• 전자공학회논문지D
• /
• 제35D권8호
• /
• pp.69-75
• /
• 1998

We demonstrate wavelength conversion of 2.5Gb/s optical signals by four-wave mixing (FWM) in a semiconductor optical amplifier (SOA). We investigate the effect of input pump and signal powers on the coversion efficiency, optical signal-to-noise ratio (OSNR) and extinction ratio to be a measure of performance in a wavelength converter. As a result, we show that the maximum bit error rate (BER) performance can be obtained by co promising among high-vonversion efficiency (minimum Pprobe), high-OSNR (maximum Pprobe) and low-cross-gain saturation effects (Pprobe kept at least 6dB weaker than Ppump). In our experiment, we obtain optimum performance at +3 dBm pump power and -6dBm signal power. The power penalty incurred in the wavelength conversion can be minimized by careful selection of the input pump and signal powers. We show that about 0.5dB power penalty for 3.2nm wavelength coversion at 10-10 BER is achievable.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 1995년도 춘계학술대회 논문집
• /
• pp.241-245
• /
• 1995

This paper shows that the proposed fuzzy-sliding mode for SCARA robot control could reduce chattering problemed in sliding mode control and is robust against parameter uncertainties. It was very small quantities of chattering in the fuzzy-sliding mode control conpared with that in sliding mode control with two dead-band. In here, the sliding mode control with two dead-band is the method to reduce some chattering by changing into a continuous variable lower control input gain when a state value in pahase palne converged sithin two dead-band. But, the fuzzy-sliding mode control for more reducing chattering is the method to change control input by slicing mode into that by fuzzy rule within two dead-band. Simulations show that the effect of reducing chattering by the fuzzy-sliding mode is superior to sliding mode control with two dead-band.

• 대한전자공학회논문지SD
• /
• 제44권10호
• /
• pp.61-66
• /
• 2007

본 논문에서는LCD (Liquid Crystal Display) source driver IC에서 사용되는 고전압 op-amp의 출력 편차를 개선하기 위하여 전압 이득을 향상한 CMOS rail-to-rail 입/출력 op-amp를 제안하였다. 제안된 op-amp는 15 V 이상의 고전압 MOSFET의 과도한 channel length modulation에 의한 전압 이득의 감소로 offset 전압이 커지는 문제를 해결하기 위하여 cascode 구조를 갖는 floating current source 및 class-AB control단을 채용하고 있다. 제안된 op-amp는 HSPICE 시뮬레이션을 통하여 전압 이득이 기존 대비 30 dB 향상됨을 확인하였으며, onset 전압은 기존 6.84 mV에서 $400\;{\mu}V$ 이하로 개선됨을 확인하였다. 또한, 제안된 op-amp가 적용된 LCD source driver IC의 실측 결과 출력 편차는 기존 대비 2 mV 향상됨을 확인하였다.

• Journal of Power Electronics
• /
• 제19권6호
• /
• pp.1366-1379
• /
• 2019

High-gain DC/DC converters have become one of the key technologies for the grid-connected operation of new energy power generation, and its research provides a significant impetus for the rapid development of new energy power generation. Inspired by the transformer effect and the ripple-suppressed ability of a coupled inductor, a double-coupled inductor high gain DC/DC converter with a ripple absorption circuit is proposed in this paper. By integrating the diode-capacitor voltage multiplying unit into the quadratic Boost converter and assembling the independent inductor into the magnetic core of structure coupled inductors, the adjustable range of the voltage gain can be effectively extended and the limit on duty ratio can be avoided. In addition, the volume of the magnetic element can be reduced. Very small ripples of input current can be obtained by the ripple absorption circuit, which is composed of an auxiliary inductor and a capacitor. The leakage inductance loss can be recovered to the load in a switching period, and the switching-off voltage spikes caused by leakage inductance can be suppressed by absorption in the diode-capacitor voltage multiplying unit. On the basis of the theoretical analysis, the feasibility of the proposed converter is verified by test results obtained by simulations and an experimental prototype.

• 전기학회논문지
• /
• 제65권1호
• /
• pp.81-87
• /
• 2016

An LCL-type Isolated dc-dc converter operating for constant output voltage is analyzed, including the effect of a high frequency transformer using ac complex circuit approximation. Its solution is derived and is used to obtain the characteristics of the proposed converter. The analyses show through converter modeling, phasor diagram and gain comparison that inclusion of a high frequency transformer results in introduction of magnetizing inductance and leakage inductances at conventional LCL dc-dc converter with ideal transformer. The theoretical and simulation results are presented in case of the wide variations in input voltage and load current in detail. Analysis and simulation results observed that introduction of a transformer in the dc-dc converter had considerable effect on the performance, especially in the case of low output voltage and large load.

