• Journal of Power Electronics
• /
• v.15 no.6
• /
• pp.1468-1479
• /
• 2015

Renewable energy resources such as wind and photovoltaic power generation systems demand a high step-up DC-DC converters to convert the low voltage to commercial grid voltage. However, the high step-up converter using a transformer has limitations of high voltage stresses of switches and diodes when the transformer winding ratio increases. Accordingly, conventional studies have been applied to series-connect multioutput converters such as forward-flyback and switched-capacitor flyback to reduce the transformer winding ratio. This paper proposes new single-ended converter topologies of an isolation type and a non-isolation type to improve power efficiency, cost-effectiveness, and output ripple. The first proposal is an isolation-type charge-pump switched-capacitor flyback converter that includes an extreme-ratio isolation switched-capacitor cell with a chargepump circuit. It reduces the transformer winding number and the output ripple, and further improves power efficiency without any cost increase. The next proposal is a non-isolation charge-pump switched-capacitor-flyback tapped-inductor boost converter, which adds a charge-pump-connected flyback circuit to the conventional switched-capacitor boost converter to improve the power efficiency and to reduce the efficiency degradation from the input variation. In this paper, the operation principle of the proposed scheme is presented with the experimental results of the 100 W DC-DC converter for verification.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.21 no.6
• /
• pp.265-275
• /
• 2017

In order to improve the seismic performance of structures, friction pendulum system (FPS) is the most commonly used seismic isolation device in addition to lead rubber bearing (LRB) in high seismicity area. In a nuclear power plant (NPP) with a large self weight, it is necessary to install a large number of seismic isolation devices, and the position of the center of rigidity varies depending on the arrangement of the seismic isolation devices. Due to the increase in the eccentricity, which is the difference between the center of gravity of the nuclear structure and the center of stiffness of the seismic isolators, an excessive seismic response may occur which could not be considered at the design stage. Three different types of eccentricity models (CASE 1, CASE 2, and CASE 3) were used for seismic response evaluation of seismically isolated NPP due to the increase of eccentricity (0%, 5%, 10%, 15%). The analytical model of the seismic isolation system was compared using the equivalent linear model and the bilinear model. From the results of the seismic response of the seismically isolated NPP with increasing eccentricity, it can be observed that the effect of eccentricity on the seismic response for the equivalent linear model is larger than that for the bilinear model.

• Smart Structures and Systems
• /
• v.22 no.4
• /
• pp.441-457
• /
• 2018

Characteristic parameter values of seismic isolators deviate from their nominal design values due to uncertainties and/or errors in their material properties and element dimensions, etc. Deviations may increase over service life due to environmental effects and service conditions. For accurate evaluation of the seismic safety level, all such effects, which would result in deviations in the structural response, need to be taken into account. In this study, the sensitivity of the probability of failure of the structures equipped with nonlinear base isolation systems to the uncertainties in various isolation system characteristic parameters is investigated in terms of various isolation system and superstructure response parameters in the context of a realistic three-dimensional base-isolated building model via Monte Carlo Simulations. The inherent record-to-record variability nature of the earthquake ground motions is also taken into account by carrying out analyses for a large number of ground motion records which are classified as those with and without forward-directivity effects. Two levels of nominal isolation periods each with three different levels of uncertainty are considered. Comparative plots of cumulative distribution functions and related statistical evaluation presented here portray the potential extent of the deviation of the structural response parameters resulting from the uncertainties and the uncertainty levels considered, which is expected to be useful for practicing engineers in evaluating isolator test results for their projects.

• Earthquakes and Structures
• /
• v.16 no.6
• /
• pp.743-755
• /
• 2019

In this paper, a new system of seismic isolation for buildings - called suspended columns - is introduced. In this method, the building columns are placed on the hinged cradle seats instead of direct connection to the foundation. In this system, each of the columns is put on a seat hung from its surrounding area by a number of cables, for which cavities are created inside the foundation around the columns. Inside these cavities, the tensile cables are hung. Because of the flexibility of the cables, the suspended seats vibrate during an earthquake and as a result, there is less acceleration in the structure than the foundation. A Matlab code was written to analyze and investigate the response of the system against the earthquake excitations. The findings showed that if this system is used in a building, it results in a significant reduction in the acceleration applied to the structure. A shear key system was used to control the structure for service and lateral weak loads. Moreover, the effect of vertical acceleration on the seismic behavior of the system was also investigated. Effect of the earthquake characteristic period on the system performance was studied and the optimum length of the suspension cables for a variety of the period ranges was suggested. In addition, measures have been taken for long-term functioning of the system and some practical feasibility features were also discussed. Finally, the advantages and limitations of the system were discussed and compared with the other common methods of seismic isolation.

