• Journal of the Korea Institute of Military Science and Technology
• /
• v.18 no.5
• /
• pp.492-497
• /
• 2015

Currently, there are many kinds of tracked armored vehicles in service and they have encountered various environment and situations. So there are many obstacles to operate them improperly such as an engine stall. The causes of engine stall are an insufficient fueling, a mixture of air-fuel or vapor lock, and load increment which results from a rapid steering or increasing a viscosity of lubricant by low temperature. In this paper, engine stall by load increment due to a rapid steering or increasing of lubricant viscosity on tracked armored vehicles is analyzed, the ways to prevent it are applied, and their degrees of improvement are evaluated.

• Structural Engineering and Mechanics
• /
• v.25 no.1
• /
• pp.53-73
• /
• 2007

In this study, an effective load increment method for multi modal adaptive non-linear static (pushover) analysis (NSA) for building type structures is presented. In the method, lumped plastisicity approach is adopted and geometrical non-linearties (second-order effects) are included. Non-linear yield conditions of column elements and geometrical non-linearity effects between successive plastic sections are linearized. Thus, load increment needed for formation of plastic sections can be determined directly (without applying iteration or step-by-step techniques) by using linearized yield conditions. After formation of each plastic section, the higher mode effects are considered by utilizing the essentials of traditional response spectrum analysis at linearized regions between plastic sections. Changing dynamic properties due to plastification in the system are used on the calculation of modal lateral loads. Thus, the effects of stiffness changes and local mechanism at the system on lateral load distribution are included. By using the proposed method, solution can be obtained effectively for multi-mode whereby the properties change due to plastifications in the system. In the study, a new procedure for determination of modal lateral loads is also proposed. In order to evaluate the proposed method, a 20 story RC frame building is analyzed and compared with Non-linear Dynamic Analysis (NDA) results and FEMA 356 Non-linear Static Analysis (NSA) procedures using fixed loads distributions (first mode, SRSS and uniform distribution) in terms of different parameters. Second-order effects on response quantities and periods are also investigated. When the NDA results are taken as reference, it is seen that proposed method yield generally better results than all FEMA 356 procedures for all investigated response quantities.

• Journal of Nutrition and Health
• /
• v.35 no.1
• /
• pp.69-77
• /
• 2002

The purpose of this study was to determine the probability of overweight throughout childhood in relation to the presence of overweight at birch or in early childhood, and presence of overweight in children's parents. Weight and height measures were collected at birth and at ages of 7, 10, 12 years from 655 6th grade primary schoolchildren. Childhood overweight was defined as a body mass index at or above the 85th percentile for age and sex, and overweight in children's parents as a body mass index at or above 27. The prevalence of overweight increased with age of the children. Overweight at birth was not associated with overweight at 12 years of ages. However, overweight at 12 years old was already related to overweight at 7 years old. In comparison to non-overweight peers, overweight children at ages 7(OR = 7.64, 95% CI = 4.32-13.51) and 10 years(OR = 19.69, 95% CI = 11.42-33.94) had a higher rick of becoming overweight at 12 years of age. Among children who was overweight at age 7years, 60.7% remained overweight 5 years later, Yearly increment in BMI of overweight children was larger than that of non-obese children (1.15-1.65kg/m$^2$vs 0.50-0.71kg/m$^2$. As compared with the lower case in mealy increment of BMI, the probability of being overweight at age of 12 years was greater in higher case. BMI values at age 7years were positively correlated with BMI values at age of 10 and 127ear,i, and with annual increments in BMI. But those relationships with birth weight were not observed. Children were at greater risk for overweight if at least ogle parent was overweight. The odds ratio for child overweight associated with maternal overweight was 2.41(95% CI = 1,13-5.IS), and those associated with paternal overweight 1.70(95% CI = 0.92-3.17). And parents' BMIs were positively correlated with children's BMI values and yearly BMI increment. In conclusion, overweight at early childhood and annual inclement in BMI can be important in predicting the prevalence of overweight and the risk that overweight will remain after 7 years of age. The risk of being overweight throughout the childhood increases by the parents'overweight.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.4
• /
• pp.1325-1332
• /
• 2010

SISI(Short Increment Sensitivity Index) test is to identify recruitment phenomenon that is used to diagnose detailed lesion of sensory-neural hearing loss. This paper describes SISI test software implemented to personal computer(PC). This software supports two test modes, consisting of auto-mode and manual-mode, which are classified according to whether or not audiologist to lead test, thereby enabling cost effective test. In addition, it has been designed to perform automatic masking in case of necessity. And by supporting not only 1dB increment but also 2 and 5dB increment, SISI test program of this paper makes it possible to acquire more accurate test result.

• Journal of the Korean Data and Information Science Society
• /
• v.21 no.4
• /
• pp.709-717
• /
• 2010

The task of association rule mining is to find certain association relationships among a set of data items in a database. There are three primary measures for association rule, support and confidence and lift. In this paper we developed a association rule ranking function using conditional probability increment ratio. We compared our function with several association rule ranking functions by some numerical examples. As the result, we knew that our decision function was better than the existing functions. The reasons were that the proposed function of the reference value is not affected by a particular association threshold, and our function had a value between -1 and 1 regardless of the range for three association thresholds. And we knew that the ranking function using conditional probability increment ratio was very well reflected in the difference between association rule measures and the minimum association rule thresholds, respectively.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.4
• /
• pp.621-629
• /
• 1992

