• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 D
• /
• pp.1261-1263
• /
• 1998

In this paper, we obtained that the monodomain alignment of nematic liquid crystal (NLC) increases with increasing irradiation time with linearly polarized ultraviolet (LPUV) light irradiation on polyimide (PI) surfaces. It was found that the monodomain alignment of NLC is obtained in a cell with normally LPUV light irradiated on PI surface at 30 min. and then oblique LPUV is secondly irradiated on PI surfaces rotated by $90^{\circ}$. The pretilt angle of NLC is generated about $2.5^{\circ}$ with oblique angle of $60^{\circ}$ and then decreased with increasing the oblique angle of IN light irradiation. It is considered that the pretilt angle of NLC is attributed to the photo-depolymerization of polymer with the oblique angle of UV light. The voltage-transmittance and response time characteristics of photo-aligned twisted nematic (TN)-LCD with UV light irradiation time of 60 min. were almost same in comparison with rubbing treated TN-LCD.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 C
• /
• pp.1585-1587
• /
• 1997

We investigated the generation of high pretilt angle for nematic liquid crystal (NLC) in the cell with slanted non-polarized ultraviolet (UV) light irradiation on two kinds of the polyimide (PI) film. It was shown that the monodomain alignment in NLC is obtained in the cell with slanted non-polarized UV light irradiation on PI surface. The pretilt angle of NLC is generated about 3 degrees in the cell with slanted non-polarized UV light irradiation with 70 degrees on PI surface without side chain. But, the pretilt angle of NLC is generated about 1 degree in the cell with slanted non-polarized UV light irradiation with 80 degrees on PI surface with side chain. We consider that the pretilt angle generation in NLC is attributted to anisotropic dispersion force between the LC molecular and the PI surface.

• 농약과학회지
• /
• 제19권1호
• /
• pp.1-4
• /
• 2015

잔류성 유기오염물질인 과불화합물 중 perfluorooctanesufonic acid (PFOS)와 perfluorooctanoic acid (PFOA)의 잔류분석은 환경부 "잔류성 유기오염물질 공정시험기준"에 따라 hydrophilic-lipophilic balance (HLB) solid phase extraction (SPE) 전처리 후 LC-$MS^n$를 이용해 정량 분석하고 있다. 본 연구에서는 환경부 설정 공정시험법에 따라 농업용수 전처리 후, 시험법에서 제거하지 못한 미지의 불순물을 Envi-Carb$^{TM}$을 통해 회수율에 영향을 주지 않고 손쉽게 제거하였다. 또한, 과불화합물 분석에 사용되는 LC-$MS^n$ 중 quadrupole-time-of-flight mass spectrometry (qTOFMS)에서 측정된 PFCs의 정량한계를 평가한 결과, 시험에 사용된 장비간 정량한계 편차가 크게 관찰되었으나, 시험대상 장비 모두 농업용수 중 ng/L 수준으로 잔류하는 과불화합물의 정밀 잔류분석에 사용가능 한 것으로 확인되었다.

• 분석과학
• /
• 제22권1호
• /
• pp.65-74
• /
• 2009

옻나무는 아시아지역 전역에 주로 분포하며 예로부터 도료 및 약용 식물로 많이 사용되어져 왔었다. 특히 우리나라에서 재배되는 옻나무가 그 기능이 더욱 우수하다고 알려져 있는데 그 원인은 명확히 밝혀진 바가 없다. 우선 옻나무에서 우루시올의 추출을 위하여 나무는 soxhlet의 방법으로, 옻나무 추출물은 liquid-liquid extraction (LLE)의 방법을 이용하여 각각의 우루시올을 추출하였으며, 추출한 각 성분들은 high performance liquid chromatography/ultraviolet & visible detector system (HPLC/UV-Vis)에 먼저 적용하여 분리의 최적 조건을 찾았다. 그리고 각 성분에 대한 정확한 분석을 위하여 reverse phase liquid chromatography on-line electro spray ionization mass spectrometer (LC-MS/MS)를 이용하였으며 이를 바탕으로 분자량에 따른 성분 확인과 함량을 연구하였다. 이동상의 조건으로는 methanol : 0.1% formic acid : DDW를 929 : 1 : 70의 부피비로 사용하여 최적의 분리 조건을 얻었다. 이러한 LC의 조건으로 다시 LC-MS/MS에 적용하여 MRM의 방식으로 각각의 함량을 구할 수 있었다. 분자량에 따라 총 4종류의 우루시올 동종체들이 존재를 확인하였다. 본 연구를 통하여 한국산 옻나무 추출물의 경우 외국산 옻나무의 것 보다 곁사슬에 이중결합이 많은 우루시올 동종체의 함량이 많이 존재하며 그 전체적 비율이 높은 것으로 밝혀졌다.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2004년도 Asia Display / IMID 04
• /
• pp.773-775
• /
• 2004