• Journal of Families and Better Life
• /
• v.20 no.2
• /
• pp.147-159
• /
• 2002

The purpose of this study is to investigate children's perceptions of their own peer status and the variables that affect the perception. Four hundred boys and girls in grades five and six participated in this study. The participants were sampled from elementary schools located in two cities in Cheon-buk Province. Out of the 400 self-report questionnaires filled by the participants, 380 were used for the data analyses. The methods of analyses included basic descriptive categorical analysis (frequencies, means, percentages) as well as t-test, one way ANOVA, and multiple regressions. To summarize major findings from the analyses; first, a significant difference was found in children's aggression by father's job and mother's age, in children's popularity by school GPA, father's education, mother's education, and fathers job, and in children's isolation by father's age, father's education, mother's education, and father's job. Second, children's aggression was significantly dependent upon self-esteem, loneliness, family harmony, and family communication. Children's popularity was related with school grade, name satisfaction, body satisfaction, self-esteem, number of close friends, loneliness, family harmony family communication, parental love and acceptance, and perceived closeness to mother. Children's isolation was significantly associated with school grade, body satisfaction, self-esteem, number of close friends, loneliness, family harmony, family communication, parental love and acceptance, and perceived closeness to mother Third, according to the multiple regression analyses, it was found that highly aggressive children tend to report less family harmony, more loneliness, and a larger number of friends. Also, highly popular children tend to report less loneliness, larger number of friends, strong family harmony, and higher academic achievement. On the other hand, highly isolated children tend to perceive weak family harmony, more loneliness, and lower body satisfaction. Lastly, the overall peer status indicator depended significantly on family harmony, loneliness, self-esteem, academic achievement, body satisfaction.

• Journal of Institute of Control, Robotics and Systems
• /
• v.22 no.10
• /
• pp.859-868
• /
• 2016

This paper proposes a new global positioning system (GPS) receiver algorithm to improve the positioning accuracy of a transporter using fault detection and isolation techniques from satellite signals. To improve the positioning accuracy, several factors including a feasible number of satellite signals, SNR, NAV Measurement Quality Indicator (mesQI), and Doppler, among others, have been utilized in the proposed algorithm. To increase the number of feasible satellite signals, an erroneous satellite signal has been replaced by the previous one. In conventional approaches, received GPS signals are analyzed and directly determined to be contaminated or not. The only clean signals are utilized for identifying the current location. This fault detection and isolation (FDI) feasibility test is popular for commercial GPS receivers. In the urban environment, especially near a building, the feasible number of satellite signals becomes insufficient to position the transporter. To overcome this problem, satellite signals are efficiently selected and recovered. Additionally, using the proposed GPS receiver algorithm, a feasible number of satellite signals can be increased, thereby improving the positional accuracy. Real world experiments using a transporter that carries blocks in a shipyard have demonstrated the superiority of the proposed algorithm compared to conventional approaches.

• Journal of the Korean Society of Tobacco Science
• /
• v.18 no.2
• /
• pp.126-131
• /
• 1996

In this study effects of isolation distance, transplanting time of maternal plants, and bagging of flower head with the gauze-cloth bag on the outcrossing of burley tobacco (Nicotiana tabacum L.) were investigated. Also the effect of fertilizer level and control of the number of capsules per plant on seed production and quality were examined. A male sterile line. produced 0.3 to 3.8 capsules Per plant when it was Planted with normally flowering tobacco with the average outcrossing of 7.2 plants, ranging from 2 to 18 out of 20 plants. With the farther the isolation distance between maternal plants and pollen donor plant, the lower the outcrossing occurred. Outcrossing occurred even at the isolation distance of 312 m. When the maternal plants were transplanted 35 days after transplanting the pollen donor ones, the outcrossed plants were not decreased significantly. The bagging of the flower head with the gauze-cloth bas (#0.9∼ 1.0 mm) decreased the outcrossed plants significantly, but couldn't prevent the outcrossing completely. The seed amount per plant was higher in the highly fertilized cultivation. The number of seed capsules per plant affected significantly on seed yield and quality. When the seed capsules was controlled by 30 or 50 capsules per plant, the weight of 1,000 seeds and germination rate were higher than those with 70 or 90 capsules per plant. Key words : Nicotiana tabacum, outcrossing, bagging.

