• Journal of the Society of Naval Architects of Korea
• /
• v.48 no.5
• /
• pp.381-389
• /
• 2011

In this study, we are focusing our attention on lift characteristics of the low aspect wings for Wing-In Ground effect crafts (WIG). Experimental measurements at an open-type wind tunnel are carried out and results are comparatively presented. In order to simulate the realistic ground condition in where the WIG craft is flying, moving ground is implemented by a conveyor belt rotating with the same velocity of the inflow. We consider two different wings (NACA0012 and DHMTU section) which have four different aspect ratios (0.5, 1.0, 1.5 and 2.0). Forces acting on the wings are measured and lift characteristics are elaborately investigated for various different conditions. In addition, end-plate effects are estimated. Results are validated by comparing with theoretic solutions of the symmetric airfoil. Present results show that ground effects are differently generated in moving or fixed ground conditions, and hence left characteristics are affected by the ground condition. Consequently, accurate aerodynamic forces acting on the WIG craft are guaranteed in a realistic moving ground condition.

• Journal of the Society of Naval Architects of Korea
• /
• v.54 no.6
• /
• pp.470-475
• /
• 2017

Since the intake air of gas turbine engine of marine purpose contains water particles, inertial separator for separating the air and water particles are provided. Saw type and wave type separator are now used to separate inflow water particle from the gas. In this paper, the design parameters of saw type separator are studied by numerical simulations. Using the commercial CFD program, Star-CCM+, Lagrangian-Eulerian method was used to perform the analysis of two phase flow of the mist in the air. This method solves Reynolds-Averaged Navier-Stokes equations in Eulerian framework for the continuous phase, while solves equation of motion for individual particles in Lagrangian framework. Lagrangian multiphase method was applied to monitor the particles of different sizes and shapes and to verify collision between particles by chasing particles. Water particles were injected through injectors located at the inlet of the separator and escape mode was used which assumes that the particles attached on the surface of inertial separator were removed from the simulation, effectively escaping the solution domain. Through the numerical computations with the inlet condition of constant water particle size in the wetness fraction of 85%, efficiency of eliminating the water particle and the pressure drop between the inlet and outlet were examined.

• Journal of the Society of Naval Architects of Korea
• /
• v.54 no.6
• /
• pp.461-469
• /
• 2017

A segment of the wave board has been expressed as a submerged line segment in the two dimensional wave flume. The lower end of the line segment could be extended to the bottom of the wave flume and the other opposite upper end of the board could be extended to the free surface. It is assumed that the motion of the wave board could be defined by the sinusoidal motion in horizontal direction on either end of the wave board. When the amplitude of sinusoidal motion of the wave board on lower and upper end are equal, the wave board motion could express the horizontally oscillating submerged segment of piston type wave generator. The submerged segment of flap type wave generator also could be expressed by taking the motion amplitude differently for the either end of the board. The pivot point of the segment motion could play a role of hinge point of the flap type wave generator. Simplified analytic solution of oscillating submerged wave board segment in water of finite depth has been derived through the first order perturbation method at two dimensional domain. The case study of the analytic solution has been carried out and it is found out that the solution could be utilized for the design of wave generator with arbitrary shape by linear superposition.

• Korean Journal of Microbiology
• /
• v.13 no.3
• /
• pp.109-115
• /
• 1975

DNA's were extracted from Saccharomyces cerevisiae and Mycobacterium phlei and the damaging cell walls of these microoragnisms were examined under an electron microscope in the extraction process in which a number of physico-chemical tratments of cells was involved. While the DNA was easily extracted from S. cerevisiae using conventional meylelded very little DNA, of M. phlei was extremely difficult to isolate and yielded very little DNA, applying various methods of isolation published earlier. When the cell walls of S. cerevisiae were examined with the electron microscope, they were not yet damaged even after the cells were treated with sodium lauryl sulfate(SLS) and ethylene diamine tetracetic acid(EDTA), but they were completely destroyed by the treatment of sodium perchlorate followed by the addition of chloroform and a vigorous agitation. Oozing cytoplasm through the broken cell walls was also observed. In the extraction of DNA from M.phlei, the pronase was not effective at the aerobic environment of the sample. When phenol was applied at the last step of DNA isolation, an extreme damage mass yielding little DNA into the solution. Unlike the cells of S.cerevisiae.M.phlei cells showed a tendency of aggregation, thus the destruction of cell walls by sodium hydroxide was seen only on the walls of peripheral cells in the aggregated mass, leaving the walls of the inner cells undamaged.

• Journal of Korean Foot and Ankle Society
• /
• v.6 no.1
• /
• pp.35-39
• /
• 2002

Purpose: The purpose of this study was to evaluate the effect of hyperbaric oxygen therapy(HBOT) and the resultant amputation rate in the treatment of diabetic foot ulcer. Material and methods: From 2000 Jan. to 2002 April, thirty two diabetic foot patients were admitted for treatment of foot ulcers and infection. Of the thirty two cases, thirteen patients received HBOT and nineteen did not. The results were analyzed by amputation rate and healing time. All were classified according to the Wagner classification. Results: Of the HBOT treated group, three(23%) patients underwent amputation: two below knee and one metatarsophalangeal disarticulations. Of the non-treated group, eleven(58%) patients underwent amputation, : four below knee and seven metatarsophalangeal disarticulations. The healing times, based on hospital days were average 16, 38, 43 days in the HBOT treated group and average 20, 50, 35 days in the non treated group respectively in Wagner grade II, III, IV. Conclusions: HBOT might be effective in decreasing amputation rate and hospital stay in diabetic patients with severe foot ulcers.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.49 no.1
• /
• pp.23-28
• /
• 2012

The performance improvement of the secondary storage is very slow compared to the main memory and processor. The data is loaded from secondary storage to memory for the execution of an application. At this time, there is a bottleneck. In this paper, we propose an Executable Compression Method to speed up the initial loading time of application. and we examined the performance. So we implemented the two applications. The one is a compressor for Execution Binary File. and The other is a decoder of Executable Compressed application file on the Embedded System. Using the test binary files, we performed the speed test in the six files. At the result, one result showed that the performance was decreased. but others had a increased performance. the average increasing rate was almost 29% at the initial loading time. The level of compression had different characteristics of the file. And the performance level was dependent on the file compressed size and uncompress time. so the optimized compression algorithm will be needed to apply the execution binary file.

