• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.20 no.8
• /
• pp.703-709
• /
• 2010

An analysis tool for predicting transmission loss in high speed trains based on combined use of the statistical energy analysis and the finite element methods has been proposed. The analysis utilizes a commercially available numerical solver VA ONE with imbedded NASTRAN module. The proposed analysis tool is first verified by comparing numerically predicted transmission loss of a light rail transport(LRT) structure with experimental results. The comparison shows that the numerically predicted transmission loss is similar to the experimental data. The analysis tool is then applied to the prediction of transmission loss in the high speed train(HST) currently under development. Various sub-structures such as the floor, side panel and ceiling have been numerically analyzed to predict their transmission losses. The results obtained here can be used as input data for predicting the interior noise level of the HST at design stage.

• International Journal of Concrete Structures and Materials
• /
• v.7 no.1
• /
• pp.51-59
• /
• 2013

The use of light-gauge steel framing in low-rise commercial and industrial building construction has experienced a significant increase in recent years. In such construction, the wall framing is an assembly of cold-formed steel (CFS) studs held between top and bottom CFS tracks. Current construction methods utilize heavy hot-rolled steel sections, such as steel angles or hollow structural section tubes, to transfer the load from the end seats of the floor joist and/or from the load-bearing wall studs of the stories above to the supporting load-bearing wall below. The use of hot rolled steel elements results in significant increase in construction cost and time. Such heavy steel elements would be unnecessary if the concrete slab thickening on top of the CFS wall can be made to act compositely with the CFS track. Composite action can be achieved by attaching stand-off screws to the track and encapsulating the screw shank in the deck concrete. A series of experimental studies were performed on full-scale test specimens representing concrete/CFS flexural elements under gravity loads. The studies were designed to investigate the structural performance of concrete/CFS simple beams and concrete/CFS continuous headers. The results indicate that concrete/CFS composite flexural elements are feasible and their structural behavior can be modeled with reasonable accuracy.

• Korean Institute of Interior Design Journal
• /
• v.14 no.5 s.52
• /
• pp.44-51
• /
• 2005

This study focuses 'Korean characteristics' in architectural interior design. In this study, some Korean characteristics was extracted by analysing traditional Korean spaces and as well as by considering the architectural interior spaces which are designed with Korean character since 1970. This paper started with differenciating the elements and principles that consist of space, and then classified the elements into 8 categories such as Spatial system, Enclosure system, Circulation system, Material system, Furnishing system, Light, Color, Context which are analysing frames. As a conclusion, the concepts of Korean characteristics are extracted and suggested as design concept with Korean characteristics by analysing the contents of each category. These concepts were presented with simple diagrams and supporting cases were also presented in this paper. The design concepts of 'Korean characteristics' are classified in the 25 concepts: Holonic composition, Transitional space, Hierarchy by floor level, Gradation of privacy, Changeability, Various central yards, Space with opened edges, Gray space, Continuity of space, Translucent wall, Folding-lifting wall, Skeleton, Abstract facet, Path as a message, Mild light, Multii-layered vista, Fluidity, framed scenery, Serial view, Interpenetrating Space, Harmony with nature, Organic interrelationship, Complementary Dual Structure, Temporal change of space, Hierarchical order.

• Journal of the Korean Institute of Educational Facilities
• /
• v.11 no.1
• /
• pp.25-37
• /
• 2004

This study is derived from a problem for the blind, how to recognize the space and how to find their way. Unlike ordinary people, the disabled people are closely related with special constructor environment using the other sense. Especially, to find his/her location, each person depends on the wayfinding ability as acquiring specific and various information,(e.g. recognizing figure by tactile sense, space size by auditory sense, direction by light from a window and regular noise, and existence of switch in a specific place.) Those senses help the person's wayfinding to his/her destination. The procedure of wayfinding are location, position, orientation, navigation, and movement. Consequently, construction for the people above mentioned can offer a design-guideline considering following factors, building arrangement considering regular noise, refurbishment, plan configuration of floor and wall-skin changed, circulation stream that maintains right angle by the regular noise in the building, enforcement location character by the inflow of the light into a crossing.

• Journal of the Korean Solar Energy Society
• /
• v.24 no.2
• /
• pp.39-50
• /
• 2004

One of the challenge for successful daylighting design might be to capture sunlighting that varies in both intensity and position and to deliver the luminous flux into the inner space as deep as possible. Conventional glazing apertures allow daylight in the outer 3.5m of a perimeter spaces. More advanced daylighting technologies can extend this daylighting depth by reflecting sunlight further from the windows within a deep floor area. For this purpose, this study developed light shelves based on performance evaluation with a mock-up model that constructed recently and measured under real sky condition. All these daylighting devices have a customized geometry developed from the solar path at a given latitude and utilize unique reflecting finishing to maximize the amount of redirection and diffusion of the daylight. This paper tells that the best daylighting penetration typically can be expected from using light-colored sloped external shelves.

