• Korean Journal of Applied Biomechanics
• /
• v.13 no.2
• /
• pp.139-160
• /
• 2003

The purpose of this study was to suggest the guideline for scientific and quantitative skill acquisition methods of badminton smashing so that the novice could learn the motions of badminton smashing efficiently. The subject participated consisted of total 6 middle school students of the stilled(3) and the unskilled(3). The cinematographical experimental & Analysis equipments used in the study were composed of two Model D-5100 Video Cameras, a control point, a synchronization timer and Kwon3d motion analysis system. The conclusions obtained were as follows, 1. It was necessary for the unskilled to learn the smashing impact phase in situation of max. velocity of COG in order to minimize the timing loss phase. 2. Particularly. The power from segments of Power Zone must participate in utilization in sequence of order of trunk-upper arm- forearm-hand-racket segment in both the skilled and the unskilled.. 3. Therefore it was necessary for the unskilled to do smashing practice for cumulated sum of absolute & relative velocity transfer into shuttle cock after adjusting anterior-posterior tilting angle and max timing, in sequence of segment recruited.

• Journal of the Korean Ceramic Society
• /
• v.32 no.10
• /
• pp.1178-1188
• /
• 1995

Bi4Ti3O12 (BIT) and its rare earth (Y, Nd, Sm, Gd)-substituted derivatives were synthesized using a sol-gel method to investigate their microstructures, cystal structures and electrical properties depending on the subsituted elemetns. Nd- or Sm-substitution into BIT appeared to be favorable, while Y- or Gd-substitution occurred with a pyrochlore phase. This suggests that a smaller trivalent rare earth ion may not be favorable in the structure of BIT. The rare earth derivatives showed that their particle sizes and shapes were considerably different depending on the kinds of substituted elements. Y-substitution resulted in developing a relatively even particle size and a dense microstructure. In structure, they may be similar to the pseudo-orthorhombic BIT but close to a paraelectric tetragonal phase. Their a (or b) axes were shortened, compared to the one of BIT. Such a distortion may result a decrease in the tilting of TiO6. BIT and the derivatives showed that their dielectric constants and losses were 40~120 and less than 0.03, respectively in the frequency range of 1~10 MHz. The dielectric loss of Y-substituted derivative was the lowest one and changed a little to frequency. Curie points were observed in all the derivatives like BIT to suggest that they would be ferroelectric. The temperature stability of the delectric properties of the derivatives below the Curie points were relatively better than the one of BIT.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.28 no.1
• /
• pp.41-51
• /
• 2004

A direct numerical simulation is performed to analyze the effects of a localized time-periodic blowing on a turbulent boundary layer flow at R $e_{+}$=300. Main emphasis is placed on the blowing frequency effect on near-wall turbulent flow structures at downstream. Wall-normal velocity on a spanwise slot is varied periodically at different frequencies (0.004$\leq$ $f^{＋}$$\leq$0.080). The amplitude of periodic blowing is $A^{＋}$=0.5 in wall nit, which corresponds to the value of $v_{rms}$ at $y^{＋}$=15 without blowing. The frequency responses are scrutinized by examining the phase or time-averaged turbulent statistics. The optimal frequency ( $f^{＋}$=0.03) is observed, where maximum increase in Reynolds shear stress, streamwise vorticity fluctuations and energy redistribution occurs. The phase-averaged stretching and tilting term are investigated to analyze the increase of streamwise vorticity fluctuations which are closely related to turbulent coherent structures. It is found that the difference between PB and SB at a high blowing frequencies is negligible.e.e.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.11a
• /
• pp.283-287
• /
• 2003

Crystal structure of $(Ba_{1-x}La_x)[Mg_{(1+x)/3}Nb_{(2-x)/3}]O_3$ (BLMN) ceramics with $0{\leq}x{\leq}1$ was investigated using synchrotron X-ray powder diffraction (XRD) and high resolution transmission electron microscopy (HRTEM). When La content, x, is above 0.1, the 1:2 ordered hexagonal structure found in $Ba(Mg_{1/3}Nb_{2/3})O_3$ (BMN) was transformed into 1:1 ordered cubic structure. The 1:1 ordered cubic structure was maintained up to x=0.7. However, when x exceeded 0.7, BLMN was transformed 1:1 ordered structure which has cation displacement and in-phase and anti-phase tilt of octahedra.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.7
• /
• pp.718-723
• /
• 2004

Crystal structure of $(Ba-{1-x}La_x)[Mg_\frac{1+x}{3}}Nb_\frac{{2-x}{3}}]O_3$ (BLMN) ceramics with 0\leq1x \geq was investigated using synchrotron X-ray powder diffraction (XRD) and high reso(B $a_{l-x}$L $a_{x}$)[M $g_{(1+x)}$3/N $b_{(2-x)/3}$］ $O_3$lution transmission electron microscopy (HRTEM). When the La content, x, is above 0.1, the 1:2 ordered hexagonal structure found in Ba($Mg_\frac{1}{3}Nb_\frac{2}{3}})O_3$(BMN) was transformed into 1:1 ordered cubic structure. The 1:1 ordered cubic structure was maintained up to x=0.7. When x exceeded 0.7, however, BLMN was transformed into 1:1 ordered structure which has cation displacement and in-phase and anti-phase tilt of octahedra.

