• Journal of the Korean Applied Science and Technology
• /
• v.20 no.2
• /
• pp.148-153
• /
• 2003

Electron transfer through an Langmuir-Blodgett(LB) monolayer film sandwiched between metal electrodes. We used an eicosanoic acid material and the material was very famous as a thin film insulating material. Eicosanoic acid monolayer was deposited by Langmuir-Blodgett(LB) technique and a subphase was a $CdCl_2$ solution as a 2${\times}10^{-4}$ mol/L. Also we used a bottom electrode as an Al/$Al_2O_3$ and a top electrode as a Al and Ti/Al. Here, the $Al_2O_3$ on the bottom electrode was deposited by thermal evaporation method. The $Al_2O_3$ layer was acted on a tunneling barrier and insulating layer in tunnel diode. It was found that the proper transfer surface pressure for film deposition was 25 mN/m and the limiting area per molecule was about 24 ${\AA}^2$/molecule. When the positive and negative bias applied to the molecular device, the behavior shows that a tunnel switching characteristics. This result were analyzed regarding various mechanisms.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.9 no.4
• /
• pp.241-244
• /
• 2004

Protein A molecular thin film was fabricated as a platform of antibody-based biosensor. For the immobilization of the protein A thin film, a viologen multilayer was built up using the Langmuir-Blodgett (LB) technique, and then, protein A was adsorbed on the viologen LB film by an electrostatic interaction force, which was formed as a hetero-film structure. For the deposition of viologen, surface pressure area ($\pi$-A) isotherm was investigated. The fabricated protein A-viologen hetero LB film was investigated using atomic force microscopy (AFM). Using the developed molecular film, antibody immobilization and fluorescence measurement was carried out.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.8
• /
• pp.581-586
• /
• 1998

This paper describes athermally stimulated displacement current (TSDC) of arachidic acid(AA) and polyamic acid alkylamine salts(PAAS) Langmuir-Blodgett(LB) films, which is a precursor of polyimide(PI). The TSDC measurements of AA LB film were performed from temperature to about 11$0^{\circ}C$ at a rate of 0.2$^{\circ}C$/ｓ inside a vacuum chamber for a reference. And the TSDC measurements PAAS LB film were performed from room temperature to about 25$0^{\circ}C$ and temperature was increased at the same rate as that of AA LB film. They show that there are TSDC peaks at about 7$0^{\circ}C$ in the arachidic acid LB films, and at about 7$0^{\circ}C$ and 16$0^{\circ}C$ in the PAAs LB films. Results of these measurements indicate the one small peak at 7$0^{\circ}C$ is resulted from a softening of the alkyl group and the large peak at 16$0^{\circ}C$ is possibly due to dipole of C-O group in the PASS molecule. We have calculated the vertical component of the AA and PAAs L film out of the TSDC curves. It shows that the dipole moment of the AA LB film is about 70-mD at 7$0^{\circ}C$. And the dipole moment of PAAS LB film is about 040mD at 7$0^{\circ}C$ and about 200mD at 16$0^{\circ}C$ in the first measurement of TSDC. In the second measurement of TSDC of PASS LB film after cooling down to room temperature, the TSDC peaks are almost disappeared.

• Journal of the Korean Applied Science and Technology
• /
• v.26 no.4
• /
• pp.400-406
• /
• 2009

We investigated the electrochemical properties for Langmuir-Blodgett (LB) films of functionalized polyimide. LB films of polyimide monolayer were deposited by the Langmuir-Blodgett method on the indium tin oxide(ITO) glass. The electrochemical properties measured by cyclic voltammetry with a three-electrode system(an Ag/AgCl reference electrode, a platinum wire counter electrode and LB film-coated ITO working electrode) at various concentrations(0.5, 1.0, and 1.5 N) of $NaClO_4$ solution. The current of reduction and oxidation range was measured from 1650 mV to -1350 mV, continuously. The scan rates were 50, 100 and 150 mV/s, respectively. As a result, monolayer and multilayer LB films of polyimide are appeared on irreversible process caused by the oxidation current from the cyclic voltammogram.

• Proceedings of the KIEE Conference
• /
• 1991.07a
• /
• pp.244-246
• /
• 1991

Recently, a study on LB ultra thin film of molecular size is widely performed. To make use of LB ultra thin film in engineering applications, it is important to investigate how uniformly Langmuir film is deposited on a substrate. In this paper, to confirm the uniformity of film deposition, the relation between the monolayer numbers deposited and its ratio is investigated by deposition of the Y type and Hetero type LB film. If films are deposited ideally, the deposition ratio will become 1.0. From the experimental results, it can be suggested that the deposition of LB film is done well, as we obtained an approximate value 1.0 by the calculation of deposition ratio of L film area and LB film deposition area.