For high end, large area displays, all current LC modes require some degree of optical compensation to improve the front of screen viewing experience. Currently most optical films are laminated to the outside of the LCD cell, between the glass and polariser. In this paper we wish to show how it is possible to integrate the compensating optical film within a VA mode LCD cell. The paper will describe the process of making the biaxial film through the process of in-situ photopolymerisation of an aligned film of reactive mesogens in the cholesteric phase using polarised UV light. The film can be made on the colour filter array side of the LCD panel. In addition the process of fabricating a VA mode LCD containing this film will be described and the performance of this module will be presented

• 대한수의학회지
• /
• 제48권1호
• /
• pp.33-38
• /
• 2008

In veterinary medicine amitraz has been used as an insecticide to eliminates mites, lice, and ticks in dogs, cats, goats, swine and cattle. The objective of present study was to developed an analytical method using one-step extraction and determination of the amitraz in veterinary drugs by liquid chromatography (LC). The amitraz was analyzed by LC equipped with Waters XTerra RP18 ($4.8{\times}250mm;\;5{\mu}m;\;Waters,\;USA$) analytical column, using 75% acetonitrile (acetonitrile/D.W; 75/25) at 1.0 ml/ min. The UV-VIS detection of amitraz was made at 290 nm. Calibration graphs were linear with very good correlation coefficients ($r^2>0.9999$) from $80{\sim}120{\mu}g/ml$. The limit of detection was $0.09{\mu}g/ml $ and limit of quantification was $0.27{\mu}g/ml $. The method showed good intra-day precision (CV 0.05~0.09%) and inter-day precision (CV 0.06~0.18%).

• Food Science and Biotechnology
• /
• 제18권4호
• /
• pp.842-848
• /
• 2009

The purpose of this study was to determine the extent of domoic acid (DA) a potent neurotoxin, responsible for the syndrome amnesic shellfish poisoning (ASP) contamination of various species of bivalve shellfish purchased from fish market in Korea and the implications for food safety. Liquid chromatography (LC) methods were applied to quantify DA in shellfish after sample clean-up using solid-phase extraction (SPE) with strong anion exchange (SAX) cartridges. Toxin detection was achieved using photodiode array ultraviolet (LC-UV) and electrospray ionization-mass (LC-ESI-MS). DA was identified in 4 bivalve shellfishes of 872 shellfishes collected from March, 2006 to October, 2007 in Korea. DA amount of 3 surf clams (Mactra veneriformis) collected at Seoul, Daejeon, and Daegu were 4.13, 1.99, and 1.94 mg/kg, respectively. DA amount of 1 pink butterfly shell (Peronidia venulosa) collected at Seoul was 3.02 mg DA/kg. The amounts of DA that were present in 4 bivalve shellfishes were within EU guideline limits for sale of shellfish (20 mg DA/kg).

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2008년도 추계학술대회 논문집 Vol.21
• /
• pp.330-330
• /
• 2008

It is widely investigated to liquid crystal (LC) alignment using non-contact alignment method such as ion-beam (IB) irradiation, UV alignment, and oblique deposition. Because conventional rubbing method has some drawbacks. These include defects from dust and electrostatic charges and rubbing scratch during rubbing process. In addition, rubbing method needs additional process to remove these defects. Therefore rubbing-free methods like ion-beam irradiation are strongly required. We studied LC alignment effect on poly imide surface by IB irradiation and electro-optical (EO) characteristics of twisted nematic liquid crystal display (TN-LCD). In this experiment, a good uniform alignment of the nematic liquid crystal (NLC) with the ion-beam exposure on the polyimide (PI) (SE-150 from Nissan Chemical) surface was observed. We also achieved low pretilt angle as a function of ion-beam irradiation intensity. In addition, it can be obtained the good EO properties of the IB-aligned TN-LCD on PI surface. Some other experiments results and discussion will be included in the poster.

• Journal of Information Display
• /
• 제5권2호
• /
• pp.23-26
• /
• 2004

For high end, large area displays, all current LC modes require some degree of optical compensation to improve the front of screen viewing experience. Currently most optical films are laminated to the outside of the LCD cell, between the glass and polariser. In this paper we wish to show how it is possible to integrate the compensating optical film within a VA mode LCD cell. The paper will describe the process of making the biaxial film through the process of in-situ photopolymerisation of an aligned film of reactive mesogens in the cholesteric phase using polarised UV light. The film can be made on the colour filter array side of the LCD panel. In addition the process of fabricating a VA mode LCD containing this film will be described and the performance of this module will be presented.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2009년도 9th International Meeting on Information Display
• /
• pp.604-606
• /
• 2009

We propose a method to control the pretilt angle of liquid crystal (LC) by doping a proper amount of UV curable reactive mesogen (RM) monomers in hometropic polyimide (PI). The intermediate pretilt angles are produced by anchoring competition between homeotropic PI and the polymerized RM which direction is along the LC molecules under electric field.