• Journal of information and communication convergence engineering
• /
• v.17 no.3
• /
• pp.185-190
• /
• 2019

The explosive growth of data traffic and services has created cost challenges for networks. Studies have attempted to effectively apply network slicing in fifth generation networks to provide high speed, low latency, and various compatible services. However, in network slicing using mixed-integer linear programming, the operation count increases exponentially with the number of physical servers and virtual network functions (VNFs) to be allocated. Therefore, we propose an efficient slice allocation method based on cluster technology, comprising the following three steps: i) clustering physical servers; ii) selecting an appropriate cluster to allocate a VNF; iii) selecting an appropriate physical server for VNF allocation. Solver runtimes of the existing and proposed methods are compared, under similar settings, with respect to intra-slice isolation. The results show that solver runtime decreases, by approximately 30% on average, with an increase in the number of physical servers within the cluster in the presence of intra-slice isolation.

• Microbiology and Biotechnology Letters
• /
• v.24 no.2
• /
• pp.178-184
• /
• 1996

Dryfilm method by using 3M Petrifilm$^{TM}$ has been examined to replace conventional agar method for isolation of microorganisms from foods. The objectives of the present study were to evaluate suitability of dryfilm method as a microbial isolation method and to determine the effect of antimicrobial agent on dryfilm for isolation of microorganisms from foods. Five different foods, milk, ground beef, fishery surimi, Takju and wheat flour were used to isolate the natural microflora in foods and the inoculated Escheri chia coli. Standard method agar (SMA, Difco) and Petrifilm$^{TM}$ aerobic count (PAC, 3M) were used to isolate total microorganisms from foods. Violet red bile agar (VRBA), brilliant green lactose bile (BGLB) broth and Petrifilm$^{TM}$ coliform count (PCC, 3M) were used to isolate coliforms from foods. E. coli broth (EC broth) and Petrifilm$^{TM}$ E. coli count (PEC, 3M) were used to isolate E. coli from foods. Acidified potato dextrose agar (APDA) and Petrifilm$^{TM}$ yeast & mold count (PYMC, 3M) were used to isolate yeasts and molds from foods. Total aerobic plate counts isolated from five different foods by SMA and PAC (3M) were riot significantly different each other at P<0.05 level and were highly correlated each other ($\geq$0.96). Mugwort extract as an antimicrobial agent did not affect microbial enumeratiion of Dryfilm. Significantly higher number of coliform colonies were formed on VRBA than PCC (3M) from ground beef, but they were not significantly different in coliform colonies from milk samples. PCC (3M) and BGLB were not significantly different for enumeration of coliforms in milk and beef samples. Significantly higher number of E. coli were isolated by EC broth than PEC from ground beef, but these were not significontly different for enumeration of E. coli from milk. Yeast and mold counts isolated from Takju and wheat flour by APDA and PYMC (3M) were not significantly different at P<0.05 level. These data indicate that dryfilm method by using 3M Petrifilm$^{TM}$ can be successively used as an alternative to conventional agar method for enumeration of microorganisms in various foods.

• Journal of Families and Better Life
• /
• v.19 no.6
• /
• pp.77-93
• /
• 2001

The purpose of this study is investigated on the loneliness of childhood and related variables. 400 boys and girls were sampled far this study that they are elementary school 5th 6th located in IK-San, Kim-Je city. Survey was conducted by self-reported questionnaires and 380 questionnaires were finally used for the data analysis. The data analysis with SPSS Computer program were frequency, percentage, mean, 7- 1est, one-way ANOVA with Duncan's Multiple Range test and Multiple Regression Analysis. The results of this study can be summarized as follows : 1. Significant difference was founded in children's loneliness according to father's education, father's job mother's education, school grade, name satisfaction, body satisfaction, siblings, close relation friend number, family harmony, parent's love- acceptable. 2. Significant difference was founded in children's loneliness according to peer status degree (popular isolation aggression). Higher popular children was perceived lower in loneliness than lower popular children. Higher isolation children was perceived higher in loneliness than lower isolation. Higher aggression children was perceived higher in loneliness than lower aggressive in loneliness. 3. In the result of multiple regression analysis the influence on the loneliness be presented as follows in order of importance , peer status of isolation degree popular degree mother's job of self business, parent's love-acceptable, friends number. The result the above study indicates that peer status family harmony, parent's love- acceptable, child's psychological environmental variables influences on the loneliness but essential variables are influences peer status on the loneliness.