• Journal of Industrial Technology
• /
• v.3
• /
• pp.87-94
• /
• 1983

Heating characteristics of red pepper paste packed in report pouches of various thicknesses and their storage stability were investigated to determine the adequate processing conditions that good bacteriological safty and minimal quality changes could be obtained, when sterilized by using a steam-air system retort. A heat penetration into pouch-packed red pepper paste was carried out through by a conductive heat transfer, indicating a simple logarithmic heating curve, and the smaller thickness revealed the higher heat penetration rate, suggesting the possibility of high temperature-short time sterilization of red pepper paste. The processing conditions with Fo-value of 4.5 or higher were sufficient for keeping up bacterial safty, but based on C-value, better quality retention was obtained at pouch thickness of 15mm under the processing temperature of $120^{\circ}C$. Subsequent storage study revealed that the red pepper paste packed in 15mm and processed at $120^{\circ}C$ with Fo=4.5 could be held without any spoilage and overall acceptance change, when stored for 6 months at room temperature under the relative humidity of 70%. After 3 months storage in $38^{\circ}C$ under saturation humidity, overall acceptance of red pepper paste were judged not to be maintainable on the acceptable level, but it may be suggested that above the results could be kept up a desirable quality without any remarkable deterioration.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.25 no.3
• /
• pp.382-388
• /
• 2011

Traditional Korean Medicine and Taoism think of the importance of a life nurturing for one's health and longevity. However, for a life nurturing, Traditional Korean Medicine aims at a person living up to one's natural life span. Taoism lays importance on ascending up to the sky to be a Taoist hermit with supernatural powers. Therefore, they both differ in the pursuit of their goals and their methods in doing respectively. In this study we have shown similarities and differences in the meaning and ways to practice su-seung-hwa-gang (body water rising and heat falling) which Traditional Korean Medicine and Taoism regard highly as a means of the practice of a life nurturing. Su-seung-hwa-gang is a concept that both Traditional Korean Medicine and Taoism set a high value on and at the same time it is a concrete method of a life nurturing demonstrating the possibility of 'non-disease treatment' through the active efforts of Traditional Korean Medicine.

• The Journal of the Acoustical Society of Korea
• /
• v.21 no.3E
• /
• pp.126-131
• /
• 2002

Ultrasonic measurements are made in egg white to study the properties of the solution of the natural protein. The high-Q ultrasonic resonator method is used to get the ultrasonic absorption spectra over the range 0.2-10 ㎒ at 20℃. It is proportional to the 1.25th power of the frequency. The gelation process caused by heat is studied from the change in the velocity and the absorption. at 3 ㎒ using the pulse echo overlap technique over the range of 10-80℃. The absorption decreases with increasing temperature up to 60℃ where it turns up sharply and rapidly increases thereafter. The strong absorption in the gel region is described by the interaction between the solution and the network structure made of protein. Very slow variation in time elapse is observed after the temperature is quickly raised. It would be a real-time observation of the network building process and the characteristic time for the process is shown to be 400 min. A hysteresis phenomenon with respect to the temperature is observed. This phenomenon is associated with the memorizing effect of the network structure of protein of the gel.

• Journal of the Korean Society for Heat Treatment
• /
• v.32 no.6
• /
• pp.249-255
• /
• 2019

This study is intended to clarify the main microstructural factors that contribute to an increase of hardness during isothermal aging in Mg-Al alloy. For this work, Mg-9.3%Al alloy specimens were solution-treated at 688 K for 24 h followed by water quenching, and then aged at 473 K for up to 24 h. The aging at 473 K yielded nodular discontinuous precipitates (DPs) with (${\alpha}+{\beta}$) lamellar morphology at the grain boundaries, and the volume fraction of DPs increased from 0% to ~30% with increasing aging time up to 12 h. For the aging times longer than 12 h, further formation of DPs was substantially inhibited owing to the occurrence of significant continuous precipitation within the ${\alpha}-(Mg)$ matrix, and the density of continuous precipitates (CPs) becomes greater with increasing aging time. Hardness of the specimen was steadily increased with aging time up to 24 h. Microstructural examination on the aged specimens revealed that the increased overall hardness at the early stage of aging is associated with the increased volume fraction of DPs, but at the later stage of aging, where the amount of DPs was hardly changed, the increased hardness of the ${\alpha}-(Mg)$ matrix in response to the higher density of CPs within the matrix, plays a key role in increasing the overall hardness value.

