• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.27 no.2
• /
• pp.110-114
• /
• 2014

In this study, we report the doping effect of graphene quantum dots (QDs) in nematic liquid crystal (NLC) system on rubbed polyimide (PI) surface. The good LC alignment and high thermal stability in QD-LC cell system on rubbed PI surfaces can be measured. Also, the low threshold voltage of QD-TN cell was observed about 2.77 V. The fast response time of 13.2 ms for QD-TN cell can be achieved. Finally, the good voltage holding ratio of QD-TN cell on rubbed PI surface was measured.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.533-534
• /
• 2008

This paper presents a multi-phase ring VCO for low-cost, low-power GPS receiver. In the RF band used in GPS, L1 band is now in commercial-use and L2,L5 are predicting to be commercial-use soon. Thus Wide band PLL and Cost-effective IC solutions are required for future multi-band GPS receiver that received three types band at once. A new PLL architecture for multi-band GPS application is proposed. Ring VCO is even smaller than LC-VCO and a good alternative for low-cost solution. Proposed multi-phase ring VCO offers wide frequency range covering L1, L2, and L5 band, 20% reduction of area, 23% reduction of PLL power and can generate I/Q without extra I/Q generator.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.501-503
• /
• 2008

This paper presents the design of a 2.4 GHz low phase noise fully integrated LC Voltage-Controlled-Oscillator (VCO) in $0.18{\mu}m$ CMOS technology. The VCO is without any tail bias current sources for a low phase noise and, in which differential varactors are adopted for the symmetry of the circuit. At the same time, the use of differential varactors pairs reduces the tuning range, i.e., the frequency range versus VTUNE, so that the phase noise becomes lower. The simulation results show the achieved phase noise of -138.5 dBc/Hz at 3 MHz offset, while the VCO core draws 3.9mA of current from a 1.8V supply. The tuning range is from 2.28GHz to 2.55 GHz.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1998.06a
• /
• pp.259-262
• /
• 1998

The liquid crystal (LC) alignment and pretilt angle generation using photo-alignment method were investigated in this study. We obtained that the monodomain alignment of nematic(N) LC increases with increasing irradiation time in a cell with linearly polarized ultraviolet (LPUV) light irradiation on polyimide (Pl) surfaces. We consider that the monodomain alignment is able to be anisotropic dispersion force due to photo-depolymerization of polymer with LPUV light irradiation on Pl surface. Also, we observed that the uniform alignment of NLC is obtained in a cell with normally LPUV light irradiated on Pl surface at 30 min. and then oblique LPUV is secondly irradiated on Pl surfaces rotated by 90$^{\circ}$. The pretilt angle of NLC is generated about 1.5$^{\circ}$ with oblique angle 60$^{\circ}$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.10
• /
• pp.878-884
• /
• 1998

We have investigated that the monodomain alignment of nematic liquid crystal (NLC) is obtained with polarized ultraviolet(PUV) light irradiation on polyimide (PI) surface. The LC alignment capability increases with increasing the UV light irradiation time. The polarized UV light irradiation on oblique angle of 60。 irradiated on PI surface rotated by 90。 at 10 min. after being normally irradiated on PI surface at 30 min., the generated pretilt angle of NLC is about 2.5。. The pretilt angle of NLC is attributed to the interaction between the LC molecules and the asymmetric triangular structure of polymer surface due to photo-depolymerization of polymer with the oblique UV light on PI surface. The voltage -transmittance and response time characteristics of photo-aligned twisted nematic (TN)-LCD with UV light irradiation time 60 min. were almost same in comparison with the rubbing-treated TN-LCD.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.10
• /
• pp.871-875
• /
• 2000

Effects of liquid crystal (LC) alignment using a in-situ photoalignment method by polarized UV exposure on a polyimide (PI) surface with medium side chain were studied. The generated pretilt angle in nematic(N) LC using a in-situ photoalignment method was smaller than that of a conventional photoalignment method for short UV exposure time. Also, the pretilt angle of NLC using a in-situ photoalignment method increases with increasing UV exposure time on the PI surfaces. Finally, the pretilt angle of NLC can be improved by annealing treatment.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.545-548
• /
• 1999

The electro-optical characteristics of photo-aligned vertical-alignment (VA)-liquid crystal display (LCD) with non-polarized ultraviolet (UV) light irradiation of 45\`on homeotropic polyimide (Pl) surface were investigated. LC alignment on photo-aligned VA-LCD is attributed to photo-depolymerized reaction of the polymer with non-polarized UV light irradiation on PI surface. We had good voltage-transmittance (V-T) characteristics of photo-aligned VA-LCD. The response time of photo-aligned VA-LCD was slower than that of the rubbing-aligned VA-LCD. Finally, we suggest that the slow response time of photo-aligned VA-LCD depends on the LC domain.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.336-339
• /
• 2000

Effects of liquid crystal (LC) alignment using an in-situ photo-alignment method by linearly polarized UV exposure during imidization of polyirnide (PI) on the two kinds of PI surfaces with side chain were investigated. The generated pretilt angle in nematic (N) LC using an in-situ photo-alignment method was smaller than that of a conventional photo-alignment method for short UV exposure time. Also, the pretilt angle of the NLC using an in-situ photo-alignment method increases with increasing UV exposure time on the two kinds of the PI surfaces. Finally, the pretilt angle of NLC can be improved by annealing treatment.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.4
• /
• pp.306-313
• /
• 1998

To elucidate the liquid crystal(LC) molecules alignment mechanism, it is important to determine the molecular orientation of the rubbed polymer surface molecules that directly contact with LC molecules. In this work, the molecular orientation on a rubbed surface of polyimide (SE-3310, Nissan) film has been studied by polarized FTIR absorption spectroscopy. It has been found that molecular chain on the rubbed surface of polymide film are oriented along the rubbing direction and are tilted up on an average by 5.0$^{\circ}$. In the SHG(Second Harmonic Generation) measurement, the pretilt angle of molecular chain on the poylmide fim was 4.6$^{\circ}$ fro, the surface plane. And the pedit angle of liquid crystal (ZLI-2293, Merck) molecules measured by crystal rotation method was 5.4$^{\circ}$in the same rubbing condition.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.12
• /
• pp.1133-1138
• /
• 1998

In this paper, we obtained the monodomain alignment of nematic liquid Crystal(NLC) in the cell fabricated by transcription alignment method on polyimide(PI) surface with side chain. It is considered that the LC alignment produced by the transcription alignment method is attributed to a memory effect of the NLC on PI surfaces. Also we observed that the generated pretilt angle of NLC is about $3.7^{\circ}$ with transcription alignment on PI surface. Next, we measured that the voltage-transmittance characteristics of transcription-aligned TN-LCD are almost same compared to rubbing-aligned TN-LCD. Also, we measured that the curve of transcription-aligned TN-LCD is less sharp than that of the rubbing-aligend TN-LCD in the decay time characteristics. It is considered that the response time characteristics of transcription-aligned TN-LCD are attributed to the weak anchoring strength between the LC molecules and the polymer surface.