• 전력전자학회논문지
• /
• 제19권6호
• /
• pp.557-563
• /
• 2014

This study deals with a resonant converter of an anti-start air conditioner compressor for commercial vehicles. The anti-start air conditioner compressor must generally have a high current, high efficiency, a low volume, and a low weight. To reduce the switching losses and voltage and current stresses of the device, the anti-start air conditioner compressor applies the full-bridge L-C resonant converter topology. Hardware parameters are designed to have a wide voltage range, and the switching frequency range of the L-C resonant converter is determined. Simulation is implemented using PSIM and an experiment is performed to verify the proposed converter.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2003년도 학술대회논문집
• /
• pp.311-314
• /
• 2003

In this paper, proposed circuit proposes that Active-Clamp-Circuits basis of a current-fed inverter linked type high frequency resonant dc-dc converter of conventional. and the paper the most of characteristics of the reduced high voltage stress main switches with active clamp circuits and output current constant with the resonant part consists of L, C resonant tank circuit. Also, the capacitor (C$_1$, C$_2$) connected in switches are a common using by resonance capacitor and ZVS capacitor. and circuit analysis used state equation of each part modes. Also we conform a rightfulness theoretical analysis by comparing a parameters values and simulation values obtained from simulation using Power MOS-FET as switching devices.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 하계학술대회 논문집
• /
• pp.976-980
• /
• 2001

In this study, P $b_{0.88}$(L $a_{a}$N $d_{l-a}$)$_{0.08}$(M $n_{1}$3/S $b_{2}$3/)$_{0.02}$ $Ti_{0.98}$ $O_3$system ceramics were manufactured for 20 MHz class resonator application. Electromechanical coupling factor, mechanical quality factor and dynamic range of 3rd overtone thickness vibration mode were measured as the variations of La and Nd molar ratio. Mechanical quality factor and dynamic range at $\alpha$=0.6 composition ceramics showed the highest value of 2, 691 and 52.37 dB, respectively. The tempearture coefficient of resonant frequency measured from -2$0^{\circ}C$ to 8$0^{\circ}C$ showed an excellent value of 5ppm/$^{\circ}C$ at $\alpha$ = 1 composition ceramics. ceramics.s.

• 조명전기설비학회논문지
• /
• 제17권1호
• /
• pp.86-93
• /
• 2003

본 논문은 출력전류를 증가하기 위해서 L과 C를 공진 탱크회로로 구성하는 고주파 공진을 이용한 전류형 고주파 공진 U-U 컨버터를 보여주고 있다. 이 회로구성은 L과 C를 공진 탱크회로로 구성하였고, 스위칭 양단에 커패시터를 삽입하여 공진과 ZVS(Zero Voltage Switching) 커패시터로 동시에 사용하였다. 따라서, 컨버터는 턴ㆍ온, 턴ㆍ오프에서 스위칭 손실과 집음, 전압 스트레스를 줄일 수 있고, U전원 공급으로부터 리플이 적은 일정한 전류를 공급하기 위한 U 리액터는 공진 리액터와 연결되어 있기 때문에 부하 단락시 안정하게 동작하는 장점이 있다. 본 컨버터의 회로해석은 무차원화 파라미터 기법을 도입하여 행하였고, 또한 ZVS영역특성, 출력전력특성, 출력전압특성, 출력전류특성 등 여러 특성평가를 하였다. 여러 특성평가를 바탕으로 설계하였고, 실험을 통한 실험치와 이론치를 비교하여 이론해석의 정당성도 입증하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 B
• /
• pp.1026-1028
• /
• 2001

In this paper, proposal circuit proposes that load parallel resonant DC-DC Converter consist of L and C resonant tank circuit. Also, the capacitor$(C_1,\;C2)$ connected in switch are a common using by resonance capacitor and ZVS capacitor. The analysis of proposed circuit uses normalized parameter and characteristic estimation which is needed in each step before design is generally described the proposed circuit with the characteristics of average power and average output voltage etc. Alse, we conform a rightfulness theoretical analysis by comparing a theoretical values and experimental values obtained from experiment using MOSFET as switching devices.