• Transactions of the Korean hydrogen and new energy society
• /
• v.26 no.2
• /
• pp.184-191
• /
• 2015

As the power electronics system increases the frequency, the power loss and thermal management are paid more attention. This research presents a real time model of dissipation power with junction temperature response for 120kw IGBT inverter which is applied to the thermal management of high power IGBT inverter. Since the computational time is critical for real time simulation, look-up tables of IGBT module characteristic curve are implemented. The power loss from IGBT provides a clue to calculate the temperature of each module of IGBT. In this study, temperature of each layer in IGBT is predicted by lumped capacitance analysis of layers with convective heat transfer. The power loss and temperature of layers in IGBT is then communicated due to mutual dependence. In the dynamic model, PWM pulses are employed to calculation real time IGBT and diode power loss. Under Matlab/Simulink$^{(R)}$ environment, the dynamic model is validated with experiment. Results showed that the dynamic response of power loss is closely coupled with effective thermal management. The convective heat transfer is enough to achieve proper thermal management under guideline temperature.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.16 no.11
• /
• pp.1060-1067
• /
• 2004

To apply an analysis method of life cycle cost when assessing economics of equipment system, we should basically set up preconditions such as useful life, price escalation rate, interest rate, etc. as well as consider a calculation algorism of source energy and heat source system, which is a complex process for life cycle costing. For this reason, equipment designers tend to plan heat source systems, without a thorough investigation on economics of alternative systems at the pre-design phase. In this process, architectural designers should adopt a proper heat source system, which is one of the most important factors for planning an appropriate architectural design, through a discussion with equipment designers in a short time. In order to offer an evaluation method for equipment designers to analyze economics of an alternative heat source system easily at the pre-design phase, this research would define the simplified economics, evaluation method through analysis of existing papers for economics evaluation, and examine validity through comparison of simplified method values ($LCC_{EC}$) and life cycle costing values ($LCC_{15}$) for six alternative heat source systems.

• Fire Science and Engineering
• /
• v.25 no.2
• /
• pp.107-113
• /
• 2011

This paper presents the results of artificially accelerated aging characteristics of the rate of rise spot type heat detectors. This experiment carried out to investigate the detector's operating characteristics when a fire was broken out or the regular tests were performed. The result showed that the delay of operating time or no-operation of heat detector which was made by company B and used in the field for 5 years may be occurred even at the $100^{\circ}C$. This result is due to the leakage of inflated air from heat chamber. However the operating display LED was not out of order, even if the temperature was increased up to $160^{\circ}C$.

• Journal of Radiation Industry
• /
• v.7 no.2_3
• /
• pp.183-190
• /
• 2013

Mistletoe (Viscum album) has been widely used as a functional food material for various therapeutic purposes from ancient time. In this study, we examined anti-diabetic and cytotoxic activities of heated-treated mistletoe and the effects of gamma-irradiation on its activities. Heat-treated mistletoe extract was prepared by heating during different time (3, 6, 9 and 12 h) and gamma-irradiated with different doses of 0, 10, 30, 50, 70 and 100 kGy. Heat-treated mistletoe extracts showed a concentration-dependent cytotoxicity on rat insulinoma RINm5F cells and the effect was gradually decreased as heating time increased up to 12 h. 12 h heat-treated extract was no cytotoxic. Gamma-irradiation enhanced the reduction of heat-treated mistletoe-induced cytotoxicity and the decreasing effect was an irradiating dose-dependent. In particular, all of 70 kGy irradiated and heat-treated mistletoe extracts did not showed the cytotoxicity and the effect was comparable to 12 h heat-treated mistletoe extract. Among those extracts, 3 h heat-treated mistletoe extract gradually increased the insulin secreting activity by gamma-irradiation and the effect was the best at 70 kGy, whereas 12 heat-treated extract was no effect. On the test of ${\alpha}$-glucosidase inhibitory activity, 3 h heat-treated mistletoe extract showed the concentration dependent effects and gamma-irradiation induced more activity at 70 kGy, compared to non-irradiated 3 h and 12 h heated mistletoe extracts. These results suggest that the combination of heat treatment and gamma-irradiation might be more effective than only heat-treatment for improving the anti-diabetic activity of mistletoe extract and reducing its cytotoxicity.

• Journal of the Korean Society for Heat Treatment
• /
• v.17 no.5
• /
• pp.278-282
• /
• 2004

Effect of pre-treatment on the gas nitriding process of austenitic stainless steels has been investigated and the following results were obtained. Minimum pre-treatment time was decreased to 5min with increasing treatment temperature from $200^{\circ}C$ to $600^{\circ}C$. Surface activation effect by the pre-treatment was maintained in the air up to holding time of 64hr, judging from the analysis result of gas nitrided specimens. The Depth of nitrided layer of STS 304 and 316 stainless steels were ranged from $5{\mu}m$ to $90{\mu}m$ at $440^{\circ}C{\sim}600^{\circ}C$. The X-ray diffraction intensity for austenitic stainless steels were increases as nitriding temperature from $440^{\circ}C$ to $600^{\circ}C$.

• Journal of the Korean Ceramic Society
• /
• v.26 no.4
• /
• pp.471-478
• /
• 1989

In this study we investigated the gelation time of sol which containing mixtures of TEOS with H2O, ethanol, HCl in the preparation of monolithic silica glass through Sol-Gel method. In this case apparent activation energies were observed by Arrhenius equation. We investigated the conversion from gel to glass in drying and heat treatment stages using DT-TG, FT-IR, XRD analysis and dried gel conversed to glass by heat treatment up to 85$0^{\circ}C$. The results of this experiment showed that the gelation time of solutions were promoted when increasing the amount of addition of H2O and HCl catalyst for TEOS and high reaction temperature of solution.