• Journal of Soil and Groundwater Environment
• /
• v.26 no.5
• /
• pp.29-38
• /
• 2021

This study investigated the mineralogical properties of bentonite and illite and evaluated the Cs sorption at various concentrations (C_w≈1-10⁵ ㎍/L). Bentonite samples, collected from South Korea and USA, majorly consisted of Ca- and Na-montmorillonite, showed large cation exchange capacity (CEC, 91.4 and 47.3 meq/100 g) and specific surface area (SSA, 46.1 and 39.7 m²/g). In contrast, illite sample (USA) had relatively low values for 14.4 meq/100g of CEC and 29.3 m²/g of SSA, respectively. Bentonite and illite had different non-linear sorption for Cs along with C_w. At low C_w<10 ㎍/L, illite showed higher sorption capacity than bentonite despite low CEC because of the existence of specific sorption sites at the weathered mineral edge. However, as C_w increased, bentonite represented high sorption capacity because the cation exchange between Cs and interlayer cations was effective at high C_w conditions. These results implicated that the Cs concentration is important to evaluate the sorption performance of bentonite and illite. Finally, the Cuadros' kinetic model for illitization using various K concentrations (2×10^-5 and 1.7×10^-3 mol/L) and temperature (100-200℃) showed that up to 50% of the montmorillonite in bentonite could be converted to illite, suggesting that the illitization should be considered to evaluate the sorption performance of the bentonite in deep geological disposal repository.

• Journal of Radiation Protection and Research
• /
• v.46 no.2
• /
• pp.58-65
• /
• 2021

Background: The evaluation of skyshine distribution, release of airborne radioactive nuclides, and soil activation and groundwater migration were required for radiological assessment of the impact on the environment surrounding In-Flight (IF)-system facility of the RAON (Rare isotope Accelerator complex for ON-line experiment) accelerator complex. Materials and Methods: Monte Carlo simulation by MCNPX code was used for evaluation of skyshine and activation analysis for air and soil. The concentration model was applied in the estimation of the groundwater migration of radionuclides in soil. Results and Discussion: The skyshine dose rates at 1 km from the facility were evaluated as 1.62 × 10^-3 μSv·hr^-1. The annual releases of ³H and ¹⁴C were calculated as 9.62 × 10^-5 mg and 1.19 × 10^-1 mg, respectively. The concentrations of ³H and ²²Na in drinking water were estimated as 1.22 × 10^-1 Bq·cm^-3 and 8.25 × 10^-3 Bq·cm^-3, respectively. Conclusion: Radiological assessment of environmental impact on the IF-facility of RAON was performed through evaluation of skyshine dose distribution, evaluation of annual emission of long-lived radionuclides in the air and estimation of soil activation and groundwater migration of radionuclides. As a result, much lower exposure than the limit value for the public, 1 mSv·yr^-1, is expected during operation of the IF-facility.

• Journal of Soil and Groundwater Environment
• /
• v.29 no.1
• /
• pp.1-9
• /
• 2024

As part of monitoring technology aimed at verifying the stability of CO₂ geologic storage and mitigating concerns about leakage, a method for measuring the pH and alkalinity of high-pressure fluid samples was established to obtain practical technology. pH measurement for high-pressure samples utilized a high-pressure pH electrode, and alkalinity was measured using the Gran titration method for samples collected with a piston cylinder sampler (PCS). Experimental samples, referencing CO₂-rich water and CO₂ geologic storage studies, were prepared in the laboratory. The PCS controls the piston, preventing CO₂ degassing and maintaining fluid pressure, allowing mixing with KOH to fix dissolved CO₂. Results showed a 6.1% average error in high-pressure pH measurement. PCS use for sample collection maintained pressure, preventing CO₂ degassing. However, PCS-collected sample alkalinity measurements had larger errors than non-PCS measurements, limiting PCS practicality in monitoring field settings. Nevertheless, PCS could find utility in preprocessing for carbon isotope analysis and other applications. This research not only contributes to the field of CCS monitoring but also suggests potential applications in studies related to natural analogs of CCS, CO₂-rock interaction experiments, core flooding experiments, and beyond.

