• Applied Science and Convergence Technology
• /
• 제25권6호
• /
• pp.124-127
• /
• 2016

Humidity calibration for a temperature-stable quartz oscillator (TSQO) was investigated to exclude the influences of relative humidity on the TSQO output in order to use the corresponding devices outdoors. The TSQO output is a voltage that is inversely proportional to the electric impedance of the quartz oscillator, which depends on the viscosity and density of the measured gas. The TSQO output was humidity calibrated using its humidity dependence, which was obtained by varying the relative humidity (RH) from 0 to 100 RH% while other conditions were kept constant. The humidity dependencies of the TSQO output were fit by a linear function. Subtracting the change in the TSQO output induced by the change in humidity, calculated with the function from the experimentally measured TSQO output for a range of 0-100RH%, eliminated the influence of humidity on the TSQO output. The humidity calibration succeeded in reducing the fluctuations of the TSQO output from 0.4-3% to 0.1-0.3% of the average values for a range of 0-100RH%, at constant temperatures. The necessary stability of the TSQO output for application in hydrogen sensors was below one-third of the change observed for a hydrogen leakage of 1 vol.% hydrogen concentration, corresponding to 0.33% of the change in each background. Therefore, the results in this study indicate that the present humidity calibration effectively suppresses the influence of humidity, for the TSQO output for use as an outdoor hydrogen sensor.

• 한국안전학회지
• /
• 제27권3호
• /
• pp.111-116
• /
• 2012

This study is about the quantitative safety assessment of hydrogen station in Korea operating with on-site type. This was written by background information that before qualitative safety assessment to write. For the qualitative safety assessment method, the study used FMEA(failure mode & effect analysis) and HAZOP(hazard & operability), and adopted the FTA(fault tree analysis) as the quantitative safety assessment method. To write the FTA, we wrote FT by Top event that hydrogen leakage can be called most serious accident of hydrogen station. Each base event collect reliability data by reliability data handbook, THERP-HRA and estimation of the engineering. Assessment looked at the high frequency and the possible risk through Gate, Importance, m.cutsets analysis.

• 한국가스학회지
• /
• 제25권4호
• /
• pp.57-62
• /
• 2021

본 연구는 국제공동 연구로 개발 된 HyKoRAM 프로그램을 이용하여 저장설비(튜브트레일러)의 누출 시 위험성평가를 진행하였다. 수소충전소 내의 고압가스설비는 크게 4가지로 저장설비(튜브트레일러), 처리설비(압축기), 압축가스설비, 충전설비(디스펜서)로 분류된다. 그 중 저장설비인 튜브트레일러의 설계 사양, 주변 환경 조건 등을 반영하여 기존에 발생된 사고 및 잠재적 사고 위험 사고 시나리오를 구성하였다. 이를 통해, 수소충전소 저장 설비의 위험을 확인하고 수소충전소 안전성 향상을 위한 대책을 제안한다.

• 대한조선학회논문집
• /
• 제60권6호
• /
• pp.433-440
• /
• 2023

This study aims to establish safety zones for bunkering operations of hydrogen propulsion ships in coastal areas through risk assessment and evaluate their validity. Using a 350 kW-class ferry operating in Busan Port as the subject of analysis, with quantitative risk assessment based on accident consequence and frequency analysis, along with a social risk assessment considering population density. The results of the risk assessment indicate that all scenarios were within acceptable risk criteria and ALARP region. The most critical accident scenarios involve complete hose rupture during bunkering, resulting in jet flames (Frequency: 2.76E-06, Fatalities: 9.81) and vapor cloud explosions (Frequency: 1.33E-08, Fatalities: 14.24). For the recommended safety zone criteria in the 6% hose cross-sectional area leakage scenario, It could be appropriate criteria considering overall risk level and safety zones criteria for hydrogen vehicle refueling stations. This research contributes to establishing safety zone for bunkering operations of hydrogen propulsion ships through risk assessment and provides valuable technical guidelines.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 D
• /
• pp.1925-1927
• /
• 1999

At the study, it has fabricated Al/AlN/GaAs MIS capacitor using DC reactive sputtering method. To applicate GaAs semiconductor in a MIS devices, investigated capability of AIN thin film by the insulator layer. Also it has investigated inversion of C-V characteristics by addition of the hydrogen(hydrogen concentration: 5%) and it has investigated that leakage current has $10^{-8}A/cm^2$ for 1 MV/cm breakdown electric field of I-V characteristics.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 C
• /
• pp.1239-1241
• /
• 1995

