• Proceedings of the KSR Conference
• /
• 2006.11b
• /
• pp.245-250
• /
• 2006

From the research which it sees the safety regarding a high-speed railway vehicle collision and a derailment evaluation research it an example and executed. Japan, France, Germany and Spain, Italy and with our country together it compared a high-speed railway vehicle collision of the high-speed railroad operating nation and derailed relation safety standard and safety against the evaluation system trade name comparison it analyzed. The research which it sees it led and the accident instance against the hazard analysis against the collision and a derailment of the high-speed railway vehicle and a risk evaluation together and a high-speed vehicle collision and derailed it cannot prevention plan from hereafter domestic comparison it analyzed forecast it presented.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.2
• /
• pp.1-11
• /
• 1998

The 4WS system is usually developed to improve the maneuverability at low speed and the straight line stability at high speed, but it is found to have the severe understeer characteristics at high speed. Therefore a 4WS vehicle requires to turn the steering wheel much more than a 2WS vehicle at high speeds even a driver goes through the same curved road. In this study, to enhance the cornering performance of the 4WS vehicle at high speed, a DYC 4WS system is proposed based on the nonlinear 4WS system and direct yaw moment control system. Especially the proposed DYC 4WS system is able to realize a zero side slip angle for vehicles and a cornering performance similar to the 2WS vehicle at high speed.

• Proceedings of the KSR Conference
• /
• 2008.06a
• /
• pp.1137-1142
• /
• 2008

In this paper, an effect on power conversion unit in high-speed railway vehicle by loss of contact between a catenary system and pantograph suppling electrical power to high-speed railway vehicle are investigated. One of the most important needs accompanied by increasing the speed of high-speed railway vehicle is reduced that arc phenomenon by loss of contact brings out EMI. in case of high-speed railway vehicle using electrical power, as comparison with diesel rolling stock, PLD(Power Line Disturbance) such as harmonic, transient voltage and current, EMI, dummy signal injection etc usually occur. To analysis the effect on loss of contact, it is necessary electrical modeling system between the contact line and the pantograph according to the loss of contact. Therefore analytical model of a contact line and a pantograph is constructed to simulate the behaviour of loss of contact. The reliability of the modeling system is verified by simulation implementation on kinds of loss of contact.

• Structural Engineering and Mechanics
• /
• v.77 no.5
• /
• pp.627-635
• /
• 2021

The speed of rail vehicles become higher and higher over two decades, and China has unveiled a prototype high-speed train in October 2020 that has been able to reach 400 km/h. At such high speeds, wheel-rail force items that had previously been ignored in common computational model should be reevaluated and reconsidered. Aiming at this problem, a new model for investigating the vehicle-bridge interaction at high moving speed is proposed. Comparing with the common model, the new model was more accurate and applicable, because it additionally considers the second-order pseudo-inertia forces effect and its modeling equilibrium position was based on the initial deformed curve of bridge, which could include the influences of temperature, pre-camber, shrinkage and creep deformation, and pier uneven settlement, etc. Taking 5 km/h as the speed interval, the dynamic responses of the classical vehicle-bridge system in the speed range of 5 km/h to 400 km/h are studied. The results show that ignoring the second-order pseudo-inertia force will underestimate the dynamic response of vehicle-bridge system and make the high-speed railway bridge structure design unsafe.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.33 no.5
• /
• pp.358-364
• /
• 2009

This paper is to investigate the influence of driving patterns of slow and high speed vehicles on the performance of continuously regenerating diesel particulate filter(DPF) system matched with operating conditions in field application. The DPF performance test for field application was carried out for two identical DPFs installed to slow and high speed vehicles. A slow speed vehicle was selected among local buses which have driving patterns to repeat running and stop frequently, while a high speed vehicle was prepared to have long route of high speed over 60km/h like inter-city buses. In this test, the regeneration performance on the DPF of slow speed vehicle deteriorated because of high soot load index(SLI) in spite of same balance point temperature(BPT) distribution for high speed vehicle. The DPF of slow speed vehicle melted in the end because the rapid increase of back pressure caused high temperature over $1200^{\circ}C$ in the ceramic wall of DPF. The PM components like ash collected to the filter in the DPF were analyzed in order to investigate the cause of the defect and provide an operation performance of DPF system. In the result of the analysis, high levels of lubrication oil ash(Ca, Mg, P, Zn) were detected.