• Korean Journal of Ecology and Environment
• /
• v.49 no.4
• /
• pp.279-288
• /
• 2016

Stable Isotope Analysis(SIA) of carbon and nitrogen is useful tool for the understanding functional roles of target organisms in biological interactions in the food web. Recently, mixing model based on SIA is frequently used to determine which of the potential food sources predominantly assimilated by consumers, however, application of model is often limited and difficult for non-expert users of software. In the present study, we suggest easy manual of R software and package SIAR with example data regarding selective feeding of crustaceans dominated freshwater zooplankton community. We collected SIA data from the experimental mesocosms set up at the littoral area of eutrophic Chodae Reservoir, and analyzed the dominant crustacean species main food sources among small sized particulate organic matters (POM, <$50{\mu}m$), large sized POM (>$50{\mu}m$), and attached POM using mixing model. From the results obtained by SIAR model, Daphnia galeata and Ostracoda mainly consumed small sized POM while Simocephalus vetulus consumed both small and large sized POM simultaneously. Copepods collected from the reservoir showed no preferences on various food items, but in the mesocosm tanks, main food sources for the copepods was attached POM rather than planktonic preys including rotifers. The results have suggested that their roles as grazers in food web of eutrophicated reservoirs are different, and S. vetulus is more efficient grazer on wide range of food items such as large colony of phytoplankton and cyanobacteria during water bloom period.

• Analytical Science and Technology
• /
• v.32 no.1
• /
• pp.17-23
• /
• 2019

Sources of NOx are both anthropogenic (e.g. fossil fuel combustion, vehicles, and other industrial processes) and natural (e.g. lightning, biogenic soil processes, and wildfires). The nitrogen stable isotope ratio of NOx has been proposed as an indicator for NOx source partitioning, which would help identify the contributions of various NOx sources. In this study, the ${\delta}^{15}N-NO_2$ values of vehicle emissions were measured in an urban region, to understand the sources and processes that influence the isotopic composition of NOx emissions. The Ogawa passive air sampler was used to determine the isotopic composition of $NO_2$(g). In urban tunnels, the observed $NO_2$ concentration and ${\delta}^{15}N-NO_2$ values averaged $3809{\pm}2656ppbv$ and $7.7{\pm}1.8$‰, respectively. The observed ${\delta}^{15}N-NO_2$ values are associated with slight regional variations in the vehicular $NO_2$ source. Both $NO_2$ concentration and ${\delta}^{15}N-NO_2$ values were significantly higher near the expressway ($965{\pm}125ppbv$ and $5.9{\pm}1.4$‰) than at 1.1 km from the expressway ($372{\pm}96ppbv$ and $-11.5{\pm}2.9$‰), indicating a high proportion of vehicle emissions. Ambient ${\delta}^{15}N-NO_2$ values were used in a binary mixing model to estimate the percentage of the ${\delta}^{15}N-NO_2$ value contributed by vehicular NOx emissions. The calculated percentage of the ${\delta}^{15}N-NO_2$ contribution by vehicles was significantly higher close to the highway, as observed for the $NO_2$ concentration and ${\delta}^{15}N-NO_2$.

• Korean Journal of Mineralogy and Petrology
• /
• v.35 no.1
• /
• pp.13-24
• /
• 2022

The Arctic Ocean is very sensitive to global warming and Arctic Ocean sediments provide a records of terrestrial climate change, analyzing their composition helps clarify global warming. The gravity core sediment ARA07C-St02B was collected at the East Siberian margin during an Arctic expedition in 2016 on the Korean ice-breaking vessel ARAON, and its provenance was estimated through sedimentological, mineralogical and geochemical analysis. The core sediment was divided into four units based on sediment color, sand content and ice-rafted debris content. Units 1 and 3 had higher sand and ice-rafted debris contents than units 2 and 4, and contained a brown layer, whereas units 2 and 4 were mainly composed of a gray layer. Correlation analysis using the adjacent core sediment ARA03B-27 suggested that the sediment units were deposited during marine isotope stage 1 to 4. The bulk mineral, clay mineral, and geochemical compositions of units including a brown layer differed from units including a gray layer. Bulk and clay mineral compositions indicated that coarse and fine sediments had a different origin. Coarse sediments might have been deposited mostly by the East Siberian Coastal Current from the Laptev Sea and the East Siberian Sea or by the Beaufort Gyre from the Chukchi Sea, whereas fine sediments might have been transpoted mostly by currents from the East Siberian Sea, the Chukchi Sea and the Beaufort Sea. Some of the coarse sediments in unit 1 and fine sediments in unit 3 might have been deposited by iceberg ice, sea ice or current from the Beaufort Sea and the Canada Archipelago. Investigating the geochemical composition of the potential origins will elucidate the origin and transportation of the study area's core sediments.