• Korean Journal of Materials Research
• /
• v.9 no.9
• /
• pp.943-947
• /
• 1999

The crystal structure and the microwave dielectric properties of $La(Mg_{1/2}Ti_{1/2})O_3$ ceramics have been investigated. $La(Mg_{1/2}Ti_{1/2})O_3$ has the 1:1 ordered monoclinic structure with the lattice parameters of $a = 5.5467(3){\AA}, b = 5.5616(3){\AA}, c = 7.8426(5) {\AA} and \beta = 89.9589 (2)^{\circ}$ The spacegroup of LMT is $P2_1/n$. Monoclinic LMT has the in­phase and anti-phase tilting of octahedra with the $a^_a^_c^_$ tilting system. Anti-parallel shift of A-site cations was also found in LMT. The relative density of the specimens sintered above $1600^{\circ}C$ was ranged between 95 % and 96 % of the theoretical density and the dielectric constant of specimens was about 28. The highest $Q\timesf$ achieved in this investigation was 63,100 for the specimen sintered at $1630^{\circ}C$ for 5 hr. Temperature coefficient of resonance frequency ranged from $>-74 ppm/^{\circ}C ~ -79 ppm/^{\circ}C$.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.2
• /
• pp.41-51
• /
• 2004

In this paper, the beam steering dipole phased array antenna systems for IMT-2000 base station have been designed. The designed beam steering dipole phased array antenna systems are constituted by the antenna part and the beam steering control system part. The antenna part is designed by the proposed flat dipole for the broadband characteristics, and the 8${\times}$8 dipole array antenna is constructed by the proposed flat dipole for the directional radiation pattern. Besides the vertical power divider is designed for the vertical power distribution. The beam steering control system part is designed the horizontal power divider for the horizontal power distribution, the 4-bit phase shifters and the driving circuit of phase shifters for the horizontal beam tilting. In order to evaluate a performance of the designed antenna systems, they were fabricated and the radiation characteristics were measured. From the measured results, we found that the horizontal beams were tilted by the each control signals, and the measured radiation characteristics showed good agreement with the design goals.

• The Journal of Korean Physical Therapy
• /
• v.10 no.1
• /
• pp.127-138
• /
• 1998

This study was carried out tn invstigate and compare biomechanical characteristics during free speed gait in hemiplegic patients after stroke who took therapeutic exercise by analyzing kinematic and kinetic data in the sagital plane and electromyographic data. Six patients($41\~69$ years old) and age-matched six volunteers in good health(51-61 years old) wire studied. The patients were sorted into two groups, depending on their self-speed of walking : fast speed group(3 patients) and slow speed group(3 patients). The results were as fellows. : 1. In spatio-temparal parameters, affected and unaffected side of fast group showed symetry but blew group showed asymetry of single limb support, opposite foot contact and stance phase (p<0.05). Compared with normal group, patient group showed slower velocity, shoter stride length and longer double limb support (p<0.05). 2. In the pelvic anterior tilt, patient group showed lower valued than normal group. It. In the ground reaction force-vertical force, fast group showed similar double peak gragh compared with normal group, butvslow group showed lower values without double peak (p<0.05).

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.48 no.12
• /
• pp.987-995
• /
• 2020

Accurate alignment between high-performance payloads and attitude control sensors is essential factor to guarantee accurate attitude orientation and high pointing stability of the satellite. Space craft developers often use theodolite measurement system for satellite alignment during ground AIT(Assembly Integration and Test) phase. When measuring theodolite, errors may occur due to line of sight error, tilting axis error, vertical index error, and vertical axis error. In addition, errors that can occur during alignment measurements with multiple theodolites are analyzed through the alignment cube measurements test. Based on the alignment cube measurements test, a technical method that can improve the alignment measurement accuracy was suggested and it's measurements results satisfied the satellite design requirements.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.2
• /
• pp.19-29
• /
• 2004

In this paper, the beam steering dipole phased array antenna systems for IMT-2000 base station have been designed. The designed beam steering dipole phased array antenna systems are constituted by the antenna part and the beam steering control system part. The antenna part is designed by the proposed flat dipole for the broadband characteristics, and the 8${\times}$8 dipole way antenna is constructed by the Proposed flat dipole for the directional radiation pattern. Besides the vertical Power divider is designed for the vertical power distribution. The beam steering control system part is designed the horizontal power divider for the horizontal power distribution, the 4-bit phase shifters and the driving circuit of phase shifters for the horizontal beam tilting. In order to evaluate a performance of the designed antenna systems, they were fabricated and the radiation characteristics were measured. From the measured results, we found that the horizontal beams were tilted by the each control signals, and the measured radiation characteristics showed good agreement with the design goals.