• 전자공학회논문지
• /
• 제51권1호
• /
• pp.172-178
• /
• 2014

본 논문은 공통 소스 증폭기의 부유 커패시턴스에 밀러 정리를 적용할 때 출력 커패시턴스를 고려한 AC 이득을 사용하여 정확한 밀러 효과 모델을 도출하였다. 정확한 AC 이득을 사용하면 부유 커패시턴스는 입력과 출력 부분에 C와 병렬 RC 회로의 직렬연결로 변환된다. 제안한 밀러 효과 모델로 구성된 등가회로의 주파수 응답 특성은 변환 전 회로의 주파수 응답 특성과 일치해 제안한 모델의 정확성이 확인되었다. 제안한 밀러 효과 모델과 소자 값이 다소 복잡하지만 공통 소스 증폭기의 특성을 이용하여 간략화 시킬 수 있다. 또한 개방 회로 시정수 방법을 사용하면 증폭기의 3-dB 주파수도 쉽게 예측이 가능하며 예측된 3-dB 주파수는 공통 소스 증폭기의 주 극점 근사 방법과 같은 값을 가진다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제32권8호
• /
• pp.1263-1268
• /
• 2008

In this paper, the low noise power amplifier for GaAs FET ATF-10136 is designed and fabricated with active bias circuit and self bias circuit. To supply most suitable voltage and current, active bias circuit is designed. Active biasing offers the advantage that variations in the pinch-off voltage($V_p$) and saturated drain current($I_{DSS}$) will not necessitate a change in either the source or drain resistor value for a given bias condition. The active bias network automatically sets a gate-source voltage($V_{gs}$) for the desired drain voltage and drain current. Using resistive decoupling circuits, a signal at low frequency is dissipated by a resistor. This design method increases the stability of the LNA, suitable for input stage matching and gate source bias. The LNA is fabricated on FR-4 substrate with active and self bias circuit, and integrated in aluminum housing. As a results, the characteristics of the active and self bias circuit LNA implemented more than 13 dB and 14 dB in gain, lower than 1 dB and 1.1 dB in noise figure, 1.7 and 1.8 input VSWR at normalized frequency $1.4{\sim}1.6$, respectively.

• 가족자원경영과 정책
• /
• 제4권1호
• /
• pp.95-111
• /
• 2000

The family financial management is the important element which has a effect on the improvement of family economic well-being. Thus the study sets up human & material resources and requirement as an input factor, family financial management as an throughput factor, and economic well-being as an output factor, and then identifies if there are some relationships among them by using a systematic approach of family financial management. The questionaires were distributed to 600 employed wives by carrying out cluster sampling and disproportional stratified sampling. The 573 cases of them were used as the mean, ratio, Pearson’s Correration, ANOVA, factors analysis, and Stepwise Regression using the SAS/PC+. The major findings of the study are as follows: 1) A practical application of information as on input variable, appears the fator which has an important effect upon the throughput factor, that is, family financial management. The employed wives should manage a lot of resources in rapidly changing social-economic circustances. So it shows that not only they should take informations open to their daily life and then make practical use of them in managing their family finance, but also they must be capable of judging and accepting reasonable informations in order to gain and manage resources suitable to the characteristics of family finance and family members’need. 2) There was significant relationship between the employed wives’family financial management and family economic well-being, focused on the systematic theory of family financial management. This study provides for the information to develope the program for the employed wives’family financial planning and counseling.

• 전자공학회논문지D
• /
• 제36D권8호
• /
• pp.62-67
• /
• 1999

본 논문에서는 반도체 광 증폭기내에서 상호 이득변조 방식을 이용한 파장변환기의 입력 다이너믹 영역을 넓히기 위한 구조를 제안하였다. 파장변환기에서의 성능의 척도가 되는 파워 패널티에 대한 입력 펌프 및 프로우브 광 세기의 영향을 조사하였으며, 그 결과 프로우브광의 세기가 펌프광의 세기보다 약 3 dB, 낮은 경우에 최적의 BER 성능을 보였다. 이러한 특성을 이용하여 입력 펌프광의 세기를 감지하고 그에 따라 프로우브 광원에 가해지는 바이어스 전류로 프로우브 광의 세기를 제어하는 파장변환기 구조를 제안하였다. 따라서 넓은 입력 다이너믹 영역을 가지는 파장변환기를 구현할 수 있으며, 2.5 Gb/s 광신호에 대해 20 dB 이상의 입력 다이너믹 영역을 얻었다.

• 한국추진공학회지
• /
• 제17권5호
• /
• pp.86-94
• /
• 2013

로켓의 연소불안정과 관련되어 분사기의 동특성을 연구하는 일은 중요하다. 와류형 분사기의 동특성에 대해서는 많은 연구가 이루어졌지만 충돌형 분사기의 동특성에 대해서는 알려진 바가 거의 없다. 따라서 본 연구에서는 충돌형 분사기의 동특성을 규명하기 위해 이에 관한 실험을 수행하였으며 동적거동을 생성시키기 위해 특별히 제작된 압력섭동기(mechanical pulsator)가 사용되었다. 가진주파수와 매니폴드 압력의 여러 조건 하에서 게인(gain)과 위상차(phase difference)를 분석하였고 주파수는 5, 10, 15 Hz의 낮은 영역에 맞춰졌다. 제트 속도를 결정하기 위한 방법에 대해 논의하였으며 실험과정 중에 나타난 특정현상이 클라이스트론(Klystron) 효과와 관련이 있는 것으로 판단되어 이에 대해 고려하였다.