of $PM_{2.5}$ at similar areas such as wildness, national park, and coastal areas in Korea.