• Korean Journal of Ecology and Environment
• /
• v.56 no.4
• /
• pp.281-302
• /
• 2023

Carbon is not only an essential element for life but also a key player in climate change. The radiocarbon (¹⁴C) analysis using accelerator mass spectrometry (AMS) is a powerful tool not only to understand the carbon cycle but also to track pollutants derived from fossil carbon, which have a distinct radiocarbon isotope ratio (Δ¹⁴C). Many studies have reported Δ¹⁴C of carbon compounds in streams, rivers, rain, snow, throughfall, fine particulate matter (PM_2.5), and wastewater treatment plant effluents in South Korea, which are reviewed in this manuscript. In summary, (1) stream and river carbon in South Korea are largely derived from the chemical weathering of soils and rocks, and organic compounds in plants and soils, strongly influenced by precipitation, wastewater treatment effluents, agricultural land use, soil water, and groundwater. (2) Unprecedentedly high Δ¹⁴C of precipitation during winter has been reported, which can directly and indirectly influence stream and river carbon. Although we cannot exclude the possibility of local contamination sources of high Δ¹⁴C, the results suggest that stream dissolved organic carbon could be older than previously thought, warranting future studies. (3) The ¹⁴C analysis has also been applied to quantify the sources of forest throughfall and PM_2.5, providing new insights. The ¹⁴C data on a variety of ecosystems will be valuable not only to track the pollutants derived from fossil carbon but also to improve our understanding of climate change and provide solutions.

• Conservation Science in Museum
• /
• v.1
• /
• pp.61-74
• /
• 1999

Elemental analysis of 40 glass samples from the Northern Tomb and the Southern Tomb of Hwangnam-daech'ong No. 98 was performed. Fourteen compositions of each sample were analyzed quantitatively by SEM-EDS and glass samples were classified by multivariate analysis such as PCA. All of 40 samples were confirmed to be Na₂O-CaO-SiO₂ system with about 20% of Na₂O. Samples were classified into two groups by doing PCA on concentrations of 5 major elements(SiO₂, Al₂O₃, Na₂O, CaO and K₂O). Samples included in group I showed the concentration of Al₂O₃ is about 9.7% and that of CaO, about 2.2%. In group II, concentration of Al₂O₃ is about 3.2% and that of CaO, about 4.9%. Especially yellow grains embedded in sample No. 12 were shown to be PbSnO₃ by micro XRD, which was the first coloring material ever found in Korea. Lead isotope ratios of samples No. 12 and No. 17 which contained lead were measured by TIMS. The origin of lead was traced by means of multivariate analysis such as SLDA. The result showed that lead from southern China and southern Korea had been used for making glass.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.38 no.10
• /
• pp.1101-1107
• /
• 2014

A heavy ion accelerator is a device that accelerates heavy ions in the radio frequency (RF) range. The electric field that flows into the RF cavity continuously accelerates heavy ions in accordance with the phase of the input electromagnetic wave. For the purpose, it is necessary to design a coupler shape that can stably transfer the RF wave into the cavity. The RF coupler in a heavy ion accelerator has a large temperature difference between the input port and output port, which radiates the RF waves. It is necessary to consider the heat deflection on the RF coupler that occurs as a result of the rapid temperature gradient from an ultra-low temperature about 0 K to a room temperature about 300 K. The purpose of this study was to improve the system performance through an analysis of the intensity of the output electric field and temperature distribution considering various shapes of the RF coupler, along with an analysis of the durability considering the heat deflection and heat loss.

• Conservation Science in Museum
• /
• v.2
• /
• pp.57-68
• /
• 2000

This study is a scientific analysis of 12 bronze materials which were excavated from Sanoisa temple in Chongju. Analysis of crystalline shape, size and distribution of the each sample metal suggested that they can be classified as tableware(wrought), vessels for memorial service(casting) and bell bronze, which is the same result as classification based on elemental composition. Most of the tableware are forging wares with composition of 8:2:0 in Cu:Sn:Pb, and vessels for memorial service are casting wares whose composition is 7:1:2 in Cu:Sn:Pb, and bell bronze's composition is Cu:Sn:Pb = 85:10:5/9:1:0. The result clearly shows that composition is closely related with usage and manufacturing method of wares. Trace elements such as Co, Fe and As are the elements with high correlation coefficient with Cu, which means they exist as impurities in Cu, and the content of As showed an increase in the order of tableware, memorial service vessels and bell bronze. In addition, the analysis of lead isotope ratio showed that 3 bronze materials with high lead content were made from the lead coming from Japan and China. The composition of the solder was Cu:Sn:Pb = 83:12:5 where small Pb crystals were distributed evenly.