This study is concerned with an application of the Boundary Element Method to 2-dimensional elastoplastic stress analysis on the material nonlinearities. The boundary integral formulation adopted an initial stress equation in the inelastic term. In order to determine the initial stress increment, the increment of initial elastic strain energy due to elastic increment in stressstrain curve was used as the convergence criterion during iterative process. For the validity of this procedure, the results of B.E.M. with constant elements and NISA with linear elements where compared on the thin plate with 2 edge v-notches under static tension and the thick cylinder under internal pressure. And this paper compared the results of using unmedical integral with the results of using semi-analytical integral on the plastic domain integral.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.30 no.4
• /
• pp.134-153
• /
• 1988

This paper was carried out to investigate the existence of a unique stress- strain behavior by obtaining some factors influencing the time dependent stress- strain behavior of clay. The results obtained from this study were summarized as follows ; 1. The relationship between stress ratro and strain in normally consolidated clay was in- dependent on pre-shear consolidation pressure. Therefore, shear strain could be expressed as a function with stress ratio. 2. The constitutive equation of shear strain on Modified Carn Clay Model coincided better with the observed value than Cam Clay Model. 3. The relationships between deviator stress and shear strain, between pore water pressure and shear strain were unified by the mean equivalent pressure. 4. The shear strain contour in norrnally consolidated clay was increased linearly through origin, but that in overconsolidated clay was not in accordance with the result of the former. 5. Because the effective stress path of normally consolidated clay was unified by the mean equivalent pressure, state boundary surface in (e,p,q) space was transformed into two dimensional surface. But it was considered to be suitable that the unified stress- strain in overconsolidated clay be expressed by a function with overconsolidation ratio. 6. The deviator for constant strain was increased linearly with increment of strain rate ($\varepsilon$) on semi-log scale, but pore water pressure was decreased. 7. The behavior of stress relaxation was transformed from linear to curvilinear with inc - rement of strain rate before stress relaxation test, and pore water pressure was increased in total range. 8. The strain of creep was increased linearly with increment of time on semi-log scale. The greater the strain rate before creep test became, the greater the increment of strain of creep became. And the pore water pressure during creep test was increased generally with increment of time on semi-log scale.

• Korean Journal of Applied Biomechanics
• /
• v.29 no.4
• /
• pp.247-254
• /
• 2019

Objective: The goal of this study was to determine the center of pressure (CoP) complexity pattern in approximate entropy technique between genders at different conditions of running speed. Background: It is conducted to evaluate the complexity pattern of CoP in the increment of running speed to have insights to injury prediction, stability, and auxiliary aids for the foot. Method: Twenty men (age=22.3±1.5 yrs.; height=176.4±5.4 cm; body weight=73.9±8.2 kg) and Twenty women (age=20.8±1.2 yrs.; height=162.8±5.2 cm; body weight=55.0±6.3 kg) with heel strike pattern were recruited for the study. While they were running at 2.22, 3.33, 4.44 m/s speed on a treadmill (instrumented dual belt treadmills, USA) with a force plate, CoP data were collected for the 10 strides. The complexity pattern of the CoP was analyzed using the ApEn technique. Results: The ApEn of the medial-lateral and antero-posterior CoP in the increment of running speed showed significantly difference within genders (p<.05), but there were not statistically significant between genders at all conditions of running speed. Conclusion: Based on the results of this study, CoP complexity pattern in the increment of running speed was limited to be characterized between genders as an indicator to judge the potential injury and stability. Application: In future studies, it is needed to investigate the cause of change for complexity of CoP at various running speed related to this study.

• Journal of Convergence Society for SMB
• /
• v.1 no.1
• /
• pp.67-73
• /
• 2011

Handover in high speed mobile communication service, in particulary mobile WiMAX is supported efficiency mobility to 120km/h speed. But, in order to accommodate number of user increment in a cell, wireless network is increment to microcell and picocell by allocate bandwidth and by decrease cell size. handover is occurrent and increment connection failure ratio In this result. IEEE 802.16 standard is support seamless connection through handover optimization scheme. But because authentication process is abbreviate, network weakness is exposure. In this paper, we propose handover scheme for support realtime service as VoIP, Picure communication, Streaming Data Service in order to support partially encryption method. In experiment, proposed scheme is proof which process time is increment 20% more than previous scheme.

• Journal of Biosystems Engineering
• /
• v.27 no.1
• /
• pp.51-58
• /
• 2002

The goal of this research was to an optimum conditions for the brown rice conditioning from data of milling characteristics after conditioning of the brown rice. The range of the initial moisture content of the sample was 13%, 14%, and 15%, the range of the increment of the moisture content was 0.4% and 0.8% with respect to the initial moisture content, and a ripe time after conditioning was eight hours. The results obtained from this research can be summarized as fellows. 1 The crack ratio after conditioning the brown rice with the initial moisture content was increased as the initial moisture content decreased and increment of the moisture content increased. The crack ratio of the milled rice was increased than that of the non-conditioned brown rice and decreased with the conditioned brown rice with the increment of the moisture content of 0.4% and 0.5%. 2. The broken rice ratio after conditioning the brown rice with the initial moisture content was a little higher than that of the non-conditioned brawn rice. The broken ratio of the conditioned brown rice with the increment of the moisture content of 0.4% was increased around 0.2∼0.4% with respect to the non-conditioned brown riced and the broken ratio of the brown rice was high with increased amount of water sprayed during conditioning process. 3. The moisture content of the milled rice after conditioning the brown rice with the initial moisture content increased around 0.3∼0.8% with respect to the non-conditioned milled rice. 4. The electric energy consumption on milling process with the conditioned brown rice by the initial moisture content was decreased 3.4∼39.1% with respect to the non-conditioned brown rice.