• Journal of IKEEE
• /
• v.24 no.2
• /
• pp.649-653
• /
• 2020

GPS is a representative satellite navigation system that provides users with accurate location and time information. GPS L1 C / A is opened for civilian and thus utilized in various fields. When the satellite signal reaches the receiver, signal acquisition unit of the digital signal processing hardware searches and acquires the signal among visible satellites. The signal acquisition unit has different implementation methods depending on the signal searching method, such as serial search acquisition, parallel frequency search, parallel code phase search. In this paper, we compare and analyze the three representative acquisition hardwares using live GPS L1 C/A signals. According to the comparison, the parallel code phase search acquisition outperforms the other methods due to reduction of the number of the searchings and a high resolution.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.533-534
• /
• 2008

This paper presents a multi-phase ring VCO for low-cost, low-power GPS receiver. In the RF band used in GPS, L1 band is now in commercial-use and L2,L5 are predicting to be commercial-use soon. Thus Wide band PLL and Cost-effective IC solutions are required for future multi-band GPS receiver that received three types band at once. A new PLL architecture for multi-band GPS application is proposed. Ring VCO is even smaller than LC-VCO and a good alternative for low-cost solution. Proposed multi-phase ring VCO offers wide frequency range covering L1, L2, and L5 band, 20% reduction of area, 23% reduction of PLL power and can generate I/Q without extra I/Q generator.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.14 no.9
• /
• pp.725-733
• /
• 2002

In this study, the heat transport limitations of a two-phase closed thermosyphon were investigated. For the test, a two-phase closed thermosyphon ($L_t/: 600 mm,\;L_e:105mm,\;L_a:75mm,\;L_c:420mm,\;D_o:22.2mm,$ container: copper (inner grooved surface), working fluid: PFC ($C_6F_14$) was fabricated with a reservoir that can change the fill charge ratio. The following was imposed as the factors on the heat transport limitations of a two-phase closed thermosyphon. 1) Fill charge ratio of the working fluid. 2) Tilt angle of the longitudinal axis. From tile experimental data, some results were obtained as follows. When the fill charge ratio was relatively small ($\psi$20%), the heat transport limitation occurred about 100W by dry-out limitation. However over 40%, it shelved nearly constant value (500 W) by flooding limitation. The heat transport limitation according to the tilt angle increased smoothly until the tilt angle was $60^{\circ}$,/TEX>, after then decreased slowly.

• Proceedings of the KIEE Conference
• /
• 1996.07a
• /
• pp.98-100
• /
• 1996

In this paper, the Two-Double 1-2phase exciting driver circuit, in order to improving the starting characteristics of Linear Stepping Motor(LSM), is designed. And the static thrust forces of LSM is measured through the chopper constant current method according to the 2 phase, the Double 1-2phase, and the Two-Double 1-2phase exciting method.

• Journal of Ginseng Research
• /
• v.47 no.1
• /
• pp.159-165
• /
• 2023

Background: Red ginseng marc, the residue of red ginseng left after water extraction, is rich in dietary fiber. Dietary fiber derived from fruits or vegetables can promote the proliferation of probiotics, and it is a key technology in the food industry to increase the productivity of probiotics by adding growth-enhancing substances such as dietary fiber. In this study, the effect of red ginseng dietary fiber (RGDF) on the growth of probiotic bacterial strains was investigated at the phenotypic and genetic levels. Methods: We performed transcriptome profiling of Lactiplantibacillus plantarum IDCC3501 in two phases of culture (logarithmic (L)-phase and stationary (S)-phase) in two culture conditions (with or without RGDF) using RNA-seq. Differentially expressed genes (DEGs) were identified and classified according to Gene Ontology terms. Results: The growth of L.plantarum IDCC3501 was enhanced in medium supplemented with RGDF up to 2%. As a result of DEG analysis, 29 genes were upregulated and 30 were downregulated in the RGDF-treated group in the L-phase. In the S-phase, 57 genes were upregulated and 126 were downregulated in the RGDF-treated group. Among the upregulated genes, 5 were upregulated only in the L-phase, 10 were upregulated only in the S-phase, and 3 were upregulated in both the L- and S-phases. Conclusions: Transcriptome analysis could be a valuable tool for elucidating the molecular mechanisms by which RGDF promotes the proliferation of L.plantarum IDCC3501. This growth-promoting effect of RGDF is important, since RGDF could be used as a prebiotic source without additional chemical or enzymatic processing.

• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 2004.04a
• /
• pp.125-130
• /
• 2004

As an application of GPS is increased by world geodetic system introduction gradually, in this time, It is increased necessary of GPS baseline analysis program development. In this study, I developed a baseline analysis program by L1/L2 carrier. And I compared a baseline analysis result with a commercial program. I showed precision of approximately ${\pm}$1cm in a baseline length in case of Narrow lane as a result that a baseline analysised a developed program.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.36 no.7
• /
• pp.731-738
• /
• 2012

In this study, the evaluation of the aerodynamic characteristics of the NREL Phase VI Rotor System has been performed, for the 7 m/s upwind case using commercial FEA and CFD tools which are ANSYS Mechanical 12.1 and CFX 12.1. The initial operating conditions of the rotor blade include a $3^{\circ}$ tip pitch angle. A numerical simulation was carried out on only the rotor parts, excluding the tower structure based on the equivalent stiffness model, to consider the aeroelastic effect for the numerical simulation using the loosely coupled 2-way fluid-structure interaction method. The blade root bending moment was monitored in real time to obtain reasonable results. To verify the analysis results, the numerical simulation results were compared with the measurements in the form of the root bending moment and the pressure distributions of the NREL/NASA Ames wind tunnel test.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.1
• /
• pp.58-64
• /
• 2016

In this paper, the design of rotor shape was performed for improvement of start-up characteristics and efficiency in single-phase LSPM. In order to improve the start-up characteristics, shape of rotor aluminium cage bar was changed. Through arrangement of permanent magnets and installation of flux barriers, it was performed torque ripple reduction and efficiency improvement. Cogging torque and back-EMF is calculated by the no-load analysis, start-up time is calculated by the start-up state analysis, efficiency and torque ripple is calculated by steady state analysis. The characteristics of the motor were calculated through FEM.

• Applied Chemistry for Engineering
• /
• v.22 no.4
• /
• pp.376-383
• /
• 2011

The CMCs of LA and LA3 nonionic surfactants obtained from the reaction between glycidol and lauryl alcohol were found to be $0.97{\times}10^{-3}mol/L$ and $1.02{\times}10^{-3}mol/L$ respectively and the surface tensions for 1 wt% surfactant were 26.99 and 27.48 mN/m respectively. Dynamic surface tension measurements using a maximum bubble pressure tensiometer showed that the adsorption rate of surfactant molecules at the interface between the air and the surfactant solution was found to be relatively fast in both surfactant systems, presumably due to the high mobility of surfactant molecules. The contact angles of LA and LA3 nonionic surfactants were 27.8 and $20.9^{\circ}$ respectively and the dynamic interfacial tension measurement by a spinning drop tensiometer showed that interfacial tensions at equilibrium condition in both systems were almost the same. Also both surfactant systems reached equilibrium in 2~3 min. Both surfactant solutions showed high stability when evaluated by conductometric method and the LA nonionic surfactant system provided the higher foam stability than the LA3 nonionic surfactant system. The phase behavior experiments showed a lower phase or oil in water (O/W) microemulsion in equilibrium with an excess oil phase at all temperatures studied. No three-phase region was observed including a middle-phase microemulsion or a lamellar liquid crystalline phase.

• Journal of Pharmaceutical Investigation
• /
• v.35 no.1
• /
• pp.51-55
• /
• 2005

A high-performance liquid chromatographic method was employed for the determination of bumetanide in human plasma. After addition of internal standard (IS, naproxen) and acidification of the plasma with 1 M hydrochloric acid, the drug and IS were extracted into dichloromethane. The organic phase was back-extracted into 1 M sodium bicarbonate solution and 50 ${\mu}l$ of the aqueous phase was injected onto a reversed-phase C18 column with a mobile phase consisting of methanol: water: glacial acetic acid = 65 : 35 : 1. The samples were detected utilizing a fluorescence detector (excitation wavelength 235 nm, emission wavelength 405 nm). The method was specific and validated with a lower limit of 5 ng/mL. Intra- and inter-day precision and accuracy were acceptable for all quality control samples including the lower limit of quantification. The applicability of the method was demonstrated by analysis of plasma after oral administration of a single 2 mg dose to 24 healthy subjects. From the plasma bumetanide concentration vs. time curves, the mean AUC was $246.5{\pm}73.8\;ng{\cdot}hr/mL$ and $C_{max}$ of $132.1{\pm}40.9$ ng/mL reached 1.2 hr after administration. The mean biological half-life of burnet ani de was $1.1{\pm}0.2$hr. Based on the results, this simple and validated assay method could readily be used in any pharmacokinetic or bioequivalence studies using humans.