• Journal of International Society for Simulation Surgery
• /
• v.2 no.2
• /
• pp.90-93
• /
• 2015

The fibula free flap has now become the most reliable and frequently used option for mandible reconstruction. Recently, three dimensional images and printing technologies are applied to mandibular reconstruction. We introduce our recent experience of mandibular reconstruction using three dimensionally planned fibula free flap in a patient with gunshot injury. The defect was virtually reconstructed with three-dimensional image. Because bone fragments are dislocated from original position, relocation was necessary. Fragments are virtually relocated to original position using mirror image of unaffected right side of the mandible. A medical rapid prototyping (MRP) model and cutting guide was made with 3D printer. Titanium reconstruction plate was adapted to the MRP model manually. 7 cm-sized fibula bone flap was designed on left lower leg. After dissection, proximal and distal margin of fibula flap was osteotomized by using three dimensional cutting guide. Segmentation was also done as planned. The fibula bone flap was attached to the inner side of the prebent reconstruction plate and fixed with screws. Postoperative evaluation was done by comparison between preoperative planning and surgical outcome. Although dislocated condyle is still not in ideal position, we can see that reconstruction was done as planned.

• The Journal of Internal Korean Medicine
• /
• v.33 no.3
• /
• pp.306-316
• /
• 2012

Objectives : Mori Folium is used for hyperlipidemia or diabetes. The study was designed to test the anti-obesity effect of Mori Folium on body weight, hepatic fat accumulation and serum lipid level. Methods : The extract from Mori Folium was made by the pharmacy department of Kyung-hee oriental medical hospital. Normal diet, high-fat diet, 30% reduced diet and Mori Folium groups were set. The normal group was administered normal rat food, but the other three groups were administered high fat food. We measured body weight once a week. After 3 weeks experiment, hepatic lipid accumulations were measured. Also we compared serum lipid levels among the 4 groups after 3 weeks. Results : Mori Folium had no effect on body weight, but the 30% reduced diet had an inhibitory effect on body weight gain. Mori Folium had more inhibitory effect on hepatic fat accumulation than a 30% reduced diet. Mori Folium also has more inhibitory effect on serum triglyceride than 30% reduced diet. Conclusions : Mori Folium has anti-obesity effect on hepatic lipid accumulaion and serum triglyceride level in high fat diet induced rats.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.23 no.5
• /
• pp.980-985
• /
• 2009

The study was designed to test anti-platelet effect and find out anti-platelet mechanism of extract from Gamisopunghwalheol-tang in vitro. The extract was investigated for the inhibition against the aggregation of human platelet suspensions induced from collagen by aggregometer. And also the extract was investigated for the inhibition against the aggregation of human platelet suspensions who is taking aspirin or clopidogrel induced from collagen by aggregometer. In collagen-induced platelet aggregation test, the extract significantly inhibited collagen-induced platelet aggregation in a concentration-dependent manner(p<0.05). The extract significantly inhibited collagen-induced platelet aggregation of human platelet who is taking aspirin or clopidogrel ing 0 mg/ml concentration(p<0.05). And the extract inhibited more ingpatients who is taking aspirin. These results show that the extract from Gamisopunghwalheol-tang has anti-platelet aggregation effect.

• Archives of Plastic Surgery
• /
• v.40 no.4
• /
• pp.353-358
• /
• 2013

Background Robots have allowed head and neck surgeons to extirpate oropharyngeal tumors safely without the need for lip-split incision or mandibulotomy. Using robots in oropharyngeal reconstruction is new but essential for oropharyngeal defects that result from robotic tumor excision. We report our experience with robotic free-flap reconstruction of head and neck defects to exemplify the necessity for robotic reconstruction. Methods We investigated head and neck cancer patients who underwent ablation surgery and free-flap reconstruction by robot. Between July 1, 2011 and March 31, 2012, 5 cases were performed and patient demographics, location of tumor, pathologic stage, reconstruction methods, flap size, recipient vessel, necessary pedicle length, and operation time were investigated. Results Among five free-flap reconstructions, four were radial forearm free flaps and one was an anterolateral thigh free-flap. Four flaps used the superior thyroid artery and one flap used a facial artery as the recipient vessel. The average pedicle length was 8.8 cm. Flap insetting and microanastomosis were achieved using a specially manufactured robotic instrument. The total operation time was 1,041.0 minutes (range, 814 to 1,132 minutes), and complications including flap necrosis, hematoma, and wound dehiscence did not occur. Conclusions This study demonstrates the clinically applicable use of robots in oropharyngeal reconstruction, especially using a free flap. A robot can assist the operator in insetting the flap at a deep portion of the oropharynx without the need to perform a traditional mandibulotomy. Robot-assisted reconstruction may substitute for existing surgical methods and is accepted as the most up-to-date method.