The different hydrogen passivation effects on low-temperature processed and high-temperature processed poly-Si thin film transistors have been investigated. The hydrogen passivation on low-temperature processed poly-Si TFT results in the increase of the field-effect mobility and the decrease or the threshold voltage, while the hydrogenation increases the field-effect mobility and decreases the leakage current in high-temperature processed poly-Si TFT. The effective trap state densities of low-temperature processed poly-Si TFT before and after 5 hours of hydrogenation are estimated at about $4.0{\times}10^{12}/cm^2$ and $1.5{\times}10^{12}/cm^2$, while those of high-temperature processed poly-Si TFT are about $1.5{\times}10^{12}/cm^2$ and $1.2{\times}10^{12}/cm^2$, respectively.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2008년도 International Meeting on Information Display
• /
• pp.867-869
• /
• 2008

We have investigated the effects of hydrogen plasma treatment by PECVD (Plasma Enhanced Chemical Vapor Deposition) in the back channel region, the method for reducing the off state leakage current which increases with the short channel length of a-Si:H TFTs. To improve the off current characteristics, we analyzed the hydrogen plasma treatment with various RF power and plasma treatment times of PECVD. As the result of hydrogen plasma treatment in the back channel region it was remarkably reduced the off current level of 2um channel length TFT.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 하계학술대회 논문집 Vol.5 No.1
• /
• pp.41-43
• /
• 2004

Dielectric thin films of $(Pb_{0.72}La_{0.28})Ti_{0.93}O_3$ were deposited on $Pt(111)/Ti/SiO_2/Si$ substrates in situ by pulsed laser deposition(PLD) and annealed with different gases which are forming gas and oxygen gas, respectively. The diffusion of hydrogen into the ferroelectric film was caused by annealing process and resulted in the destruction of polarization. The dielectric properties of forming gas annealed PLT thin films, which are dielectric constant, ferroelectric characteristic, and leakage current characteristics, were degraded

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2002년도 International Meeting on Information Display
• /
• pp.563-566
• /
• 2002

We investigated to decrease the leakage current of SiNx film by employing $N_2$ plasma treatment. The insulator layers were prepared by two step process; the $N_2$ plasma treatment and then PECVD SiNx deposition with $SiH_4$, $N_2$ gases. To prove the influence of the $N_2$ plasma treatment, the Si substrate was exposed to the plasma, which was generated in Ne gas ambient. Without plasma treatment SiNx film grow at the rate of 7. 03 nm/min, has a refractive index n = 1.77 and hydrogen content of $2.16{\times}10^{22}cm^{-3}$ for $N_2/SiH_4$ gas flow ratio of 20. The obtained films were analyzed in terms of deposition rates, refractive index, hydrogen concentration, and electrical properties. By employing $N_2$ plasma treatment, interface traps such as mobile charges and injected charges were removed, hysteresis of capacitance-voltage (C-V) disappeared. We observed plasma treated sample were decreased the leakage current density reduces by 2 orders with respect to the sample having no plasma treatment.

• 한국산업보건학회지
• /
• 제23권4호
• /
• pp.384-392
• /
• 2013

Objective: This study inspected incident cases, legal control levels, and GHS(Globally Harmonized System of Classification and Labeling of Chemicals) classification results of strong acids such as hydrogen fluoride, hydrogen chloride, nitric acid, and sulfuric acid, which have been responsible for many recent chemical accidents. As a result, it is deemed necessary for legal control levels of these strong acids to be revised and GHS classification be managed nation-wide. Methods: This study inspected incident cases and legal control levels for strong acids such as hydrogen fluoride, hydrogen chloride, nitric acid, and sulfuric acid. The study analyzed and compared chemical information status and GHS classification results. Results: There were 76 domestic incidents involving strongly acidic hazardous materials over the five years between 2007 and 2011. They include 37 leakage incidents(46.7%) within a workplace, 30 leakage incidents(39.5%) during transportation, and nine leakage incidents(13.8%) following an explosion. The strongly acidic materials in question are defined and controlled as toxic chemicals according to the classes of Substances Requiring Preparation for Accidents, Managed Hazardous Substance, Hazardous Chemical(corrosive) as set forth under the Enforcement Decree of the Toxic Chemicals Control Act and Rules on Occupational Safety and Health Standards of Occupational Safety and Health Act. Among them, nitric acid is solely controlled as a class 6 hazardous material, oxidizing liquid, under the Hazardous Chemicals Control Act. The classification results of the EU ECHA(European Chemicals Agency) CLP(Commission Regulation(EC) No. 790/2009 of 10 August 2009, for the purposes of its adaptation to technical and scientific progress, Regulation(EC) No 1272/2008 of the European Parliament and of the Council on classification, labeling and packaging of substances and mixtures) and NIER (National Institute of Environmental Research) are almost identical for the three chemicals, with the exception of sulfuric acid. Much of the classification information of NITE (National Institute of Technology and Evaluation) and KOSHA(Korea Occupational Safety and Health Agency, KOSHA) is the same. NIER provides 12(41.4%) out of 29 classifications, as does KOSHA.