• Wind and Structures
• /
• v.29 no.5
• /
• pp.299-312
• /
• 2019

Due to the rugged terrain, metro lines in mountain city across numerous wide rivers and deep valleys, resulting in instability of high-pier bridge and insecurity of metro train under crosswind. Compared with the conditions of no-wind, crosswind triggers severer vibration of the dynamic system; compared with the short-pier viaduct, the high-pier viaduct has worse stability under crosswind. For these reasons, the running safety of the metro vehicle traveling on a high-pier viaduct under crosswind is analyzed to ensure the safe operation in metro lines in mountain cities. In this paper, a dynamic model of the metro vehicle-track-bridge system under crosswind is established, in which crosswind loads model considering the condition of wind zone are built. After that, the evaluation indices and the calculation parameters have been selected, moreover, the basic characteristics of the dynamic system with high-pier under crosswind are analyzed. On this basis, the response varies with vehicle speed and wind speed are calculated, then the corresponding safety zone is determined. The results indicate that, crosswind triggers drastic vibration to the metro vehicle and high-pier viaduct, which in turn causes running instability of the vehicle. The corresponding safety zone for metro vehicle traveling on the high-pier is proposed, and the metro traffic on the high-pier bridge under crosswind should not exceed the corresponding limited vehicle speed to ensure the running safety.

• Proceedings of the KSR Conference
• /
• 2009.05b
• /
• pp.217-222
• /
• 2009

High-speed EMU under development vibrates more than a articulated high-speed train since power units are attached on each vehicle and railway vehicle. In this study, anisotropic equivalent stiffness of a aluminum extrusion plate were calculated to know and predict vibration characteristic of High-speed EMU under development. Eigen frequencies and modal shape of high speed train vehicle were calculated. And vibration generated was predicted at each position of vehicle when vehicle was operating.

• Proceedings of the KSR Conference
• /
• 2008.11b
• /
• pp.1435-1440
• /
• 2008

High-speed train under development is a type of EMU(electric multiple units). Since power sources like motors and gears are distributed in the high-speed EMU, the high-speed EMU generates vibration and sound more than the articulated high-speed train. Vibration of vehicle, vibration between rails and wheels, hunting of bogie and snake motion reduce ride comfort. In this paper, to decrease the vibration of the articulated high-speed train, improvements were presented using an analytical model and a simulation model. The simulation model of the high-speed EMU was designed on the basis of the korean high-speed train and the design parameters for ride comfort were showed and the dynamic characteristics of the vehicle was understood. To consider the characteristics of the vehicle suspension, the analytical model was designed and the simulation model was verified with it.

• Proceedings of the KSR Conference
• /
• 1999.05a
• /
• pp.83-94
• /
• 1999

This study is about design of vehicle for air tightness to pressure waves of high speed train. When the train runs to high speed over 300km/h, the comfort of passenger come down due to difference pressure between inside and outside of passenger room. The car-body was carried out the design of air-tightness, and the analysis of inside pressure of vehicle in tunnel by TG_TUN of ALSTOM Co. The result of analysis should be used the design of air pressurized system and car-body of G7 high speed train project.

• Proceedings of the KSR Conference
• /
• 2004.10a
• /
• pp.393-398
• /
• 2004

From the research which it sees the noise of the high-speed railroad use nation it gave and the vehicle sound arresting tile masturbation which is a sound arresting unit standard it slept and in an environment noise standard side from it classified. The case foreign nation vehicle of the KTX vehicle where vehicle sound arresting from the side the high speed railroad use nations from the open ground with 64-68 dBA are used first of all from domestic and it compares and the efficiency almost is a possibility of knowing the beginning of history box from the interior sound arresting side. Also it will be developed from domestic and to case of the position KHST vehicle the speed 50 km/h is more speed up the KTX vehicle than in spite of the standard which is equal will pay with 350 km/h and it will be having and the possibility the strong point is knowing very from the interior sound arresting side it was. For railroad area along resident at the comfort improvement of the second the environment noise standard which it presents from the nation of most the patronage standard inland conforms in the law standard and the case high speed railroad of the place comparing domestic which is presented is not in spite of still prepared 2004 April commerce is operated standard easily not to be, it appeared with the fact that the speed governing one standard establishment by law is necessary.