• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.375-378
• /
• 2007

This paper describes indoor location estimation intelligent robot. It is loaded indoor location estimation function using RSSI based indoor location estimation system and wireless sensor networks. Spartan III(Xilinx, U.S.A.) is used as a main control device in the mobile robot and the current direction data is collected in the indoor location estimation system. The data is transferred to the wireless sensor network node attached to the mobile robot through Zigbee/IEEE 802.15.4, a wireless communication. After receiving it, with the data of magnetic compass the node is aware of and senses the direction the robot head for and the robot moves to its destination. Indoor location estimation intelligent robot is can be moved efficiently and actively without obstacle on flat ground to the appointment position by user.

• Proceedings of the Korea Contents Association Conference
• /
• 2009.05a
• /
• pp.491-496
• /
• 2009

In this paper, we propose USN Protocol of Room Control with high efficiency and new routing techniques. I establish a network of cluster hierarchy structure under bases standard for IEEE 802.15.4 and another networks to manage each room use a control packet transmitted and The proposed protocol does not perform BroadCast over a network and transmits a packet to same layer to the destination and then passes the packet after doing searches. If a destination to be transmitted cannot be looked up, the protocol transmits AODV routing packet so that not only traffic load of a wireless network is decreased, but also efficient routing path can be obtained.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.9
• /
• pp.1939-1946
• /
• 2012

USNs (Ubiquitous Sensor Networks) such as IEEE 802.15.4 ZigBee network share ISM (Industrial, Scientific, and Medical) frequency band with WiFi networks. Once both networks operate in a region, packet collision may happen because of frequency overlapping. To assure this possibility, we conducted experiments where WiFi and ZigBee communication networks had been installed in an area. As a result of the test, successful data transmission rate were reduced due to the frequency overlapping between a WiFi communication channel and a ZigBee communication band. To cope with this problem, we propose a collision avoidance algorithm. In the proposed algorithm, if frequency collision is sensed, new communication channel with different frequency band is allocated to each node. Performance of the proposed frequency collision avoidance algorithm was tested and the results were described.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.6
• /
• pp.1185-1192
• /
• 2015

A wireless bridge is essential to transmit control and managing information to sensors or instruments from a central integrated ship area network station. In this paper, a WPAN protocol is adopted for development of a seamless N-screen wireless service in Indoor and Ship Area Networks. Furthermore, to provide the OSMU (One Source Multi Use) N-screen service through P2P streaming in the seamless WPAN protocol, a Grid-based WPAN networking technology is proposed and analyzed. The proposed Grid-based WPAN networking technology supports multi-path and fast path-setup functions for N-screen communications. The simulation results demonstrate that the proposed Grid-based WPAN networking technology outperforms the IEEE 802.15.4 based network in terms of N-screen transmission delay.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.7
• /
• pp.3-9
• /
• 2013

This paper proposes a selective-weighted energy detection (S-WED) and a synchronization algorithm appropriate for it in IR-UWB system. Energy detectors that are practical in terms of implementation are employed widely for noncoherent reception in IR-UWB systems. However, they show low performance due to using the energy samples captured at symbol rate. For this reason, weighted energy detectors are developed to improve the performance of EDs. Hence, for WED, not only synchronization but also the weight coefficients are needed to be obtained prior to data detection. Meanwhile, the optimal weighting coefficients of WEDs are known to be energy values. Therefore, synchronization and the weighting coefficients can be obtained simultaneously. This paper proposes an S-WED and a simple synchronization algorithm for it in which sub-intervals having energies under a certain level are excluded in energy accumulation resulting in a simpler WED with a bit performance increase in low SNR region. The proposed algorithm is verified through simulations using the preamble symbol and channel models defined in the IEEE 802.15.4a.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.11A
• /
• pp.1086-1095
• /
• 2007

This paper proposes a novel non-coherent TOA estimation scheme using multiple correlation process on the existence of multiple simultaneously operating piconets (SOPs). Impulse radio-ultra wideband (IR-UWB) based on direct sequence spread spectrum (DSSS) using Gold sequence is employed in order to discriminate each piconet. In order to enhance the characteristic of correlation, this paper presents the method of multiple mask operation (MMO). The time of arrival (TOA) of direct line of sight (DLOS) path is estimated via two step coarse/fine timing detection. To verify the performance of proposed scheme, two distinct channel models approved by IEEE 802.15.4a Task Group (TG) are considered. According to the simulation results, it could conclude that the proposed scheme have performed better performance than the conventional method well even in densed indoor multi-path environment as well as in the existence of multiple SOPs.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.2 s.93
• /
• pp.199-203
• /
• 2005

In this paper, a novel compact and frequency band-notch antenna for Ultra-Wideband(UWB) applications is proposed. The designed antenna not only shows good impedance bandwidth for ultra-wideband but has band notch characteristic for the frequency band of $5.15\~5.825\;GHz$ limited by IEEE 802.1la and HIPERLAN/2. To achieve both properties of wide band and band notch, the techniques of a concaved ground plane and inserted U-shaped thin slot into planar radiator are used respectively. A manufactured antenna satisfied VSWR<2 for the frequency band of $2.95\~11.7\GHz$ except the limited band of $4.92\~5.866\;GHz$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.12 s.103
• /
• pp.1194-1205
• /
• 2005

This paper proposes a uni-planar elliptical element UWB antenna with band-notched characteristic and modified pound plane fed by CPW. The antenna achieves VSWR below 2 for UWB band(3.1 GHz${\~}$10.6 GHz). In addition, a band-notched characteristic is achieved by inserting a horizontal slot on the radiation element to avoid the interference with 5 GHz(5.15 GHz${\~}$5.825 GHz) band limited by IEEE 802.1la. The antenna has a thin profile, compact size, and ease of manufacture by adopting a CPW feed structure without any additional background plane. Measured data show that the proposed antenna has good return loss below -10 dB, about 2.1 dB${\~}$4.75 dB maximum gain over the bandwidth, omni-directional radiation patterns, linear phase response.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.10
• /
• pp.20-28
• /
• 2007

Zigbee sensor network base on IEEE802.15.4 has local address of 2 byte on transmit packet data which is pick up the address for each sensor node. Sensor network is requested low power, low cost, many nodes at hues physical area. There for Zigbee is very good solution supporting for next Ubiquitous generation but the Zigbee sensor network has address allocation problem of each sensor node. Is established standard from Zigbee Alliance, to the address allocation method uses Cskip algorithm. The Cskip algorithm use the hazard which allocates an address must blow Hop of the maximum modification and child node number. There is to address allocation and from theoretically it will be able to compose a personal 65536 sensor nodes only actual with concept or space, only 500 degree will be able to compose expansion or the low Zigbee network. We proposed an address allocation method using coordinate value for Zigbee sensor network.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.5
• /
• pp.1-11
• /
• 2008

Wireless Sensor Networks is applied to improvement of life convenience or service like U-City as well as environment pollution, tunnel and structural health monitoring, storm, and earthquake diagnostic system. To increase the usability of sensor data and applicability, mobile devices and their facilities allow the applications of sensor networks to give mobile users and actuators the results of event detection at anytime and anywhere. In this paper, we present MUSNEMO(Multi-sensor centric Ubiquitous Smart sensor NEtwork using Mobile devices) developed system for providing more efficient and valuable information services with a variety of mobile devices and network camera integrated to WSN. Our system is performed based on IEEE 802.15.4 protocol stack. To validate system usability, we built sensor network environments where were equipped with five application sensors such magnetic, photodiode, microphone, motion and vibration. We also built and tested proposed MUSNEMO to provide a novel model for event detection systems with mobile framework.