• Journal of The Korean Digital Architecture Interior Association
• /
• v.12 no.4
• /
• pp.87-95
• /
• 2012

Autoclaved lightweight concrete (ALC), also known as autoclaved aerated concrete (AAC), is a lightweight, precast building material that simultaneously provides structure, insulation. ALC is a unique building material. Because of its cellular nature, it is lightweight, self-insulating, as well as sound and fireproof. ALC products include blocks, wall panels, floor and roof panels, and lintels. Recently, the use of ALC has became increasingly popular. However, ALC have high water absorption, low compressive strength and popout the origin of the low surface strength in its properties. Thus, this study is to improve the fundamental strength by controls of increasing of admixtures and chemical reactants. Admixtures make use of meta kaolin and silica fume, chemical reactants make use of sodium silicate and sodium hydroxide. From the test result, the ALC using admixtures and chemical reactants have a good fundamental properties compared with plain ALC. These good fundamental properties is caused by the admixtures and chemical reactants of ALC by the reason of the micro filling effect and chemical binding of C-S-H gel, tobermolite and quartz.

• Proceedings of the KIEE Conference
• /
• 1998.07e
• /
• pp.1770-1772
• /
• 1998

This study is concluded under by investigation about the lighting environment on a blackboard in elementary, middle, high school of inchon metropolitan. 1. The illumination was approximated to standard value in the side of quantity by the result of the Mimistry of Education's command. However, the uniformity of illuminescence was relatively increased. 2. In order to raise the blackboard lighting, we installed local lighting fixture for blackboard but most of schools are directly adopted to the way of sticking to the blackboard and the lower part of the blackboard is not effective. So that it is desirable of teacher and students to put the local lighting in front of the higher part of the blackboard or install in setting the perfect diffusion light from the ceiling. 3. Deviation of luminance is also more groat when local lighting exist for blackboard. And, regardless of local lighting, luminance of blackboard in side of window, from direction of floor is high because of regular reflected light. Therefore a curtain or blind must be installed pertinently.

• Journal of the Korean Institute of Educational Facilities
• /
• v.4 no.4
• /
• pp.29-41
• /
• 1997

The objective of this paper is to construct a model to be used in deciding whether to repair or rebuild school buildings is depending on their ages and other factors. The theme of this paper is the age is the main variable but other factors such as floor, innerwall, ceiling, door, inner window of the class room, outer window of the class room, inner window of the corridor, outer window of the corridor, middle window between the classroom and the corridor, light, heater, speaker, fire protection sensor, TV monitor, and telephone status would influence the final decisions. This paper employs an experimental case study method. Using the stepwise, statistical, classification method commonly used in discriminant analysis, it evaluates 12,766 rooms of 87 different high schools in Seoul. The result of this study indicates that some critical variables influencing the final decisions are the status of TV monitor, middle window between the classroom and the corridor, light, inner window of the corridor, fire protection sensor, innerwall, speaker utensil, outer window of the class room, and door of the class room. This paper also suggests a linear discriminant function will be used for this kind of studies. Finally the paper recommends policies with respect to the variables and discriminant functions evaluated.

• Korean Institute of Interior Design Journal
• /
• no.17
• /
• pp.65-72
• /
• 1998

This study intends to analyze the various spatial structures and characteristics of the museum based on the two of the Renzo Piano's recent projects Menil Collection '||'&'||' Museum and Beyeler Foundation Museum Which defined the direction of the "Third Generation" in museum architecture with reference to the quality of spatial experience and design applications. Comparison and analysis were done on the basic spatial organization floor layout accessibility exhibition area lighting plan and circulation between the two museum. Through the itemized common characteristics of the museum the architect's proposal on meaning and direction of the new museum architecture can be viewed. The contemporary museums distinguish themselves quite clearly from their predecessors and this applies both to their own form and to their spatial organization. As the public demands and requests toward the museum building facility expand everyday the architect must respond by providing multiple types of space where people can experience different atmosphere in each area. One concept he used to create multi experienced area was manipulation of the natural light using by the state-of-the-art techniques of the light filtering system and multi-layering roof system to protect the valuable collections against the direct sunlight. But mainly it was to prove his strong belief in "architecture of light" by creating space with minimized meaning by purposely distinguished area in order to provide maximum support to the physical value of the collection " The connection with nature" is another concept which Piano used to provide the public a tranquil experience through out the architecture which engages in a lively dialogue with art. In spatial organization Piano concerned on functionality which not only concentrated on the visitor's point of view but also on the museum staff's comfort. Unlkie the traditional museum he alternates various size of exhibition areas for spatial hierarchy. Specially the spatial flexibility that the temporary exhibition areas are able to be expanded to the permanent exhibition areas by adjoining t재 spaces differentiate Piano's new museum from the rest. museum from the rest.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.10
• /
• pp.5176-5183
• /
• 2013

In general, Korean Lightweight Concrete used Heat insulating material for building and filler for civil construction, backfill material for tunnel, office floor fillers, lightweight blocks and so on. These expand the range of use ALC(autoclaved lightweight concrete) on the soft-ground at regular intervals during road construction by installing piles used as substrates for the process is under study. In this study, behavior characteristics on the soft-ground of pavement analysis was used to test the geo-Centrifuge. Prototype pavement reduced to 1/30 slab form of the composition as kaolinite model tests were conducted in the soft ground. Pile Arrangement (having 36 component pile with an array of $3{\times}12$) was used to group of piles. Tests of gravity 30 level the centrifugal force acting Light-weight pavement models. Based on the Prototype pavement of the behavior characteristics of pavement behavior characteristics were estimated. FMA analysis of the 10 times as big 39.4kg (actual load 35 ton) of the lateral load is applied to the case 7.8mm (actual behavior 23.4mm) behavior was fine.