• 전력전자학회논문지
• /
• 제9권4호
• /
• pp.326-333
• /
• 2004

본 논문에서는 Power-MOSFET를 통해 L및 C로 링크된 2조의 공진형 Full-bridge 인버터 회로를 다중 결합하여 대용량 전력변환장치의 소자에 인가되는 전압이나 부하전류를 분산 제어하는 기법을 제안하고 있다. 이 방식은 두 조의 인버터가 시분할로 구동되기 때문에 각 인버터의 독립된 출력이 부하단에서 합성되어 전력이 공급된다. 출력제어 기법은 시분할 합성법을 사용하고 이에 따른 인버터의 회로동작 모드를 분석하고 해석하였으며, 시뮬레이션을 통한 이론적 해석결과를 검정하고 이를 실험을 통해 비교 고찰하였다.

• Geomechanics and Engineering
• /
• 제28권1호
• /
• pp.25-33
• /
• 2022

The energy transferred on drill rods by dynamic impact mainly determines the penetration depth for in-situ tests. In this study, the dynamic response and transferred energy of drill rods are determined from the frequency of the stress waves. AW-type drill rods of lengths 1 to 3 m are prepared, and strain gauges and an accelerometer are installed at the head and tip of the connected rods. The drill rods are hung on strings, allowing free vibration, and then impacted by a pendulum hammer with fixed potential energy. Increasing the rod length L increases the wave roundtrip time (2L/c, where c is the wave velocity), and hence the transferred energy at the rod head. At the rod tip, the first velocity peak is higher than the first force peak because a large and tensile stress wave is reflected, and the transferred energy converges to zero. The resonant frequency increases with rod length in the waveforms measured by the strain gauges, and fluctuates in the waveforms measured by the accelerometer. In addition, the dynamic response and transferred energy are perturbed when the cutoff frequency is lower than 2 kHz. This study implies that the resonant frequency should be considered for the interpretation of transferred energy on drill rods.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2002년도 학술대회 논문집
• /
• pp.189-192
• /
• 2002

In this study, The experimental open-tube-type and close-tube-type thermoacoustic refrigerator were constructed. The resonant characteristics of a thermoacoustic refrigerator were investigated. In order to determine the optimum resonant tube length and frequency, We changed the length of resonant tube from 400mm to 850mm and the frequency from 100Hz to 1000Hz. In case of first harmonic, the temperature difference of open-tube-type (1/4 wave) refrigerator was $41^{\circ}C$(resonator length :500mm). The temperature difference of close-tube-type (1/2 wave) refrigerator was $43^{\circ}C$(resonator length :850mm). In this experiments, the experimental 1/2 wave refrigerator is slightly cooler than the experimental l/4 wave refrigerator.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1995년도 추계학술대회 논문집
• /
• pp.5.2-8
• /
• 1995

0.15($Ba_{1-x}Sr_{x}$)O-$0.15Sm_2O_3$-$0.7TiO_2$(x=0∼9[m/o]ceramics were fabricated by mixed-oxide method. Microwave dielectric properties were investigated with sintering conditions aid Sr addictive. In the specimen with x=0[m/o] sintered at 1350∼1470[$^{\circ}C$], dielectric constant, quality factor and temperature coefficient of resonant frequency were 70∼74, 2800∼3300(at 3[GHz]), -1.33∼+l.66[ppm/$^{\circ}C$, respectively. Increasing the Sr additive from 0 to 5[m/o], dielectric constant and temperature coefficient of resonant frequency were increased and quality factor was decreased. In the specimen with x=r[m/o] sintered at 1375[$^{\circ}C$], 6[hr], dielectric constant, quality factor and temperature coefficient resonant frequency were 75.62, 2785(at 3[GHz]), +8.39[ppm/$^{\circ}C$], respectively.

• Current Applied Physics
• /
• 제18권11호
• /
• pp.1225-1229
• /
• 2018

In this paper, we investigated the electronic structures and defect states of $SrLaMgTaO_6$ (SLMTO) double perovskite structures by using resonant inelastic x-ray scattering. Recently, $Eu^{3+}$ doped SLMTO red phosphors have been vigorously investigated due to their higher red emission efficiency compared to commercial white light emitting diodes (W-LED). However, a comprehensive understanding on the electronic structures and defect states of host SLMTO compounds, which are specifically related to the W-LED and photoluminescence (PL), is far from complete. Here, we found that the PL spectra of SLMTO powder compounds sintered at a higher temperature, $1400^{\circ}C$, were weaker in the blue emission regions (at around 400 nm) and became enhanced in near infrared (NIR) regions compared to those sintered at $1200^{\circ}C$. To elucidate the difference of the PL spectra, we performed resonant inelastic x-ray spectroscopy (RIXS) at Ta L-edge. Our RIXS result implies that the microscopic origin of different PL spectra is not relevant to the Ta-related defects and oxygen vacancies.