• Journal of the Korean Applied Science and Technology
• /
• v.29 no.3
• /
• pp.421-428
• /
• 2012

We investigated an electrochemical properties for Langmuir-Blodgett (LB) nano-films of polyimide and phospholipid mixture. LB films of polyamic acid and phospholipid monolayer were deposited by the Langmuir-Blodgett method on the indium tin oxide(ITO) glass. The electrochemical properties measured by cyclic voltammetry with three-electrode system(an Ag/AgCl reference electrode, a platinum wire counter electrode and LB film-coated ITO working electrode) in $KClO_4$ solution. The current of reduction and oxidation range was measured from 1650 mV to -1350 mV, continuously. The scan rates were 50, 100, 150, 200 and 250 mV/s, respectively. As a result, monolayer LB films of polyamic acid and phospholipid mixture was appeared on irreversible process caused by the reduction current from the cyclic voltammogram. Diffusion coefficient (D) effect in the polyamic acid and phospholipid mixture was used in the LAPC with LLPC fewer than the diffusion coefficient values.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.143-146
• /
• 1999

In this study, Ultra-thin films of (N-ducosyl quinolinium)-TCNQ(1:2) complex were prepared on the hydrophilic substrate by Langmuir-Blodgett(LB) technique. By measure of UV-vis spectra and capacitance, deposition status was confirmed together with the thickness of natural oxidized aluminum film inside a device and dielectric constant of (N-docosyl quinolinium)-TCNQ(1:2) complex. The electrical properties of (N-docosyl 7uin7linium)-TCNQ(1:2) complex were investigated at room temperature. The conductivity of this film measured by the direction uf either vertical or horizontal axis is results in a quite different value.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.459-462
• /
• 2001

We have investgated the photoisomerization using light irradiation 8A5H LB film accumulated by monolayer and three layers on an ITO. We determined electrochemical measurement by using cyclic voltammetry with a three-electrode system, An Ag/AgCl reference electrode, a platinum wire counter electrode and LB film-coated ITO working electrode measured in 0.1mol/L NaClO$_4$ solution. The scan rate was 100mv/s.

• Macromolecular Research
• /
• v.16 no.4
• /
• pp.367-372
• /
• 2008

We fabricated tetra(5-n-nonyl-8-tert-butyl-2,3-pyrazino[2,3-b]indolo)porphyrazinato copper(II) (Cu-Pc-$C_8$) Langmuir-Blodgett (LB) films. We further investigated the influence of arachidic acid (AA) as a transfer promoter, as well as the effect of dipping speed, on the deposition of the films on hydrophilic and hydrophobic substrates. In the case of pure Cu-Pc-$C_8$ LB deposition on a hydrophilic substrate, the transfer ratio was close to one for up-stroke depositions, but the previously deposited film was peeled off and re-spread onto water at down-stroke depositions. Whereas the stability of the Cu-Pc-$C_8$ LB films was not improved by AA addition on hydrophilic substrates, the deposition of Cu-Pc-$C_8$ was significantly improved by the presence of AA on a hydrophobic substrate. The AA-assisted deposition had transfer ratio of close to 1 and was essentially stable up to 10-layer depositions. Comparison of the UV-visible spectrum of a Cu-Pc-$C_8$/AA LB film with that of Cu-Pc-$C_8$/AA solution in dichloroethane revealed that the Soret and Q bands for the Cu-Pc-$C_8$/AA LB film were broadened and red-shifted due to the aggregation of phthalocyanines upon assembly in the LB film.

• Korean Journal of Materials Research
• /
• v.9 no.12
• /
• pp.1229-1233
• /
• 1999

In this research, We fabricated Langmuir-Blodgett(LB) ultra-thin films with (N-docosyl quinolinium)- TCNQ(1:2) complex. The characteristics ${\pi}$-A isotherms were studied to find optimum conditions of deposition by varing temperature of subphase, compression speed of barrier and amount of spreading solution. Film formation was verified by measuring transfer ratio, maximum absorption of UV-vis spectra, capacitance and ellipsometry. From the results, it was concluded that the LB film formed well with molecular oder was fabricated.